• Journal of the Korea Institute of Military Science and Technology
• /
• v.19 no.3
• /
• pp.363-370
• /
• 2016

This paper proposes a Ku-band multi-mode coupler and its monopulse tracking system, which can be applied to a unmaned aircraft vehicle(UAV) platform. In general, the carrier-to-noise(C/N) level of the beacon signal from a Ku-band commercial satellite is relatively weak compared to that of a military satellite because the Ku-band satellite has been designed for commercial services. Therefore, this paper proposes a coupler and its multi-mode monopulse tracking system satisfying the tracking accuracy under a low C/N environment and analyzes the tracking accuracy. After that, we perform a real satellite tracking test and compare the accuracy of the test with the analysis result before validating the performance of the architecture of the proposed satellite tracking system.

• The KIPS Transactions:PartC
• /
• v.8C no.6
• /
• pp.703-710
• /
• 2001

In this paper, we consider a multiple watermarking for image copyright protection. Multiple watermarking can be defined that two or more watermarks are inserted into the same content. Multiple watermarking using spread spectrum technique is able to extract the correct watermarks from the watermarked content when the orthogonality among keys should be guaranteed only. To keep the orthogonal property between keys, we perform the process of Gram-Schmidt on the random sequences. The orthogonalized sequences are used as keys to embed the watermarks. The proposed method can not only extract correctly the embedded watermarks but also show the robustness against various attacks such as Gaussian noise addition, histogram equalization, gamma correlation, sharpening and brightness/contrast adjustment.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.43 no.9 s.351
• /
• pp.17-22
• /
• 2006

CMOS LC VCO with fast response adaptive frequency calibration (AFC) technique for IEEE 802.11a/b/g WLANs is designed in 1.8V $0.18{\mu}m$ CMOS process. The possible operation is verified for 5.8GHz band, 5.2GHz band, and 2.4GHz band using the switchable L-C resonators. To linearize its frequency-voltage gain (Kvco), optimized multiple MOS varactor biasing tecknique is used. In order to operate in each band frequency range with reduced VCO gain, 4-bit digitally controlled switched- capacitor bank is used and a wide-range digital logic quadricorrelator (WDLQ) is implemented for fast frequency detector.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.11
• /
• pp.1082-1089
• /
• 2004

In this paper, miniaturization of an elliptic-response open-loop resonator filter and design flexibility using similarity transformation of the coupling matrix are proposed. Moreover, the filter with wider fractional bandwidth is designed by the proposed method. In order to verify the proposed method, three 4th-order elliptic-response open-loop resonator filters with a relative bandwidth of 4 % at the center frequency of 2.0 GHz are designed. One is realized with constant-width microstrip line resonator and the others are implemented with different-width microstrip line resonator. Compared with the former one, the latter have shown the size reduction of 13 % and 25 %, respectively. Since it may not be possible to implement the resonators with very narrow spacing for the required coupling coefficient filters with two different configurations representing same response characteristic through similarity transformation of the coupling matrix are proposed. From this design flexibility, a filter with a relative bandwidth of 8 % at the center frequency of 2.0 GHz is designed with realizable design parameters.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2018.05a
• /
• pp.59-60
• /
• 2018

In this paper, we studied a design method for a band-pass waveguide filter with a modified H-type resonant iris (RI) placed in a thin transverse wall of a rectangular waveguide. The horizontal straight gap at the center of a conventional H-shaped iris is modified to a U-shaped one to increase the equivalent capacitance, and the equivalent inductance is improved by changing the vertical two straight slots into C-shaped ones. A third-order band pass filter using the proposed modified H-shaped iris was designed and, it was observed that the filter operated in the frequency range of 9.22-9.75 GHz with its insertion loss of 0.5 dB and return loss of 17 dB.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.3C
• /
• pp.248-255
• /
• 2002

An RF module in compliance with the IEEE 802.11a standard has been designed and its performance has been measured. Conventional heterodyne architecture with 580MHz intermediate frequency has been realized. Measurement results show that the receiver has a low Noise Figure of 5dB, the maximum gain of 70dB, and dynamic range as wide as 61dB. Also, the SAW filter used for channel selection in the IF section allowed minimum inter-channel interference. in addition to satisfying the RF output power requirement, the transmitter features its output P1dB as high as 34dBm so that the high peak-to-average ratio of the Orthogonal Frequency Division Multiplexing (OFDM) modulation scheme can be handled with minimum nonlinear distortion. The output P1dB of 34dBm of the transmitter corresponds to back-off powers of 18dB and 11dB with respect to the output power for the low and the middle frequency bands, respectively.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.8C
• /
• pp.803-811
• /
• 2002

Asynchronous Transfer Mode-Passive Optical Network(ATM-PON) Technology is one of the best solutions for implementation of broadband access network. In this paper, we propose a new Dynamic Bandwidth Allocation (DBA) algorithm for ATM-PON systems. The DBA is a key technique for data traffic management. DBA has been studied widely to allow ATM-PON to transport data traffic cost-effectively and efficiently, and currently a hot standardization issue in Full Service Access Network(FSAN) and ITU-T. The proposed DBA algorithm efficiently manages the user traffics according to their service categories. Performance of the proposed algorithm, in aspect of Cell Transfer Delay(CTD) and Cell Delay Variation(CDV), is evaluated using computer simulation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.12C
• /
• pp.1240-1248
• /
• 2006

In this paper, we present a new method for user selection, sub-band allocation, and power allocation in order to maximize the system throughput under the constraint of transmit power in multiuser downlink orthogonal frequency division multiple access (OFDMA) systems with partial channel quality information (CQI). In previous schemes, each user in one cell transmits CQI of all sub-bands to the base station, which requires enormous feedback overhead. Therefore, we proposed an efficient power allocation and modulation and coding selection scheme in which each user transmits partial CQI and one additional information to reduce the amount of feedback. Simulation results show that we can greatly reduce the amount of feedback than full feedback system.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.2 s.93
• /
• pp.154-160
• /
• 2005

Microwave Otters are essential device in modem wireless systems. A compact dimension BPF(Band-pass Filter) for IEEE 802.11a WLAN service is realized using LTCC multi-layer process. To extrude 2-stage band-pass equivalent circuit, band-pass and J-inverter transform applied to Chebyshev low-pass prototype filter. Because parallel L-C resonator is complicate and hard to control the inductor characteristics in high frequency, the shorted $\lambda/4$ stripline is selected for the resonator structure. The passive element is located in the different layers connected by conventional via structure and isolated by inner GND. The dimension of fabricated stacked band-pass filter which is composed of six layers, is $2.51\times2.27\times1.02\;mm^3$. The measured filter characteristics show the insertion loss of -2.25 dB, half-power bandwidth of 220 MHz, attenuation at 5.7 GHz of -32.25 dB and group delay of 0.9 ns at 5.25 GHz.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.2C
• /
• pp.110-120
• /
• 2003

In this paper, we propose a Multiresolution Motion Estimation(MRME) adapted to Low-Band-Shift(LBS) method in wavelet domain. To overcome shift-variant property on wavelet coefficients, the LBS was previously proposed. This method which is applied to reference frame in video coding technique, has superior performance in terms of rate-distortion characteristic. However, this method needs more memory and computational complexity. In this paper, The computational complexity of the proposed method(LBS-MRME) is about 15.6% of that of existing method at 3-level wavelet transform. And although it has about 7 times as much as existing method's motion vector since each subband has different motion vector, it decreases motion compensated prediction error by detailed motion estimation, and then has better efficient coding performance. The experimental results with the proposed method showed about 0.3∼11.6% improvement of MAD performance in case of lossless coding, and 0.3∼3.0㏈ improvement of PSNR performance at the same bit rate in case of lossy coding.