• 전기학회논문지
• /
• 제61권11호
• /
• pp.1668-1670
• /
• 2012

In this paper, a satellite array antenna operates at 12.2GHz~12.75GHz was designed and fabricated. The lowest height and high gain electrical beam tilt was obtained by applying backed slot and sub-reflector widening the distance between the patch and the GND. The simulation and measurement showed good agreements, the electrical beam tilt was $10^{\circ}$, the gain was 26.5dBi, the VSWR was less than 3:1 and the return loss was less than -15dB.

• 태양에너지
• /
• 제19권3호
• /
• pp.85-91
• /
• 1999

This study represented experimental research on the flat-plate solar collector. The heat performances were measured the tube array surface temperature by thermal-couple. The solar collector($W{\times}H$) of $580{\times}1100$, various tilt angles of 30, 45, 60 degree and the internal tube number of 4, 6, 8, 10(ea) were utilized in the present investigation. It is found that the thermal concentration is higher as the tilt angle become larger and the solar tubes are more and more. In this stuby obtained results of following: The array of tubes in collector has the best nice in that the number of tube is eight and the tilt angle is 60 degree. The collect energy by each tube array shown high value by increase the number of tubes and tilt angles. In addition to, the collect energy depends on by the tilt angle than the number of tube.

• 전기학회논문지
• /
• 제62권5호
• /
• pp.712-716
• /
• 2013

In solar generation, the PV array's azimuth is headed due south and the tilt is generally $33^{\circ}$ in order to acquire maximum generation. However, when installed in a site where there are buildings or other facilities, the azimuth and tilt are adjusted. Yet, when the azimuth and tilt are deviated from due south and $33^{\circ}$, the generation quantity is decreased substantially and currently a method to estimate the decreasing proportion is unavailable. Therefore, in this thesis, an equation on the "change ratio of solar radiation due to the changes in tilt and azimuth" was deduced by utilizing empirical data on the amount of solar radiation received according to the changes of tilt and azimuth and Interpolation. By using this equation, the decreasing proportion of generating quantity due to the installation methods of PV system can be estimated, therefore, it can be usefully utilized when designing and going through feasibility studies for development of solar generation systems.

• 한국통신학회논문지
• /
• 제23권6호
• /
• pp.1419-1424
• /
• 1998

고도각 주사 위상배열안테나에서 감지기 수는 안테나의 가격과 무게를 낮추는 중요한 요소 가운데 하나이다. 따라서, 배열요소 사이 거리와 관계가 있는 안테나 기움각은 매우 중요한 설계 매개변수이다. 이 논문에서는 몇몇 균일 배열안테나와 비균일 배열안테나에 대한 정확한 최적 기움각을 이론적으로 얻어 본다. 네 가지 균일 선형 배열안테나를 생각하고 비균일 여기 배열안테나로는 체비셰프 배열요소를 생각한다.

• Current Optics and Photonics
• /
• 제6권3호
• /
• pp.332-336
• /
• 2022

Given a cubic space, it is easy to uniformly illuminate the floor with light sources placed on top. However, little has been reported about uniform illumination on walls with the same configuration of light sources. Here we present a luminaire consisting of nine light-emitting diodes (LEDs) with perfect Lambertian distribution, placed on the top as a 3 × 3 rectangular LED array. The distances between LEDs and tilt angles of each individual LED are adjustable and optimized by an annealing algorithm. After optimization, the array produces a rectangular illumination pattern on one wall with a uniformity of about 89%. Analysis shows that the tilt angles of individual LEDs are key parameters for uniform side illumination. In a scenario that is more practical, the tilt angles of all the LEDs are set to be the same, only decreasing the uniformity to 83%.

• 한국음향학회지
• /
• 제43권4호
• /
• pp.455-465
• /
• 2024

천해역에서 효과적인 거리추정 방법으로 알려진 배열 불변성은 도파관 불변성으로 요약될 수 있는 이상적인 도파관 내에서의 광대역 확산 특징을 기반으로 개발되었으며, 배열 기울기가 존재하는 상황에서도 배열 기울기와 거리를 동시에 추정할 정도로 강인하다. 최근에는 도파관 불변성의 각도 종속성을 완전히 고려할 수 있도록 확장되었다. 하지만, 거리-종속 환경에 대해 거리-독립 환경의 배열 불변성 기법을 적용한다면, 해저 지형 오정합에 의해 거리추정오차가 발생하게 된다. 본 논문에서는 이러한 거리추정 오차를 상응 거리 개념을 도입하여 해석하고자 한다. 거리-종속 환경에서의 수치 시뮬레이션 수행과 해상 실험 데이터를 통해 거리추정의 오차와 상응 거리 사이의 관계를 입증하였다.

• 한국태양에너지학회 논문집
• /
• 제37권6호
• /
• pp.69-77
• /
• 2017

The amount of solar irradiation obtained by a photovoltaic (PV) solar panel is the major factor determining the power generated by a PV system, and the array tilt angle is critical for maximizing panel radiation acquisition. There are three types of PV systems based on the manner of setting the array tilt angle: fixed, semi-fixed, and tracking systems. A fixed system cannot respond to seasonal solar altitude angle changes, and therefore cannot absorb the maximum available solar radiation. The tracking system continually adjusts the tilt angle to absorb the maximum available radiation, but requires additional cost for equipment, installation, operation, and maintenance. The semi-fixed system is only adjusted periodically (usually seasonally) to obtain more energy than a fixed system at an overall cost that is less than a tracking system. To maximize semi-fixed system efficiency, determining the optimal tilt angle adjustment schedule are required. In this research, we conducted a simulation to derive an optimal operation schedule for a semi-fixed system in Seoul, Korea (latitude $37.5^{\circ}$). We implemented a solar radiation acquisition model and PV genereation model on MATLAB. The optimal operation schedule was derived by changing the number of tilt angle adjustments throughout a year using a Dynamic Algorithm. The results show that adjusting the tilt angle 4 times a year was the most appropriate. and then, generation amount of PV system increased 2.80% compared with the fixed system. This corresponds to 99% compared to daily adjustment model. This increase would be quite valid as the PV system installation area increased.

• Journal of the Optical Society of Korea
• /
• 제13권4호
• /
• pp.451-455
• /
• 2009

We present a numerical procedure that compensates for tilt phase aberration in in-line digital holography by computing the period of interference patterns in the reconstructed phase image. This method enables the reconstruction of correct and accurate phase information, even if strong tilt aberrations exist. Example applications of tilt aberration compensation are shown for a tilted plate, a micro-lens array, and a thin film transistor. This method is convenient because it uses only one hologram and no hardware to minimize the tilt aberration.

• 한국통신학회:학술대회논문집
• /
• 한국통신학회 1998년도 하계종합학술발표회 논문집(하)
• /
• pp.718-721
• /
• 1998

• 한국통신학회:학술대회논문집
• /
• 한국통신학회 1998년도 추계종합학술발표회 논문집(상)
• /
• pp.784-787
• /
• 1998