• Journal of the Korean Ceramic Society
• /
• v.35 no.8
• /
• pp.783-790
• /
• 1998

The characterization of the complexation reaction of PVA and Al(III) ion at different pH and the sint-ering behaviour of UO2 containing the PVA-Al(III) complexes were investigated. Compared with pure PVA powder the complexed PVA-Al(III) powder had compacter shape and lower decomposition temperature The major phase of PVA-Al(III) complex decomposed at 90$0^{\circ}C$ was $\alpha$-Al2O3 The PVA-Al(III) complex formed at pH 9 had the lowest relative viscosity the highest Al content of 36% and the smallest particle size of 19${\mu}{\textrm}{m}$ While the pure UO2 pellet appeared with bimodal one. The grain size of the pure UO2 pellet was 7${\mu}{\textrm}{m}$ but that of the PVA-Al(III) complex added UO2 pellet was increased up to 36${\mu}{\textrm}{m}$ The largest grain size was ob-tained when the PVA-Al(III) complex formed at pH9 was added and the PVA-Al(III) complex formed at pH 11 had the greatest effect on increasing pore size.

• The Korean Journal of Ceramics
• /
• v.6 no.4
• /
• pp.401-404
• /
• 2000

Mimicking the bacterial synthesis of magnetosomes, in which the functionalized surface of a cytoplasmic (lipid) membrane is considered to be stimulating the crystal growth of magnetite, we have successfully grown magnetite films at $30^{\circ}C$ using an arachic acid monomolecular layer as a functionalized surface. The lipid monomolecular layer was spread on an aqueous solution of FeCl$_2$ which was oxidized by flowing a mixed gas, with ratio $O_2$/$N_2$=1/2000, on the surface of the lipid layer. Mossbauer and X-ray diffraction analyses revealed that the Fe$_3$O$_4$ films contain small amounts of ferric hydroxyl impurity phases of ${\alpha}$-FeOOH and ${\tau}$-FeOOH. This is because the oxygen partial pressure at the ferrite/aqueous interface changed as the film (through which the gas penetrated) increased in thickness. Methods to obtain single phase magnetite films are proposed.

• Journal of the Korean Ceramic Society
• /
• v.53 no.5
• /
• pp.511-520
• /
• 2016

Electrolyte-supported symmetric Ni-YSZ cermet electrodes of ca. $23{\mu}m$ were prepared by screenprinting and the impedance was measured as a function of humidity from 2% to 90% balanced in $H_2$ at a total flow rate of 50 sccm. The Ni felt current collector of 1 mm thickness exhibited a Gerischer-like gas concentration impedance in the low frequency range, which was similarly observed in the cermet-supported solid oxide cells, while the Pt paste collector exhibited only electrochemical polarization. The electrochemical polarization of both samples was modeled by a non-ideal diffusion-reaction transmission line model including CPEs with ${\alpha}$= 0.5. In the case of the Pt paste collector, all the Bisquert parameters exhibited humidity dependence to the -1/2 power, supporting a non-faradaic chemical reaction mechanism at three phase boundaries. Consequently, the surface diffusivity and reaction rate increased linearly with humidity. Less pronounced humidity dependence and somewhat lower utilization length with an Ni felt collector can be attributed to the diffusion-limited gas flow through the collector.

• Journal of the Korean Society of Safety
• /
• v.8 no.4
• /
• pp.175-182
• /
• 1993

Volatilization of toxic heavy metals, especially, metal chlorides at elevated temperatures in oxidation conditions was observed using a thermogravimetric furnace since such metal chlorides used to be a cause for the disease of industrial workers by their toxicity and high volatile extent. Most of tested metal chloride compounds were evaporated or decomposed into gas phase at elevated temperatures ranged from 200~90$0^{\circ}C$, while CrCl$_3$ and NiC1$_2$became stable with converting into oxide forms. A kinetic model for evaporation/condensation could predict maximum evaporation flux and the calculated values were compared with real evaporation flux. The ratio of two fluxes could be explained as the fraction of impinging gas molecules to the condensing surface( $\alpha$ ) and obtained in the range of 10$^{-3}$ ~10$^{-9}$ for the experimented toxic heavy metal chlorides. This ratio might be used to define the volatile extent or toxicity of such toxic metal compounds. The schemes to avoid volatilization of toxic heavy metals Into the atmosphere were suggested as follows ; 1 ) controlling the compositions of metals and Chlorine produced substances( such as PVC ) in the treated materials using a reverse estimation from regulatory limit and characteristics of a processing facility, 2) Installation of wet type devices such as a scrubber for condensing the metal compounds.

• Journal of Pharmaceutical Investigation
• /
• v.16 no.2
• /
• pp.55-67
• /
• 1986

Inclusion complexation of tiaprofenic acid (TPA) with cyclodextrins $({\alpha}-,\;{\beta}-,\;{\gamma}-CyDs)$ in aqueous solution and in solid phase was investigated by solubility method, measurement of partition coefficient, ultra-violet, circular dichroism, infrared spectroscopies, powder X-ray diffractometry and differential scanning calorimetry. Investigations were made to prepare inclusion complexes of TPA with ${\beta}-CyD$ in solid powdered form by coprecipitation, freeze-drying, spray-drying and co-pulverization methods. The coprecipitation, freeze-drying and spray-drying methods were successful in obtaining inclusion complexes. The results showed that the latter two methods might be originally superior to the former in obtaining powdered inclusion completes. Especially, it was shown by powder X-ray diffractometry that spray-dried ${\beta}-CyD$ alone, TPA-spray-dried ${\beta}-CyD$ physical mixture, and spray-dried $TPA-{\beta}-CyD$ complex were amorphous. The dissolution behaviours of $TPA-{\beta}-CyD$ systems prepared by above four methods were compared with those of TPA alone and $TPA-{\beta}-CyD$ physical mixture, and the rates of dissolution of TPA in pH 1.2 buffer were greatly enhanced by inclusion complexation and copulverization.

• Environmental Engineering Research
• /
• v.23 no.3
• /
• pp.309-315
• /
• 2018

Chlortetracycline (CTC) is one of the most important compounds in antibiotic production, and its distribution has been widely investigated due to health and ecological concerns. This study presents systematic approach to optimize the high-performance liquid chromatography-tandem mass spectrometry for analyzing CTC in a multiple reaction monitoring mode ($479{\rightarrow}462m/z$). One-factor-at-a-time (OFAT) test with response surface analysis (RSA) was used as optimization strategy. In OFAT tests, the fragmentor voltage, collision energy, and ratio of acetonitrile in the mobile phase were selected as major factors for RSA. The experimental conditions were determined using a composite in cube design (CCD) to maximize the peak area. As a result, the partial cubic model precisely predicted the peak area response with high statistical significance. In the model, the (solvent composition) and (collision $energy^2$) terms were statistically significant at the 0.1 ${\alpha}$-level, while the two-way interactions of the independent variables were negligible. By analyzing the model equation, the optimum conditions were derived as 114.9 V, 15.7 eV, and 70.9% for the fragmentor voltage, collision energy, and solvent composition, respectively. The RSA, coupled with the CCD, offered a comprehensive understanding of the peak area that responds to changes in experimental conditions.

• Journal of Korea Foundry Society
• /
• v.22 no.3
• /
• pp.114-120
• /
• 2002

A new titanium based alloy, Ti-10Ta-10Nb, has designed to examine the improved mechanical properties and biocompatibility. A specimen of titanium alloy was melted in a consumable vacuum arc furnace and homogenized at $1050^{\circ}C$ for 24 h. The effect of hot rolling on microstructure was estimated after rolling at $400^{\circ}C$ and $800^{\circ}C$ respectively. Surface of melted alloy by consumable vacuum arc melting was consisted of rough surface and it was changed to sound surface by coating of $ZrO_2$ slurry on copper mold surface. The hardness of Ti-10Ta-10Nb alloy increased with the amount of${\alpha}+{\beta}$ phase. Ti-10Ta-10Nb alloy showed $Widmanst{\"{a}}ten$ structure by hot rolling at $800^{\circ}C$ and in the rolling ${\beta}-region$ was negligible effects on microstructure refining.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.08a
• /
• pp.122.2-122.2
• /
• 2013

플라즈마 전해산화(plasma electrolytic oxidation) 기술을 이용하여 제작한 산화 피막은 피막의 하층부(기지 금속과 접해 있는 부분)는 ${\alpha}$-phase의 산화물이 대부분을 이루고 있으며, 기지 금속과의 접착성도 뛰어나다. 하지만 피막의 표면이 거칠고, 다공성을 띄는 특징을 보인다. 본 연구에서는 피막의 거칠기와 다공성을 제어하기 위한 방법으로 전해액에 포함된 불순물(Si, P 등) 조성비의 변화에 초점을 맞췄으며, 불순물(Si, P 등)의 조성비를 변화시켜 가면서 실험을 진행하였다. 실험에는 60 Hz, 35 kW(700 V, 50 A)의 power supply가 사용되었다. 또한, 실험의 결과로 제작된 시편의 내전압(10 V/s), 내플라즈마(200 W, 10 min, Ar 5 sccm, 200 mTorr), 내화학성(HCl 36.46 wt%, 120 min) 테스트를 진행하였으며, 실험 결과를 바탕으로 ${\phi}300$ 대면적 시편의 제작도 완료하였다.

• Korean Journal of Materials Research
• /
• v.16 no.11
• /
• pp.687-691
• /
• 2006

Synthesis of Iron oxides by air oxidation of $FeSO_4$ solutions in the presence of NaOH, Diethylenetriamine (DETA), Butylamine (BA) and influence of ultrasonic wave were investigated by XRD, SEM and particle size analyzer. As the DETA addition increased to 0.05 mol, $Fe_3O_4$ was formed with goethite($\alpha$- FeOOH) and $Fe_3O_4$ single phase was formed above 0.18mol of DETA. As the BA addition increased, the XRD peak intensity of (020) face of lepidocrocite($\gamma$-FeOOH) was developed until the formation of $Fe_3O_4$ and reduced the size of the iron oxide particles formed. Ultrasonic wave reduced the size of the iron oxide particles but gave little effects on the iron oxide particles synthesized by amine.

• Food Science and Biotechnology
• /
• v.17 no.6
• /
• pp.1265-1271
• /
• 2008

Adlay bran is a waste product previously thought to have no commercial value, Its methanolic extract was fractionated using n-hexane (ABM-Hex), ethyl acetate (ABM-EtOAc), 1-butanol (ABM-BuOH), and water (ABM-$H_2O$). The ABM-EtOAc fraction exhibited a strongest inhibition against growth of human lung cancer cell A549 and human colorectal carcinoma cells HT-29 and COLO 205. Inhibition of cell cycle progression at $G_0/G_1$ transition, increase of cells at the sub-$G_1$ phase, and DNA ladders were observed in cells treated with ABM-EtOAc. The ABM-BuOH fraction showed the strongest inhibition of proinflammatory cytokines tumor necrosis factor (TNF)-$\alpha$ and interlukin (IL)-$1{\beta}$ in stimulated RAW 264.7 macrophages. Further, ABM-EtOAc and ABM-BuOH inhibited cyclooxygenase (COX)-2 expression in A549 and HT-29 carcinoma cells, while COX-l expression was not affected. These results reveal that both ABM-EtOAc and ABM-BuOH may aid the prevention of cancers and the applications in cancer chemotherapy.