• Physical Therapy Korea
• /
• v.18 no.2
• /
• pp.9-17
• /
• 2011

The objective of this research was to examine the effects of lumber stabilization exercise and a general physiotherapy program for caregivers with chronic low back pain. Sixteen people participated in this study and were randomly assigned to two groups for either lumbar stabilization exercise or for general physiotherapy, respectively. The experiment was performed for eight weeks. To examine the general as well as the medical characteristics of the participants, the following measurements were used: Visual Analogue Scale (VAS); Oswestry Disability Index (ODI); Back Performance Scale (BPS); Roland - Morris Disability Questionnaire (RMDQ); and Beck Depression Index (BDI). To compare the general and medical characteristics of the participants in the two groups, an independent t test were used. During the experiment, a paired t test was conducted to determine whether there was a significant difference in the values of VAS, ODI, BPS, RMDQ, and BDI before and after the experiment. To examine the difference in the VAS, ODI, BPS, RMDQ, and BDI values in the two groups, ANCOVA was used with pre test values as a covariate. According to the test results, in the lumbar stabilization exercise group, the VAS, ODI, BPS, RMDQ, and BDI values showed a statistically significant difference before and after the test (p<.05). In comparison, in the general physiotherapy program group, only the ODI and BPS values showed a statistically significant level of improvement. Regarding the degree of improvement, participants in the lumbar stabilization exercise group showed statistically significant progress compared to those in the general physiotherapy group. In summary, lumbar stabilization exercise is regarded as more effective than general physiotherapy for treating caregivers with chronic low back pain. In future studies, it will be useful to expand the research and to examine the long term effects of lumbar stabilization exercise on workers.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2007.10a
• /
• pp.693-697
• /
• 2007

The SSB modem performs the modulation process which converts the digital voltage level to the audible frequency band signal and the demodulation process which converts reversely the audible frequency signal to the digital voltage level. The modulator and the demodulator are implemented with a single DSP chip. Because of the SSB specific character, the distortion occurs when the frequency is changed. This distortion has no effect on voice communication, but it has an significant effect on data communication. In other words, it is impossible to send data stream with adjacent 2 periods. Therefore, in case of using 2-tone FSK, it is needed to send at least 3 periods to transmit 1 bit. Therefore we implemented the modem using modified phase-delay shift keying to transmit 1 tone signal for high speed transmission. In the 1200[bps] mode, it generates 0, $187{\mu}s$ delay time at 1.3kHz symbol frequency, and in the 2400[bps] mode, 0, $70{\mu}s$, $130{\mu}s$, $200{\mu}s$ delay time at 1.5kHz symbol frequency. Finally, in the maximum 3600[bps] mode, it generates 0, $100{\mu}s$, $160{\mu}s$, $250{\mu}s$ delay time at 2.0kHz symbol frequency. The measured results of the implemented SSB modem shows a good transfer functional characteristic by spectrum analyzer, almost same bandwidth in pass band and 20dB higher SNR comparing the German PACTOR and American CLOVER and in the experimental transmitting test, we verified the transmitted data is received correctly in platform.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.2
• /
• pp.385-390
• /
• 2006

This paper examines the sampling and jitter specifications and considerations for Global Navigation Satellite Systems (GNSS) software receivers. Software radio (SWR) technologies are being used in the implementation of communication receivers in general and GNSS receivers in particular. With the advent of new GPS signals, and a range of new Galileo and GLONASS signals soon becoming available, GNSS is an application where SWR and software-defined radio (SDR) are likely to have an impact. The sampling process is critical for SWR receivers, where it occurs as close to the antenna as possible. One way to achieve this is by BandPass Sampling (BPS), which is an undersampling technique that exploits aliasing to perform downconversion. BPS enables removal of the IF stage in the radio receiver. The sampling frequency is a very important factor since it influences both receiver performance and implementation efficiency. However, the design of BPS can result in degradation of Signal-to-Noise Ratio (SNR) due to the out-of-band noise being aliased. Important to the specification of both the ADC and its clocking Phase- Locked Loop (PLL) is jitter. Contributing to the system jitter are the aperture jitter of the sample-and-hold switch at the input of ADC and the sampling-clock jitter. Aperture jitter effects have usually been modeled as additive noise, based on a sinusoidal input signal, and limits the achievable Signal-to-Noise Ratio (SNR). Jitter in the sampled signal has several sources: phase noise in the Voltage-Controlled Oscillator (VCO) within the sampling PLL, jitter introduced by variations in the period of the frequency divider used in the sampling PLL and cross-talk from the lock line running parallel to signal lines. Jitter in the sampling process directly acts to degrade the noise floor and selectivity of receiver. Choosing an appropriate VCO for a SWR system is not as simple as finding one with right oscillator frequency. Similarly, it is important to specify the right jitter performance for the ADC. In this paper, the allowable sampling frequencies are calculated and analyzed for the multiple frequency BPS software radio GNSS receivers. The SNR degradation due to jitter in a BPSK system is calculated and required jitter standard deviation allowable for each GNSS band of interest is evaluated. Furthermore, in this paper we have investigated the sources of jitter and a basic jitter budget is calculated that could assist in the design of multiple frequency SWR GNSS receivers. We examine different ADCs and PLLs available in the market and compare known performance with the calculated budget. The results obtained are therefore directly applicable to SWR GNSS receiver design.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.10
• /
• pp.1852-1857
• /
• 2007

The SSB modem performs the modulation process which converts the digital voltage level to the audible frequency band signal and the demodulation process which converts reversely the audible frequency signal to the digital voltage level. The modulator and the demodulator are implemented with a single DSP chip. Because of the SSB specific character, the distortion occurs when the frequency is changed. This distortion has no effect on voice communication but it has an significant effect on data communication. In other words, it is impossible to send data stream with adjacent 2 periods. Therefore, in case of using 2-tone FSK, it is needed to send at least 3 periods to transmit 1 bit. Therefore we implemented the modem using modified phase-delay shift keying to transmit 1 tone signal for high speed transmission. In the 1200[bps] mode, it generates 0, $187{\mu}s$, delay time at 1.3kHz symbol frequency, and in the 2400[bps] mode, 0, $70{\mu}s\;130{\mu}s\;200{\mu}s$, delay time at 1.5kHz symbol frequency. Finally, in the maximum 3600[bps] mode, it generates 0, $100{\mu}s\;160{\mu}s\;250{\mu}s$ 2.0kHz symbol frequency. The measured results of the implemented SSB modem shows a good transfer functional characteristic by spectrum analyzer, almost same bandwidth in pass band and 20dB higher SNR comparing the emu FACTOR and American CLOVER and in the experimental transmitting test, we verified the transmitted data is received correctly in platform.

• Journal of Marine Life Science
• /
• v.6 no.2
• /
• pp.73-79
• /
• 2021

Bisphenol A is a representative endocrine disruptor and continuously detected in aquatic environment due to wide use, resulting in adverse effects on growth, development, and reproduction in diverse organisms as well as human. Structural analogs have been developed to substitute BPA are also suspected to have endocrine disrupting effects. In the present study, the time-dependent expression patterns of ecdysteroid synthesis (nvd, cyp314a1), receptors (EcRA, EcRB, USP, ERR), and downstream signaling pathway - related genes (HR3, E75, Vtg, VtgR) were investigated using quantitative real time reverse transcription polymerase chain reaction (qRT-PCR) in the brackish water flea Diaphanosoma celebensis exposed to Bisphenol analogs (BPs; BPA, BPF, and BPS) for 6, 12, and 24 h. As results, the expression of nvd, cyp314a1, EcRs, USP, ERR and E75 mRNA was upregulated at 6 h exposure to BPF, which is earlier than BPA and BPS (12 h). On the other hand, HR3, E75 and VtgR mRNA levels were elevated at 6 h earlier at BPS and BPF than at BPA (12 h), but Vtg mRNA level was slightly changed within 24 h. These findings suggest that like BPA, BPF and BPS can also modulate the transcription of ecdysteroid pathway - related genes with different mechanisms, and have a potential as endocrine disruptors. This study will provide a better understanding the molecular mode of action of bisphenols on ecdysteroid pathway in the brackish water flea.

• Journal of The Korean Association For Science Education
• /
• v.22 no.4
• /
• pp.706-716
• /
• 2002

The purpose of this study was to compare and analyze the science process skills and teaching methods between the 6th and the 7th elementary school science textbooks. For this study, science textbooks and teacher's guidebooks from the 3rd to the 6th grade were analyzed. In this research the science process skills are divided by basic process skills(BPS) and integrated process skills(IPS). The BPS is composed of observing, classifying, measuring, predicting and inferring skill, which are 5 subcategories. The IPS is composed of problem cognition, formulating hypothesis, controlling variables, transforming data, interpreting data, drawing result, and generalization, which are 7 subcategories. The results found in the analysis of science process skills in the 6th and 7th science textbooks are as follows: 1. The percentage of the BPS was increased, but the IPS was decreased in the 7th than the 6th. 2. The percentage of the IPS was higher than the BPS in the 6th science textbooks, but the BPS was higher than IPS in lower grade and the IPS was higher than the BPS in higher grade in the 7th textbooks. 3. Observing and problem cognition skill were most dominant in the 6th and 7th science textbooks. 4. The percentages of observing(24.8%), classifying(5.4%), measuring(5.6%), inferring(6.0%) in the BPS and interpreting data(4.4%) in the IPS were increased, but predicting(3.8%), formulating hypothesis(0.5%), controlling variables( 1.8%), transforming data( 1.2%), drawing result(0.8%) and generalization(0.9%) skills were decreased in the 7th. And teaching methods suggested in the curriculum are as follows: the percentages of learning by observation(19.2%) and role play(0.1 %) were decreased, but learning by experiment(6.2%), learning by discussion(2.0%), learning by investigation(4.6%) and creative learning(6,4%) were increased in the 7th than the 6th. In conclusion, it was found that the basic process skills were emphasized in the 7th science textbooks than the 6th and the science process skills in the science textbooks of the 7th curriculum were distributed by the grade level of the elementary children.

• Korea Information Processing Society Review
• /
• v.16 no.3
• /
• pp.25-34
• /
• 2009

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39A no.12
• /
• pp.771-773
• /
• 2014

Dual-polarization antenna system has been being researched for wireless communications under short range line-of-sight channel environments. In this paper, probability density function of signal-to-interference-ratio(SIR) for the dual-polarization antenna system is derived, and SIR outage is analyzed. It is shown that the upper bound capacity of a dual-polarization antenna system without polarization alignment is 4.5324 bps/hz.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1986.10a
• /
• pp.198-200
• /
• 1986

In this paper, the optical modem for data link realization is designed with the advantages of optical fiber : large handwidth, no electromagnetic interference, high speed and long-haul communications. Biphase cording format is used for the sync, and async, transmissions. Modem interface conform to the CCITT V.24 standard for the compatibility with existing systems. 0/E and E/0 converters are designed using LED-APD pair for long wave length and LD-APD for short wave length, respectively. As a result, the system is capable of transmitting at any bps within dc to 200Kbps in async, and at 1200bps up to 57.6Kbps in sync. transmission.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.1C
• /
• pp.22-27
• /
• 2011

This paper proposes an efficient user selection algorithm that provides a maximum 셀 용량 based Multi-user MIMO system based on zero-forcing criterion. The proposed scheme forms a primary group of users whose channel power exceeds a predetermined threshold. Through computer simulations, we have found that the proposed method outperforms the conventional scheme yielding a sum rate that is 0.33 bps/Hz higher when the total numbers of users and transmit antennas in the cell are 100 and 4, respectively.