• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2008.11a
• /
• pp.3-4
• /
• 2008

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.42 no.6
• /
• pp.106-114
• /
• 2000

In order to evaluate the shear characteristics of undisturbed weathered granite soil which is a typical residual soil in Korea, the mechanical properties are first investigated and discussed by carrying out a series of direct shear test and then dilatancy correction is performed by using Taylor’s correction equation. In this study, specimens are sampled at Pungam(-3, -8, -13m below ground surface), Kwangju and Iksan(-5m below ground surface), Jeonbuk. The test results are summarized as follows: 1) Mohr-Coulomb failure criterion is not linear under the low confining pressure. 2) The value of cohesion is smaller than usually determined value in low pressure region. 3) The value of strength parameter c and ø which are corrected by Taylor’s correction equation is a little bit small.

• Journal of IKEEE
• /
• v.23 no.4
• /
• pp.1257-1264
• /
• 2019

A 3-GSymbol/s/lane transceiver, which supports the mobile industry processor interface (MIPI) C-physical layer (PHY) specification version 1.1, is proposed. It performs channel mismatch correction to improve the signal integrity that is deteriorated by using three-level signals over three channels. The proposed channel mismatch correction is performed by detecting channel mismatches in the receiver and adjusting the delay times of the transmission data in the transmitter according to the detection result. The channel mismatch detection in the receiver is performed by comparing the phases of the received signals with respect to the pre-determined data pattern transmitted from the transmitter. The proposed MIPI C-PHY receiver is designed using a 65 nm complementary metal-oxide-semiconductor (CMOS) process with 1.2 V supply voltage. The area and power consumption of each transceiver lane are 0.136 ㎟ and 17.4 mW/GSymbol/s, respectively. The proposed channel mismatch correction reduces the time jitter of 88.6 ps caused by the channel mismatch to 34.9 ps.

• Proceedings of the Korean Society of Surveying, Geodesy, Photogrammetry, and Cartography Conference
• /
• 2006.04a
• /
• pp.281-286
• /
• 2006

In this study, acquired time series Landsat TM/ETM+ image to extract land surface temperature for wide-area region and executed geometric correction and radiometric correction. And extracted land surface temperature using NASA Model, and I achieved the first correction by perform land coverage category for study region and applies characteristic emission rate. Land surface temperature that acquire by the first correction analyzed correlation with Meteorological Administration's temperature data by regression analysis, and established correction formula. And I wished to improve accuracy of land surface temperature extraction using satellite image by second correcting deviations between two datas using establishing correction formula. As a result, land surface temperature that acquire by 1,2th correction could correct in mean deviation of about ${\pm}3.0^{\circ}C$ with Meteorological Administration data. Also, could acquire land surface temperature about study region by relative high accuracy by applying to other Landsat image for re-verification of study result.

• Korean Journal of Remote Sensing
• /
• v.28 no.4
• /
• pp.393-407
• /
• 2012

This study focuses on the correction of topographic effects caused by a combination of solar elevation and azimuth, and topographic relief in single optical remote sensing imagery, and by a combination of changes in position of the sun and topographic relief in comparative analysis of multi-temporal imageries. For the Jeju Island, Republic of Korea, where Mt. Halla and various cinder cones are located, a Landsat 7 ETM+ imagery and ASTER GDEM data were used to normalize the topographic effects on the imagery, using two topographic normalization methods: cosine correction assuming a Lambertian condition and assuming a non-Lambertian c-correction, with kernel sizes of $3{\times}3$, $5{\times}5$, $7{\times}7$, and $9{\times}9$ pixels. The effects of each correction method and kernel size were then evaluated. The c-correction with a kernel size of $7{\times}7$ produced the best result in the case of a land area with various land-cover types. For a land-cover type of forest extracted from an unsupervised classification result using the ISODATA method, the c-correction with a kernel size of $9{\times}9$ produced the best result, and this topographic normalization for a single land cover type yielded better compensation for topographic effects than in the case of an area with various land-cover types. In applying the relative radiometric normalization to topographically normalized three multi-temporal imageries, more invariant spectral reflectance was obtained for infrared bands and the spectral reflectance patterns were preserved in visible bands, compared with un-normalized imageries. The results show that c-correction considering the remaining reflectance energy from adjacent topography or imperfect atmospheric correction yielded superior normalization results than cosine correction. The normalization results were also improved by increasing the kernel size to compensate for vertical and horizontal errors, and for displacement between satellite imagery and ASTER GDEM.

• Environmental Engineering Research
• /
• v.25 no.3
• /
• pp.439-445
• /
• 2020

In the estimation of the aerosol single fiber efficiency using fibrous filters, there is a size range, where the particles penetrate most effectively through the fibrous collectors, and corresponding minimum single fiber efficiency. For small particles in which the diffusion mechanism is dominant, the Cunningham slip correction factor (C_c) affects the single fiber efficiency and the most penetrating particle size (MPPS). Therefore, for accurate estimation, C_c is essential to be considered. However, many previous studies have neglected this factor because of its complexity and the associated difficulty in deriving the appropriate parameterization particularly for the MPPS. In this study, the expression for the MPPS, and the corresponding expression for the minimum single fiber efficiency are analytically derived, and the effects of C_c are determined. In order to accommodate the slip factor for all particle-size ranges, C_c is simplified and modified. Overall, the obtained analytical expression for the MPPS is in a good agreement with the exact solution.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.9 no.2
• /
• pp.159-172
• /
• 2006

In this study, the series of Landsat TM/ETM+ images was acquired to extract land surface temperature for wide-area and executed geometric correction and radiometric correction. And the land surface temperature was extracted using NASA Model, and achieved the first correction by performing land coverage category for study area and applied characteristic emission rate. Land surface temperature which was acquired by the first correction was analyzed in correlation with Meteorological Administration's temperature data by regression analysis, and established correction formula. And I wished to improve accuracy of land surface temperature extraction using satellite image by second correcting deviations between two data using establishing correction formula. As a result, land surface temperature acquired by 1st and 2st correction could be corrected in mean deviation of about ${\pm}3.0^{\circ}C$ with Meteorological Administration data. Also, I could acquire land surface temperature about study area by higher accuracy by applying to other Landsat images for re-verification of study results.

• Nuclear Engineering and Technology
• /
• v.42 no.6
• /
• pp.670-679
• /
• 2010

In this paper, a new approach using a pixel-based correction method was developed to fix the non-uniform responses of flat-bed type scanners used for radiochromic film dosimetry. In order to validate the method's performance, two cases were tested: the first consisted of simple dose distributions delivered by a single port; the second was a complicated dose distribution composed of multiple beams. In the case of the simple individual dose condition, ten different doses, from 8.3 cGy to 307.1 cGy, were measured, horizontal profiles were analyzed using the pixel-based correcton method and compared with results measured by an ionization chamber and results corrected using the existing correction method. A complicated inverse pyramid dose distribution was made by piling up four different field shapes, which were measured with GAFCHROMIC$^{(R)}$EBT film and compared with the Monte Carlo calculation; as well as the dose distribution corrected using a conventional method. The results showed that a pixel-based correction method reduced dose difference from the reference measurement down to 1% in the flat dose distribution region or 2 mm in a steep dose gradient region compared to the reference data, which were ionization chamber measurement data for simple cases and the MC computed data for the complicated case, with an exception for very low doses of less than about 10 cGy in the simple case. Therefore, the pixel-based scanner correction method is expected to enhance the accuracy of GAFCHROMIC$^{(R)}$EBT film dosimetry, which is a widely used tool for two-dimensional dosimetry.

• Journal of Veterinary Clinics
• /
• v.5 no.2
• /
• pp.95-99
• /
• 1988

An observational study on the recurrences of left abomasal displacement after surgical correction was conducted in 178 Holstein cows. The correction methods were right flank omentopexy (A), right ventral paramedian abomasopexy (B) and left flank abomasopexy (C). Four(5.4) out of 74 cows by method A, 2(2.0) out of 101 cows by method B and 1(33.3%) out of 3 cows by method C had the recurrence of the disease after the first operation. As for the method A, 3 cows and a cow recurred 13-18 months and 27 months after the first operation, respectively. As for the method B, recurrence of the disease in two cows occurred 14 and 19 days after surgery, respectively. In a cow which had been indicated by method C, the recurrence was recurred 14 months after the operation.

• Journal of Advanced Navigation Technology
• /
• v.26 no.2
• /
• pp.119-124
• /
• 2022

The international gnss service (IGS) provides real-time service (RTS) orbit and clock correction applicable to the broadcast ephemeris of GNSS satellites. However, since the RTS correction cannot be received if the Internet connection is lost, the RTS correction should be predicted and used when a signal interruption occurs in order to perform stable precise point positioning (PPP). In this paper, PPP was performed by predicting orbit and clock correction using a long short-term memory (LSTM) algorithm in real-time during the signal loss. The prediction performance was analyzed by implementing the LSTM algorithm in RPI (raspberry pi), the processing speed of which is not high. Compared to the polynomial prediction model, LSTM showed excellent performance in long-term prediction.