• Proceedings of the Korean Ceranic Society Conference
• /
• 2004.10a
• /
• pp.99.1-99.1
• /
• 2004

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2000.11a
• /
• pp.78-78
• /
• 2000

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.11a
• /
• pp.12-12
• /
• 2009

We weal know that PbO was poisonous and prone to volatilize, then to pollute the circumstance and hurt to people, so we should dope other innocuous additives instead of lead to increase Tc of composite PTC material. In order to prepare lead-free $BaTiO_3$-based PTC with middle Curie point, the incorporation on $(BaNaK)(TiNb)O_3$ into $BaTiO_3$-based ceramics was investigated on samples containing 0.05, 0.07 and 0.1mol% of $(BaNaK)(TiNb)O_3$. $(BaNaK)(TiNb)O_3$ was compounded as standby material by conventional solid-state reaction technique. The starting materials were $Na_2O_3$,$K_2CO_3$, $BaCO_3$, $TiO_2$ and $Nb_2O_5$ powder, and using solid-state reaction method, too. The microstructure of samples were investigated by SEM, DSC, XRD and dielectric properties. Phase composition and lattice parameters were investigated by X-ray diffraction. Also, we are measure the resistivity of sintered bodies with calcinations condition.

• Electrical & Electronic Materials
• /
• v.10 no.1
• /
• pp.20-25
• /
• 1997

In this study, piezoelectric actuator samples were fabricated using 0.375PMN-0.37OPT-0.255PZ system ceramics with Barium substitution and the strain properties of them were investigated. Dielectric constant of the specimens increased with the increase of Ba content up to 5mol% and decreased with futher addition of Ba. The largest piezoelectric coefficient and electromechanical coupling coefficient were observed at the sintering temperature of 1250'C and Barium content of 5mol%. The characteristics of strain hysteresis was found largely with varing the sintering temperature on the single round type, and the strain is proportional to piezoelectric coefficient.

• Journal of the Mineralogical Society of Korea
• /
• v.1 no.2
• /
• pp.94-103
• /
• 1988

Diamond anvil cell (DAC) interfaced with a YAG laser heating system has been used to study the phase transformations on perovskite structured titanates ($BaTiO_3$, and $PbTiO_3$) and to synthesize the silicate perovskite phase from the orthopyroxenes of $MgSiO_3$ and $(Mg_{0.87},\;Fe_{0.13})SiO_3$. $BaTiO_3$ and $PbTiO_3$ transform from tetragonal phase to cubic at the pressures of approximately 2.6 GPa and 4.0 GPa at room temperature, respectively. Cubic phases of the both show wide range of stability in the extended in-situ high pressures and high temperature regions. Starting orthoenstatite of $MgSiO_3$ has yielded the perovskite phase as the major structure with ilmenite, gamma-spinel, betta-spinel and stishovite phases at ~38 GPa and ${\sim}1,000^{\circ}C$. $(Mg_{0.87},\;Fe_{0.13})SiO_3$ has shown the perovskite as the major phase with betta-spinel, stishovite and enstatite phases at ~35 GPa and ${\sim}1,000^{\circ}C$. The ilmenite phase does not occur at this condition.

• Journal of the Korean Ceramic Society
• /
• v.30 no.2
• /
• pp.101-106
• /
• 1993

Effects of CaO on microwave dielectric properties of (Ba, Pb)O-Nd2O3-TiO2 ceramic ystem were investigated. As the content of CaO increases, the sintered bulk density decreases due to the decrease of sinterability. However, with increasing the sintering tmperature, the relative dielectric constants increases. This has been attributed on the formation of the 2nd phase inclusion, TiO2(rutile). The Q values increase due to the compensation effect of Ca ions up to 1 wt%, and then decrease due to the interfacial relaxation effects. The temperature coefficient of resonance frequency increases to a positive direction with increasing the amounts of CaO.

• Journal of the Korean Ceramic Society
• /
• v.41 no.6
• /
• pp.444-449
• /
• 2004

The microwave dielectric properties of low temperature sintered BaO-Nd$_2$O$_3$-TiO$_2$ (here after BNT) with a Pb-based glass-ceramics were studied in order to investigate their applicability to Low Temperature Co-fired Ceramics (LTCC) for fabrication of multilayered Radio Frequency (RF) passive components module. The BNT ceramics, with 5∼30 wt% of PbO-TiO$_2$-A1$_2$O$_3$-SiO$_2$ based glass-ceramics, were sintered at 105$0^{\circ}C$, which is lower than 130$0^{\circ}C$, sintering temperature of pure BNT ceramics. With increasing the amount of the glass-ceramics, sintering rate of the ceramics become activated due to the softening of glass, resulting in low-temperature densification. BaO-Nd$_2$O$_3$-TiO$_2$ microwave ceramics with 20 wt% glass-ceramics exhibit sintered relative densities over 95% and dielectric constant of 72, quality factor of 1500, and temperature coefficient of frequency of +22 ppm/$^{\circ}C$. This enhanced dielectric properties are attributed to mainly the presence of crystalline phases PbTiO$_3$ within the Pb-based glass.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1996.05a
• /
• pp.292-294
• /
• 1996

Dielectric properties were investigated at Mn doped 0.17($Ba_{0.53}$, $Pb_{0.47}$)0-$0.16Nd_2O_3$-$0.67TiO_2$ system in microwave frequency. It was observed that dielectric constant of 90.1, quality factor of 1320 (at 3.8GHz) and temperature coefficient of resonance frequency 2.3 ppm/$^{\circ}C$ for 0.5wt% Mn doped 0.17($Ba_{0.53}$, $Pb_{0.47}$)0-$0.16Nd_2O_3$-$0.67TiO_2$ system in sintering condition $1290^{\circ}C$/2hr. The quality factor increase due to the compensation effect of Mn ions yp to 0.5wt% and the decrease due to the interface relaxation effect. The temperature coefficient of resonance frequency increases to negative direction with increasing the amounts of Mn.

• Korean Journal of Materials Research
• /
• v.5 no.2
• /
• pp.151-156
• /
• 1995

Low temperature firing $(Ba, Sr)TiO_{3}$ dielectrics were successfully prepared with lead based glass and those electrical properties were investigated. Different amount of PbO content glass materials were added to dielectrics to investigate the sinterability and its dielectric properties. Also, various compositions of ceramic capacitors were prepared to applicate in multilayer ceramic capacitors. A large amount of experiment has been done with various Pb contented glasses and different sintering temperatures. The sintering temperature of $(Ba,Sr)TiO_{3}$can be reduced from $1350^{\circ}C$to as low as $1050^{\circ}C$ with 4wt% addition of $PbO-ZnO-B_{2}O_{2}$ glass materials. Its dielectric constant at room temperature was up to 8100 with low dielectric loss, 0.005. This ceramic capacitor showed fully fired microstructures with its grain size of 1-3$\mu \textrm{m}$. The sintered body which was sintered at $1150^{\circ}C$ for 2hr with 4wt% $PbO-ZnO-B_{2}O_{2}$ glass material addition satisfied the Z5U specification of the EIAS.

• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.41 no.8
• /
• pp.858-868
• /
• 1992

0.085Ba(LaS11/2TNbS11/2T)OS13T-0.915Pb(ZrS1yTTiS11-yT)OS13T (0.45$\leq$y$\leq$0.65) transparent electrooptic ceramics were fabricated by two-stage sintering method. The structural, ferroelectric and electrooptic properties were investigated varying composition and second sintering time. Also the possibility of application to electrooptic device was studied. If we increase the PbZrOS13T contents, dielectric constants were increased and Curie temperature was decreased. In the composition of 0.55[mol] PbZrOS13T, electromechanical coupling factor and piezoelectric charge constant were the highest values of 43[%] and 173x10S0-12T[C/N], respectively. Mechanical quality factors were decreased with the increasing PbZrOS13T contents. Light transmittance was increased with wavelength when measured from 300[nm] to 900[nm], and with PbZrOS13T contents in the range of 0.50[mol]-0.65[mol], and had the highest value of 67[%] in the composition of 0.65[mol] PbZrOS13T. From the results of ferroelectric hysteresis loop and transmitted light intensity with electric field, the specimens with compositions of 0.65,0.60,0.55[mol] PbZrOS13T were applicable to electrooptic memory device and those with compositions of 0.50,0.45[mol] PbZrOS13T were applicable to linear electrooptic device.