• 한국신재생에너지학회:학술대회논문집
• /
• 2010.06a
• /
• pp.129.2-129.2
• /
• 2010

AEM which were used for solid alkaline fuel cell(SAFC) were prepared by photo polymerization in method pore-filling with various quaternary ammonium cationic monomers and crosslinkers without an amination process. Their specific thermal and chemical properties were characterized through various analyses and the physico-chemical properties of the prepared electrolyte membranes such as swelling behavior, ion exchange capacity and ionic conductivity were also investigated in correlation with the electrolyte composition. The polymer electrolyte membranes prepared in this study have a very wide hydroxyl ion conductivity range of 0.01 - 0.45S/cm depending on the composition ratio of the electrolyte monomer and crosslinking agent used for polymerization. However, the hydroxyl ion conductivity of the membranes was relatively higher at the whole cases than those of commercial products such as A201 membrane of Tokuyama. These pore-filling membranes have also excellent properties such as smaller dimensional affects when swollen in solvents, higher mechanical strength, lowest electrolyte crossover through the membranes, and easier preparation process compared of traditional cast membranes. The prepared membranes were then applied to solid alkaline fuel cell and it was found comparable fuel cell performance to A201 membrane of Tokuyama.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2016.11a
• /
• pp.151-151
• /
• 2016

수소는 친환경 에너지원으로 주목 받고 있으며 미래 화석연료의 고갈에 대비할 수 있는 물질이다. 수전해는 natural gas steam reforming 또는 coal gasification 같은 방법에 비해 공해 물질의 방출이 없어 미래지향적인 기술로 간주된다. 저온형 수전해는 크게 알칼리 수전해와 고분자 전해질막 수전해로 구분되며 각각의 기술은 장단점을 가지고 있다. 알칼리 수전해는 비백금계 물질을 촉매로 사용할 수 있는 이점이 있으나 알칼리 용액으로 인한 부식, 높은 과전압에 의한 효율저하 그리고 간헐적인 사용에 적합하지 않다. 고분자 전해질막 수전해는 간헐적인 사용이 용이하고 높은 에너지 밀도를 가지지만 산성분위기로 인한 백금계 촉매를 사용해야 하므로 수소 생산 비용이 증가하게 된다. 본 연구에서는 알칼리 수전해와 고분자 전해질막 수전해 방식의 이점을 최대한 이용하고 단점을 극복하기 위한 방법으로 음이온 교환막(anion exchange membrane, AEM)을 적용한 셀 구조를 소개한다. 본문에서는 AEM 수전해 단위 셀의 구성요소들인 AEM 종류, 가스 확산층의 밀도와 운전조건인 알칼리 수용액 농도, 온도의 조건을 다르게 하여 최상의 구성 요소 조건 및 운전조건을 알아보았다.

• Microbiology and Biotechnology Letters
• /
• v.7 no.3
• /
• pp.127-133
• /
• 1979

By the treatment of several mutagens, a number of 5'-guanylic acid producing mutants from 5'-xan-thylic acid were obtained from Brevibacterium ammoniagenes ATCC 6871. The indispensensable genetic-characters of the mutants were adenine requirement, lack of GMP-reductase and mutation to adenosine resistance from adenosine sensitiveness. Main product from 5'-xanthylic acirl by strain BA-17-2 was 5'-guanulic acid, and was isolated in a crystalline form by the use of anion exchange resin, Duolite 102 D. The isolated crystalline was identified as 5'-guanylic acid by means of paper chromatography, ultrav-iolet absorption spectra, and infrared absorption spectrum.

• Microbiology and Biotechnology Letters
• /
• v.26 no.5
• /
• pp.413-419
• /
• 1998

Aryl acylamidase [EC 3.5.1.13] present in an acetaminophen-assimilating Pseudomonas sp. has been purified to a homogeneity using series of ammonium sulfate fractionation, DEAE-Sephacel anion exchange, Phenyl-Sepharose CL-4B hydrophobic, and Sephadex G-100 gel-permeation chromatography. The molecular weight, which was estimated by gel-permeation filtration and sodium dodecyl sulfate polyacylamide gel electrophoresis, was about 57 kDa and 56 kDa, respectively, indicating that this enzyme is a monomeric protein. The optimum pH was 10.5 and the optimum temperature was 40$^{\circ}C$. After incubation of the enzyme at 50$^{\circ}C$ for 30 min, residual activity of the enzyme was 34% compared to its original activity. The Km values for acetaminophen and 4'-nitroactanilide were 0.10 mM and 0.11 mM, respectively.

• The Korean Journal of Food And Nutrition
• /
• v.16 no.2
• /
• pp.152-157
• /
• 2003

Serratia marcescens ATCC 25419 protease was purified to homogeneity by ammonium sulfate treatment, and DEAE-cellulose anion exchange chromatography. The specific activity of the enzyme was increased 448-fold during purification with an overall yield of 43.0%. Metal reactivation on the purified protease from S. marcescens was studied. S. marcescens protease was a metalloenzyme to be completely inhibited its activity by EDTA and the enzyme outstandingly inhibited by Hg, Fe, Cu, but the activity was increased approximately 20% by Co. The reactivation of the apoenzyme was effective with Mn, Co, Zn in pH range from 6 to 8. Among metalloenzymes prepared to the addition of Mn, Co, Zn to restore the degree of activity of native enzyme, Zn-enzyme was similar to the native enzyme in respects with enzyme activity, alkali-inactivation, thermo-stability.

• Korean Journal of Microbiology
• /
• v.36 no.1
• /
• pp.14-19
• /
• 2000

Algal lytic enzyme, an extracellular enzyme, was purified from the culture filtrate of Penicillium oxalicum(HCLF-34) by ultrafiltration, gel filtration chromatography, and anion exchange chromatography. The enzyme has a molecular mass of approximately 22 kDa, an it is a monomer by renaturation SDS-PAGE. The amino acid sequences of the enzyme was revealed to be NH2-Glu-Ser-Tyr-Ser-Ser-Asn-Ala-Ala-Gly-Ala-Val-Leu-Ile---, had about 84% identity with the mature light chain of aspergillopepsin II precursor and 81% identity with the mature protein of the acid proteinase EapC precursor.

• Nuclear Engineering and Technology
• /
• v.45 no.1
• /
• pp.61-66
• /
• 2013

Among the radioactive wastes generated from the nuclear power plant, a radioactive nuclide such as $^{129}I$ is classified as a difficult-to-measure (DTM) nuclide, owing to its low specific activity. Therefore, the establishment of an analytical procedure, including a chemical separation for $^{129}I$ as a representative DTM, becomes essential. In this report, the adsorption and recovery rate were measured by adding $^{125}I$ as a radio-isotopic tracer ($t_{1/2}$ = 60.14 d) to the simulation sample, in order to measure the activity concentration of $^{129}I$ in a pressurized-water reactor primary coolant. The optimum condition for the maximum recovery yield of iodine on the anion exchange resins (AG1 x2, 50-100 mesh, $Cl^-$ form) was found to be at pH 7. In this report, the effect of the boron content in a pressurized-water reactor primary coolant on the separation process of $^{129}I$ was examined, as was the effect of $^3H$ on the measurement of the activity of iodine. As a result, no influence of the boron content and of the simultaneous $^3H$ presence was found with activity concentrations of $^3H$ lower than 50 Bq/mL, and with a boron concentration of less than 2,000 ${\mu}g/mL$.

• Journal of Korean Society of Environmental Engineers
• /
• v.32 no.2
• /
• pp.149-154
• /
• 2010

The feasibility of lead removal by electrolytic coprecipitation was investigated. Electrolysis bath was divided into anode and cathode chamber with anion exchange resin filled membrane. Sea water was electrolyzed and pH of the electrolyte in cathode chamber was increased. Consequently it induced the formation of $Mg(OH)_2$ and $CaCO_3$. The colloidal type precipitates, hich have high surface area, adsorbed lead ions in sea water and coprecipitated. Sea water electrolyses were conducted at different current density. Concentrations of Mg, Ca and Pb in the solution were measured with titration and ASV method. Morphology and crystallography were analyzed with SEM, EDS and XRD. As pH and current density increased, most of lead ions in the sea water were successfully removed.

• Journal of the Korean Chemical Society
• /
• v.34 no.1
• /
• pp.98-101
• /
• 1990

A new spectrophotometric determination method of scandium in the tin slag solution has been investigated using methyl thymol blue as a colorimetric reagent. Scandium is recovered by the anion exchange resin, Amberlite IRA 400, using the mixture solution of ammonium sulfate and sulfuric acid and an eluent. The mole ratio of complex of scandium and MTB at pH 6 is 1 to 1 and the wave length of the maximum absorbance is 585 nm and the molar absorptivity at this wave length is $2.0 {\times} 10^4\;\iota{\cdot}mol^{-1}{\cdot}cm^{-1}$. When tin slag solution is loaded into anion exchange resin and eluted, ions in the solution except scandium ion are eluted rapidly and scandium is eluted lately. So scandium is recovered easily.

• Proceedings of the Membrane Society of Korea Conference
• /
• 2004.05a
• /
• pp.207-210
• /
• 2004

The pore-filled anion-exchange membranes were prepared in this study with an asymmetric poly(vinylidene fluoride)(PVDF) membrane as a nascent membrane and poly(vinylbenzyl chloride)(PVBCl) as a polyelectrolyte. The solution of PVBCI having the chloromethylate aryl ring of 80 percents and 1,4-diaminobicyclo [2,2,2]octane(DABCO) was made with the solvent of tetrahydrofuran(THF) and N,N-Dimethylformamide(DMF), which is in the rotio of 8:2. A new preparation method in this study, i.e. in-situ crosslinking, enabled us to produce the pore-filled membranes without change of size, and to control the properties of final membrane with various degree of cross-linking. From the result of surface morphologies of SEM and AFM the polyelectrolyte exists in the pores of nascent membrane as a certain configuration. From the investigation of the solvent affecting much to the permeability and rejection, it was found. that the membranes using DMF and THF showed better performances than the membranes produced by THF only. The water permeability of the final membrane at low pressure(100㎪) showed a typical ultrafiltation membrane's permeability (8-10kg/㎡hr) and good values of rejection(55∼60 percent).