• Journal of IKEEE
• /
• v.10 no.1 s.18
• /
• pp.10-15
• /
• 2006

In this paper, a clock and data recovery (CDR) circuit for a serial link with a half rate 4x oversampling phase and frequency detector structure without a reference clock is described. The phase detector (PD) and frequency detector (FD)are designed by 4X oversampling method. The PD, which uses bang-bang method, finds the phase error by generating four up/down signal and the FD, which uses the rotational method, finds the frequency error by generating up/down signal made by the PD output. And the six signals of the PD and the FD control an amount of current that flows through the charge pump. The VCO composed of four differential buffer stages generates eight differential clocks. Proposed circuit is designed using the 0.18um CMOS technology and operating voltage is 1.8V. With a 4X oversampling PD and FD technique, tracking range of 24% at 3.125Gbps is achieved.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.11 no.7
• /
• pp.665-670
• /
• 2016

In this paper, we suggest the design of OP-AMP using MOSFET in the operation of sub-threshold condition as a basic unit of an IoT. The sub-threshold operation of MOSFET is useful for an ultra low power consumption of sensor network system in the IoT, because it cause the supply voltage to be reduced. From the simulation result using 0.35 um CMOS process, the supply voltage, VDD can be reduced with 0.6 V, open-loop gain of 43 dB and the power consumption was evaluated with about $1.3{\mu}W$ and the active size for an integration was measured with $64{\mu}m{\times}105{\mu}m$. It is expected that the proposed circuit is applied to the low power sensor network for IoT.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.11
• /
• pp.130-137
• /
• 2013

This paper presents analog front-end(AFE) circuits for bio-potential measurement. The proposed AFE is composed of IA(instrument amplifier), BPF(band-pass filter), VGA(variable gain amplifier) and SAR(successive approximation register) type ADC. The low gm(LGM) circuits with current division technique and Miller capacitance with high gain amplifier enable IA to implement on-chip AC-coupling without external passive components. Spilt capacitor array with capacitor division technique and asynchronous control make the 12-b ADC with low power consumption and small die area. The total current consumption of proposed AFE is 6.3uA at 1.8V.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.12
• /
• pp.40-48
• /
• 2013

This paper presents multi-channel transimpedance amplifier(TIA) arrays in short-range LADAR systems for unmanned vehicles, by using a 0.18um CMOS technology. Two $4{\times}4$ channel TIA arrays including a voltage-mode INV-TIA and a current-mode CG-TIA are introduced. First, the INV-TIA consists of a inverter stage with a feedback resistor and a CML output buffer with virtual ground so as to achieve low noise, low power, easy current control for gain and impedance. Second, the CG-TIA utilizes a bias from on-chip bandgap reference and exploits a source-follower for high-frequency peaking, yielding 1.26 times smaller chip area per channel than INV-TIA. Post-layout simulations demonstrate that the INV-TIA achieves 57.5-dB${\Omega}$ transimpedance gain, 340-MHz bandwidth, 3.7-pA/sqrt(Hz) average noise current spectral density, and 2.84mW power dissipation, whereas the CG-TIA obtains 54.5-dB${\Omega}$ transimpedance gain, 360-MHz bandwidth, 9.17-pA/sqrt(Hz) average noise current spectral density, and 4.24mW power dissipation. Yet, the pulse simulations reveal that the CG-TIA array shows better output pulses in the range of 200-500-Mb/s operations.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.41 no.12
• /
• pp.27-34
• /
• 2004

The study on the RF substrate circuit is necessary to model RF output characteristics of deep submicron MOSFETs below 0.2$\mum$ gate length that have bun commercialized by the recent development of Si submicron process. In this paper, direct extraction methods are developed to apply for a simple substrate resistance model as well as another substrate model with connecting resistance and capacitance in parallel. Using these extraction methods, better agreement with measured Y22-parameter up to 30 GHz is achieved for 0.15$\mum$ CMOS device by using the parallel RC substrate model rather than the simple resistance one, demonstrating the RF accuracy of the parallel model and extraction technique. Using this model, bias and gate length dependent curves of substrate parameters in the RF region are obtained by increasing drain voltage of 0 to 1.2V at deep submicron devices with various gate lengths of 0.11 to 0.5㎛ These new extraction data will greatly contribute to developing a scalable RF nonlinear substrate model.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.1
• /
• pp.50-55
• /
• 2008

In this paper, New LC VCO with $8{\sim}10.9$ GHz Band has been designed using commercial $0.35-{\mu}m$ CMOS technology. This proposed circuit is consisted of the parallel construction of the typical NMOS and PMOS cross-coupled pair which is based on the LC tank, MOS cross-coupled pair which has same tail current of complementary NMOS and PMOS, and output buffer. The designed LC VCO, which is according to proposed structure in this paper, takes a 29% improvement of the wide tuning range as 8 GHz to 10.9 GHz, and a 6.48mW of low power dissipation. Its core size is $270{\mu}m{\times}340{\mu}m$ and its phase noise is as -117dBc Hz and -137dBc Hz at 1-MHz and 10-MHz offset, respectively. FOM of the new proposed LC VCO gets -189dBc/Hz at a 1-MHz offset from a 10GHz center frequency. This design is very useful for the 10Gb/s clock generator and data recovery integrated circuit(IC) and SONET communication applications.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.10a
• /
• pp.451-454
• /
• 2015

This paper introduces 3 type of OTAs with $0.35-{\mu}m$ standard CMOS technology for Low-Power, Low-Voltage. The first type is a two-stage OTA designed to operate with a 1-V VDD and it has $1.774{\mu}W$ low power consumption. All transistors are operating in strong inversion. It takes Gm-Enhancement techniques to compensate gm, which is lowered by Bulk-Driven technique and has an Wide swing current mirror for low voltage operation and a Class-A output. The second type is a Two-stage OTA designed to operate with a 0.8-V VDD and It has 52nW low power consumption and 112dB high gain. The current mirror uses Composite Transistor binding Gates of two MOSFET to raise Rout which is similar with cascode structure. The third type is a Two-stage OTA designed to operate with a 0.6-V VDD and It has 160nW low power consumption and 72dB high gain. It takes Level Shift technique by Common Gate structure to amplify signals without additional bias voltage at second stage.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.22 no.1
• /
• pp.91-99
• /
• 2018

This paper has proposed a low-noise and high-linear RF receiver supporting TV white space from 470 MHz to 698 MHz), which is implemented in $0.13-{\mu}m$ CMOS technology. It consists of a low-noise amplifier, a RF band-pass filter, a RF amplifier, a passive down-conversion mixer, and a channel-selection low-pass filter. A low-noise amplifier and RF amplifier provide a high voltage gain to improve the sensitivity level. To suppress strong and nearby interferers, two RF filtering schemes have been performed by using a RF BPF and a down-conversion mixer. The proposed LPF has been based on the common-gate topology and adopted a bi-quad cell to achieve -24dB/oct characteristics. In addition, the RF receiver can support the overall TV band by controlling a LO frequency. The simulated results show a voltage gain of 56 dB, a noise figure of less than 2 dB, and an out-of-channel IIP3 of -2.3 dBm. It consumes 37 mA from a 1.5 V supply voltage.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.42 no.5 s.335
• /
• pp.47-54
• /
• 2005

In this paper, novel test patterns and on-chip data are presented to indicate that the variation of coupling capacitance, ${\Delta}Cc$ by crosstalk can be larger than static coupling capacitance, Cc. It is also shown that ${\Delta}Cc$ is strongly dependent on the phase of aggressive lines. for anti-phase crosstalk ${\Delta}Cc$ is always larger than Cc while for in-phase crosstalk ${\Delta}Cc$ is smaller than Cc. HSPICE simulation shows good agreement with the measurement data.

• Proceedings of the IEEK Conference
• /
• 2005.11a
• /
• pp.797-800
• /
• 2005

In this paper, the designed 10-bit current steering data driving circuit consists of bias circuits, shift registers, data and line latches, level shifters, and 10-bit D/A converters. This data driving circuit can improve image quality, driving speed, and can reduce process error, DNL error, and glitch noise. To reduce current cells, the 10-bit D/A converter was designed 3+3+4 hybrid type. As a result 49 current cells are decreased. The transient analysis shows that currents flows a few of mA in data line and the currents have 1024 gray levels of current values. Total circuits are designed for 10 ${\mu}s$ speed. Thus the designed 10-bit current steering data driving circuit can be usable in HDTV/XGA AMOLED displays. These data driving circuits are designed for 0.35 ${\mu}m$ CMOS process at 3.3 V and 18 V supply voltage and simulated with HSPICE..