• Journal of the Korean Society of Industry Convergence
• /
• v.6 no.2
• /
• pp.123-129
• /
• 2003

Oxindoles(6a-g) are obtained by rhodium(II)-catalyzed Wolff rearrangement of diazoquinolinediones in moderate yields. Treatment of 6a-g oxindole derivatives reacted with CAN in acetonitrile at room temperature to gave 7a-g isatins in good yields. The structures of these compound were identified by MP, IR and NMR-spectra.

• Environmental Engineering Research
• /
• v.10 no.1
• /
• pp.22-30
• /
• 2005

Nitrite accumulation is not unusual in batch processes such as sequencing batch reactor (SBR) with high-strength of ammonium or nitrate wastewaters. A possible mechanism of nitrite inhibition on Acinetobacter was depicted in a biochemical model, which the protonated species, nitrous acid form of nitrite, affects proton relating transport at the proton-pumping site crossing the cell membrane under unlimited carbon and phosphorus conditions. This effect exerts inhibition of phosphorylation under aerobic condition and yields low APT/ADP ratio, consequently decrease poly-P synthesis and phosphorus uptake from outside the cell in the model.

• Clean Technology
• /
• v.24 no.4
• /
• pp.371-379
• /
• 2018

The objective of this study is to develop a platinum/hexaaluminate pellet catalyst for the decomposition of eco-friendly liquid propellant. Pellet catalysts using hexaaluminate prepared by ultrasonic spray pyrolysis as a support and platinum as an active metal were prepared by two methods. In the case of the pellet catalyst formed by loading the platinum precursor onto the hexaaluminate powder and then adding the binder (M1 method catalyst), the mesopores were well developed in the catalyst after calcination at $550^{\circ}C$. However, when this catalyst was calcined at $1,200^{\circ}C$, the mesopores almost collapsed and only a few macropores existed. On the other hand, in the case of a catalyst in which platinum was supported on pellets after the pellet was produced by extrusion of hexaaluminate (M2 method catalyst), the surface area and the mesopores were well maintained even after calcination at $1,200^{\circ}C$. Also, the catalyst prepared by the M2 method showed better heat resistance in terms of platinum dispersion. The effects of preparation method and calcination temperature of Pt/hexaaluminate pellet catalysts on the decomposition of liquid propellant composed mainly of ammonium dinitramide (ADN) or hydroxyl ammonium nitrate (HAN) were investigated. It was confirmed that the decomposition onset temperature during the decomposition of ADN- or HAN- based liquid propellant could be reduced significantly by using Pt/hexaaluminate pellet catalysts. Especially, in the case of the catalyst prepared by the M2 method, the decomposition onset temperature did not show a large change even when the calcination temperature was raised at $1,200^{\circ}C$. Therefore, it was confirmed that Pt/ hexaaluminate pellet catalyst prepared by M2 method has heat resistance and potential as a catalyst for the decomposition of the eco-friendly liquid propellants.

• Microbiology and Biotechnology Letters
• /
• v.10 no.1
• /
• pp.15-26
• /
• 1982

A potential fungal lipid producer from starch, which was identified as Muror plumbeus, was isolated from natural sources and its optimum cultivation condition for lipid production was investigated. The Mucor plumbeus FRI 0007 showed the highest felt weight and lipid content which were 2.09 $\pm$ 0.24g per 50$m\ell$ of medium and 37.43% on dry weight basis respectively after 20 days incubation on the medium containing 21% of starch as a carbon source. The urea was the best nitrogen source as compared with sodium nitrate, potassium nitrate, magnesium nitrate, ammonium nitrate and ammonium acetate and its optimum concentration was 2.14g/$\ell$, showing 2.39 $\pm$ 0.07 g felt/50$m\ell$ of medium and 50.73% lipid content on dry weight basis after 25 days incubation. Besides the starch as a carbon source and urea as a nitrogen source, the Mucor plumbeus FRI 0007 utilized ZnSO$_4$, MgSO$_4$, NaH$_2$PO$_4$, $K_2$SO$_4$and FeCl$_3$as mineral sources. However, it did not require ail the above 5 minerals in group in-dispensably for its growth and lipid accumulation. The lipid and economic coefficient of Mucor plumbeus FRI 0007 grown on the medium containing 0.44g $K_2$SO$_4$or 5.00g MgSO$_4$/$\ell$solely were 14.96 and 15.37 and 31.12 and 26.10 which was higher than those on the medium containing the above 5 minerals.

• Journal of Korean Society of Environmental Engineers
• /
• v.30 no.6
• /
• pp.621-627
• /
• 2008

In this study, a technique of speciation and determination of the trace inorganic arsenic(As(III) and As(V)) in water sample using HPLC-DRC-ICP-MS has been developed. Isocratic mobile phase of 10 mM ammonium nitrate and 10 mM ammonium phosphate monobasic was used and methanol(5 v/v%) was used as flushing solvent. Selection of the best flow rate of reaction gas, O$_2$, and optimization of the parameters such as pH and flow rate of mobile phase, and injection volume of sample for the separation and detection of arsenic species were carried out. The oxygen flow rate of 0.5 mL/min, pH of 9.4 and flow rate of 1.5 mL/min of mobile phase, and injection volume of sample of 100 $\mu$L were found to be the best parameters for the speciation and determination of arsenic species. The analytical features of the method were detection limit 0.10 and 0.08 $\mu$g/L, precision(RSD) 4.3% and 3.6%, and recovery 95.2% and 96.4% for As(III) and As(V), respectively. Analysis time was 4 minutes per sample. Linear calibration graphs with r$^2$ = 0.998 were obtained for both As(III) and As(V). Speciation analysis of arsenic species in the raw water samples collected from the tributary streams to Han River and main stream of Paldnag were performed by the proposed method. The concentrations of As(III) ranged from 0.10 to 0.22 $\mu$g/L and As(V) concentrations ranged from 0.44 to 1.19 $\mu$g/L, and 93.5% of total arsenic was found to be As(V).

• Journal of Environmental Science International
• /
• v.2 no.4
• /
• pp.271-278
• /
• 1993

Optimal biodegradation kinetics models to the initial nonylphenol ethoxylates-30 concentration were investigated and had been fitted by the linear regression. Microorganisms capable of degrading nonylphenol ethoxylates-30 were isolated from sewage near Ulsan plant area by enrichment culture technique. Among them, the strain designated as EL-10K had the highest biodegradability and was identified as Pseudomonas from results of taxonomical studies. The optimal conditions for the biodegradation were 1.0 g/ι of nonylphenol ethoxylates-30 and 0.02 g/ι of ammonium nitrate at pH 7.0 and 3$0^{\circ}C$. The highest degradation rate of nonylphenol ethoxylates-30 was about 89% for 30 hours incubation on the optimal condition. Biodegradation data were fit by linear regression to equations for 3 kinetic models. The kinetics of biodegradation of nonylphenol ethoxylates was best described by first order model for 0.1 $\mu\textrm{g}$/ι nonylphenol ethoxylates-30 ; by Monod no growth model and Monod with growth model for 0.5 $\mu\textrm{g}$/mι and 1.0, 5.0 $\mu\textrm{g}$/mι, respectively.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.31 no.5
• /
• pp.754-759
• /
• 2002

In order to develope a new pretense applicable to industries, a bacterium which produces a remarkable amount of extracellular pretense were isolated from soil. About 10 bacterial strains producing pretense were isolated from samples of soil, and strain PANH765 showed the highest activity of pretense production among them. The strain was identified as Bacillus subtilis according to the Bergey's Manual of Systematic Bacteriology based on its morphological, cultural and physiological characteristics. B. subtilis PANH765 showed the maximal production of pro-tease in the medium containing 2.0% glucose, 1.0% yeast extract, 0.2% ammonium nitrate, 0.02% ferrous sulfate and 0.02% dipotassium hydrogen phosphate. Under the optimal condition with temperature of 3$0^{\circ}C$, initial pH of 7.0 and shaking speed of 150 rpm, the pretense production reached a maximum level with 36 hr cultivation (6.34 U).

• Journal of Microbiology and Biotechnology
• /
• v.25 no.10
• /
• pp.1670-1679
• /
• 2015

Two hollow fiber membrane biofilm reactors (HF-MBfRs) were operated for autotrophic nitrification and hydrogenotrophic denitrification for over 300 days. Oxygen and hydrogen were supplied through the hollow fiber membrane for nitrification and denitrification, respectively. During the period, the nitrogen was removed with the efficiency of 82-97% for ammonium and 87-97% for nitrate and with the nitrogen removal load of 0.09-0.26 kg NH₄⁺-N/m³/d and 0.10-0.21 kg NO₃^--N/m³/d, depending on hydraulic retention time variation by the two HF-MBfRs for autotrophic nitrification and hydrogenotrophic denitrification, respectively. Biofilms were collected from diverse topological positions in the reactors, each at different nitrogen loading rates, and the microbial communities were analyzed with partial 16S rRNA gene sequences in denaturing gradient gel electrophoresis (DGGE). Detected DGGE band sequences in the reactors were correlated with nitrification or denitrification. The profile of the DGGE bands depended on the NH₄⁺ or NO₃^- loading rate, but it was hard to find a major strain affecting the nitrogen removal efficiency. Nitrospira-related phylum was detected in all biofilm samples from the nitrification reactors. Paracoccus sp. and Aquaspirillum sp., which are an autohydrogenotrophic bacterium and an oligotrophic denitrifier, respectively, were observed in the denitrification reactors. The distribution of microbial communities was relatively stable at different nitrogen loading rates, and DGGE analysis based on 16S rRNA (341f /534r) could successfully detect nitrate-oxidizing and hydrogen-oxidizing bacteria but not ammonium-oxidizing bacteria in the HF-MBfRs.

• Applied Chemistry for Engineering
• /
• v.26 no.6
• /
• pp.681-685
• /
• 2015

In this study, pure $BiVO_4$ powder and metal-doped $M-BiVO_4$ (M = Mg, Cu) powder, well known as thermochromic materials, were prepared from a mixed aqueous solution of bismuth nitrate ($Bi(NO_3)_3$) and ammonium vanadate ($NH_4VO_3$) in autoclave by hydrothermal method. The crystal structure, microstructure, and thermochromic property of samples were analyzed using FE-SEM, FT-IR, XRD, DSC, UV-Vis-NIR spectroscopy and colorimeter. When heating samples above phase transition temperature, the color of $M-BiVO_4$ (M = Mg, Cu) sample was thermally changed more clearly than that of using only pure $BiVO_4$ sample.

• Journal of Life Science
• /
• v.13 no.5
• /
• pp.705-711
• /
• 2003

The gellan was produced by Pseudomonas elodea under aerobic condition. In this study, the effects of inoculum size, carbon sources and concentration, nitrogen source, and C/N ratio on the cell growth and the production of gellan were evaluated. The maximum growth of P. elodea and gellan production was obtained at 5% (v/v) of inoculum size and glucose showed best results among 9 carbon sources tested. The maximum specific yield of 2.22 and productivity of $0.03 g/\ell$h were obtained at 1.0% (w/v) of glucose. The maximum gellan production was obtained at medium without ammonium nitrate. This indicates that nitrogen limitation is essential for the production of gellan. The highest cell and gellan production were obtained at 20 of C/N ratio.