• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.4
• /
• pp.75-87
• /
• 2010

For two input-protection schemes suitable for RF ICs utilizing the thyristor and diode protection devices, which can be fabricated in standard CMOS processes, we attempt an in-depth comparison on HBM ESD robustness in terms of lattice heating inside protection devices and peak voltages developed across gate oxides in input buffers, based on DC, mixed-mode transient, and AC analyses utilizing a 2-dimensional device simulator. For this purpose, we construct an equivalent circuit for an input HBM test environment of a CMOS chip equipped with the input ESD protection circuits, which allows mixed-mode transient simulations for various HBM test modes. By executing mixed-mode simulations including up to six active protection devices in a circuit, we attempt a detailed analysis on the problems, which can occur in real tests. In the procedure, we suggest to a recipe to ease the bipolar trigger in the protection devices and figure out that oxide failure in internal circuits is determined by the junction breakdown voltage of the NMOS structure residing in the protection devices. We explain the characteristic differences of two protection schemes as an input ESD protection circuit for RF ICs, and suggest valuable guidelines relating design of the protection devices and circuits.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.46 no.2
• /
• pp.72-77
• /
• 2009

In this paper, a 3.2Gb/s clock and data recovery (CDR) circuit for a high-speed serial data communication without the reference clock is described This CDR circuit consists of 5 parts as Phase and frequency detector(PD and FD), multi-phase Voltage Controlled-Oscillator(VCO), Charge-pumps (CP) and external Loop-Filter(KF). It is adapted the PD and FD, which incorporates a half-rate bang-bang type oversampling PD and a half-rate FD that can improve pull-in range. The VCO consists of four fully differential delay cells with rail-to-rail current bias scheme that can increase the tuning range and tuning linearity. Each delay cell has output buffers as a full-swing generator and a duty-cycle mismatch compensation. This materialized CDR can achieve wide pull-in range without an extra reference clock and it can be also reduced chip area and power consumption effectively because there is no additional Phase Locked- Loop(PLL) for generating reference clock. The CDR circuit was designed for fabrication using 0.18um 1P6M CMOS process and total chip area excepted LF is $1{\times}1mm^2$. The pk-pk jitter of recovered clock is 26ps at 3.2Gb/s input data rate and total power consumes 63mW from 1.8V supply voltage according to simulation results. According to test result, the pk-pk jitter of recovered clock is 55ps at the same input data-rate and the reliable range of input data-rate is about from 2.4Gb/s to 3.4Gb/s.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.12
• /
• pp.73-82
• /
• 2008

There are several approaches for reducing the ROB(Reorder Buffer) complexity in processors. The one technique that makes the simplest ROB ports relies on a distributed implementation that spreads the centralized ROB structure across the functional units(FUs). Each distributed buffers are decided on the size of them by workload of the functional units. The performance of the processor depends on the size of distributed ROB. However, most of previous works have depended on the simulation results to decide the optimsize of distributed ROB. In this Paper, we use an analytical model based on the M/M/1 Queuing theory to determine the optimum size of each distributed ROB. Our schemes are evaluated by using the simulation performed by the CPU2000 benchmarks. We are able to choose the optimum size of distributed ROB showing the 99.2% performance compared with existing superscalar processors. We can save 82% hardware resources in ports and reduce more than 30% of delay when ROB and distributed ROB proposed in this paper are designed by HDL.

• Journal of the Korean GEO-environmental Society
• /
• v.15 no.9
• /
• pp.69-75
• /
• 2014

Rock fall protection system installed against rock slope is one of the most conventional way to protect nearby infra structures. Despite of wide application of typical rectangular nets, virtually installed to protect rock slope face, several problems have also been pointed out up to date. Rectangular draped nets are vulnerable to a sudden external shock such as rock fall, because it doesn't have any systematical buffers or shock absorbers. Furthermore, it has been widely recognized from the some cases of rock fall accident in Korea that rock fall protection nets cause wide range of failure in the rock slope faces due to insufficient pullout bearing capacity of fixing parts. Therefore, in this study, we tried to make a consideration about the problems of existing standard rock fall protection nets in Korea, and develop a new type of hexagonal net with a shock absorber based on design rock fall energy. In this paper, laboratory and full scale test procedure is described to analysis the performance of newly developed hexagonal rock fall net, and the key results are presented and discussed.

• The KIPS Transactions:PartC
• /
• v.9C no.4
• /
• pp.605-614
• /
• 2002

Amount of the web traffic web server handles are explosively increasing, which requires that the performance of the web server should be improved for the various web services. Although the analysis for the HTTP traffic with the proper tuning for the web server is essential, the research relevant to the subject are insignificant. In particular, although most of applications are implemented over HTTP 1.1 protocol, the researches mostly deal with the performance evaluation of the HTTP 1.0 protocol. Consequently, the modeling approach and the performance evaluation over HTTP 1.1 protocol have not been well formed. Therefore, basing on the HTTP 1.1 protocol supporting persistent connection, we present an analytical end-to-end tandem queueing model for web server to consider the specific hardware configuration inside web server beginning at accepting the user request until completing the service. we compare various performances between HTTP 1.0 and HTTP 1.1 under the overloading condition, and then analyze the characteristics of the HTTP traffic that include file size requested to web server, the OFF time between file transfers, the frequency of requests, and the temporal locality of requests. Presented model is verified through the comparing the server throughput according to varying requests rate with the real web server. Thereafter, we analyze the performance evaluation of the web server, according to the interrelation between TCP Listen queue size, the number of HTTP threads and the size of the network buffers.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.10
• /
• pp.4666-4672
• /
• 2011

Performance of NOx removal in SCR(Selective Catalytic Reduction) process depends on such various factors as catalyst factors (catalyst composition, catalyst form, space velocity, etc.), temperature of exhaust gas, and velocity distribution of exhaust gas. Especially the flow uniformity of gas stream flowing into the catalyst layer is believed to be the most important factor to influence the performance. In this research, the flow characteristics of a SCR process at design stage was simulated, using 3-dimensional numerical analysis method, to confirm the uniformity of the gas stream. In addition, the effects of guide vanes, baffles, and perforated plates on the flow uniformity for the inside and catalyst layer of the reactor were studied in order to optimize the flow uniformity inside the SCR reactor. It was found that the installation of a guide vane at the inlet duct L-tube part and the installation of a baffle at the upper part is very effective in avoiding chaneling inside the reactor. It was also found that additional installation of a perforated plate at the lower part of the potential catalyst layer buffers once more the flow for very uniform distribution of the gas stream.

• Journal of KIISE:Information Networking
• /
• v.29 no.6
• /
• pp.696-705
• /
• 2002

This paper presents a new copy network for multicast ATM switches. Many studies have been carried out up to date since the proposition of Lee's copy network. However, the overflows and cell conflicts within the switch have still been raised a problem in argument. In order to reduce those problems, we proposed a 3-dimensional multicast switching architecture which has shared buffers in this paper. The proposed architecture can reduce the overflows and cell conflicts through multiple paths and output ports even in the high load environments. Also, we proposed a cell splitting algorithm which handles the cell in the case of large fan-out, and a copy network to increase throughput by expanding the Lee's Broadcast Banyan Network(BBN). Cell copy uses the Boolean interval splitting algorithm and the multicast pattern of the cells according to the self-routing characteristics of the network. In the proposed copy network, we improve the problems such as overflow, cell splitting of large fanout, cell conflicts, etc., which were still existed in the Lee's network. The results of performance evaluation by computer simulation show that the proposed scheme has better throughput, cell loss rate and cell delay than the conventional method.

• Journal of KIISE:Information Networking
• /
• v.29 no.3
• /
• pp.299-313
• /
• 2002

Recently, the demand for mobile communications and multimedia services has rapidly increased so that conventional cellular system cannot fulfill the requirement of users (capacity and QoS) any more. Therefore, the hierarchical cellular system has been suggested in order to guarantee the QoS and to admit large population of users. IMT-2000 adopts the hierarchical cellular structure, which requires a call control algorithm capable of manipulating and utilizing the complicated structure of hierarchical cellular structure with handiness and efficiency. In this thesis, as an improvement of conventional combined algorithm, a new call control algorithm considering the moving speed of terminal and bandwidth is suggested. This algorithm employs buffers and guard channels to reduce the failure rate. Also, this algorithm considers the moving speed of terminal and bandwidth to elevate the efficiency. Furthermore, calls are handled separately according to the moving speeds of terminal and bandwidths to improve the QoS and reduce the handover rate. As an evaluation of the suggested algorithm, a model hierarchical cellular system is constructed and simulations are conducted with various types of traffic. As the result of the simulations, such indices as block rate, drop rate, channel utilization, and the number of inter layer handovers are examined to demonstrate the excellency fo the suggested algorithm.

• Journal of Broadcast Engineering
• /
• v.15 no.2
• /
• pp.205-216
• /
• 2010

In this paper, a method of MPEG-2 Transport Stream (TS) multiplexing for Ultra HDTV (UHDTV) and its design and implementation as a SW tool is described. In practice, UHD video may be divided into several HD videos and each video is encoded in parallel. Therefore, it is necessary to synchronize and multiplex multiple bitstreams encoding each HD video for transmitting and storing UHD video. In this paper, it is assumed that 4 HD videos partitioning a UHD spatially are encoded as H.264/AVC and two 5.0 channel audios are encoded by AC-3. Therefore, 4 H.264/AVC elementary streams (ESs) and 2 AC-3 ESs is mainly considered in the TS multiplexing of UHD. For the carriage of H.264/AVC and AC-3 over MPEG-2 TS, PES packetization and TS multiplexing are designed and implemented based on the extended specification of the MPEG-2 Systems and ATSC (Digital audio compressed standard), respectively. The implemented UHD TS multiplexing tool emulates real time HW operation in the time unit corresponding to the duration of one TS packet transmission in a given TS rate. In particular, in order to satisfy the timing model, the buffers defined in the TS System Target Decoder (T-STD) are monitored and their statuses are considered in the scheduling of TS multiplexing. For UHD multiplexing, two kinds of multiplexing structures, which are UHD re-multiplexing and UHD program multiplexing, are implemented and their strength and weakness are investigated. The developed UHD TS multiplexing tool is tested and verified in terms of the syntax and semantics conformance and functionalities by using a commercial analyzer and real-time presentation tools.

• Journal of Embryo Transfer
• /
• v.27 no.1
• /
• pp.29-35
• /
• 2012

The purpose of this study was to examine the effect of growing stages of the Korean Native Striped Bull (KNSB) on the freezability and fertility of frozen-thawed semen. First, we investigated the total motility (TM) and progressive motility (PM) according to the diluent used for semen freezing. Second, we examined the effect of the age of KNSB on semen volume, TM and PM of fresh and frozen-thawed semen. Third, we examined the effect of frozen semen from the different age of KNSB on the $in-vitro$ fertilization rate, and the artificial insemination pregnancy rate. The diluents used in this experiment were Triladyl$^{(R)}$ and Tris-egg yolk extender (EYE). Semen was collected from 5 KNSB in the growing stage (15 months) and 5 adult KNSB (36 months). When Triladyl or Tris-EYE extender was used for semen freezing, there was no difference of the mean TM and the mean PM. However, the mean TM was significantly higher in Bull No. 1885 than Bull No. 4283 ($p$ <0.05). The mean volume of semen collected from the 15-month-old bulls (2.3 ml) was significantly lower ($p$ <0.05) than that from the 36-month-old bulls (5.0 ml). The mean semen concentration was similar for the 15-month-old ($2.1{\times}10^9$ spermatozoa/ml) and 36-month-old ($1.8{\times}10^9$ spermatozoa/ml) bulls. For the 15-month-old and 36-month-old bulls, the mean TM of fresh semen were 93.7% and 88.3%, respectively, and the mean PM were 97.0% and 88.3%, respectively; the 15-month-old bulls showed a particularly high PM ($p$ <0.05). For the 15-month-old and 36-month-old bulls, the mean TM (56.0% and 58.0%, respectively) and the mean PM (64.0% and 70.7%, respectively) of frozen-thawed semen did not differ. The development rates of embryos after $in-vitro$ fertilization and the pregnancy rate after artificial insemination using frozen-thawed semen did not differ according to the bull's age. In summary, semen volume differed according to the bull's age, but semen concentration and survival rate, the $in-vitro$ fertilization rate, and the pregnancy rate did not differ according to the stripe bull's age. Accordingly, semen from bulls in the growing stage can be collected and frozen for the preservation and multiplication of rare livestock.