• Journal of the Korean Institute of Gas
• /
• v.15 no.1
• /
• pp.22-29
• /
• 2011

Pipes buried in around a construction site of urbanized area tend to be affected by the vibration caused by construction loads. The behaviors of buried pipes affected by periodic vibration were analyzed through numerical analyses based on existing study and experimental results. From the results of theses analyses, the serviceability of buried pipes subjected to vibration was verified. This study analyzed the pipe behaviors subjected to dump truck loads with respect to burial depths, and this research was performed as foundation study to establish standards for managing buried pipes. The analyses were performed with burial depth of 0.6, 1.2, 1.8m and vehicle velocity of 10km/h. From theses analyses, the vibration velocity and occurred stress tend to decrease as a burial depth increases.

• Analytical Science and Technology
• /
• v.30 no.6
• /
• pp.338-347
• /
• 2017

The purpose of this study is to investigation of the decomposition characteristics in a pilot-scale burial site of livestock in three kinds of typical soils in Korea: sandy loam soil, clay loam soil, and sandy soil. In this study, we confirmed that most of the animals in the condition were decomposed within three years as mentioned in the "Livestock burial regional environmental research guidelines." We also determined that the decomposition rate of dead cows was higher than that of dead pigs, and that the biodegradation rate depends on the soil types in the following order: sandy soil > clay loam soil > sandy loam soil. The various external environment factors, such as temperature, moisture, pH, earthiness, nutrient, and the burial depth, should be managed properly for appropriate decomposition of dead animals.

• Journal of Satellite, Information and Communications
• /
• v.2 no.2
• /
• pp.75-79
• /
• 2007

Satellite imagery was applied to locating archeological sites and remains around northeastern areas of China, called as Manchuria, and Korean peninsular, such as Mountain Fortress of Goguryeo Dynasty era($37BC{\sim}771AD$), and firing torch and smoke beacon signal sites at mountain tops in Josun Dynasty era($1392{\sim}1910AD$) as well as burial sites below the ground level in the modern era. Information on archeological sites, fire posts and burial places could be found in various literatures, but real figures of such cultural assets have been disappearing due to land development programs and human activities in recent years. Some of these historical sites were identified in satellite images using GPS(Geographical Positioning System). Real locations of these sites would be further necessary to be verified.

• 보존과학연구
• /
• s.23
• /
• pp.59-75
• /
• 2002

In this study human bones and teeth, excavated from the Myeongam-risite in Asan, Chungcheongnam-do Province, have been analysed by nuclear DNA typing and mitochondrial DNA sequencing methods. Twenty-one samples of long bones and twenty-seven samples of teeth from twenty-one individuals were collected and analysed. Among these thirteenteeth were successfully subjected to nuclear DNA extraction, quantification, and PCR(Polymerase Chain Reaction) amplification. Silver STR III (D16S539, D7S820, D13S317) multiplex PCR method was used in this study for a short tandem repeat (STR) analysis. Mitochondrial DNAs of tooth samples were also amplified and sequenced by a DNA sequencer. These analyses show that a sample from Burial no. 29 and one from Burial no. 38(right) possessed the same maternal inheritance. This may suggest that the Myeongam-ri cemetery was used by a kin group for a relatively long period of time.

• Journal of the Korean earth science society
• /
• v.41 no.6
• /
• pp.658-669
• /
• 2020

The horizontal-to-vertical spectral ratio (HVSR) analysis is conducted to estimate the site amplification effect and the thickness of the sedimentary layer beneath the measurement site. We investigated the effects of meteorological variations (wind and precipitation rate) and sensor burial depths on HVSR analysis. The HVSR results were unstable when seismographs were exposed on the ground. The HVSR results of ambient noise data measured under strong winds were also unstable. It is recommended to measure the ambient noise at wind speeds of <3 m s-1. Stable HVSR results were obtained when seismographs were buried, regardless of the precipitation rates. The results of this study provide the best observations and optimal weather conditions required to acquire accurate and reliable HVSR results.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2004.08a
• /
• pp.8-21
• /
• 2004

Examples of GPR survey results at a variety of archaeological sites are presented. Several new analyses which include static corrections for the tilt of the GPR antenna are shown for imaging of burial mounds with significant topography. Example archaeological site plans developed from GPR remote sensing of Roman and Japanese sites are given. The first completely automated GPR survey, using only Global Positioning Satellite navigation to create 3D data volumes, is employed for a site in Louisiana to detect lost graves of the Choctaw Indian Tribe.

• Asian-Australasian Journal of Animal Sciences
• /
• v.30 no.11
• /
• pp.1660-1666
• /
• 2017

Objective: Burial is associated with environmental effects such as the contamination of ground or surface water with biological materials generated during the decomposition process. Therefore, bacterial communities in leachates originating from the decomposing bovine carcasses were investigated. Methods: To understand the process of bovine (Hanwoo) carcass decomposition, we simulated burial using a lab-scale reactor with a volume of $5.15m^3$. Leachate samples from 3 carcasses were collected using a peristaltic pump once a month for a period of 5 months, and bacterial communities in samples were identified by pyrosequencing of the 16S rRNA gene. Results: We obtained a total of 110,442 reads from the triplicate samples of various sampling time points (total of 15 samples), and found that the phylum Firmicutes was dominant at most sampling times. Differences in the bacterial communities at the various time points were observed among the triplicate samples. The bacterial communities sampled at 4 months showed the most different compositions. The genera Pseudomonas and Psychrobacter in the phylum Proteobacteria were dominant in all of the samples obtained after 3 months. Bacillaceae, Clostridium, and Clostridiales were found to be predominant after 4 months in the leachate from one carcass, whereas Planococcaceae was found to be a dominant in samples obtained at the first and second months from the other two carcasses. The results showed that potentially pathogenic microbes such as Clostridium derived from bovine leachate could dominate the soil environment of a burial site. Conclusion: Our results indicated that the composition of bacterial communities in leachates of a decomposing bovine shifted continuously during the experimental period, with significant changes detected after 4 months of burial.

• Journal of the Korean earth science society
• /
• v.36 no.3
• /
• pp.222-235
• /
• 2015

Samples were collected from both places including the coastal area within the height of 5 m above the mean sea level (msl) (DH) and the top of the coastal terrace of 10-15 m msl (KS) high in Gwangseungri, Gochanggun, Korea. To find the origin of the deposit in the coastal area, granulometric analysis and geochemical analysis were performed. The result showed that the DH samples were originated from the reddish soils overlaying weathered bedrock which presented gradual change of chemical composition from the bottom toward the top. Clay minerals were found from the DH samples. These results concluded that the DH samples were found as in-situ weathered materials. The KS samples were originated from the soil layer covering gravel layer at the foot slope of the hill along the coast. The KS samples contained different chemical compositions from the DH. It is inferred that some of this layer was disturbed or experienced the influx of foreign material. The particle size of the KS samples was different from those found on the beach. The particle size of lower parts of KS site was finer than that on the beach, but the particle size of middle part of the site was coarser than that on the beach. The sorting of the KS site was poorer than that on the beach. Thus, it is inferred that some parts of the layer were formed by short-lived high energy event rather than sustained and continuous action of tidal currents and/or waves. Analysis using an optically stimulated luminescence (OSL) method showed that the burial age of samples from KS site were found 0.65-0.71 ka. Though the characteristics of the sediment layer and forming event in this area should be further studied, it can be inferred that this sedimentary layer formed by coastal flooding with storm.

• Korean Journal of Heritage: History & Science
• /
• v.53 no.1
• /
• pp.24-33
• /
• 2020

In excavated bronze artifacts, corrosion products of various shapes and colors are observed due to multiple corrosion factors coexisting in the burial environment, and these corrosion products can constitute important data not only in terms of long-term corrosion-related information, but also in connection with preservation of artifacts. As such, scientific analysis is being carried out on the corrosion layer and corrosion products of bronze artifacts, and the corrosion mechanism and the characteristics of corrosion products elucidated, which is essential for interpreting the exposed burial environment and its association with corrosion factors inside the burial environment. In this study, after classifying excavated bronze artifacts according to alloy ratio and fabrication technique, comprehensive analysis of the surface of corrosion artifacts, corrosion layer, and corrosion products was carried out to investigate the corrosion mechanism, formation process of the corrosion layer, and characteristics of corrosion products. The study designated two groups according to alloy ratio and fabrication technique. In Group 1, which involved a Cu-Sn-Pb alloy and had no heat treatment, the surface was rough and external corrosion layers were formed on a part, or both sides, of the inside and the outside, and the surface was observed as being green or blue. α+δ phase selection corrosion was found in the metal and some were found to be concentrated in an empty space with a purity of 95 percent or more after α+δ phase corrosion. The Cu-Sn alloy and heat-treated Group 2 formed a smooth surface with no external corrosion layer, and a dark yellow surface was observed. In addition, no external corrosion layer was observed, unlike Group 1, and α corrosion was found inside the metal. In conclusion, it can be seen that the bronze artifacts excavated from the same site differ in various aspects, including the formation of the corrosion layer, the shape and color of the corrosion products, and the metal ion migration path, depending on the alloy ratio and fabrication technique. They also exhibited different corrosion characteristics in the same material, which means that different forms of corrosion can occur depending on the exposure environment in the burial setting. Therefore, even bronze artifacts excavated from the same site will have different corrosion characteristics depending on alloy ratio, fabrication technique, and exposure environment. The study shows one aspect of corrosion characteristics in specific areas and objects; further study of corrosion mechanisms in accordance with burial conditions will be required through analysis of the corrosive layer and corrosive product characteristics of bronze artifacts from various regions.

• Journal of Radiation Protection and Research
• /
• v.41 no.2
• /
• pp.173-178
• /
• 2016

Background: In situ gamma spectrometry has been used to measure environmental radiation, assumptions are usually made about the depth distribution of the radionuclides of interest in the soil. The main limitation of in situ gamma spectrometry lies in determining the depth distribution of radionuclides. The objective of this study is to develop a method for subsurface characterization by in situ measurement. Materials and Methods: The peak to valley method based on the ratio of counting rate between the photoelectric peak and Compton region was applied to identify the depth distribution. The peak to valley method could be applied to establish the relation between the spectrally derived coefficients (Q) with relaxation mass per unit area (${\beta}$) for various depth distribution in soil. The in situ measurement results were verified by MCNP simulation and calculated correlation equation. In order to compare the depth distributions and contamination levels in decommissioning KRR site, in situ measurement and sampling results were compared. Results and Discussion: The in situ measurement results and MCNP simulation results show a good correlation for laboratory measurement. The simulation relationship between Q and source burial for the source layers have exponential relationship for a variety depth distributions. We applied the peak to valley method to contaminated decommissioning KRR site to determine a depth distribution and initial activity without sampling. The observed results has a good correlation, relative error between in situ measurement with sampling result is around 7% for depth distribution and 4% for initial activity. Conclusion: In this study, the vertical activity distribution and initial activity of $^{137}Cs$ could be identifying directly through in situ measurement. Therefore, the peak to valley method demonstrated good potential for assessment of the residual radioactivity for site remediation in decommissioning and contaminated site.