• Journal of the Korean Institute of Landscape Architecture
• /
• v.33 no.6 s.113
• /
• pp.90-97
• /
• 2006

The effects of a green buffer zone to protect a residential area from air pollution from industrial facilities and traffic was examined by analyzing the case of a green buffer zone in the Shiwha industrial complex. The green buffer zone is 175 m wide. The intent was to assess the dispersion patterns of atmospheric air pollutants and the reduction in concentration around the green buffer zone. To measure atmospheric sulfur dioxide$(SO_2)$ and nitrogen dioxide$(NO_2)$ concentration, badge-type passive samplers were used and set up at 76 locations in order to measure the concentration of air pollutants with respect to the spatial dispersion. The weighted mean values of $SO_2\;and\;NO_2$ concentration were $3\~57 ppb\;and\;18\~62 ppb$ and the differences among the green buffer zone, the industrial area and the residential areas were $0.7\~1.1 ppb$. Mean values of atmospheric concentrations of $NO_2$ were similar in industrial and, residential areas and the green buffer zone. Results of the study show that the effect of the green buffer zone on reducing the dispersion of air pollutants was very low. This study also recommends that micro-climate, i.e., wind direction should be considered as a factor for planning and design of green buffer zones.

• Korean Chemical Engineering Research
• /
• v.49 no.6
• /
• pp.835-839
• /
• 2011

The characteristics of torch-type atmospheric pressure plasma and its sterilization effects have been analyzed. The length of plasma flame was varied with the level of applied voltage and the mixture gases composed of argon and oxygen. The effect of plasma flame on the temperature increase of surface treated was limited to $43^{\circ}C$ as a maximum temperature under exposing time of 10 min. The sterilization for E. coli was strongly affected by the applied voltage, the oxygen ratio in the mixture gas and the treatment time. At a high concentration of ozone, the increase of treatment time under the direct contact with plasma flame yields to maximize the effect of the sterilization on E. coli.

• Journal of the Korean institute of surface engineering
• /
• v.36 no.1
• /
• pp.69-73
• /
• 2003

The atmospheric pressure plasma is regarded as an effective method for surface treatments because it can reduce the period of process and doesn't need expensive vacuum apparatus. The performance of non-transferred plasma torches is significantly depended on jet flow characteristics out of the nozzle. In order to produce the high performance of a torch, the maximum discharge velocity near an annular gap in the torch should be maintained. Also, the compulsory swirl is being produced to gain the shape that can concentrate the plasma at the center of gas flow. In this work, the distribution of gas flow that goes out to atmosphere through a plenum chamber and nozzle is analyzed to evaluate the performance of atmospheric pressure plasma torch which can present the optimum design of the torch. Numerical analysis is carried out with various angles of an inlet flow velocity. Especially, three-dimensional model of the torch is investigated to estimate swirl effect. We also investigate the stabilization of plasma distribution. For analyzing the swirl in the plenum chamber and the flow distribution, FVM (finite volume method) and SIMPLE algorithm are used for solving the governing equations. The standard k-model is used for simulating the turbulence.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.29 no.11
• /
• pp.74-81
• /
• 2015

In the measurement of atmospheric static electric field, it is important to know characteristics of corona discharges caused at the tip of test electrode. This paper presents the fundamental data of DC corona discharges that occurred at the tip of a needle-shaped electrode placed in the homogeneous background electric field which simulates the atmospheric static field under thundercloud. The major characteristics of interest for this purpose are the polarity effect of corona discharges and the magnitudes and time intervals of corona current pulses. The experimental set-up consists of the plate-to-plate configuration with a needle-shaped protrusion, DC power supply, and voltage and current measuring devices. As a result of experiments, the polarity dependence of corona pulses is significantly pronounced. The time intervals between successive corona pulses in the negative polarity is much longer than those in the positive polarity. The time intervals for both polarities is drastically decreased as the applied electric field is increased. Also the magnitudes of the positive corona pulses are slightly changed with an increase in applied electric field, but those of the negative corona pulses are linearly increased with increasing the applied electric fields.

• Nuclear Engineering and Technology
• /
• v.53 no.1
• /
• pp.244-252
• /
• 2021

Wind plays an important role in cases of unexpected radioactive pollutant dispersion, deciding distribution and concentration of the leaked substance. The accurate prediction of wind has been challenging in numerical weather prediction models, especially near the surface because of the complex interaction between turbulent flow and topographic effect. In this study, we investigated the characteristics of atmospheric dispersion of radioactive material (i.e. ¹³⁷Cs) according to the simulated boundary layer around the HANARO research nuclear reactor in Korea using the Weather Research and Forecasting (WRF)-Mesoscale Model Interface (MMIF)-California Puff (CALPUFF) model system. We examined the impacts of orographic drag on wind field, stability calculation methods, and planetary boundary layer parameterizations on the dispersion of radioactive material under a radioactive leaking scenario. We found that inclusion of the orographic drag effect in the WRF model improved the wind prediction most significantly over the complex terrain area, leading the model system to estimate the radioactive concentration near the reactor more conservatively. We also emphasized the importance of the stability calculation method and employing the skillful boundary layer parameterization to ensure more accurate low atmospheric conditions, in order to simulate more feasible spatial distribution of the radioactive dispersion in leaking scenarios.

• Journal of The Korean Astronomical Society
• /
• v.51 no.4
• /
• pp.119-127
• /
• 2018

We examine whether the solar eclipse effect is dependent on the geographic conditions under which the geomagnetic field variations are recorded. We concentrate our attention on the dependence of the solar eclipse effect on a number of factors, including, the magnitude of a solar eclipse (defined as the fraction of the angular diameter of the Sun being eclipsed), the magnetic latitude of the observatory, the duration of the observed solar eclipse at the given geomagnetic observatory, and the location of the geomagnetic observatory in the path of the Moon's shadow. We analyze an average of the 207 geomagnetic field variation data sets observed by 100 INTERMAGNET geomagnetic nodes, during the period from 1991 to 2016. As a result, it is demonstrated that (1) the solar eclipse effect on the geomagnetic field, i.e., an increase in the Y component and decreases in the X, Z and F componenets, becomes more distinct as the magnitude of solar eclipse increases, (2) the solar eclipse effect is most conspicuous when the modulus of the magnetic latitude is between $30^{\circ}$ and $50^{\circ}$, (3) the more slowly Moon's shadow passes the geomagnetic observatory, the more clear the solar eclipse effect, (4) the geomagnetic observatory located in the latter half of the path of Moon's shadow with respect to the position of the greatest eclipse is likely to observe a more clear signal. Finally, we conclude by stressing the importance of our findings.

• Atmosphere
• /
• v.20 no.4
• /
• pp.437-449
• /
• 2010

The relocation effect of observation station (REOS) on the homogeneity of seasonal mean of maximum and minimum temperature, diurnal temperature range (DTR) and relative humidity (RH) was investigated using surface observation data and document file. Twelve stations were selected among the 60 stations which have been operated more than 30 years and relocated over one time. The data from Chunpungryeong station were used as a reference to separate the impacts of station relocation from the effects caused by increased green house gases, urbanization, and others. The REOS was calculated as a difference between REOS of relocated station and REOS of reference station. Although the REOS is clearly dependent on season, meteorological elements, and observing stations, statistically significant impacts are found in many stations, especially the environment of observing station after relocation is greatly changed. As a result, homogeneity of seasonal mean of meteorological elements, especially DTR and RH, is greatly reduced. The results showed that the effect of REOS, along with the effect of urbanization, should be eliminated for the proper estimation of climate change from the analysis of long-term observation data.

• Journal of Integrative Natural Science
• /
• v.5 no.4
• /
• pp.220-228
• /
• 2012

District of Korea affected by westerly wind and heavy rainfall is predominantly distributed in the west and south of Honam district. So, this study is becoming a necessity. In this study, it is investigated that the characteristics of heavy rainfall occurred frequently in Honam district along the border of mT airmass after the end of rainy season due to atmospheric instability, lower (850 hPa) convergence and topographic effect. Our results show that heavy rainfall occurred in Honam district along the border of mT airmass results from the appropriate mechanism of the unstable vertical structure and moisture flux in the expansion and contraction of the border of mT airmass. All things considered, the improvement of the predictability of heavy rainfall occurred in Honam district along the border of mT airmass could be possible by the generalization of the results of this study.

• Journal of the Korean Society for Railway
• /
• v.8 no.4
• /
• pp.299-307
• /
• 2005

In general, structural integrity of rolling stock structures should last more than 25 years. During the lifetime corrosive degradation occurs. For structural design and diagnosis, quantitative relationship between corrosive degradation and variation of mechanical properties such as tensile strength and fatigue strength is needed. In this study, first of all we established the atmospheric corrosion test procedure. At regular intervals using specimens of SM490A and SS400 on the atmospheric corrosion test bed, we carried out tensile and fatigue tests. The fatigue strength decreases as the atmospheric corrosion period increases. In addition we studied the effect of post-weld heat treatment on the tensile and fatigue behaviour and performed electrochemical corrosion tests.

• Journal of Environmental Science International
• /
• v.16 no.8
• /
• pp.985-994
• /
• 2007

To investigate the effect of NOx and VOCs(volatile organic compounds) on the generation of high ozone episode, examined the hourly variations of ozone, NOx and VOCs concentrations, and calculated the ozone isopleth about maximum ozone concentrations using OZIPR which was presented by U. S. EPA at three sites in Busan. There was some difference by the sites, but decreasing VOCs concentration was effective for reduction of ozone at 22 July, the episode day of 2005. In the year 2006, the episode day was 8 August and the variations of NOx and VOCs concentration was little than variation of ozone. So it was estimated that the photochemical production of ozone was low than transportation of ozone. And the result of the OZIPR modeling was that decreasing VOCs concentration was effective for reduction of ozone.