• 한국식품영양과학회지
• /
• 제28권5호
• /
• pp.963-968
• /
• 1999

This study was tried to evaluate possibilities for discriminating the mixture degree of wheat flour from buckwheat products. Buckwheat was milled into four grades of powder, i.e. whole grain flour (WGF), inner layer flour(ILF), middle layer flour(MLF) and outer layer flour(OLF)), and these powders were mixed with wheat flour(WF) to make mixed samples. Ash, protein and fat contents of the buckwheat flours were high in the order of OLF=WGF>MLF>ILF. On the other hand, WF showed a similar content to OLF in ash and protein, and to ILF in fats. Potassium and magnesium contents were higher in all the buckwheat powder than in the wheat flour. Flavonoid contents were higher in order of OLF>WGF=MLF> ILF, but it was not in wheat flour. Although the reliable correlation between mix ratio and components, i.e. mag nesium or ash analyzed were found, it did not seem to reflect sufficiently the expected variations of contents of original material components. Also, compositions of commercial buckwheat products were analyzed to evaluate the mixed ratio of buckwheat flour and wheat flour. The results suggest that the components analyzed in this study as putative marker were not good in determining whether or how much buckwheat products contained wheat flour.

• 한국지역사회생활과학회지
• /
• 제20권4호
• /
• pp.493-502
• /
• 2009

The purpose of this study was to investigate the properties of baguettes containing buckwheat flour. Physical properties of the bread flour mixed with buckwheat flour were tested by rapid visco analyzer(RVA), farinogram, and alveogram. Water activity of baguettes were measured and their properties were tested by rheometer. As the amount of buckwheat flour increased the peak viscosity and the holding strength were decreased, but the set back value was increased. Therefore, buckwheat flour prevented the gelatinization process. As the amount of buckwheat flour increased, the consistency and water absorption were increased, but development and stability were lower than the control. The bread flour containing high amount of buckwheat flour resulted in less breakdown and low farinogram quality number. As the amount of buckwheat flour was increased, Pmax, L, G, and W values were decreased on alveogram. The water activity and the springness of all samples were decreased during the storage, but the hardness was increased, especially after two days of storage. The sensory properties of baguette containing 10% buckwheat flour had the best scores.

• 한국식품영양학회지
• /
• 제20권4호
• /
• pp.414-420
• /
• 2007

The purpose of this study was to investigate the properties of yellow layer cake with added buckwheat flour. The physical properties of the cake flour with added buckwheat flour were tested by RVA, farinogram, and alveogram, and then, after making the yellow layer cake, the samples were analyzed by rheometer. We found that the pasting temperature decreased with the addition of buckwheat flour in the cake flour, but peak viscosity, holding strength, and final viscosity increased. For the farinogram, the flour containing buckwheat showed increases for consistency and water absorption, but stability was decreased. The $P_{max}$ of the alveogram was not consistent according to the addition of buckwheat flour to the cake flour. The L- and G-values showed decreases, but they were not significant. After making the yellow layer cakes with added buckwheat flour, crumb softness was analyzed with storage for 7 days. The hardness and Max. G of the yellow layer cakes with buckwheat flour increased, and the highest values were after 1 day of storage. However, springness decreased with the addition of buckwheat flour as compared to the control, and showed the highest value at 7 days.

• 한국식생활문화학회지
• /
• 제20권6호
• /
• pp.715-720
• /
• 2005

Jeolpyon rice cake was made using buckwheat flour and measured its texture, color and sensory properties as follows. According to the amylograph guage test, rice flour was the highest in its initial pasting temperature $82.5^{\circ}C$. With 5% addition of buckwheat flour, it came to be $81.0^{\circ}C$ and became $79.5^{\circ}C$ at 10%, and $78.0^{\circ}C$ at 15%, which was lower than the control. And its maximum temperature at peak viscosity showed at $87^{\circ}C$ and it showed no difference in temperature according to the amount of buckwheat flour. The maximum value (peak point) was 690 BU in control and it increased following to the added amount of buckwheat flour, 710 BU in adding buckwheat flour 10% and 740 BU in 15% of buckwheat flour. In relating to the changes of texture, it became hard by the added amount of buckwheat flour because of decreasing cohesiveness and springiness, but increasing gumminess and brittleness. The hardness increased by adding with buckwheat flour through the freeze preserving period. But adding buckwheat flour of 10% decreased the hardness. Regarding the color value, lightness decreased by the adding buckwheat flour, but a and b value increased. As a result of the sensory analysis about Jeolpyon prepared with buckwheat flour, the most favoured ratio of buckwheat flour for color and preference was at 10%. In case of 15%, it was a little dark so it was not desirable. Based on the above test, the best combination ratio of buckwheat for Jeolpyon was 10%. And Jeolpyon can be easily made at home as well as mass production due to relatively simple making procedure.

• Preventive Nutrition and Food Science
• /
• 제15권4호
• /
• pp.329-334
• /
• 2010

Buckwheat flour was incorporated into steamed breads by adding the flour in the range of 0~9% based on the Baker's percentages and the physicochemical properties and consumer acceptance were investigated. After mixing, kneading, proofing, and molding, bread dough was steamed for 15 min using a steam tray and boiling water. The samples were cooled to room temperature for 15 min and packed in airtight bags for further analyses. pH of the steamed bread decreased slightly while titratable acidity increased significantly from 1.02 to 1.37 mL with the incorporation of more buckwheat flour in the formulation (p<0.05). Water activity was not affected by the buckwheat flour level (p>0.05). Moisture content slightly decreased from 43.72 to 42.30% while soluble solids content increased from 0.63 to 0.85 as the buckwheat flour concentration increased. As a result of the addition of buckwheat flour, the specific volume decreased from 3.31 to 2.57 mL/g; on the other hand, the spread ratio ranged from 2.17 to 2.21 without significant differences among them (p>0.05). At the higher level of buckwheat content, lower scores of all color parameters ($L^*$, $a^*$, and $b^*$-values) were observed. Firmness increased significantly with an increase in buckwheat flour content (p<0.05). Consumer acceptance tests indicated that incorporation of up to 3% buckwheat flour in the formulation of steamed breads did not significantly influence the consumers' acceptability in all attributes tested, except for color and elasticity.

• 동아시아식생활학회지
• /
• 제21권1호
• /
• pp.53-59
• /
• 2011

The purpose of this study was to investigate the properties of frozen cookies containing buckwheat flour. Buckwheat flour was added to cake flour bases at concentrations of 3%, 6%, and 9%. Falling numbers, RVA (rapid visco analyzer) increased with the addition of buckwheat flour, whereas initial pasting temperature decreased. The set back value, which is a prediction of retrogradation, did not show any significant difference. The alveographic P values of the treatment were lower than that of the Control. In the farinogram test, water absorption increased upon the addition of buckwheat flour, whereas stability and farinogram quality number decreased. In conclusion, the addition of 6% buckwheat flour is recommended to obtain the optimal volume of frozen cookies.

• 한국식품영양과학회지
• /
• 제29권2호
• /
• pp.241-247
• /
• 2000

The possibility of buckwheat-wheat flour mixture as bread was studied by adding 10, 20, and 30% of buckwheat to wheat flour. To improve bread-making quality of the mixture, gluten, ascorbic acid, and hydroxy propyl methyl cellulose (HPMC) were added to 30% buckwheat-wheat flour and sensory evaluation was also exercised on it. The weight of bread increased but the volume of that decreased as the percentage of buckwheat to wheat flour increased, and improved bread-making quality by adding gluten, ascorbic acid, HPMC to 30% buckwheat-wheat composite flour. When it comes to color, color of the bread got darker as the percentage of buckwheat increased, got brighter when gluten and HPMC were added and showed little difference when ascorbic acid was added. Texture of bread increased in maximum weight, strength, hardness but decreased in springiness and cohesiveness. The use of additives showed influence to the some results. In terms of the aging process, enthalpy increased with storage time, and it could be slowed down by the use of the additives. The sensory evaluation shwoed that 10% buckwheat-wheat bread was most excellent, 20% bread was similar to other bread made from wheat flour, and the bread made by mixing additives were better than just 30% buckwheat-wheat flour in terms of quality.

• 동아시아식생활학회지
• /
• 제20권6호
• /
• pp.969-974
• /
• 2010

The purpose of this study was to investigate the quality characteristics of frozen cookies made with 3%, 6%, 9% buckwheat flour. The higher amount of buckwheat flour added to the frozen cookies, the greater the decrease in water activity, hardness, Max. G and brittleness compared to control. Lightness, redness, and yellowness of the cookies with buckwheat flour were slightly lower than those of control. Brown color and buckwheat odor of the cookies with buckwheat flour were higher, whereas egg odor and butter flavor were lower than those of control. Overall acceptance of the frozen cookies with 3% buckwheat flour was high.

• 한국식품영양과학회지
• /
• 제28권2호
• /
• pp.383-389
• /
• 1999

To determine the optimum condition for buckwheat noodle making, we prepared noodle from com posite flours of buckwheat, wheat and corn starch, and those physical properties and sensory evalua tion were investigated. The weights of cooked noodle became lower with increasing buckwheat content level indicating that elution of its components to soup was high. Wheat flour in the composite flours probably caused to drop gelatinization temperature and maximum viscosity compared to buck wheat flours. Corn starch in the composite flours increase gelatinization temperature and maximum viscosity compared to buckwheat flours. From the result of farinogram, buckwheat flour lower water absorption ability, and increased dough development time compared to composite flours. Adhesiveness of the cooked noodle with wheat flour was decreased. Cohesiveness of the cooked noodle was decrea sed with increasing buckwheat flour level. In sensory evaluation, chewing and softness of noodle with 100% buckwheat flour was evaluated the best. In taste, BW1 and BSW1 noodles showed slightly higher preference although there was no significant differences.

• 한국식품조리과학회지
• /
• 제27권1호
• /
• pp.11-19
• /
• 2011

In this study, the physicochemical properties of buckwheat flour and quality characteristics of brown-rice doughs containing various concentrations of buckwheat flour stored at $-18^{\circ}C$ for 4 weeks and fermented were studied. The total polyphenolic contents, electron donating ability (EDA) of 0.5%, gelatinization onset temperature (To), gelatinization peak temperature (Tp), and gelatinization conclusion temperature (Tc) of buckwheat flour were 1,920.10mg%, 6.95%, $70.11^{\circ}C$, $78.21^{\circ}C$, and $84.05^{\circ}C$, respectively. There were no significant differences in the amount of yeast between brown-rice Jeung-pyun dough samples containing different levels of buckwheat flour and stored for different time periods. The amounts of carbon dioxide gas evolved from the brown-rice doughs were increased by increasing the concentration of buckwheat flour. The pH of brown-rice dough samples decreased with increasing storage period. Therefore, frozen brown-rice dough containing 6-15% buckwheat flour and stored for 3 weeks were the most desirable.