• 한국통신학회논문지
• /
• 제28권4B호
• /
• pp.270-281
• /
• 2003

E-PON 은 광대역 액세스 망에서 급증하는 인터넷 데이터 트래픽을 지원하고 대역폭의 동적 할당 기능을 효과적으로 지원한다. 본 논문에서는 E-PON에서 QoS를 고려한 트래픽과 최선형(Best-Effort) 트래픽의 두 가지 형식을 가진 트래픽이 유입될 때 QoS 서비스에 제약된 지연 시간과 지연 변이를 보장하고 최선형 서비스에는 대역폭을 최대학 보장해 주는 Dual-GPS 스케쥴러를 제안한다. 제안된 기법은 Ethernet 수동형 광 네트워크에서 상향 데이터 전송 시 새로운 슬롯할당 기법을 통하여 QoS 가 요구되는 전송 플로우에 대해 제약된 지연시간과 지연 변이를 제어하는 특성을 보인다. 시뮬레이션 결과 제안하는 기법이 기존의 대역할당 기법보다 지연 및 지연 변이 제어능력이 우수하다.

• IEIE Transactions on Smart Processing and Computing
• /
• 제4권3호
• /
• pp.141-144
• /
• 2015

A broadband radio frequency synthesizer for multi-band, multi-standard mobile DTV tuners is proposed, it's loop bandwidth can be calibrated to optimize integrated phase noise performance without the problem of phase noise peaking. For this purpose, we proposed a new third-order scalable loop filter and a scalable charge pump circuit to minimize the variation in phase margin during calibration. The prototype phase-lock loop is fabricated in 180nm complementary metal-oxide semiconductor shows that it effectively prevents phase noise peaking from growing while the loop bandwidth increases by up to three times.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제13권4호
• /
• pp.263-271
• /
• 2013

A low dropout regulator (LDO) with fast transient responses is presented. The proposed LDO eliminates the trade-off between slew rate and unity gain bandwidth, which are the key parameters for fast transient responses. In the proposed buffer, by changing the slew current path, the slew rate and unity gain bandwidth can be controlled independently. Implemented in $0.18-{\mu}m$ high voltage CMOS, the proposed LDO shows up to 200 mA load current with 0.2 V dropout voltage for $1{\mu}F$ output capacitance. The measured maximum transient output voltage variation, minimum quiescent current at no load condition, and maximum unity gain frequency are 24 mV, $7.5{\mu}A$, and higher than 1 MHz, respectively.

• 대한전자공학회논문지
• /
• 제25권8호
• /
• pp.867-873
• /
• 1988

The degradation due to channel distortion in a quadrature modulation system from the ideal constant values over the bandwidth of a direct sequence spread spectrum signal are considered. Through using series expansion for the channel gain and phase response, the degradation in the correlator output at the receiver is found as a function of the parameters involved , including phase error, delay error, linear gin variation, quadratic gain variation, and quadratic phase variation.

• 한국멀티미디어학회논문지
• /
• 제8권12호
• /
• pp.1623-1630
• /
• 2005

Adaptive modulation and coding (AMC), which has a number of variation levels in accordance with the fading channel variation, is a promising technique for communication systems. In this paper, we present an AMC method using the cluster in OFDM system for bandwidth efficiency and performance improvement. The AMC schemes applied into each cluster or some clusters are determined by the minimum or the average SNR value among all the sub carriers within the corresponding cluster. It is important to find the optimal information on cluster because AMC performance can be varied according to the number and position of cluster. It is shown by computer simulation that the AMC method outperforms the fixed modulation in terms of bandwidth efficiency and its performance can be determined by the position and number of clusters.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제9권10호
• /
• pp.4015-4033
• /
• 2015

The future mobile networks consist of hyper-dense heterogeneous and small cell networks of same or different radio access technologies (RAT). Integrating mobile networks of different RATs to provide seamless and smooth mobility service will be the target of future mobile converged network. Generally, handover from high-speed networks to low-speed networks faces many challenges from application perspective, such as abrupt bandwidth variation, packet loss, round trip time variation, connection disruption, and transmission blackout. Existing inter-RAT handover solutions cannot solve all the problems at the same time. Based on the high-layer convergence sublayer design, a new receiver-aided soft inter-RAT handover is proposed. This soft handover scheme takes advantage of multihoming ability of multi-mode mobile station (MS) to smooth handover procedure. In addition, handover procedure is seamless and applicable to frequent handover scenarios. The simulation results conducted in UMTS-WiMAX converged network scenario show that: in case of TCP traffics for handover from WiMAX to UMTS, not only handover latency and packet loss are eliminated completely, but also abrupt bandwidth/wireless RTT variation is smoothed. These delightful features make this soft handover scheme be a reasonable candidate of mobility management for future mobile converged networks.

• 반도체디스플레이기술학회지
• /
• 제22권3호
• /
• pp.8-13
• /
• 2023

High bandwidth memory a core technology of the future memory semiconductor industry, is attracting attention. Temporary bonding and debonding process technology, which plays an important role in high bandwidth memory process technology, is also being studied. In this process, total thickness variation is a major factor determining wafer performance. In this study, the reliability of the equipment measuring total thickness variation is identified, and the servo motor settling, and wafer total thickness variation measurement accuracy are analyzed. As for the experimental variables, vacuum, acceleration time, and speed are changed to find the most efficient value by comparing the stabilization time. The smaller the vacuum and the larger the radius, the longer the settling time. If the radius is small, high-speed rotation performance is good, and if the radius is large, low-speed rotation performance is good. In the future, we plan to conduct an experiment to measure the entire of the wafer.

• 한국광학회지
• /
• 제2권2호
• /
• pp.67-73
• /
• 1991

단일 종모드로 동작하며, 10mW의 출력을 가지는 AlGaAs 반도체 레이저를 이용하여 Fabry-Perot 공진기형 레이저 증폭기 시스템을 구성하고 비포화 신호이득(unsaturated signal gain), 신호이득 대역폭(signal gain bandwidth), 포화출력(saturation power)을 측정하였다. 증폭기 레이저의 펌핑전류에 따른 비포화 신호 이득은 발진 문턱 전류 근처에서 $0.7\mu\textrmW$의 레이저 출력을 증폭기 레이저에 입사시켰을 때 최대 25dB을 얻었으며 이때 신호이득의 대역폭이 3 GHz 정도임을 확인하였다. 또한 입력 세기(input power)에 따른 비포화 신호이득의 변화를 측정하고 이때의 포화출력을 측정하였다.

• 한국전자파학회논문지
• /
• 제17권6호
• /
• pp.556-561
• /
• 2006

본 논문에서는 기존의 주파수 reconfigurable 안테나의 협대역 특성을 개선하기 위한 대역폭 확장 특성을 가지는 주파수 reconfigurable 슬롯 안테나가 제안되었다. 제안된 안테나는 주파수 reconfigurable 특성을 가지는 동시에 대역폭을 확장시키기 위하여 넓은 슬롯 및 좁은 슬롯 두 부분으로 구성되어 있다. 삼각형 구조의 넓은 슬롯은 제안된 안테나의 대역폭을 증가시키는 역할을 하며, 좁은 슬롯은 PIN diode를 장착하는 역할을 한다. 제안된 안테나는 PM diode의 동작 상태를 바꿈에 따라 슬롯의 총 길이를 변화시키며, 이로 인해 중심 주파수 조절과 임피던스 정합의 변화를 최소화시킨다.

• Journal of Power Electronics
• /
• 제11권2호
• /
• pp.156-162
• /
• 2011

The control loop time delay caused by sampling, the zero-order-holder effect and calculations is inevitable in the digital control of dc-dc switching converters. The time delay will limit the bandwidth of the control loop and therefore degrade the transient performance of digital systems. In this paper, the quantization time delay effects with different time delay values based on a generic second-order system are analyzed. The conclusion that the bandwidth of digital control is reduced by about 20% with a one cycle delay and by 50% with two cycles of delay in comparison with no time delay is obtained. To compensate the time delay and to increase the control loop bandwidth, a duty ratio predictive control scheme based on linear extrapolation is proposed. The compensation effect and a comparison of the load variation transient response characteristics with analogy control, conventional digital control and duty ratio predictive control with different time delay values are performed on a point-of-load Buck converter by simulations and experiments. It is shown that, using the proposed technique, the control loop bandwidth can be increased by 50% for a one cycle delay and 48.2% for two cycles of delay when compared to conventional digital control. Simulations and experimental results prove the validity of the conclusion of the quantization effects of the time delay and the proposed control scheme.