• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 추계학술대회 논문집 학회본부 C
• /
• pp.795-797
• /
• 1998

A $BaTiO_3$, ferroelectric material, was mixed $SrTiO_3$, $(x)BaTiO_3-(1-x)SrTiO_3$($0.7{\leq}x{\leq}1$) ceramic capacitor with stable electrical properties in high voltage was fabricated. And microstructure, electrical property were investigated with $SrTiO_3$ mol ratio. The shrinkage, open porosity, sintering density were predominated at $9BaTiO_3-0.1SrTiO_3$. Increasing $SrTiO_3$ mol ratio, curie temperature was shifted at low temperature and maximum permittivity was increased. Also, $0.9BaTiO_3-0.1SrTiO_3$ was showed stable dielectric properties at $25{\sim}80[^{\circ}C]$. V-I properties of specimen were observed in the temperature range of $21{\sim}143[^{\circ}C]$, were divided into three regions. The region I below 10[kV/cm] was shown Ohmic conduction, the region II from 10 to 30[kV/cm] was explained by the Poole-Frenkel emission theory and the region III above 30[kV/cm] was analysed by the tunneling effect.

• 한국세라믹학회지
• /
• 제18권1호
• /
• pp.13-22
• /
• 1981

This study is to investigate the effective mineralizer in the manufacture of forsterite porcelain as a high frequency insulator. A mixture of $Mg(OH)_2$. and $SiO_2$.($\alpha$-Quartz) corresponding to the molar ratio of 2.0 MgO: 1.0 $SiO_2$ was prepared from the materials of high purity. It was heated to 140$0^{\circ}C$ at the rate of 20$0^{\circ}C$/hr, which was kept constantly for 1 hour, and one has made chamotte after cooling. Six kinds of glasses were prepared by an 0.1 atomic equivalent of K ions substitution-Ba, Bi, Zn, Cd, Zr-to the basic K-glass (0.333 $K_2O$.1.14 $SiO_2$) and were melted approximately at 150$0^{\circ}C$. The forsterite bodies were provided by adding each glass (10, 15, 20, 25, 30%) to the forsterite chamotte, which was fired at 1320, 1360, 1400, 144$0^{\circ}C$. (1 hr). One has examined the physical and dielectric properties for the specimens. The results of the experiments are as follows; 1. As for water absorption: Bodies were better vitrified with an addition and temperature change of Ba, Bi, Zn-glasses. The specimen containing Cd-glass showed deviation of slow decreasing, where as K-glass was completely not vitrified. 2. Bodies containing Ba, Zn, Bi-glasses appeared comparatively high Modulus of Rupture at 136$0^{\circ}C$, while containing Zr-glass had the highest Modulus of Rupture as the addition changes remarkably at 140$0^{\circ}C$. 3. It was estimated that 20-25% glass present in a forsterite bodies were in good conditions as for physical properties. 4. Specimens of Ba, Bi, Zr-glasses were superior as for dielectric properties, where among Ba-glass was most excellent. 5. Dielectric constant commonly increases in a slight gradient as firing temperature rises. 6. The petrographic examination showed that the bodies containing Ba, Bi-glasses had fine crystals, and were observed distinctly large mosaic crystals in the Zn-glass.

• 한국재료학회:학술대회논문집
• /
• 한국재료학회 2010년도 춘계학술발표대회
• /
• pp.48.2-48.2
• /
• 2010

The effect of additives as rare-earth in dielectric materials has been studied to meet the development trend in electronics on the miniaturization with increasing the capacitance of MLCCs (multi-layered ceramic capacitors). It was reported that the addition of rare-earth oxides in dielectrics would contribute to enhance dielectric properties and high temperature stability. Especially, dysprosium and thulium are well known to the representative elements functioned as selective substitution in barium titanate with perovskite structure. The effects of these additives on microstructure and electric properties were studied. The 0.8 mol% Dy doped $BaTiO_3$ and the 1.0 mol% Tm doped $BaTiO_3$ had the highest electric properties as optimized composition, respectively. According to the increase of rare-earth contents, the growth of abnormal grains was suppressed and pyrochlore phase was formed in more than solubility limits. Furthermore, the effect of two rare-earth elements co-doped $BaTiO_3$ on the dielectric properties and insulation resistance was investigated with different concentration. The dielectric specimens with $BaTiO_3-Dy_2O_3-Tm2O_3$ system were prepared by design of experiment for improving the electric properties and sintered at $1320^{\circ}C$ for 2h in a reducing atmosphere. The dielectric properties were evaluated from -55 to $125^{\circ}C$ (at $1KHz{\pm}10%$ and $1.0{\pm}0.2V$) and the insulation resistance was examined at 16V for 2 min. The morphology and crystallinity of the specimens were determined by microstructural and phase analysis.

• 한국재료학회지
• /
• 제6권12호
• /
• pp.1155-1161
• /
• 1996

Pb(In1/2Nb1/2)O3 (PIN)세라믹스에서 Pb+2이온 대신에 Ca+2, Sr+2, Ba+2 이온을 부분적으로 치환하여 상합성 과정 및 유전특성을 조사하였다. 페로브스카이트 PIN을 얻기위한 최적조건을 도출하기위하여 하소, 치환 이온의 종류 및 그량, 소결민돌, 유전특성의 관점에서 관찰하였다. 페로브로스카이트 PIN상을 합성하기 위해서는 Ba+2이온의 치환이 가장 효과적이었다.

• 한국결정성장학회지
• /
• 제20권6호
• /
• pp.278-282
• /
• 2010

Tm 도핑에 따른 $BaTiO_3$ ceramics의 전기적 특성과 열화 거동에 미치는 영향에 대하여 core-shell 형성과 가속열화시험에 의한 미세화학변화의 관점에서 연구하였다. $Tm_2O_3$를 첨가하지 않은 $BaTiO_3$와 1 mol%를 첨가한 $BaTiO_3$를 펠렛과 적층 형태의 시편으로 각각 제조하였다. 1 mol% $Tm_2O_3$가 첨가된 유전체 시편의 유전상수는 $Tm_2O_3$를 첨가하지 않은 시편에 비해 약 40% 높게 나타났고 X7R 조건을 만족하였다. 절연저항 또한 1 mol% $Tm_2O_3$가 첨가된 시편은 $5.43{\times}10^{10}{\Omega}$으로 $Tm_2O_3$를 첨가하지 않은 시편의 $1.11{\times}10^{10}{\Omega}$보다 높게 나타났다. 이는 $Tm^{3+}$ 이온이 Ba site와 Ti site에 선택적으로 치환되고 유전체 미세조직 내에 core-shell 구조를 형성하여 전기적 특성을 향상시킨 것으로 설명된다. 각각의 조성에 따라 제조된 적층 시편의 $150^{\circ}C$, 70 V, 24시간 가속열화시험결과에 따르면, 1 mol% $Tm_2O_3$가 첨가된 $BaTiO_3$는 첨가되지 않은 시편에 비해 전극 층으로의 산소확산이 감소됨을 확인하였고, 이는 $Tm^{3+}$ 이온의 Ti site 치환에 의해 발생한 산소공공이 Ni 전극과 반응할 수 있는 과잉 산소를 줄여주기 때문으로 판단된다.

• 센서학회지
• /
• 제18권5호
• /
• pp.343-348
• /
• 2009

$NiO{\cdot}(Co_{0.25}Mn_{0.75})_2O_3$(Mn-Ni-Co) and $Ba_{0.5}Sr_{0.5}TiO_3$(BST) thick films were screen printed on Pt patterned alumina substrate to investigate the effects of sintering temperature on humidity and temperature sensing properties of ceramic sensors. A raise in sintering temperature increased resistance and B constant of the Mn-Ni-Co temperature sensor. This may have derived from the synergic effects of the reduction in charge carriers caused by the substitution of Co for Mn as well as the formation of microcracks from the difference in thermal expansion coefficients. Dependence of resistance on humidity of the Mn-Ni-Co temperature sensor, however, was not found. BST films sintered at temperatures in the range of $1100^{\circ}C$ to $1150^{\circ}C$ showed excellent humidity sensing properties. The BST humidity sensor was faster in its response than the Mn-Ni-Co temperature sensor. The humidity sensor, however, proved to be unstable under various temperatures, suggesting a need for a temperature stabilizing device. In contrast, the Mn-Ni-Co temperature sensor was stable under humid conditions.

• 한국전기전자재료학회논문지
• /
• 제27권12호
• /
• pp.797-802
• /
• 2014

In this study, in order to develop the capacitor composition ceramics with the good dielectric properties, $(Ba_{1-x}Ca_x)(Ti_{0.85}Zr_{0.12}Sn_{0.03})O_3$ (abbreviated as BCTZ) ceramics were prepared by the conventional solid-state reaction method. The effects of Ca substitution on the microstructure and dielectric properties was investigated. The X-ray diffraction patterns demonstrated that all the specimens showed perovskite phase, and secondary phases are indicated in the measurement range of X-ray diffraction. Also, all the specimens indicated an rhombohedron phase structure. It was identified from the X-ray diffraction patterns that the secondary phase formed in grain boundaries and then decreased the dielectric properties. For all the specimens, observed one peak was tetragonal cubic phase transition temperature($T_c$), which is located in the vicinity of room temperature.

• Bulletin of the Korean Chemical Society
• /
• 제34권1호
• /
• pp.267-270
• /
• 2013

• 한국초전도저온공학회:학술대회논문집
• /
• 한국초전도저온공학회 2002년도 학술대회 논문집
• /
• pp.346-350
• /
• 2002

The effect of Ca-doping on the superconducting properties of Nd-Ba-Cu-O bulk superconductors, fabricated by the oxygen-controlled melt growth process, has been systematically investigated. Various c-axis textured bulk samples were grown using precursors with the nominal compositions of N $d_{1.8-x}$C $a_{x}$B $a_{2.4}$C $u_{3.4}$ $O_{y}$ (x = 0.00, 0.02, 0.05, 0.10, 0.15) in a reduced oxygen atmosphere of 1% $O_2$ in Ar. Magnetization measurements revealed that the critical temperatures( $T_{c}$) were almost linearly depressed from 95K to 86K with increasing the Ca dopant from x = 0.0 to 0.15, respectively, and thus critical current densities( $J_{c}$) at 77K and for H//c-axis of specimens were gradually degraded with increasing x. Compositional analyses revealed that although the amounts of the Ca dopant both in NdB $a_2$C $u_3$ $O_{y}$(Nd123) and N $d_4$B $a_2$C $u_2$ $O_{10}$(Nd422) were increased with increasing x, only less than half of the initial Ca compositions were detected in melt-grown Ca-doped Nd-Ba-Cu-O bulk crystals. The supression of $T_{c}$ is attributed to an increased Nd substitution for the Ba site in the Nd123 superconducting matrix with increasing the amount of the Ca dopant.t.opant.t.t.t.t.t.

• Journal of Magnetics
• /
• 제18권4호
• /
• pp.386-390
• /
• 2013

This paper studies the effects of A-site substitution by barium on the magnetic and magnetocaloric properties of $Pr_{0.5}Sr_{0.5-x}Ba_{x}MnO_{3}$ (x = 0, 0.04, 0.08 and 0.1). The tetragonal crystal structures of the samples are confirmed by room temperature X-ray diffraction. The dependence of the Curie temperature ($T_C$) and the magnetic entropy change (${\Delta}S_M$) on the Ba doping content has been investigated. The samples of all doping contents undergo the second order phase transition. As the concentration of Ba increased, the maximum entropy change ($|{\Delta}S_M|_{max}$) increased gradually, from 1.15 J $kg^{-1}$ $K^{-1}$ (x = 0) to 1.36 J $kg^{-1}$ $K^{-1}$ (x = 0.1), in a magnetic field change of 1.5 T. The measured value of $T_C$ is 265 K, 275 K, 260 K and 250 K for x = 0, 0.04, 0.08 and 0.1, respectively. If combining these samples for magnetic refrigeration, the temperature range of ~220 K and 290 K, where |${\Delta}S_M$|max is stable at ~1.27 J $kg^{-1}$ $K^{-1}$ and RCP = 88.9 $J{\cdot}kg^{-1}$ for ${\Delta}H$ = 1.5 T. $Pr_{0.5}Sr_{0.5-x}Ba_{x}MnO_{3}$ compounds, are expected to be suitable for magnetic-refrigeration application due to these magnetic properties.