• Journal of the Korea Institute of Military Science and Technology
• /
• v.11 no.5
• /
• pp.92-98
• /
• 2008

Chaff is one of important devices for heliborne protection from radars and missiles. When we use a chaff for heliborne protection, J/S(jamming signal of chaff vs reflected signal from heliborne) is important factor to analyze a heliborne survive. When the radial angle between missile and heliborne is changed, J/S of missile receiver is changed and jamming effectiveness of chaff is also changed. We calculate the RCS of chaff and heliborne, and compare the returned signals in a half power beam width of receiver antenna. We analyze chaff dispense modes and specially simulate the effectiveness of a dilution mode chaff between missile and heliborne.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.16 no.9
• /
• pp.819-827
• /
• 1991

In this study, the efficiency of spectrum utilization has compared in case of channel spacking 100 KHz and 200 KHz by application of technical specifications of domestic FM broadcasting varing with effective radiated power, terrain irregularity factor and effective height of thrnsmit antenna. The results show that if arranging by 100 KHz channel total number of available channel will increase twice and the efficiency of spectrum unilization will be better 1.36 to 2.0 times than that of 200 KHz channel spacing.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.202-202
• /
• 2011

Diagnostics of plasma density is a key factor for monitoring plasma processing. Various probes are invented to measure plasma density and cut-off probe is a one of the most promising diagnostics tool for measuring plasma density. However, at the low density or high pressure the cut-off probe cannot clearly resolve the cut-off peak. Several reasons make this problem: Cut-off likes peaks caused by cavity resonances and weaken transmission spectrum signal at high pressure. Recently, You et al., have researched mechanism of cut-off probe and we improve the cut-off reliability and sensitivity base on that research. Modified cut-off antenna is adapted and bias cut-off probe method is tried. These experiment results have good agreement with the previous study and show good measurement characteristics.

• 제어로봇시스템학회:학술대회논문집
• /
• 2001.10a
• /
• pp.69.6-69
• /
• 2001

The SSPA makes the power level of EIRP up to 16W, and compensates for temperature to the SSPA´s maximum stability. The up and the down converters are dually conversed like as individual synthesizers for selecting of independent transmit-receive transponder. The function of the up-converter is to convert the 70MHz IF signal modulated in the indoor unit modem into a 14.0 ∼ 14.5 GHz Ku-band up-link signal to be sent to the antenna. The down-converter converts the 12.25 ∼ 12.75 GHz Ku-band down-link signal or a trouble malfunction of SSPA may be a fatal factor to operation of the whole satellite communication network. Therefore, this study developed the remote monitoring and control program to monitor the SSPA´s status before the problem occurs for stable operation of the system. This software ...

• Journal of the Korean Magnetic Resonance Society
• /
• v.23 no.3
• /
• pp.81-86
• /
• 2019

Overhauser dynamic nuclear polarization (O-DNP) has been an efficient method to boost the thermal nuclear polarization in liquids at room temperature. However, O-DNP for a benchtop NMR using a permanent magnet has remained unexplored yet. In this work, we report the development of an O-DNP system adopting a permanent magnet of 1.6 T. Q-band (~43 GHz) high-power amplifier produced 6 W microwave for saturation. Instead of resonator, we used an open-type antenna for the microwave irradiation. For several representative small molecules, we measured the concentration and frequency dependences of the enhancement factor. This work paves the way for the development of a benchtop DNP-NMR system overcoming its disadvantage of low quality signal when using a permanent magnet.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2019.05a
• /
• pp.300-302
• /
• 2019

The mast, which is the highest structure in warships, as well as merchant ships, is mainly equipped with radars and navigation lights. Especially, due to the nature of the naval vessels that operate many communication equipment, various kinds of antennas such as communication antennas and TACAN for aircraft guiding are installed in the naval mast. In addition to the complex structure of the mast itself, the installed antenna is a factor that greatly increases the RCS. Therefore, the mast technology for reducing the RCS is being developed and applied in the United States and Europe.

• Publications of The Korean Astronomical Society
• /
• v.37 no.1
• /
• pp.1-11
• /
• 2022

During the course of analysing both single-dish and very long baseline interferometry (VLBI) data obtained from the Korean VLBI Network (KVN), we found a systematic offset between flux density measurements from different antennas. We were able to attribute a majority of the systematic offsets to changes in the "a priori" antenna gains, which were found to have varied up to 10 percent at 22 GHz and up to 30 percent at 43 GHz. Using historical calibrator observations, we present a revised set of gains that may be applied to KVN data taken from 2015 August to 2019 January. Application of the revised gains to the KVN results in a consistency of correlated flux density measurements between the three baselines of approximately five percent. We found that images from the recalibrated data typically have a 50 percent higher dynamic range, with some cases showing an increase of dynamic range of up to a factor of three.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.21 no.6
• /
• pp.799-806
• /
• 2018

In this paper, we analyzed the communication distances in the flat and spherical earth model using the main specifications of the wireless communication device under development to be installed in the unmanned surface vehicle(USV). We installed the wireless communication device on the test ship and the actual communication test was performed in the South Sea of Korea, it compared the experimental result with the simulated results. If the installation altitude of the transmitting and receiving antennas is low, there is not the big difference between the two models. However, when the altitude of one of the two antennas is high, the spherical earth model has similar results to the experimental data. As the altitude of the antenna installation increases, fading occurs in a certain section. We expect that this fading can be overcome through antenna technologies such as space diversity.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.2
• /
• pp.181-188
• /
• 2012

In this paper, the measurement data is analyzed and channel parameters are derived through MIMO Channel measurements at 781MHz considering outdoor multi-path environment. 781MHz frequency band currently operates the DTV system. However, it will be allocated new mobile communication frequency band. The channel characteristics at 781MHz seem to be similar existing mobile communication system at 900MHz but a study on channel characteristics of signal transfer process is necessary because there is incomplete study in mobile networks at 781MHz. To avoid interference with Korean DTV broadcasting, we measured channel characteristics in city/suburban areas of Jeju island by channel sounder and $4{\times}4$ antenna of the ETRI(Korea Electronics and Telecommunications Research Institute). Path Loss, Delay Spread, Angular Spread and K-factor were derived based on measured data.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.5 no.11
• /
• pp.1959-1975
• /
• 2011

Adaptive Bit Loading (ABL) in Multiple-Input Multiple-Output Orthogonal Frequency-Division Multiplexing (MIMO-OFDM) is often used to achieve the desired Bit Error Rate (BER) performance in wireless systems. In this paper, we discuss some of the bit loading algorithms, compare them in terms of the BER performance, and present an effective and concise Adaptive Grouped Loading (AGL) algorithm. Furthermore, we propose a "weight factor" for loading algorithm to converge rapidly to the final solution for various data rate with variable Signal to Noise Ratio (SNR) gaps. In particular, we consider the bit loading in near optimal Singular Value Decomposition (SVD) based MIMO-OFDM system. While using SVD based system, the system requires perfect Channel State Information (CSI) of channel transfer function at the transmitter. This scenario of SVD based system is taken as an ideal case for the comparison of loading algorithms and to show the actual enhancement achievable by our AGL algorithm. Irrespective of the CSI requirement imposed by the mode of the system itself, ABL demands high level of feedback. Grouped Loading (GL) would reduce the feedback requirement depending upon the group size. However, this also leads to considerable degradation in BER performance. In our AGL algorithm, groups are formed with a number of consecutive sub-channels belonging to the same transmit antenna, with individual gains satisfying predefined criteria. Simulation results show that the proposed "weight factor" leads a loading algorithm to rapid convergence for various data rates with variable SNR gap values and AGL requires much lesser CSI compared to GL for the same BER performance.