• Journal of environmental and Sanitary engineering
• /
• v.16 no.3
• /
• pp.80-86
• /
• 2001

This research was carried out to investigate the effect of microscopic silica matrix coagulation on heavy metals and anion removal in mining wastewater. pH and alkalinity played an important role to coagulate heavy metals such as Al, and Fe and an anion such as ${SO_4}^{2-}$ with silica matrix as well as NaOH. However, the efficiency to form coagulates was much greater in silica matrix-treated wastewater than NaOH-treated one. Fe in wastewater formed coagulation with both silica matrix and NaOH treatments resulting in lowering Fe content in wastewater at above pH 9. For Al removal in wastewater, silica matrix-treated wastewater at above pH 12.3 formed stable coagulate with Al, while NaOH-treated one did not. Alkalinities of 89 and 220 mg/L were required to stabilize silica matrix treated coagulate with Fe and Al, respectively. Reaction time of ten minute was required to provide enough reaction for coagulation between heavy metals and silica matrix. Heavy metals and anion leachates were much lower in coagulate with silica matrix than that with NaOH, which indicates that silica matrix could be used to remove heavy metals efficiently.

• Environmental Engineering Research
• /
• v.18 no.3
• /
• pp.177-189
• /
• 2013

Studies were carried out on the speciation of heavy metals (Zn, Cu, Mn, Fe, Ni, Pb, Cd, and Cr) during rotary drum composting of water hyacinth (Eichhornia crassipes) for a period of 20 days. Five different proportions of cattle manure, water hyacinth and sawdust were prepared for composting. This study concluded that, rotary drum was very efficient for the degradation of organic matter as well as for the reduction of mobility and bioavailability of heavy metals during water hyacinth composting. The results from the sequential extraction procedure of heavy metals shows that rotary drum composting changed the distribution of five fractions of Zn, Cu, Mn, Fe, Ni, Pb, Cd, and Cr. The highest reduction in the bioavailability factors of Pb and Cd was observed during the process. The total concentration of Cu, Cr, and Cd was very low compared to the other metals (Zn, Mn, Fe, Ni, and Pb); however, the percentage of exchangeable and carbonate fractions of these metals was similar to other metals. These results confirmed that the bioavailability of metals does not depend on the total concentration of metals. From this study, it can be concluded that the addition of an appropriate proportion of cattle manure significantly reduced the mobile and easily available fractions (exchangeable and carbonate fractions) during water hyacinth composting in rotary drum.

• Journal of Environmental Health Sciences
• /
• v.15 no.1
• /
• pp.33-49
• /
• 1989

Pollution in the rivers has received considerable attention in recent years, particullary with reference to the effect due to increasing concentration of heavy metals. The metals are toxic to the ecosystem as a whole and to man in particular, since he is at the end of a variety of food chains by virture of his varigated diet. In addition, numerous laboratory tests have established that certain metals, such as Cd, pose a threat to a wide variety of aquatic organisms at concentrations as low as a few $\mu$g/1. Before the biological effects of heavy metals in impacted ecosystems can be completely assessed, however it is necessary to provide data on the concentration of heavy metals in such systems. This study was performed to investigate the concentration level of heavy metals in water, fish and sediments from upstream ($S_1-S_4$) to downstream ($S_5-S_9$) of the Mankyung river. Samples of water, fish, and sediments were collected along the tributaries of the Mankyung from September to October in 1987 and analyzed for lead, cadmium, copper, and zinc by atomic absorption spectrophotometer. From the data presented in this study, we can infer that the concentrations of the heavy metals investigated both in water and sediments are similar to those found in literature for unpolluted regions. The results obtained from the analysis of the edible tissue of the C. auratus show low concentration levels of the four heavy metals investigated. We conclude that the area is still relatively unpolluted and recommended continuing the monitoring of heavy metal concentrations to improve our understanding of their cycle in the river environment.

• Journal of Environmental Health Sciences
• /
• v.43 no.3
• /
• pp.176-184
• /
• 2017

Objectives: Excluding in their homes, children spend most of their time at an elementary school, daycare center, and/or kindergarten. For educational or recreational purposes, they make use of many children's goods at these places. Some children's goods contain phthalates and heavy metals with polyvinyl chloride (PVC), so due to their physiological and behavioral characteristics children are exposed to high concentrations of phthalates and heavy metals. This study aims to measure PVC and heavy metals, which are harmful substances in children's goods which can have an effect on children's health. Methods: Six samples of children's goods were selected through cases of detected harmful substances and the results of previous research, including assembly blocks, model toys, household toys, bags, indoor play equipment, and floor mats. The selected items were measured using X-Ray Fluorescence (XRF), and the presence and content of environmentally harmful substances such as PVC or heavy metals in the materials of children's goods were examined. Results: The highest detection rate for PVC was observed in floor mats, and bags and indoor play equipment were higher than other goods in this regard. The highest detection rate for heavy metals was found in bags, followed by indoor play equipment, assembly blocks, household toys, model toys and floor mats. Except for bags containing heavy metals, five goods showed the highest level of Pb compared to other heavy metals. Floor mats contained the highest level of Pb, Cr, and Cu among all goods. Conclusion: Many children's goods contain PVC and heavy metals, and high levels of heavy metals have been detected in some goods. It is necessary to manage children's goods to support their health.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2003.09a
• /
• pp.56-63
• /
• 2003

Fractional composition and mobility of sediments some heavy metals in Okdong stream are investigated. The fractional scheme for sediment heavy metal was made for five chemically defined heavy metal forms as adsorbed fraction, carbonate fraction, reducible fraction, organic fraction, and residual fraction (Tessier et at., 1979). The most abundant fraction of the sediment heavy metal is reducible and secondly abundant organic fraction. Adsorbed fraction is minor part of the total heavy metals. Mobilization of sediment heavy metals in stream Okdong is occur 19.8∼56.7% of total cadmium concentrate. The most abundant fraction of the sediment metal is organic fraction in Cu, Pb metals investigated. Labile fraction of sediment metals are 0.5%∼48.5% of total Zn, 2.6%∼48.1% of total Pb, 0.2∼36.9% of total Cu respectively, Most of labile fraction consists of reducible fraction for Cd, Zn, adsorbed fraction for Pb, reducible fraction for Cu, adsorbed fraction for Ni. The Mobilization of Zn and Cu is most likely to occur when oxygen depletes and that of Pb and Ni occurs when physical impact, oxygen depletion and pH reduction.

• KSBB Journal
• /
• v.13 no.3
• /
• pp.279-283
• /
• 1998

To investigate the feasibility of the microbial process for removal of heavy metals from the high solid content sludge, the effect of sludge concentration on the solubilization of heavy metals by an iron oxidizing bacterium Thiolbacillus ferrooxidans was examined. With increasing the sludge concentration, the removal efficiency of heavy metals and the oxidation rate of iron were inhibited. Especially, when the sludge concentration is over 5% (w/v), the activity of T. ferrooxidans was remarkably inhibited. This inhibition is considered to occur due to the dissolved inhibitory materials such as organic compounds, heavy metals, and others which were extracted from the sludge during incubation period. In conclusion, the microbial process by T. ferrooxidans is only effectively used in ranges of 1.3 to 4.0% (w/v) sludge concentration.

• Journal of Korean Society of Environmental Engineers
• /
• v.27 no.8
• /
• pp.787-798
• /
• 2005

The objectives of this study were to assess extraction kinetics of heavy metals with extraction times and to assess extraction efficiencies of heavy metals with concentrations and kinds of washing solutions. Target materials were obtained from disused metal mines. Washing solutions were water, HCl(0.1, 0.3, 1.0 N), EDTA(0.01, 0.05, 0.1 M), and sodium dodecyl sulfate(SDS, 0.1. 0.5, 1.0%). Extraction efficiencies of heavy metals by water and SDS were below 1%, and extraction efficiencies of Zn and Cd were higher than those of Pb and Cu. As results, water and SDS were not effective in extracting heavy metals from mine tailings as washing solution, but extraction efficiencies of Pb and Cu with SDS solution increased as extraction time increased. Extraction kinetics of heavy metals with HCl and EDTA were faster than those with water and SDS. The majority of heavy metals were extracted within 6 hours, and extraction kinetics was almost independent of the solution concentration. Extraction kinetics of heavy metals after 6 hours was slow, but extraction kinetics was dependent on the solution concentration. Also, as concentrations of HCl and EDTA solution were stronger, heavy metals were extracted rapidly and extraction efficiencies were increased. The extraction efficiency was high in order of Cd>Pb>Zn>Cu in using 1.0 N HCl, and Pb>Cd>Zn>Cu in using 0.1 M EDTA. Consequently, extraction effectiveness was highest for Pb in using HCl, and for Pb and Cd in using EDTA with concentration increase. Extraction time of over 6 hours was not effective in extracting heavy metals.

• Environmental Engineering Research
• /
• v.13 no.2
• /
• pp.79-84
• /
• 2008

Adsorption of heavy metals by sawdust was investigated to evaluate the effectiveness of using sawdust to remove heavy metals from aqueous solutions. Kinetic and isotherm studies were carried out by considering the effects of initial concentration and pH. The adsorption isotherms of heavy metals fitted the Langmuir or Freundlich model reasonably well. The adsorption capacity of metal was in the order $Pb^{2+}$ > $Cu^{2+}$ > $Zn^{2+}$. A high concentration of co-existing ions such as $Ca^{2+}$ and $Mg^{2+}$ depressed the adsorption of heavy metal. Adsorption data showed that metal adsorption on sawdust follows a pseudo-second-order reaction. Kinetic studies also indicated that both surface adsorption and intraparticle diffusion were involved in metal adsorption on sawdust. Column studies prove that sawdust could be effective biosorbent for the removal of heavy metals from aqueous phase.

• Journal of Environmental Science International
• /
• v.15 no.11
• /
• pp.1053-1059
• /
• 2006

This study was performed to investigate the possible uses of waste sludge for the removal of heavy metal ions. The adsorption experiments were conducted with wastes such as sewage treatment sludge, water treatment sludge and oyster shell to evaluate their sorption characteristics. Heavy metals selected were cadmium, copper and lead. in the sorption experiments on the sewage treatment sludge, water treatment sludge, oyster shell and soil, sorption occurred in the beginning and it reached equilibrium after 40 minutes on the oyster shell and 4 hour on the sewage treatment sludge and water treatment sludge. Results of Freundlich isotherms indicated that sewage treatment sludge could be properly used as an adsorbent for heavy metals and sorption strength of heavy metals was in the order of Pb > Cu > Cd. In the influence of pH on the adsorbents, sorption rate was more than 80% in pH 4 and most of heavy metals were adsorbed in pH 9. Adsorption rate of Cd decreased with decreasing pH and then adsorption rate of Cu was lower in soil.

• Journal of the Korean Chemical Society
• /
• v.57 no.3
• /
• pp.316-321
• /
• 2013

Electrocoagulation (EC) technique is applied for the treatment of wastewater containing heavy metals ions such as nickle (Ni), lead (Pb) and cadmium (Cd) by using sacrificial anodes corrode to release active coagulant flocs usually aluminium or iron cations into the solution. During electrolytic reactions hydrogen gas evolve at the cathode. All the experiments were carried out in Batch mode. The tank was filled with synthetic wastewater containing heavy metals and efficiency of electro-coagulation in combination with aluminum and iron electrodes were investigated for removal of such metals. Several parameters, such as contact time, pH, electro-coagulant concentration, and current density were optimized to achieve maximum removal efficiency (%). The concentrations of heavy metals were determined by using Atomic Absorption Spectroscopy (AAS). It is found that the electro-coagulation process has potential to be utilized for the cost-effective removal of heavy metals from wastewater specially using iron electrodes in terms of high removal efficiencies and operating cost.