• Biotechnology and Bioprocess Engineering:BBE
• /
• v.3 no.1
• /
• pp.44-47
• /
• 1998

Maximum cellulase production was sought by comparing the activities of the cellulases produced by different Trichoderma reesei strains and Aspergillus niger. Trichoderma reesei Rut-C30 showed higher cellulase activity than other Trichoderma reesei stains and Aspergillus niger that was isolated from soil. By optimizing the cultivation conditions during shake flask culture, higher cellulase production could be achieved. The FP(filter paper) activity of 3.7U/ml and CMCase (Carboxymethylcellulase) activity of 60U/ml were obtained from shake flask culture. When it was grown in 2.5L fermentor, where pH and DO levels are controlled, the enzyme activities were 133.35U/ml (CMCase) and 11.67U/ml(FP), respectively. Ammonium sulfate precipitation method was used to recover enzymes from fermentation broth. The dried cellulase powder showed 3074.9U/g of CMCase activity and 166.7U/g of FP activity with 83.5% CMCase recovery.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.9B
• /
• pp.1635-1640
• /
• 2000

In this paper, a 18 GHz oscillator is designed with the push-push method an fabricated by semi-MMIC process, in which the second harmonic is the main output signal with the suppressed fundamental mode. In semi-MMIC process, passive components with microstrip transmission line are implemented using MMIC process on semi-insulating GaAs substrate. Then, chip types of P-HEMT, resistors, and capacitors are connected through Au wire-bonding. Also, the ground plane is inserted around the circuit and connected each other with the back-side of substrate through Au wire-bonding instead of via-hole. The semi-MMIC push-push oscillator shows the output powder of -10.5 dBm, the fundamental frequency suppression of -17.3 dBc/Hz, and the phase noise of -97.9 dBc/Hz at the offset frequency of 100 kHz.

• Journal of the Korean Ceramic Society
• /
• v.35 no.10
• /
• pp.1007-1013
• /
• 1998

The samples of Bi2Sr2Ca1-xNaxCu2O8+y with various carrier concentration were synthesized by substituting Na for Ca ion. The superconducting properties hall coefficients and X-ray powder diffraction were measur-ed the sampled. Single phase samples were obtained for 0$\leq$x<0.3 of Bi2Sr2Ca1-xNaxCu2O8+y In the single phase the critical temperature. {{{{ { T}_{c } }} and carrier concentration increase with the increase of Na concentration pass through a maximum and then decreases. In the range of x$\geq$0.7 to the Na doped samples however we observed the metal-semiconductor transition. The c-axis seemed to decrease and a and b-axes increase with increasing Na concentration in the single phase. Decreasing of c-axis while increasing x is due to the smaller size of {{{{ {Na}^{+1 } }} ions to the {{{{ { Ca}^{+2 } }} ions. In the range of x>0.3 however the trend becomes ambiguous due to the inclusion of the 10K phase and impurity phase.

• Korean Journal of Environmental Agriculture
• /
• v.34 no.3
• /
• pp.196-203
• /
• 2015

BACKGROUND: Purpose of this research is HPLC analysis method development of lycopene in tomato. And then, three components of carotenoid in four kinds of tomatoes (general tomato, cherry tomato, red and orange date tomato) were compared with each other. METHODS AND RESULTS: Lycopene in tomato was extracted with hexane likes other carotenoid components using 500 mg of dried powder sample. HPLC analysis conditions were column temperature ($40^{\circ}C$), detection wavelength (454 nm), flow rate (1.0 mL/min) and injection volume ($20.0{\mu}L$). Lycopene was analyzed by the gradient elution ($60{\rightarrow}100%$) of the mobile phase solvents A[water: methanol=25: 75 (v/v)] and B[ethyl acetate]. CONCLUSION: Three components of carotenoids (lutein, ${\beta}$-carotene, lycopene) were observed in tomatoes. The total carotenoid contents was the highest in red date tomato (662.0 mg/kg dry wt.) and the lowest in orange date tomato (111.3 mg/kg dry wt.). Lycopene contents in tomatoes was the highest percentage (93%) among all the carotenoids.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2012.10a
• /
• pp.125-127
• /
• 2012

With the progress of electronics and radio communication technology, human enjoys greater freedom in communication. However, EMW (Electro-Magnetic wave) environments have became complicate and more difficult to control. Thus, international organizations, such as the American National Standard Institution (ANSI), Federal Communications Commission (FCC), the Comite Internationale Special des Perturbations Radio electrique (CISPR), etc, have provided standard for controlling the EM wave environments and for the countermeasure of the electromagnetic compatibility (EMC). In this paper, the status of EMW absorber and the goal of smart EMW absorber ifor the future were described. Furthermore, design method of the smart EM wave Absorber with heat radiating function was suggested. The designed smart EM wave Absorber has the absoption ability of more than 5 dB from 2 GHz to 2.45 GHz band, one optimum aperture (hole) size of which was 6 mm, 9 mm in adjacent hole space, and 6.5 mm in thickness, respectivly. Thus, it is repected that these results can be applied to various EMC devices in electronic, communication, and controlling systems.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.252-252
• /
• 2007

$Al_2O_3-TiO_2$(AT)ceramics shows great promise as a dielectric material for millimeter-wave use. The sintering temperature of AT ceramics was approximately $1450^{\circ}C$ and decreased to $900^{\circ}C$ with the addition of BaCu(B2O5) (BCB) ceramic powder. The presence, of the liquid phase was responsible for the decrease of the sintering temperature. The liquid phase is considered to have a composition similar to the BaO-deficient BCB. The Q-value initially increased with the addition of BCB, but decreased considerably when a large amount of BCB was added, because of the presence of the liquid phase. Good microwave dielectric properties of $Q{\times}f\;=\;16,200\;GHz$, ${\varepsilon}_r\;=\;9$ and ${\tau}_f\;=\;-4\;ppm/^{\circ}C$ were obtained for the 20.0 mol% BCB-added AT ceramics sintered at $900^{\circ}C$ for 2 h.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.08a
• /
• pp.140.2-140.2
• /
• 2013

Strong metal-support interaction effect is an important issue in determining the catalytic activity for heterogeneous catalysis. In this work, we report the catalytic activity of $Au/TiO_2$, $Au/Al_2O_3$, and $Au/Al_2O_3-CeO_2$ nanocatalysts under CO oxidation fabricated by arc plasma deposition (APD), which is a facile dry process with no organic materials involved. These catalytic materials were characterized by transmission electron microscopy (TEM), energy-dispersive X-ray spectroscopy (EDS) and $N_2$-physisorption. Catalytic activity of the materials has measured by CO oxidation using oxygen, as a model reaction, in a micro-flow reactor at atmospheric pressure. Using APD, the catalyst nanoparticles were well dispersed on metal oxide powder with an average particle size (3~10 nm). As for catalytic reactivity, the result shows $Au/Al_2O_3-CeO_2$ nanocatalyst has the highest catalytic activity among three samples in CO oxidation, and $Au/TiO_2$, and $Au/Al_2O_3$ in sequence. We discuss the effects of structure and metal-oxide interactions of the catalysts on catalytic activity.

• Journal of Animal Environmental Science
• /
• v.7 no.1
• /
• pp.29-32
• /
• 2001

In this experiment porous calcium silicate (PCS) powder prepared by using a 50 mesh sieve was spread on top of chick droppings to investigate the odor from the manure. Zeolite was used as a comparative purpose. Reduction in ammonia production from chick droppings shortly after the PCS and zeolite application was evident (P<0.05), but there were no difference among treatments afterwards. hydrogen sulfide level was significantly lowered by both PCS and zeolite treatment(P<0.05).

• The Korean Journal of Food And Nutrition
• /
• v.34 no.3
• /
• pp.272-288
• /
• 2021

Mealworm is the most widely used edible insect in Korean traditional food. In this study, the quality characteristics and antioxidant activity of Garaedduk containing different proportions of powdered mealworm (0%, 3%, 6%, 9%, and 12%) were evaluated in order to enhance the utilization of mealworm. The results revealed that moisture content decreased while pH and starch elution increased, with increasing amount of mealworm. Furthermore, the amount of total amino acids, essential amino acids, and non-essential amino acids increased with increasing amount of mealworm. Regarding chromaticity, the L value decreased while the a and b values increased as the amount of mealworm increased. The addition of 6% mealworm showed slight differences in the pore size and surface smoothness as compared to plain Garaedduk. Texture, hardness, chewiness, and gumminess increased, but cohesiveness decreased with increasing amount of mealworm. The preference test evaluating the appearance, flavor, taste, texture, and overall preference showed that 6% mealworm additive group had the highest preference. In addition, antioxidant activity of the newly developed Garaedduk increased with increasing amount of mealworm. In conclusion, Garaedduk enriched with 6% mealworm showed promising results for developing rice cake with improved nutrition and antioxidant activity and excellent overall preference and quality.

• Journal of the Korean Physical Society
• /
• v.73 no.11
• /
• pp.1679-1683
• /
• 2018

Polycrystalline $BaSrCo_2(Fe_{1-x}Al_x)_{12}O_{22}$ (x = 0.00, 0.01, 0.05, and 0.10) samples were synthesized by polymerizable complex method. Based on the Rietveld refinement, crystal structures of the samples were found to be single-phased and determined to be rhombohedral with space group of R-3m. The hysteresis curves of the samples were measured under 15 kOe at various temperatures ranging from 4.2 and 295 K. It shows that they were not saturated with increasing Al ion contents due to the reduction of magnetic anisotropy. $M_{15kOe}$ was decreased with increasing Al ions contents. We expect that non-magnetic Al ions preferentially occupy the up-spin site of $18h_{VI}$, $3b_{VI}$, and $3a_{VI}$. The $M{\ddot{o}}ssbauer$ spectra of the samples were obtained at 295 K, and analyzed with sixsextets for Fe sites corresponding to the Y-type hexaferrite crystallography sites. The <$E_Q$> shows abrupt changes, and the <$H_{hf}$> shows abrupt decreases around x = 0.05 due to the coexistence of magnetic secondary phases.