• Proceedings of the KIPE Conference
• /
• 2008.06a
• /
• pp.241-243
• /
• 2008

In this paper, dynamic overmodulation strategies are proposed for two phase full bridge inverter. The four step operation to use maximum voltage in limited DC link is described and minimum distance, same angle and minimum switching state overmodulation techniques are presented. The simple scalar arithmetic based algorithms are proposed to implement the overmodulation techniques. Simulation results demonstrate the effectiveness of the proposed algorithms.

• Proceedings of the KIEE Conference
• /
• 2005.07d
• /
• pp.2967-2969
• /
• 2005

2003년에 영상압축의 표준으로 제시된 H.264/AVC의 압축성능은 대부분 Context-based Adaptive Binary Arithmetic Codes (CAHAC)라는 새로운 엔트로피 코딩에 기인한 것이다. 그러나, CABAC의 뛰어난 성능에도 불구하고 복잡한 처리과정 때문에 하드웨어로 구현하기가 상당히 곤란하다. 곱셈기가 없는 알고리즘임에도 불구하고 영역(range), 오프셋(offset), 그리고 컨텍스트 변수들(context varivales)을 순차적으로 구해야 하기 때문이다. 이 논문에서는 한번에 최대 두 비트를 디코딩 할 수 있는 예측기법을 통하여 CARAC의 전체적인 디코딩 시간을 줄일 수 있는 방법을 제안한다. 한 비트를 디코딩하기 위해서는 두 개의 심볼(a set of binary symbols)에 대한 확률분포를 사전에 알아야 하지만, 제안된 방법에서는 두 비트를 동시에 디코딩할 수 있도록 네 개의 심볼(two sets of binary symbols)에 대한 확률 분포를 예측하여 디코더에 제공한다. 제안된 예측기법을 CABAC 디코더에 적용한 결과, 기존보다 10-13%의 복호시간을 단축하는 효과를 가졌다. 논문에서 제안된 예측기법을 통한 고속디코더의 구현은 확률을 기반으로 하는 신호처리에 사용되어 고속의 시스템을 구성하는데 효과적으로 적용될 수 있다.

• Proceedings of the KIPE Conference
• /
• 1998.11a
• /
• pp.5-8
• /
• 1998

The adaptation to vector control theory is so generalized that it is widely used for implementing the high-performance of AC machine. Nowadays, One-Chip microprocessors or DSP chips are being well-used to implement Vector Control algorithm. DSP Chip have less flexibility for memory decoding and I/O rather than One-Chip microprocessor so that is requires more additional circuit and high cost. And the past One-Chip micro processors have difficult of implementation the complex algorithm because of small memory capacity and low arithmetic performance. Therefore we implemented the vector control algorithm of PMSM(Permanent Magnetic Synchronous Motors) using 80296SA form intel , which have many features as 6M memory space, 500MHz clock frequency, including memory decoding circuit and general I/O, Special I/O(EPA, Interrupt controller, Timer/Count, PWM generator) which is proper controller for the complex algorithm or operation program requiring so much memory capacity, So in this paper we fully digitized the vector control of PMSM included SVPWM Voltage controller using the intel 80296SA

• Journal of Korea Multimedia Society
• /
• v.17 no.4
• /
• pp.466-477
• /
• 2014

Many image hiding schemes based on least significant bit (LSB) transformation have been proposed. One of the LSB-based image hiding schemes that employs diamond encoding was proposed in 2008. In this scheme, the binary secret data is converted into base n representation, and the converted secret data is concealed in the cover image. Here, we show that this scheme has two vulnerabilities: noticeable spots in the stego-image, i.e., a non-smooth embedding result, and inefficiency caused by rough re-adjustment of falling-off-boundary value and impractical base translation. Moreover, we propose a new scheme that is efficient and produces a smooth and high quality embedding result by restricting n to power of 2 and using a sophisticated re-adjustment procedure. Our experimental results show that our scheme yields high quality stego-images and is secure against RS detection attack.

• Journal of Institute of Control, Robotics and Systems
• /
• v.19 no.10
• /
• pp.879-885
• /
• 2013

By performing interval analysis on the system transfer function, we propose an improved method of control loop design for a DC/DC converter. In conventional design methods, the effect of system parameter change due to the specified range of operating conditions and production tolerances in power components should be checked a posteriori, because this may result in a transfer function shift and performance degradation. In the proposed method, a possible parameter change is considered a priori in the design step in order that the desired crossover frequency and sufficient phase margin can be achieved even in the worst case condition. As an illustrative example, a buck dc/dc converter is designed by two different methods and performance comparisons are performed to verify the feasibility of the proposed scheme.

• Proceedings of the IEEK Conference
• /
• 2002.07c
• /
• pp.2067-2070
• /
• 2002

In this paper, a VLSI architecture for transform and quantization module, which consists of 2D-DCT, quantization, AC/DC prediction block, scan conversion, inverse quantization and 2D-IDCT, is presented. The architecture of the module is designed to handle a macroblock data within 1064 cycles and suitable for MPEG-4 video codec handling CIF image formats. Only single 1-D DCT/IDCT cores are used for the design instead of 2-D DCT/IDCT, respectively. 1-bit serial distributed arithmetic architecture is adopted for 1-D DCT/IDCT to reduce the hardware area in this architecture. As the result, the maximum utilization of hardware can be achieved, and power consumption can be minimized. The proposed design is operated on 27MHz clock. The experimental results show that the accuracy of DCT and IDCT meet the IEEE specification.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.13-14
• /
• 2006

In this paper, an efficient butterfly structure for Radix-4 FFT algorithm using DA(Distributed Arithmetic) is proposed. It is shown that DA can be efficiently used in twiddle factor calculation of the Radix-4 FFT algorithm. The Verilog-HDL coding results for the proposed DA butterfly structure show 61.02% cell area reduction comparison with those of the conventional multiplier butterfly structure. Furthermore, the 64-point Radix-4 pipeline structure using the proposed butterfly and delay commutators is compared with other conventional structures. Implementation coding results show 46.1% cell area reduction.

• Proceedings of the KIEE Conference
• /
• 1998.11b
• /
• pp.575-578
• /
• 1998

In this paper, we propose a VLSI architecture of Reed-Solomon decoder. Our goal is the development of an architecture featuring parallel and pipelined processing to improve the speed and low power design. To achieve the this goal, we analyze the RS decoding algorithm to be used parallel and pipelined processing efficiently, and modified the Euclid's algorithm arithmetic part to apply the parallel structure in RS decoder. The overall RS decoder are compared to Shao's, and we show the 10% area efficiency than Shao's time domain decoder and three times faster, in addition, we approve the proposed RS decoders with Altera FPGA Flex 10K-50, and Implemeted with LG 0.6{\mu}$ processing.

• Proceedings of the IEEK Conference
• /
• 2007.07a
• /
• pp.85-86
• /
• 2007

In this paper, a Radix-8 structure for high-speed FFT is proposed. Even throughput of the Radix-8 FFT is twice than that of the Radix-4 FFT, implementation area of the Radix-8 is larger than that of Radix-4 FFT. But, implementation area of the proposed Radix-8 FFT was reduced by using DA(Distributed Arithmetic) for multiplication. The Verilog-HDL coding results for the proposed FFT structure show 49.2% cell area increment comparison with those of the conventional Radix-4 FFT structure. Namely, to speed up twice, 49.2% of area cost is required. In case of same throughput, power consumption of the proposed structure is reduced by 25.4%.

• Proceedings of the IEEK Conference
• /
• 2007.07a
• /
• pp.263-264
• /
• 2007

In this paper, an efficient SAD(Sum of Absolute Differences) processor structure for motion estimation of 0.264 is proposed. SAD processors are commonly used both in full search methods for motion estimation or in fast search methods for motion estimation. Proposed structure consists of SAD calculator block, combinator block, and minimum value calculator block. Especially, proposed structure is simplified by using Distributed Arithmetic for addition operation. The Verilog-HDL(Hard Description Language) coding and FPGA implementation results for the proposed structure show 39% and 32% gate count reduction comparison with those of the conventional structure, respectively. Due to its efficient processing scheme, the proposed SAD processor structure can be widely used in size dominant H.264 chip.