• Economic and Environmental Geology
• /
• v.36 no.3
• /
• pp.233-242
• /
• 2003

The southeasternmost coastal area of the Korean peninsula has been regarded as a seismologically stable area as neither Quaternary faults nor earthquake activity has been reported. To clarify whether the active tectonic movement has occurred or not, a digital marine terrace mapping and fracture mapping have been done in the coastal area. Bed rocks are composed of the Cretaceous volcanic and sedimentary rocks and the Paleogene granite. Wave-cut platform in the area is smaller and narrower relative to that of the northern coastal area. Most of the platforms in the area have little Quaternary sediment. The platforms except the Holocene terrace (1 st terrace) can be divided into three steps. The lowest platform (2nd terrace) has an altitude of 8-11 m. The broad middle one (3rd terrace) is 17 to 22 m high. The highest terrace (4th terrace) is a narrow and sporadic bench with an altitude of about 44 m high. The lowest terrace is correlated to the 2nd terrace of the northern area, which corresponds to the oxygen isotopic stage 5a. The uplift rate calculated from a graphic method is 0.19 m/ky. This low uplift is typical of an intra-plate, suggesting that the area is tectonically stable. The elevation of the platforms tends slightly lower from the north to the south in the survey area. The decreasing altitude of the platforms towards the south is interpreted to result from a local block tilting during the Latest Pleistocene. This also indicates that the eastern coast of the Korean peninsula has been suffering a subsidence to the south.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.33 no.3
• /
• pp.965-974
• /
• 2013

Multiple debris flows occurred on July 27, 2012 in Mt. Umyeon, which resulted in 16 casualties and severe property demage. Accurate reproducing of the propagation and deposition of debris flow is essential for mitigating these disasters. Through applying FLO-2D model to these debris flows and comparing the results with field observations, we seek to evaluate the performance of the model and to analyse the rheological model parameters. Representative yield stress and dynamic viscosity back-calculated for the debris flows in the northern side of Mt. Umyeon are 1022 Pa and 652 $Pa{\cdot}s$, respectively. Numerical results obtained using these parameters reveal that deposition areas of debris flows in Raemian and Shindong-A regions are well reproduced in 63-85% agreement with the field observations. However, the propagation velocities of the flows are significantly underestimated, which is attributable to the inherent limitations of the model that can't take the entrainment of bed material and surface water into account. The debris flow deposition computed in Hyeongchon region where the entrainment is not significant appears to be in very good agreement with the field observation. The sensitivity study of the numerical results on model parameters shows that both sediment volume concentration and roughness coefficient significantly affect the flow thickness and velocity, which underscores the importance of careful selection of these model parameters in FLO-2D modeling.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.31 no.4B
• /
• pp.361-367
• /
• 2011

The channel-forming discharge, which is a standard and single flow for the river maintenance and restoration project, should be estimated necessarily in the stable channel design. It is difficult to produce the specific pattern for the channel-forming discharge in the domestic rivers due to the insufficient researches and case studies. Also, it is improper to adopt the foreign cases for the domestic rivers and streams which have the high coefficients of river regime. Therefore, the channel-forming discharge possible to use for rivers with high coefficients of river regime is suggested in this study through analyzing the bankfull, specified recurrence interval, and effective discharges of Mangyeong River, Cheongmi Stream, and Hampyeong Stream for the abandoned channel restoration project. The bankfull discharge was calculated with geometric data using the HEC-RAS modeling and the flow, bed materials, and sediment data for the study reaches were used to estimate the specified recurrence interval and effective discharges. As a result for calculating the channel-forming discharge, the effective discharge was greater than the bankfull discharge in the river with high coefficient of river regime and the effective discharge was greater than the bankfull and there was no correlation between the coefficient of river regime and the characteristics of the specified recurrence interval discharges.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.8 no.1
• /
• pp.35-43
• /
• 2003

Recent geomorphological changes and late Quaternary depositional sequences of Gwangyang Bay are studied based on bathymetric maps, surface sediments, and seismic profiles. As a result of the reclamation of coastal area for an industrial complex construction, the coastline of Gwangyang Bay has rapidly been changed and the area of it has now been reduced by about 25 ％ in the last 30 years. In addition, the bottom topography is actively modified by dredging for navigation channels. In surfical sediment distribution, the western part of Gwangyang Bay is dominated by mud facies, whereas the eastern part of the Bay is dominated by sand-mud mixing facies. Depositional sequences above the basement are divided into two units: Unit I in upper layer and Unit II in lower one. These depositional units are unconformably bounded by middle reflector-M. Unit II, mostly occupying the channel areas, is interpreted as fluvial-origin deposits during sea-level lowstand. Unit I typically shows a progradational pattern from the Seomjin River mouth to the Yeosu Strait, which is interpreted as deltaic deposits supplied from the Seomjin River during the Holocene sea-level highstand. The shallow gas within the sediments Is widely distributed in most area, and locally exposed onto the sea-bed due to dredging.

• Journal of Korea Water Resources Association
• /
• v.41 no.2
• /
• pp.197-212
• /
• 2008

Recently, stream flow analysis has been accomplished by one or two dimensional equations and was applied by simple momentum equations and fixed energy conservations which contain many condition limits. In this study, FLOW-3D using CFD (Computational Fluid Dynamics) was applied to stream flow analysis which can solve three dimensional RANS (Reynolds Averaged Navier-Stokes Equation) control equation to find out physical behaviors and the effect of hydraulic structures. Numerical simulation accomplished those results was compared by using turbulence models such as ${\kappa}-{\varepsilon}$, RNG (Renormalized Group) ${\kappa}-{\varepsilon}$ and LES (Large Eddy Simulation). Numerical analysis results have been illustrated by the turbulence energy effects, velocity of flow, water level pressure and eddy flows around the piers and transverse overflow type structures. These results will be able to used by basis data that catch hold of effects on long-term bed elevation changes, sediment accumulations, scours and water aggravations by removal of obsolete transverse over flow type structures in urban stream.

• Journal of the Korean Geotechnical Society
• /
• v.32 no.10
• /
• pp.17-29
• /
• 2016

A debris flow analysis model has been developed to simulate the erosion and entrainment of soil layer. Special attention is given to the model which represents strength softening behaviour of soil layer due to velocity of deformation. The 3D FE analysis by Coupled Eulerian-Lagrangian (CEL) model is conducted to simulate the debris flow. The model is validated using published data on laboratory experiment (Mangeny et al., 2010). It has been definitely shown that proposed model is in good agreement with the results of laboratory data. Futhermore, the FE analysis is conducted to ensure capability of simulating the real scale debris flow. The result of Ramian watershed, Korea shows that the debris flow has increased the volume and speed and it is in good agreement with field investigation. Based on this, it is confirmed that proposed model shows good agreement of the behavior of the actual and analytical debris flow.

• Journal of Korean Society on Water Environment
• /
• v.31 no.5
• /
• pp.523-532
• /
• 2015

Hydrocyclone is widely used in industry, for its simple design, high capacity, low maintenance and low operational cost. The objective of this study is to develop hydrocyclone coagulation and filtration system. The system is made of hydrocyclone ballasted coagulation with polyaluminium chloride silicate (PACS) and upflow filter to treat micro particles in urban storm runoff. Roadside sediment particles (< $200{\mu}m$) was mixed with tap water to make various turbid suspensions to simulate urban storm runoff. The filter cartridge was filled with polyethylene media system and ran 1hr per everyday and total operation time were 8.19hrs and backwashing everyday after end of operation. The operation condition of flowrate was $8.2{\sim}11.9m^3/day$ (mean $10.1m^3/day$) and surface overflow rate (SOR) based on filter surface area was $45.5{\sim}65.9m^3/m^2/day$ (mean $55.7m^3/m^2/day$). The range of PACS dosage concentration was 14.0~31.5 mg/L. As the results of operation, the range of removal efficiency of turbidity, SS were 81.0~95.8% (mean 89.5%) 81.8~99.0% (mean 91.4%), respectively. An increase of filtration basin retention time brought on increased of removal efficiency of turbidity and SS, and increase of SOR brought on decreased of removal efficiency. During the first flush in urban area, storm runoff have an high concentration of SS (200~600 mg/L) and the filtration bed becomes clogged and decreased of removal efficiency. Backwashing begins when the drainage pipe valve at the filtration tank bottom is completely open (backwashing stage 1). Backwashing stage 2 was using air bubbles and water jet washing the media for 5 mins and open the drainage valve. After backwashing stage 1, 2, 61.83~64.04%, 18.53~27.51% of SS loading was discharged from filtration tank, respectively. Discharged SS loading from effluent was 7.12~14.79% and the range of residual SS loading in fliter was 2.26~5.00%. The backwashing effects for turbidity, SS were 89.5%, 91.4%, respectively. The hydrocyclone coagulation and filtration with backwashing system, which came out to solve the problems of the costly exchange filter media, and low efficiency of removing micro particles of filter type nonpoint treatment devices, is considered as an alternative system.

• Water for future
• /
• v.14 no.4
• /
• pp.73-81
• /
• 1981

More than 650 numbers of water well ranging in depth from 100M to 200M were installed in South Korean Penninsula during the last decade for the purpose of industrial use and municipal water supply. Those data were compiled and synthesized by writer to determine their hydrogeologic occurences in accordance with their geologic and areal characteristics. Rocks yielding the deep seated ground water beared in the geologic primary and secondary porosities are classified into 6 groups according to their geologic, hydrogeologic, and topographic characteristics, that are: volcanic, sedimentary, meta-sediment and/or schist, andesitic, gneissic, and granitic rocks. The order of ground water productivity of the groups is as written above. Even granitic rocks including porphyries, granite, and intermediate and basic plutonic rocks is considered to be the most poorest ground water yielding group among 6, it's average yield form a single well with average drilling depth of 116M is about 225 cubic meters per day if it's drilling site is properly located. Generally speaking, seizable geologic structures such as fractured, sheared, and faulted zone at the flat surface and valley center yield almost 310% more of deep seated bet rock ground water in comparision with minor structures of joints, bedding planes, and so on that are occured at high land. 50 numbers of water well drilled at crystalline rocks were specially checked and measured it's ground water yie 1ds at each drilled depth to determine each interval's productivity while hammer drilling was going on. The results indicate that the specific capacity and yield of each water well at a depth below 70M to 80M was almost neglegible. It means that optimum well depth of crystalline rocks, except the area having seizable geologic structures, shall be not deeper than 80M.

• Ecology and Resilient Infrastructure
• /
• v.6 no.1
• /
• pp.23-33
• /
• 2019

Naeseong Stream is a sand-bed river that flows through the northern area of Gyeongbuk province. It is characterized by dynamic sandy bedforms developed in response to the seasonal hydrological fluctuation and by its unique riverine landscape called "white river." However, changes including construction of Yeongju Dam from 2010 and the extensive vegetation establishment around 2015 occurred along the Naeseong Stream. This paper aims to analyze climate, hydrology, and water quality as factors and to examine the possibility of channel changes accordingly. The second least precipitation during the last 60 years happened in 2015, which led to the lowest peak discharge in 50 years. The sediment characteristics of Naeseong Stream were not significantly different along the upstream and downstream reaches, but it was confirmed that annual minimum water level of the stream decreased continuously regardless of the dam construction. This suggests that intermittent drought and change in water quality are likely to provide favorable conditions for riparian vegetation establishment and the resulting physical changes have affected riverbed degradation. Therefore, it is necessary to conduct diversified monitoring in connection with river vegetation change in order to analyze the causes of river changes.

• Journal of Korean Society of Disaster and Security
• /
• v.12 no.1
• /
• pp.57-66
• /
• 2019

One of the most serious problems with concrete small dams or barriers installed in small/median rivers is the deposit of sediments, especially, in Korea. An effective way to discharge such sediments to downstream is to construct a bypass pipe under the river bed. However, efficiency may become lowered if ripraps are entered into the bypass pipe. Therefore, in this study, we derived the threshold condition for the exclusion of ripraps from the bypass pipe using 3D numerical analysis. Upstream flow of the small dam was assumed to be stationary, and the energy concept was applied to the control volume containing the bypass pipe and its periphery. As a result, when the ratio of the water level difference between upstream and downstream to the diameter of the riprap was approximately equal to 1.2, the threshold condition for exclusion of the stones or riprap from the bypass pipe was affirmatively determined. If the characteristics of the adsorptive sediment adversely affecting the river environment in the future would be taken into account, results from this study are expected to put to practical use in the management of concrete small dam with bypass pipe system.