• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.4
• /
• pp.401-412
• /
• 2003

In this paper, a broadband phase shifter structure using a new switched network was proposed. A new reference network is composed of coupled lines and 45$^{\circ}$open and short stubs, which are shunted at the edge points of a main line, respectively, A delay network is composed of only a standard transmission line. It is possible to design a broadband 180$^{\circ}$phase shifter that phase dispersive characteristics by an impedance ratio R of coupled lines and greater phase dispersive characteristics by characteristic impedances Zm, Zs of a main line and stubs are used together. By considering a structure symmetry, the even and odd mode analysis was performed to obtain theoretical S-parameters of the proposed phase shifter. Also, through computer simulation on the basis of derived equations, design graphs were presented to optimally design a 180$^{\circ}$broadband phase shifter. Design graphs provide the values of characteristic impedances Zm, Zs, and I/O match and phase bandwidths. To verify electrical performances of the broadband phase shifter proposed in this paper, low different 180$^{\circ}$phase shifters, operated at the center frequency 3 GHz were designed and fabricated using design graphs, and were experimented. One of them was designed as a standard Schiffman structure to compare with electrical performances. Measured results of each phase shifter to satisfy simultaneously design conditions of I/O match （VSWR=1.15:1) and maximum phase deviation $({\varepsilon}_{{\Delta}{\phi}}＝{\pm}2^{\circ})$ were well in agreement with corresponding simulation results over impedance match and phase error bandwidths, and showed broadband characteristics.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.7
• /
• pp.657-666
• /
• 2002

In this paper, a new broadband phase shifter to adjust the slope of dispersive phase characteristic for frequency of transmission network was proposed. The new fundamental network consists of a fixed main line with a length of λ/2 at the center frequency and two double stubs, each with a length of λ/8 at the center frequency, which are open and shorted, respectively, and which are shunted at the edge points of the main line. Characteristic impedances of the main line and two parallel double stubs are adjusted to produce a minimum phase error and to obtain an input and output match at the desired phase shift. Especially, the proposed structure is especially suitable for a broadband phase shifter with large phase shifts more than 90$^{\circ}$, and it is operated in the octave bandwidth. To verify the usefulness of a new broadband phase shifter, each 45$^{\circ}$-, 90$^{\circ}$-, 180$^{\circ}$-bit phase shifter and 3-bit phase shifter(45$^{\circ}$-phase step), which is cascaded in series, operated at the center frequency 3 GHz were designed, fabricated and experimented. The measured results were in very close agreement with the corresponding simulation results over the bandwidth of I/O impedance match and phase error for each phase shift.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.66 no.2
• /
• pp.379-382
• /
• 2017

This paper proposes a $4{\times}4$ broadband phased array antenna using a Left-Handed Transmission Line (LHTL) based phase shifter. The phased array is constructed with sixteen quasi-Yagi antenna elements and the phase shifters, as well as four power dividers. A key component of the system, the LHTL based phase shifter is able to control a phase delay of incident waves linearly and continuously. The fabricated phased array antenna operate for a frequency range of 800 MHz (1.6 GHz~2.4 GHz). The beam scanning range of the $4{\times}4$ array antenna is ${\pm}27^{\circ}$ horizontally and vertically while the antenna gain is maintained with a variation of ${\pm}1.4dBi$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.2
• /
• pp.123-129
• /
• 2002

5-bit broadband MMIC phase shifter has been designed and fabricated. For the broadband performance, 11.25$^{\circ}$, 22.5$^{\circ}$, 45$^{\circ}$ and 90$^{\circ}$ bit have been designed with Lange coupler and 180$^{\circ}$ bit has been implemented by using shorted coupled line with Lange coupler and $\pi$-network of transmission line. Due to Lange coupler with large size, the Lange couplers have been folded far circuit size reduction. Low loss PIN diode has been utilized as a switch for each bit. Fabricated 5-bit broadband phase shifter shows the measured results that RMS phase error of 5 major phases is 3.5$^{\circ}$, maximum insertion loss is 12.5 dB, and maximum input and output return loss are 7 dB and 10 dB, respectively. The size of fabricated phase shifter is 6.5$\times$5.3 $ extrm{mm}^2$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.5
• /
• pp.541-546
• /
• 2008

A novel, simple and broadband $90^{\circ}$ phase shifter was proposed and fabricated by the LTCC process. It is composed of a $180^{\circ}$ transmission line between two $90^{\circ}$ shorted transmission lines. Design equations for the proposed $90^{\circ}$ phase shifter are derived by the method of admittance parameter analysis. Based on design equations, $90^{\circ}$ phase shifter was designed and fabricated to operate in the C-band with ${\pm}2^{\circ}$ of phase deviation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.6B
• /
• pp.1142-1148
• /
• 1999

In this paper, the characteristics of frequency dependent dispersion are analyzed for the phase shifters in Ku-band phased array antenna system using full-wave method, SDA(Spectral Domain Approach).The design technique of asymmetric coupled-line phase shifter with dielectric overlay is proposed. The compared results of phase responses are shown with conventional symmetric coupled-line Schiffman phase shifter. The experimental results verify the improvement of broadband characteristics by the increasing bandwidths and the decreasing phase deviations.

• Journal of the Microelectronics and Packaging Society
• /
• v.12 no.2 s.35
• /
• pp.175-179
• /
• 2005

A novel, simple and broadband $180^{\circ}$ bit X-band phase shifter was proposed and fabricated in a standard micromachining process. It is composed of two $90^{\circ}$ parallel-coupled lines; one of which is shorted and the other is grounded. Design equations for the proposed $180^{\circ}$ bit phase shifter are derived by the method of even and odd mode analysis. Based on design equations, $180^{\circ}$ bit phase shifter was designed and fabricated to operate from 7 to 13 GHz with ${\pm}5^{\circ}$ of phase deviation.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.7
• /
• pp.721-727
• /
• 2014

In this paper, an broadband Schiffman phase shifter is proposed using vertically installed coupled lines. It consists of the typical coupled lines and a extra coupled lines which is installed vertically on the original coupled lines plane. Phase responses of Schiffman phase shifter with vetically installed coupled lines are analyzed in consideration of the phase velocity of two independent transmission modes and the characteristic impedances. The $90^{\circ}$ Schiffman phase shifters with high impedance ratio is realized at 2.4 GHz, which cannot be implemented with the conventional coupled lines. The measured results show that the bandwidth is 1.5~3.2 GHz(70.8 %) within the phase errors ${\pm}5^{\circ}$. The measured return loss is found to be better than 12.4 dB and insertion loss is less than 1.2 dB over the operating frequency band.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.63 no.3
• /
• pp.371-375
• /
• 2014

In this paper, we compared the performances of the Right Handed Transmission Line (RHTL) and the Left Handed Transmission Line (LHTL) phase shifters as a frequency translator. Unlike other phase shifters, both phase shifters show a $0^{\circ}-360^{\circ}$ phase variation for a broadband frequency and compact in size which are ideal to use as a frequency translator. For the performance comparison, we fabricated both a RHTL and a LHTL phase shifter to cover 1.5 GHz - 2.4 GHz range with the whole $360^{\circ}$ phase variation. For the frequency range, a LHTL based frequency translator showed a much better performance whose Spurious Free Dynamic Range (SFDR) is 4dB - 17dB higher than the RHTL based frequency translator when the sawtooth modulation freqncy is 11 kHz. This is due to the linear phase-voltage variation of LHTL phase shifter. Furthermore, the LHTL phase shifter shows a less insertion loss and a insertion loss variation than the RHTL phase shifter. Overall, the LHTL based frequency translator outperformed RHTL based freqency translator.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.10
• /
• pp.1145-1150
• /
• 2012

In this paper, an improved Schiffman phase shifter is proposed using slot-coupled lines. It consists of the typical coupled lines and a simple rectangular slot which is placed in the ground plane underneath the coupled lines. Phase responses of the slot-coupled Schiffman phase shifter are analyzed in consideration of the phase velocity of two independent transmission modes and the characteristic impedance of slot-coupled line. The $905^{\circ}$ Schiffman phase shifters with high impedance ratio is realized at 2.4 GHz, which cannot be implemented with the conventional coupled lines. The measured results show that the bandwidth is around 74.2 % within the phase errors ${\pm}5^{\circ}$. The measured return loss is found to be better than 15.0 dB and insertion loss is less than 1.5 dB over the operating frequency band.