• Journal of Broadcast Engineering
• /
• v.21 no.3
• /
• pp.404-411
• /
• 2016

In this paper, we investigate the radio wave radiation pattern to measure the actual field strength for the transmission antenna dipole antenna and the CP-ring antenna being used in our country as FM station, and the comparison was for field application. Compare results, If the transmitting station and the relay station which is located in the middle of a service area has been a useful CP-dipole antenna (four directions). CP-ring antenna having a directivity because the reflection effect of the tower was able to adjust the orientation to prevent the spread of menstrual another service area in the main direction was able to radiate high propagation 5~9dB. Especially, If the transmitting station and the relay station is located on one side of the service area for radiating radio waves in three directions by using the CP-ring antennas focus the orientation of the antenna in populated areas and road area can improve the broadcast reception environment.

• Journal of electromagnetic engineering and science
• /
• v.19 no.1
• /
• pp.37-41
• /
• 2019

A stack-ring configuration is proposed for designing a dual-band circularly polarized (CP) antenna. Each ring generates different resonant frequencies. A good CP performance at both resonant frequencies is achieved by adjusting the relative distance between the two rings. The two operating bands are separated with a small frequency ratio of 1.07. Measured results show that radiation patterns with good CP characteristics are obtained at the two resonant frequencies.

• ETRI Journal
• /
• v.31 no.5
• /
• pp.506-509
• /
• 2009

A novel design of a compact square-ring slot microstrip antenna for achieving circular polarization (CP) operation is proposed and experimentally studied. By using an arrow-shaped slot structure as a radiating element, the resonant frequency of the proposed antenna is significantly lowered, which can lead to a large size reduction for fixed frequency operation. The CP radiation characteristics are achieved by loading with proper asymmetry, which can be placed diagonally. A prototype of the proposed design is implemented and its performance is measured. Measured results show that radiation patterns with good CP characteristics are obtained at the resonant frequency.

• Journal of electromagnetic engineering and science
• /
• v.5 no.1
• /
• pp.31-35
• /
• 2005

This paper presents low form factor dual polarized antenna incorporating low profile annular ring patch antenna having 90$^{\circ}$ phase delay element for circular polarization(CP) and a reactive-loaded monopole linear polarized(LP) antenna. Both types of receiving antennas operate in the same frequency region from 2.320 GHz to 2.345 GHz, while different polarizations are used to take advantage of polarization diversity. The proposed CP antenna has good broadside radiation patterns, while the LP antenna reveals monopole-like radiation patterns. The gains of the antennas are measured to be 1.93 dBi and 2.24 dBi for CP and LP, respectively.

• Journal of electromagnetic engineering and science
• /
• v.14 no.4
• /
• pp.360-366
• /
• 2014

A single-feed composite cavity-backed four-arm curl antenna is presented for use in global positioning systems (GPS). Its primary radiating element is fed by a vacant-quarter printed ring, which helps the antenna directly match to a $50-{\Omega}$ coaxial line and produce a good circular polarization (CP). The cavity-backed reflector is employed to improve the CP radiation characteristics in terms of 3-dB axial ratio (AR) beamwidth and minimum AR value. The optimized design with an overall size of $90{\times}90{\times}25mm^3$ ($0.4725{\lambda}_o{\times}0.4725{\lambda}_o{\times}0.13{\lambda}_o$ at 1,575 MHz) results in a ${\mid}S_{11}{\mid}<-10dB$ bandwidth of 8.66% (1,514-1,651 MHz) and a 3-dB AR bandwidth of 2.23% (1,555-1,590 MHz). The antenna radiates a widebeam right-hand circular polarization and operates with a measured radiation efficiency greater than 90% within its impedance matching bandwidth.

• ETRI Journal
• /
• v.33 no.5
• /
• pp.802-805
• /
• 2011

This letter presents a K-band polarization reconfigurable antenna integrated with a silicon radio frequency MEMS switch into the form of a compact package. The proposed antenna can change its state from linear polarization (LP) to circular polarization (CP) by actuating the MEMS switch, which controls the configuration of the coupling ring slot. Low-loss quartz is used for a radiating patch substrate and at the same time for a packaging lid by stacking it onto the MEMS substrate, which can increase the system integrity. The fabricated antenna shows broadband impedance matching and exhibits high axial ratios better than 15 dB in the LP and small axial ratios in the CP, with a minimum value of 0.002 dB at 20.8 GHz in the K-band.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.8
• /
• pp.1759-1764
• /
• 2015

In this paper, we considered a design method of a circular polarization (CP) antenna for UHF (ultra high frequency) RFID (Radio Frequency IDentification) readers. The antenna is a dual-fed circular microstrip patch which produces right-handed CP. Quadrature hybrid coupler is used for dual feeding. The outputs of the coupler and circular patch are connected through copper wires, and the inductive reactance produced by the connecting wires is compensated by a ring-shaped slot inserted inside the circular patch. The effects of the geometrical parameters of the proposed antenna on the antenna performance are examined, and the parameters are adjusted to be suitable for the operation in North American UHF RFID band (902-928 MHz), which includes domestic UHF RFID band. The antenna is fabricated, and the experiment results reveal a frequency band of 854-993 MHz for a voltage standing wave ratio < 2. The fabricated antenna is connected to a commercial RFID reader, and it showed a good performance of tag identification.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.5
• /
• pp.906-912
• /
• 2017

In this paper, we studied a design method for a broadband 3-element quasi-Yagi antenna (QYA) for indoor digital television (DTV) reception. The proposed QYA employs a novel balun between a microstrip (MS) line and a coplanar strip (CPS) line feeding the driver dipole. The proposed balun is constructed by connecting the end of MS line to CPS line through a shorting pin, and the CPS and ground reflector are connected through a circular ring-type conductor. An antenna, as an design example for the proposed antenna, is designed for the operation in the frequency band of 470-806 MHz for terrestrial DTV. The antenna fabricated on an FR4 substrate with a size of $270mm{\times}150mm$ showed a good performance such as a frequency band of 470-820 MHz for a voltage standing wave ratio < 2, a gain > 4.0 dBi, and a front-to-back ratio > 8.4 dB over the DTV frequency band.

• Journal of electromagnetic engineering and science
• /
• v.13 no.1
• /
• pp.44-50
• /
• 2013

In this paper, we present a circularly polarized (CP) composite cavity-backed crossed dipole antenna for global positioning system (GPS) applications. We produce the CP radiation by crossing two dipoles through a $90^{\circ}$ phase delay line of a vacant-quarter printed ring, which also has a broadband impedance matching characteristic. Two techniques, insertion of meander lines in the dipole arm and arrowhead-shaped trace at its end, are employed to reduce the sizes of the primary radiation element. The compact radiator is backed by a cavity reflector to achieve a wide CP radiation beamwidth. The proposed antenna exhibits a measured bandwidth of 1.450~1.656 GHz for a voltage standing wave ratio (VSWR) < 2 and 1.555~1.605 GHz for AR < 3-dB. At 1.575 GHz, the antenna has a gain of 7 dBic, a frontto-back ratio of 27 dB, AR of 1.18 dB, and 3-dB AR beamwidths of $130^{\circ}$ and $132^{\circ}$ in the x-z and y-z planes, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.1
• /
• pp.75-80
• /
• 2003

This paper presents novel compact circularly polarized(CP) operation of a annular ring slot antenna with a 45$^{\circ}$truncated in the patch and a cross-slot of unequal slot lengths. A simple configuration based on a cross-slot of unequal slot lengths on the annular ring patch is adopted to realize a small-size element antenna and used a proximity coupled feed method. Experimental results show that much wider impedance bandwidth of 7.74 % and axial ratio bandwidth of 1.9 % in GPS band(1.5 GHz).