• Bulletin of the Korean Chemical Society
• /
• v.31 no.5
• /
• pp.1309-1313
• /
• 2010

The effects of boronic acid on the fluoride-selective chemosignaling behavior of a merocyanine dye were investigated. In the presence of phenylboronic acid (PBA), N-methylquinolinium-based merocyanine dye displayed fluoride-selective chromogenic signaling behavior over other commonly coexisting anions in the micromolar concentration range. Signaling is produced by a fluoride-induced displacement of the dye from its complex with PBA, resulting in a significant chromogenic signal for the fluoride ion. This signaling was successfully analyzed using a ratiometric analysis of the UV-vis absorption in response to changes in fluoride ion concentration. A PBA substituted with an electron withdrawing group was found to exhibit a more pronounced signal. Polymer-bound PBA also exhibited useful fluoride-selective signaling behavior.

• Journal of Korean Society of Water and Wastewater
• /
• v.14 no.2
• /
• pp.164-173
• /
• 2000

Fluoridation of drinking water to a level of about 0.8mg/l (below 1.5mg/l) for reducing the incidence of tooth decay is recommended. However, concerns about potential problems of unknown effects and overdosing hinders the fluoridation. This study describes the work performed to obtain information on the behavior of fluoride under various conditions in the process of water fluoridation. Effects of water treatment chemicals, water treatment unit, and water distribution on water fluoridation were investigated at both lab and an actual water treatment plant. Residual fluoride concentration was not affected by lime and chlorine dosage up to 20mg/l. Flocculation with PAC slightly decreased the residual fluoride concentration as PAC dosage increased. Average fluoride concentration of 0.87mg/l at an intake basin was decreased to 0.83mg/l by sedimentation, 0.81mg/l by dual media(sand+anthracite) filtration, and 0.79mg/l by granular activated carbon filtration in the water treatment plant.

• Journal of Korean society of Dental Hygiene
• /
• v.13 no.6
• /
• pp.1057-1062
• /
• 2013

Objectives : The purpose of this study was to investigate the possible differences in elementary schools jointed to fluoride mouth rinse plans in health centers. Methods : Students from the third to sixth grades filled out the questionnaires. Data were analyzed by the statistical package SPSS 12.0. Results : The rate of a personal toothbrush holding and toothbrushing after lunch were higher in those who rinsed their mouths with fluoride than those who did not.(p<0.05). Toothbrushing by the rolling method was more prevailing in the students who rinsed their mouths with fluoride(57.0%) and having regular dental checkup(p<0.05) than in those who did not(39.8%). Conclusions : The students who had rinsed their mouths with fluoride showed the good oral health behavior. Continuing good quality of oral health care education must be provided to the students by professional dental hygienists.

• Journal of Korean Society on Water Environment
• /
• v.23 no.2
• /
• pp.222-227
• /
• 2007

The adsorption features of fluoride ion on the oyster shell have been investigated for the purpose of the employment of waste oyster shell as an adsorbent for the treatment of fluoride ion-containing wastewater. The major component of oyster shell was examined to be Ca with minor components of Na, Si, Mg, Al, and Fe. As the initial concentration of fluoride ion was raised, its absorbed amount was enhanced at equilibrium, however, the adsorption ratio of fluoride ion compared with its initial concentration was shown to be decreased. Also, adsorption of fluoride ion onto the oyster shell resulted in the formation of $CaF_2$ in the morphological structure of adsorbent. Kinetic analysis showed that the adsorption reaction of fluoride ion generally followed a second order reaction with decreasing rate constant with the initial concentration of adsorbate. Freundlich model agreed well with the adsorption behavior of fluoride ion at equilibrium and the adsorption reaction of fluoride ion was examined to be endothermic. Several thermodynamic parameters for the adsorption reaction were calculated based on thermodynamic equations and the activation energy for the adsorption of fluoride ion onto oyster shell was estimated to be ca. 13.589 kJ/mole.

• Proceeding of EDISON Challenge
• /
• 2013.04a
• /
• pp.77-88
• /
• 2013

The computational study on the fluoride ion binding with bis(bora)calix[4]arene has been performed using density functional theory and ONIOM model. The computed structure and fluorescent behavior of bis(bora)calix[4]arene was corresponded to experiment value. The binding energy for fluoride anion is computed to be 28.05kJ/mol in the chloroform solution. We also predicted that this sensing mechanism is only valid for fluoride ion in halogens. By analyzing molecular orbitals, binding with fluoride ion reduces energy differences between HOMO and LUMO, which leads to fluorescent sensing.

• Proceedings of the Korean Powder Metallurgy Institute Conference
• /
• 2006.09a
• /
• pp.276-277
• /
• 2006

In order to accelerate the sintering of Al-Bronze powder covered with passive oxide film, we focused on the way to add Al-Ca fluoride consisting of $AlF_3$ and $CaF_2$, examined the effect of the $CaF_2$ mixing rate in Al-Ca fluoride, the amount of the added Al-Ca fluoride and the sintering temperature on sintering properties of Al-Bronze powder and considered the mechanism of the sintering acceleration. Al-Bronze powder was sintered most effectively by adding Al-Ca fluoride with the $CaF_2$ mixing rate of 20mass%. If the amount of added fluoride was over 0.05mass% and the sintering temperature was over 1123K, the sintering acceleration of the Al-Bronze powder appears. Regarding the mechanism of the sintering acceleration, it was presumed that $Al_2O_3$ film on the surface of the Al-Bronze particles was removed in the process of the formation of gaseous AlOF by the reaction with $AlF_3$, and the reaction was accelerated further by the presence of the liquid phase which is formed in Al-Ca fluoride.

• Proceedings of the Korean Fiber Society Conference
• /
• 2001.10a
• /
• pp.432-435
• /
• 2001

Polymer/clay nanocomposites have received much attention in recent years, because they often exhibit physical properties that are dramatically different from those observed in their micro- and rnacrocornposite counterparts. The presence of clay may affect the crystallization behavior of semicrystalline polymer. (omitted)

• Journal of the Korean Ceramic Society
• /
• v.26 no.5
• /
• pp.601-608
• /
• 1989

Electrical properties of ZrF4-based heavy metla fluoride glasses were measured by the ac complex impedance method. The effects of alkali and chloride ions addition into fluoro zirconate glasses on the electrical conductivity were examined. The electrical conductivities of fluoride glasses show Arrhenian behavior in the temperature range of the experiment and were decreased by the addition of sodium fluoride up to 15mol%. Mixed alkali substitution resulted in conductivity minimum at intermediate composition which is commonly observed as mixed alkali effect' in alkali oxide glasses. Chloride ion substituted for fluoride ion was found to lower the conductivity.

• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• v.28 no.1
• /
• pp.16-23
• /
• 2002

To understand the micro-mechanical changes and the effects of the fluoride on rat's femur after administration of sodium fluoride, the three-point bending test, acoustic emission analysis during the three-point bending test and scanning electron microscopy were performed. The obtained results were as follows: 1. Bone strength increased in the rats given 1, 5, 10 and 20 ppm of fluoride but, there were no statistical significances (p>0.05). 2. With increasing the concentration of fluoride, most AE events released rapidly just before the maximum load and smaller events were recorded than the control group's. The average of cumulative AE event counts until maximum load of the femur in 20 ppm group were significantly small with respect to the control group's (p<0.05). 3. Fracture surfaces were well coincide with the results of acoustic emission behavior. Analyses of fracture surfaces indicated that, consistent with its the highest load, rat femur in 20 ppm fluoride group displays the roughest surface.

• Journal of Industrial and Engineering Chemistry
• /
• v.67
• /
• pp.478-485
• /
• 2018

The effect of reduced graphene oxide (RGO) addition on the dielectric and piezoelectric behavior of the polyvinylidene fluoride (PVDF) films was studied. Dielectric constant increased by four times and piezoelectric coefficient also increased twice by the addition of RGO in the PVDF films. Based on capacitance-voltage and ellipsometry measurements and the Kramers-Kronig transformation, it is concluded that the enhanced dielectric and piezoelectric properties of the PVDF/RGO films resulted from the increased orientational polarization due to a phase transition from nonpolar crystalline ${\alpha}$ phase to polar crystalline ${\beta}$ phase in the PVDF structure.