• Proceedings of the KSRS Conference
• /
• 1998.09a
• /
• pp.319-324
• /
• 1998

Ocean Scanning Multispectral Imager (OSMI) is a payload on the Korean Multi-purpose SATellite (KOMPSAT) to perform worldwide ocean color monitoring for the study of biological oceanography. The instrument images the ocean surface using a whisk-broom motion with a swath width of 800 km and a ground sample distance (GSD) of < 1 km over the entire field-of-view (FOV). The instrument is designed to have an on-orbit operation duty cycle of 20% over the mission lifetime of 3 years with the functions of programmable gain/offset and on-board image data storage. The instrument also performs sun calibration and dark calibration for on-board instrument calibration. The OSMI instrument is a multi-spectral imager covering the spectral range from 400 nm to 900 nm using a CCD Focal Plane Array (FPA). The ocean colors are monitored using 6 spectral channels that can be selected via ground commands after launch. The instrument performances are fully measured for 8 basic spectral bands centered at 412nm, 443nm, 490nm, 510nm, 555nm, 670nm, 765nm and 865nm during ground characterization of instrument. In addition to the ground calibration, the on-board calibration will also be used for the on-orbit band selection. The on-orbit band selection capability can provide great flexibility in ocean color monitoring.

• Journal of Biomedical Engineering Research
• /
• v.20 no.2
• /
• pp.205-212
• /
• 1999

When we want to observe and record a patient's EEG in an operating room, the operation of electrosurgical unit(ESU) causes undesirable artifacts with high frequency and high voltage. These artifacts make the amplifiers of the conventional EEG system saturated and prevent the system from measuring the EEG signal. This paper describes a high-performance bipolar EEG amplifier for a CSA (compressed spectral array ) system with reduced ESU artifacts. The designed EEG amplifier uses a balanced filter to reduce the ESU artifacts, and isolates the power supply and the signal source of the preamplifier from the ground to cut off the current from the ESU to the amplifier ground. To cancel the common mode noise in high frequency, a high CMRR(common mode rejection ratio) diffferential amplifier is used. Since the developed bipolar EEG amplifier shows high gain, low noise, high CMRR, high input impedance, and low thermal drift, it is possible to observe and record more clean EEG signals in spite of ESU operation. Therefore the amplifier may be applicable to a high-fidelity CSA system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.7
• /
• pp.1347-1353
• /
• 2015

We implemented a 10 Gb/s 4-channel vertical cavity surface emission lasers (VCSEL) driver array in a $0.13{\mu}m$ CMOS process technology. To enhance high current resolution, power dissipation, and chip space area, digital APC/AMC with time division sensing technology is primarily adopted. The measured -3 dB frequency bandwidth is 9.2 GHz; the small signal gain is 10.5 dB; the current resolution is 0.01 mA/step, suitable for the wavelength operation up to 10 Gb/s over a wide temperature range. The proposed APC and AMC demonstrate 5 to 20 mA of bias current control and 5 to 20 mA of modulation current control. The whole chip consumes 371 mW of low power under the maximum modulation and bias currents. The active chip size is $3.71{\times}1.3mm^2$.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38B no.6
• /
• pp.427-434
• /
• 2013

In this paper, the design and layout of a 2.5 Gbps arrayed VCSEL driver for optical transceiver having arrayed multi-channel of integrating module is confirmed. In this paper, a 4 channel 2.5 Gbps VCSEL (vertical cavity surface emitting laser) driver array with automatic optical power control is implemented using $0.18{\mu}m$ CMOS process technology that drives a $1550{\mu}m$ high speed VCSEL used in optical transceiver. To enhance the bandwidth of the optical transmitter, active feedback amplifier with negative capacitance compensation is exploited. We report a distinct improvement in bandwidth, voltage gain and operation stability at 2.5Gbps data rate in comparison with existing topology. The 4-CH chip consumes only 140 mW of DC power at a single 1.8V supply under the maximum modulation and bias currents, and occupies the die area of $850{\mu}m{\times}1,690{\mu}m$ excluding bonding pads.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.36S no.10
• /
• pp.10-20
• /
• 1999

In this paper, we propose and analyze a multiuser receiver using a decorrelating filter and Viterbi decoders for trellis coded DS/CDMA systems with biorthgonal signal constellation in asynchronous channels. The biorthogonality is implemented by user signature waveforms and the decorrelating filter. The performance of the proposed system is investigated with emphasis on the asymptotic cases. It is shown that the proposed system can provide us with some coding gain and near-far resistance. We also analyze the performance of the proposed system with base-station antenna array.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.2
• /
• pp.199-207
• /
• 2011

A Ku-band low noise amplifier has been designed and fabricated by using 0.25 um SiGe BiCMOS process. The developed Ku-band LNA RFIC which has been designed with hetero-junction bipolar transistor(HBT) in the BiCMOS process have noise figure about 2.0 dB and linear gain over 19 dB in the frequency range from 9 GHz to 14 GHz. Optimization technique for p-tap value and electro-magnetic(EM) simulation technique had been used to overcome the inaccuracy in the PDK provided from the foundry service company and to supply the insufficient inductor library. The finally fabricated low noise amplifier of two fabrication runs has been implemented with the size of $0.65\;mm{\times}0.55\;mm$. The pure amplifier circuit layout with the reduced size of $0.4\;mm{\times}0.4\;mm$ without the input and output RF pads and DC bais pads has been incorporated as low noise amplication stages in the multi-function RFIC for the active phased array antenna of Ku-band satellite VSAT.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.28 no.6
• /
• pp.501-504
• /
• 2017

In this paper, a hybrid beamforming antenna system using broadband butler matrix and phase shifter is proposed. In the previous works, an $8{\times}8$ butler matrix is used to overcome a drawback of the $4{\times}4$ butler matrix based switched beamforming which provides only 4 beam patterns. However the $8{\times}8$ butler matrix should be designed on the bi-layered substrate using via holes due to its complex structure. It causes performance degradation. To overcome these problems, the proposed hybrid beamforming antenna system is designed on the single side of the substrate for simple structure. By addition of two phase shifter, it provide various beam patterns. The proposed antenna system provides more than 10 dBi radiation gain in the ${\pm}45^{\circ}$ scanning range by 16 input combinations.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.12 no.4
• /
• pp.28-34
• /
• 1975

텔레비젼 수신용 안테나로써 가장 널리 사용되고있는 Yagi안테나는 구조가 간단하고 지향성 이득등이 좋으나 방사주파수에 대한 반파장길이의 소자를 사용하므로 칫수가 커지고 주파수대역이 좁다. 따라서 설치 취급등에 불편을 느낄 경우가 많다. 한편 최근 일반적으로 아무곳에서나 용이하계 설치할 수 있을만큼 소형이면서 화질이 좋은 수상이 가능한 수신안테나에 대한 요망이 커지고 있는데 본 연구에서는 그 파장에 비해서 소형인 폴디드·다이폴 안테나 소자 2개를 좁은 간격으로 배열하고 이들을 이상결합하므로써 VHF텔레비젼전파의 고채널 주파수대에서 비교적 양한 단일지향성을 얻고 있다. 본 안테나에 능동소자를 이용한 저잡음광대역증폭기를 삽입한다면 다소자 Yagi안테나에 비나될 전후방비를 갖는위에 그의 이득도 크게 증가되어 일반수상안테나로 뿐만 아니라 고우스트 방지용실내안테나로서 상당한 기여틀 할것으로 생각된다. The Yagi antenna, which is most widely used for television receiving, has simple form and good directiyity as well as high gain, but it must be made with linear elements of half wave length. Therefore, the dimension of multi-element Yagi antenna becomes bulky and so a(ten it is inconvenient to install and handle, because of its big size. Moreover the frequency band width of the Yagi antenna is usually not broad enough to cover the total frequency range of VHF TV channels in our country. Recently, the aemand for an antenna which is not only small enough to install it easily anywhere but also assures good quality of pictures is generally increasing. In this study 2 elements o( folded dipole, which is small compared to its electrical ways length, are fixed parallel to each other with a narrow distance and the emfs induced in them are made to get together with some phase difference. This new phased array antenna has shown a relatively good unidirectivity through over the high channel VHF television frequency hand as well as the good PIB ratio which is comparable to that of multielements Yagi antenna. As a result this new antenna will be used as a VHF high channel TV receiving antenna and it may become better antighost antenna when used inside the room than other room antennas.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.12
• /
• pp.34-41
• /
• 2008

In this paper, we present an asymptotical analysis of channel capacity of Bell labs layered space-time (BLAST) architectures based on a zero-forcing (ZF) criterion in the sense of signal-to-noise ratio (SNR). We begin by introducing a new relationship related to multi-input multi-output (MIMO) channel capacity. We prove that Diagonal Bell Labs Space-Time (DBLAST) attains the lower bound for MIMO channels when interference nulling is carried out based on the ZF-criterion. An exact closed-form expression for the probability density function of the channel capacity is analyzed. Based on the asymptotic behavior of the channel capacity of each layer, closed-form expressions for the asymptotic ergodic capacity are derived for BLAST. Based on the analysis presented in this paper, we gain an insight on the channel capacity behavior for a MIMO channel. Computer simulation results have verified the validity and accuracy of the proposed analysis for a wide range of antenna array sizes.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.7
• /
• pp.81-88
• /
• 2004

In case of mechanical down tilting, a horizontal pattern is distorted and beam width widens whenincreasing tilt angle, which causes an expansion of hand off region and burden base station equipment. In contrast, electrical down tilting has advantage that horizontal HPBW is kept constant with down tilting. In this paper, based on a phased array technology, dual polarized base station antenna with electrical down tilting was developed at 800MHz band. The antenna has down tilting range of 0$^{\circ}$ to 14$^{\circ}$, and 15㏈i gain. We use stacked microstrip patch as a radiated element and apply balanced feed technique to improve isolation between ports and discrimination of cross polarization. The effect of electrical down tilting was verified by field test.