• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.21 no.6
• /
• pp.70-86
• /
• 2022

An autonomous demand-responsive bus with mobility-on-demand service is an innovative transport compensating for the disadvantages of an autonomous bus and a demand-responsive bus with mobility-on-demand service. However, less attention has been paid to the quantitative impact assessment of the autonomous demand-responsive bus due to the technological complexity of the autonomous demand-responsive bus. This study simulates autonomous demand-responsive bus trips by reinforcement learning on a microscopic traffic simulation to quantify the impact of the autonomous demand-responsive bus. The Chungju campus of the Korea National University of Transportation is selected as a testbed. Simulation results show that the introduction of the autonomous demand-responsive bus can reduce the wait time of passengers, average control delay, and increase the traffic speed compared to the results with fixed route bus service. This study contributes to the quantitative evaluation of the autonomous demand-responsive bus.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.23 no.5
• /
• pp.308-321
• /
• 2024

The government aims to commercialize Level 4 autonomous buses and shuttles by 2025, expanding the demonstration of Level 3 autonomous buses on urban streets, where various factors affecting the driving conditions raise safety concerns. This study used actual driving data from autonomous buses in Pangyo to identify the disengagement locations and analyzed the static and dynamic road environment factors. The results showed that the disengagement of autonomous buses frequently occurs near intersections and bus stops, with those at the bus stops due primarily to operational procedures requiring driver intervention. Excluding these, the analysis identified crosswalks and driveways as static factors, whereas fog and rain are dynamic factors affecting disengagements. Based on these findings, recommendations were proposed to minimize disengagements, aiming to improve the operational safety of autonomous buses in Korea and address upcoming challenges.

• Journal of Auto-vehicle Safety Association
• /
• v.11 no.3
• /
• pp.19-29
• /
• 2019

Recently, autonomous vehicles have been studied actively. Autonomous vehicles can detect objects around them using their on board sensors, estimate collision probability and maneuver to avoid colliding with objects. Many algorithms are suggested to prevent collision avoidance. However there are limitations of complex and diverse environments because algorithm uses only the information of attached environmental sensors and mainly depends on TTC (time-to-Collision) parameter. In this paper, autonomous driving algorithm using I2V communication-based cooperative sensing information is developed to cope with complex and diverse environments through sensor fusion of objects information from infrastructure camera and object information from equipped sensors. The cooperative sensing based autonomous driving algorithm is implemented in autonomous shuttle bus and the proposed algorithm proved to be able to improve the autonomous navigation technology effectively.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2018.10a
• /
• pp.325-328
• /
• 2018

With the rapid development of autonomous driving technology, commercialization of freight cars and buses as well as passenger cars has come to the near future. As researches for commercialization of autonomous navigation are being actively carried out in various countries around the world, in accordance with the development of technology, this paper proposes a bus adopting a new concept of community driving technology based on C-V2X for more effective autonomous driving of buses do. In order to realize the cluster bus, we propose a more effective cluster bus using C-V2X, which is the core communication of the cluster driving, which is complementary to the existing V2X for inter-vehicle communication and vehicle-to-infrastructure communication.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.60 no.1
• /
• pp.32-36
• /
• 2011

In this study, authors have proposed the autonomous state estimation which has been composed with IEC61850, GPS time synchronization and objective model design concept. The proposed method is able to supervise/correct measurement and communication error from SCADA. The major advantages of the proposed autonomous state estimation are that it is possible to evaluate integrity of data measured and transferred from SCADA, to reduce human intervention and to expense national-size applications such as EMS (Energy Management System), WAMS (Wide Area Monitoring System) or WAPS (Wide Area Protection System). This study addresses the issues related to the operation of the smart grid and proposes a new automated approach to achieve this goal. Through applying the proposed system to IEEE 14-bus test electric system, we prove the possibility of the proposed idea.

• Korean Journal of Agricultural Science
• /
• v.37 no.1
• /
• pp.123-130
• /
• 2010

A steering control system based on CAN(Controller Area Network) for autonomous tractor was developed to reduce duty of a central processing computer and to improve performance of steering control in terms of reduced control interval and error. The steering control system consisted of a SCU (Steering Control Unit), an EHPS system, and a potentiometer. The SCU consisted of an MCU (Micro Controller unit), an A/D converter, and a DC-DC converter, and a PID controller was used to control steering angle. The steering control system was communicated with the computer by CAN-bus. Each actuator and implement was connected to a multi-function board interfacing with the computer through a USB cable. Without CAN, control interval of the autonomous tractor was 1.5 seconds. When the CAN-based steering control system was combined with the autonomous tractor, however, control interval of the integrated system was reduced to those less than 0.05 seconds. When the autonomous tractor was operated with 1.5-s and 0.05-s control cycles at a 0.63-m/s travelling speed, the trajectories were close to straight lines for both of the control cycles. For a 1.34-m/s traveling speed, tractor trajectory was close to sine wave with a 1.5-s control cycle, but was straight line with a 0.05-s control cycle.

• Journal of Korea Society of Industrial Information Systems
• /
• v.27 no.6
• /
• pp.51-58
• /
• 2022

Microcontroller (MCU) is designed to properly utilize each module through programming by connecting various modules to Advanced Microcontroller Bus Architecture (AMBA). General-purpose MCUs are designed for consumers to use them appropriately in their research or industry area. However, in a specific area such as networking and AI autonomous vehicles, it is necessary to design MCU suitable for the field directly. However, there is a significant barrier for most consumers to directly design an MCU. In this paper, we provide a development guideline that can easily design an MCU for education or research purpose. First, we introduce AMBA system with open IPs, and we verify that the module operates properly through AMBA and interrupt operation. Finally, the MCU system is designed as an on-chip.

• 한국ITS학회:학술대회논문집
• /
• 2005.11a
• /
• pp.83-88
• /
• 2005

A transportation problem in Korea is a serious issue that has to be solved urgently in the motor era of 15 million vehicles. Recently ITS has been introduced to improve efficiency of the current roads because an excessive budget and a long term construction are needed to build new roads. Therefore the government enacted the law as of ITS and the in architecture. However, these ITS information services were oriented to mainly vehicles and drivers, not public entities such as bus driver, passengers and so on. Nowadays lots of local autonomous city introduced a public transportation information system (PTIS), and providing useful information for the public. For this PTIS, important design issues are to be focused on detecting and tracking technology of moving bus, and a wireless communication link to transmit the location information. This paper presents design models using several wireless communication methods, and an implementation case using a Wireless packet Data communication Network (WDN) to transmit bus location information at Seoul, Korea.

• Korean Journal of Occupational Health Nursing
• /
• v.23 no.1
• /
• pp.20-27
• /
• 2014

Purpose: This study was conducted to identify the association between emotional labor and job stress in bus drivers, as well as to propose management strategies for job stress. Methods: The study was conducted in February 2013 and involved 182 bus drivers working in the Gyeonggi area. Results: emotional labor was $9.5{\pm}2.34$ on average, and job stress was higher than the median of the same indicator among Korea's workers in the areas of physical environment, job autonomy, and relationship conflicts. Factors that affected job stress was lower if the subjects' Higher values for emotional labor indicated a higher level of job stress. Conclusion: To reduce among drivers, the following measures are necessary: increase the comfort of the driver's seat within the vehicle, provide adequate rest between bus headways, provide comfortable in-house rest facilities, and establish physical training spaces to reduce musculoskeletal disorders as well as programs for reducing back pain. In addition, relationship conflicts may be relieved by increasing job autonomy as much as possible, by granting autonomous control of working hours and bus headways, as well as by banning long work hours. Moreover, various club activities, exercise programs, and counseling programs that workers can be involved in together may be beneficial. This study is significant in that it identified the relationship of the bus drivers' emotional labor and job stress, which has previously been ignored as a research topic. Through its results, this study provides baseline data for the preparation of management strategies that can address the job stress of bus drivers.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.7 no.1
• /
• pp.158-163
• /
• 2003

When the number of disks array systems that contain multiple disk drives, system performance is limited by a bottleneck at a centralized controller at a communication path than uses a bus. A redundant array of inexpensive disks(RAID) consists of many disks to enable high performance and large capacity. We evaluate a scalable architecture called Autonomous network, in which the controller functions are distributed to all disk drives and each disk has autonomy in processing its tasks. Disks drives enable better scalability and more effective utilization of system resources than with a hierarchical system. Autonomous network provided high read/write performance throughput in proportion to the number of disks.