• Proceedings of the IEEK Conference
• /
• 2004.06b
• /
• pp.339-342
• /
• 2004

본 논문은 밀리미터파 대역 무선통신 시스템 송신부의 응용을 위해 CPW 구조를 이용하여 V-band용 상향 주파수 혼합기와 2단 구동증폭기를 설계$\cdot$제작하였다. 능동소자는 본 연구실에서 제작한 $0.1{\mu}m$ 게이트 GaAs Pseudomorphic HEMTs(PHEMTs)를 사용하였으며 입$\cdot$출력단은 CPW를 사용해 정합 회로를 설계하였다. 제작된 상향 주파수 혼합기는 LO power 5.4 dBm, 2.4 GHz IF 신호를 -10.25 dBm으로 입력하였을 때 Conversion Loss 1.25 dB, LO-to-RF Isolation은 58 GHz에서 13.2 dB의 특성을 나타내었다 2단 구동 증폭기는 측정결과 60 GHz에서 S21 이득 13 dB, $58\;GHz\;\~\;64\;GHz$ 대역에서 S21 이득 12 dB 이상을 유지하는 광대역 특성을 얻었고 증폭기의 Pl dB는 3.8 dBm, 최대 출력전력은 6.5 dBm의 특성을 얻었다.

• Publications of The Korean Astronomical Society
• /
• v.14 no.1
• /
• pp.39-45
• /
• 1999

We have carried out measurements of 1.2-1.6GHz radio interferences around Seoul Radio Astronomy Observatory located in the campus of Seoul National University. We received interference signals using a pyramidal horn antenna and measured its power using a spectrum analyzer with 1MHz resolution after $\~60dB$ amplification. In order to check the spatial characteristics, we made observations at every $30^{\circ}$ in azimuth at elevation of $30^{\circ}\;and\;60^{\circ}$. Also, in order to check the temporal characteristics, we repeated the all-sky observations five times at every six hours. The results may be summarized as follows: (1) There are strong $({\geq}-20dBm)$ interferences between 1.2 and 1.4GHz. Particularly strong interferences are observed at 1.271 and 1.281GHz, which have maximum powers of -0.34dBm and -0.56dBm, respectively. (2) The characteristics of the interferences do not depend strongly on directions, although the interferences are in general weak at high elevation and in east-west direction. (3) The interferences appear for a very short $(\leq0.01s)$ period of time, so that the average power is much smaller than the maximum power. Strong interferences with large $(\leq-49.0dBm)$ average power have been observed at 1.271, 1.281, 1.339, and 1.576GHz. At these frequencies, the interferences appear repeatedly with a period of $\leq0.1s$ By analyzing the observed power, we find that, for the strongest 1.271GHz interference, the average intensity is $-171dBW/m^2/Hz$ and that the maximum intensity is $-122dBW/m^2/Hz$. If this interference is delivered to the detector without any shielding, then its power would be much greater than the rms noise of a typical line spectrum. Therefore, it is important to shield all the parts of receiver carefully from radio interferences. Also, without appropriate shielding, the sensitivity of a receiver could be limited by the interference.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.1
• /
• pp.92-95
• /
• 2016

In this paper, an UHF-band 1 kW solid-state pulsed power amplifier was designed and implemented for the thermoacoustic imaging(TAI) at 900 MHz. The designed power amplifier has a pulse width of $80{\mu}s$ and a duty cycle of 1 % for short-pulse operation. The overall amplifier was implemented by combining of 16 single-power amplifiers adopting MRFE6P9220HR3 LDMOSFET using wilkinson power dividers. The solid-state pulsed power amplifier shows 25 % drain efficiency with a gain of 76.2 dB when the output power is 60.2 dBm for a -16 dBm input power at center frequency.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.12
• /
• pp.83-89
• /
• 2014

A ku-band complementary cross-coupled differential voltage controlled oscillator is designed, measured and fabricated using $0.18-{\mu}m$ CMOS technology. A 2.4GHz of very wide frequency tuning at oscillating frequency of 14.5GHz is achieved with presented circuit topology and MOS varactors. Measurement results show -1.66dBm output power with 18mA DC current drive from 3.3V power supply. When 5V is applied, the output power is increased to 0.84dBm with 47mA DC current. -74.5dBc/Hz phase noise at 100kHz offset is measured. The die area is $1.02mm{\times}0.66mm$.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.8
• /
• pp.121-127
• /
• 2008

This paper presents an electric field distribution in a reverberation chamber using cylindrical diffuser. The characteristics of electric field distributions are compared with QRD(Quadratic Residue Diffuser) and cylindrical diffuser for $1{\sim}3$ GHz frequency band. The FDTD(Finite-Difference Time-Domain) method is used to analyze the field characteristics, and the field uniformity. At 2 GHz, the standard deviation and the tolerance of test volume in the reverberation chamber are improved by 0.11 dB, 0.43 dB for the case of cylindrical diffuser. The field strength is increased by 43.2 dBmV/m vs QRD's of 36.6 dBmV/m. Comparing with QRD's, the characteristic of polarization is also improved. These results show that reverberation chamber using cylindrical diffuser can be used alternative facility for measurement of electromagnetic interference and immunity.

• Proceedings of the KOSOMBE Conference
• /
• v.1996 no.05
• /
• pp.335-338
• /
• 1996

We attempted to reconstruct basement membrane (BM) in between the epidermal compartment and dermal compartment in the artificial skin preparation and examine its effect on the skin architecture as well as on the epidermal differentiation. Laminin, one of the component of BM, stimulate the migration of the basal cells but type IV collagen which is a major component of the mechanical network of BM did not stimulate epidermal migration. However laminin in the presence of type IV collagen at a 1:1 molar ratio did not stimulate epidermal migration but provide nice demarcation between epidermis and dermis. This mixture of laminin and type IV collagen enhanced epidermal differentiation in the artificial skin based on the morphological observation as well as biochemical criteria. The epidermal acquirement of migratory ability on the laminin-rich substrate suggest that this type of unbalance in the expression of the components of BM may prevail in the area of healing tissue and the invasive transition of the tumor. The result in this study provide the technical improvement in the artificial skin preparation and further application of this technique for the reconstruction of other bio-artificial organ.

• Journal of Advanced Navigation Technology
• /
• v.26 no.2
• /
• pp.85-90
• /
• 2022

In this study, in order to test the performance of the aircraft system, a threat signal simulator that can transmit a signal similar to the actual threat to the aircraft under test with high power was designed. The high-power threat signal simulator should be able to transmit broadband (UHF band, L band, S band, X band) communication signals and radar signals, and control to transmit signals accurately directed to the aircraft through interfacing tracking radar. The signal strength of the developed equipment is 63 dBm to 93 dBm or more depending on type of signal, and the tracking precision is less than 0.1 degree, which satisfies the required performance. And it was confirmed that the antenna of the high-power threat signal simulator can accurately direct the signal to the aircraft position through the tracking radar interfacing.

• Journal of Animal Environmental Science
• /
• v.16 no.1
• /
• pp.51-60
• /
• 2010

This experiment was conducted to investigate the effects of concentrated pig slurry separated from membrane filter and by environment-friendly agro-materials mixtures on growth of lettuce in hydroponics. The swine waste treatment system having a ultra filtration and a reverse osmosis process was designed in this study. Filtration of pig slurry was necessary to prevent the hose clogging in hydroponics. Primary separation using ultra filter was followed by concentration by RO (Reverse Osmosis). The concentrated pig slurry (CS) was mixed by five different environment-friendly agro-materials mixtures. The chemical nutrient solution was the solution of National Horticulture Research Station for the growth of lettuce. The concentration of nutrient solution in hydroponics was adjusted a range of 1.5 mS/cm in EC. The concentrated pig slurry was low in phosphorus(P), suspended solid and heavy matal, but rich in potassium (K). The concentrated slurry was lowest in the growth characteristics of leaf lettuce. And also SPAD value in leaf was reduced in plot treated with concentrated slurry. But the growth of lettuce in the mixtures plot (CS+BM+AA, CS+BM+AA+SW) in hydroponics was significantly high compared to concentrated slurry. The fresh yield of lettuce was 78, 84% that of nutrient solution as 131.9, 142.2g in plot of CS+BM+AA and CS+BM+AA+SW, respectively. Our studies have shown that it is possible to produce organic culture using concentrated slurry and environment-friendly agro-materials mixture, although growth is slower than when using a conventional inorganic hydroponic solution.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.8
• /
• pp.69-75
• /
• 1998

We demonstrate wavelength conversion of 2.5Gb/s optical signals by four-wave mixing (FWM) in a semiconductor optical amplifier (SOA). We investigate the effect of input pump and signal powers on the coversion efficiency, optical signal-to-noise ratio (OSNR) and extinction ratio to be a measure of performance in a wavelength converter. As a result, we show that the maximum bit error rate (BER) performance can be obtained by co promising among high-vonversion efficiency (minimum Pprobe), high-OSNR (maximum Pprobe) and low-cross-gain saturation effects (Pprobe kept at least 6dB weaker than Ppump). In our experiment, we obtain optimum performance at +3 dBm pump power and -6dBm signal power. The power penalty incurred in the wavelength conversion can be minimized by careful selection of the input pump and signal powers. We show that about 0.5dB power penalty for 3.2nm wavelength coversion at 10-10 BER is achievable.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.14 no.5
• /
• pp.825-832
• /
• 2011

In this paper, we described the design and measurement results of a Front-End Receiver for S-band active phased array radar. The Front-End Receiver has input P1dB of -4dBm and IIP3 of 7dBm. The measurement results show that gain is $24{\pm}0.7dB$, noise figure are less than 2.3dB over the frequency range of $fc{\pm}0.2GHz$. The Front-End Receiver can protect the receiver path from large input signals with a maximum peak power of multi-kW and recovery time is less than 0.8us. The measurement results satisfy all specifications.