• Proceedings of the SAREK Conference
• /
• 2006.06a
• /
• pp.352-356
• /
• 2006

As a basic study to develop heating panel, the purpose of this study was to know possibility as a floor heating panel. We investigated working conditions and performance of pulsating heat pipe. Tests were conducted under the next conditions; Working fluid were R-22 and R-134a, charging ratio 40% and 50%, temperature of inlet water $60^{\circ}C$ and $70^{\circ}C$, flow rates $1{\sim}3kg/min$. The experimental results indicate that the pulsating heat pipe charged 50% showed better performance than 40%, R-22 is more suited to the working fluid than R-134a, and it has a possibility which can be applied to floor heating panel using a pulsating heat pipe.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2007.08a
• /
• pp.277-280
• /
• 2007

Field emission-back light unit (FE-BLU) was fabricated using carbon nanotube (CNT) emitter. Local dimming and local brightening techniques were achieved, which results in very high contrast ratio. In addition, the motion blur phenomenon, one of the serious problems of liquid crystal display (LCD) with cold cathode fluorescent lamp (CCFL)-BLU, was removed from LCD-TV by using FE-BLU.

• Proceedings of the Korean Society of Marine Engineers Conference
• /
• 2001.11a
• /
• pp.80-87
• /
• 2001

The fatigue crack growth behavior of the SA516/60 steel which is used for pressure vessels was examined experimentally at room temperature $25^{\circ}C, -30^{\circ}C, -60^{\circ}C, -80^{\circ}C, -100^{\circ}C$ and -l2$0^{\circ}C$ with stress ratio of R=0.05, 0.1 and 0.3. Fatigue crack propagation rate da/dN related with stress intensity factor range ΔK was influenced by stress ratio in stable of fatigue crack growth (Region II) with an increase in ΔK. The resistance of fatigue crack growth at low temperature is higher compared with that at room temperature, which is attributed to the extent of plasticity-induced by compressive residual stress according to the cyclic loads. Fractographic examinations reveal that the differences of the fatigue crack growth characteristics between room and low temperatures are mainly explained by the crack closure and the strengthening due to the plasticity induced and roughness induced.

• Journal of Korean Society of Steel Construction
• /
• v.15 no.4 s.65
• /
• pp.379-388
• /
• 2003

The response of single story buildings and other case studies were investigated to observe trends and develop a better understanding of the impact of some design parameters on the seismic response of Concentrically Braced Frames (CBF). While many parameters are known to influence the behavior of braced frames, the focus of this study was mostly on quantifying energy dissipation in compression and its effectiveness on seismic performance. Based on dynamic analyses of single story braced frame and case studies, a bracing member designed with bigger R and larger KL/r was found to result in lower normalized cumulative energy ratio in both cases.

• Journal of the Korean Ceramic Society
• /
• v.22 no.2
• /
• pp.3-10
• /
• 1985

In the study the characteristics change of crystallized $Li_2O$.$Al_2O_3$.$SiO_2$ glass-ceramics when varying RO ratio and increasing Al2O3 were investigated to produce a glass-ceramics with high mechanical strength and low thermal expansion. Parent glass was obtained by melting at 1,350~1,40$0^{\circ}C$ for 3 hours and annealing at 45$0^{\circ}C$ and the various physical characteristics were measured. Results were as follows; 1. When ZnO was replaced by MgO thermal expansion coefficient was lowered when increasing ZnO content. 2. Major crystal phase was $\beta$-spodumene the crystal growth mophology was the three dimensional sphere and the activation energy for crystallization was 54.6 Kcal/mol. 3. Parent glass heat-treated at 95$0^{\circ}C$ for 10 hours had ; a) thermal expansion coeff. of $23.2{\times}10^{-7}$/$^{\circ}C$ b)whiteness of 76 c) microhardness of 1,089kg/$mm^2$

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.5 no.2
• /
• pp.120-126
• /
• 2005

We have proposed a characteristic method to estimate real composition when multi component oxide films are deposited by ALD. Final atomic concentration ratio was theoretically calculated from the film densities and growth rates for $HfO_2$ and $Al_2O_3$ using ALD processed HfxAhOz mms.W e have transformed initial source feeding ratio during deposition to fins] atomic ratio in $Hf_xAl_yO_z$ films through thickness factors ($R_{HFO_2}$ ami $R_{Al_2O_3}$) ami concentration factor(C) defined in our experiments. Initial source feeding ratio could be transformed into the thickness ratio by each thickness factor. Final atomic ratio was calculated from thickness ratio by concentration factor. It has been successfully confirmed that the predicted atomic ratio was in good agreement with the actual measured value by ICP-MS analysis.

• Korean Journal of Clinical Laboratory Science
• /
• v.54 no.2
• /
• pp.95-102
• /
• 2022

The relationship between lipoprotein(a) and dyslipidemia is not clear. This study was therefore undertaken to investigate the relationship between lipoprotein(a) and dyslipidemia in elderly patients over 60 years. From 2014 to 2020, a total of 2,580 adults aged 60 years or older (73.31±7.24 years, 1,954 males) were enrolled in the study. The patients had checked into a general hospital, and data were obtained for lipoprotein(a), LDL-C, TG, HDL-C, hs-CRP, HbA1c, sex, age, BMI, dyslipidemia diagnosis, and use of lipid-lowering agents. BMI and HbA1c showed no correlation with lipoprotein(a), but hs-CRP (r=0.138), LDL-C (r=0.097), HDL-C (r=-0.089), TG (r=-0.073), and age (r=0.072) were significantly correlated to lipoprotein(a). The partial correlation between lipoprotein(a) and LDL-C, which was adjusted for variables, was significant only in the male gender (r=0.158, P<0.001). As the odds ratio of the 4^th quartile of lipoprotein(a) (OR=1.376, 95% CI=1.038~1.822) for dyslipidemia was found to be significant in this study when the level of LDL-C, the primary target, could not be reduced even by taking lipid-lowering drugs, we propose that lipoprotein(a) should also be included among the several factors considered as secondary targets. Our results indicate that studies on various lipid factors considering the sex, age, types and use of lipid-lowering agents, are warranted.

• Applied Chemistry for Engineering
• /
• v.5 no.1
• /
• pp.149-159
• /
• 1994

The kinetics and equilibrium of metal extraction by benzamidoxime and phenylacetamidoxime-chloroform were investigated to apply amidoxime to metal extraction as chelating agent. The overall extraction constant extraction mechanism and selective extraction of copper were examined from the relation among extraction ratio, hydrogen ion concentration and extractant concentration. The experimental rate equation of copper extraction coincided with the theoretical rate equation and was expressed as $R_o=k{\overline{C}}_{HRo}(C_{Mo}/C_{Ho})^{1/2}$. The chemical species extracted was found to the type of ${\overline{CuR_2}}$.

• The Korean Journal of Ecology
• /
• v.5 no.2_3
• /
• pp.123-131
• /
• 1982

The growth and the resistance of Amorpha fructicosa L. under water control was experimented in frames out of doors. The plant grew in a wagner's pot under water control. The soil moisture content was controlled at 5%, 10%, 15% and 20%. The growth of leaf, stem and root in the groups of 5% and 10% soil moisture content were different from values in the groups of 15% and 20%. The T/R ratio in the groups of 5% and 10% soil moisture content were different from the ratio in the groups of 15% and 20% soil moisture content. The T/R ratio of former was lower than the latter, but the C/F ratio of the former was higher than the latter. RGR and NAR of Amorpha fructicosa decreased in 5% and 10% soil moisture content but increased in 15% and 20% soil moisture content during growing period. The maximum values of RGR and NAR were respectively 0.089 and 0.080 at 20% soil moisture content. The highest value of LAR was 1.560 at 5% soil moisture content. RGR and NAR were comparatively affected by soil moisture content.

• Journal of the Korean Chemical Society
• /
• v.56 no.4
• /
• pp.440-447
• /
• 2012

Heteroleptic complexes of zirconium (IV) derived from bulky Schiff base ligands containing a sulphur atom and oximes of heterocyclic ${\beta}$-diketones of the general formula ZrLL' (where $LH_2=RCNH(C_6H_4)SC:C(OH)N(C_6H_5)N:CCH_3$, $R=-C_6H_5$, $-C_6H_4Cl(p)$ and $L^{\prime}H_2=R^{\prime}C:(NOH)C:C(OH)N(C_6H_5)N:CCH_3$, $R^{\prime}=-CH_2CH_3$, $-C_6H_5$, $-C_6H_4Cl(p)$ were prepared by the reactions of zirconium tetrachloride with disodium salts of Schiff bases ($L\;Na_2$) and oximes of heterocyclic ${\beta}$-diketones ($L^{\prime}\;Na_2$) in 1:1:1 molar ratio in dry refluxing THF. The structures of these monomeric zirconium (IV) complexes were elucidated with the help of elemental analysis, molecular weight measurements, spectroscopic (IR, NMR and mass) studies. A distorted trigonal bipyramidal geometry may be suggested for these heteroleptic zirconium (IV) complexes. The ligands (bulky Schiff base ligands containing a sulphur atom and oximes of heterocyclic ${\beta}$-diketones) and their heteroleptic complexes of zirconium (IV) were screened against A. flavus, P. aeruginesa and E. coli.