• Proceedings of the KIEE Conference
• /
• 1999.07d
• /
• pp.1710-1712
• /
• 1999

암모니아가스에 민감한 In이 도핑된 ZnO(ZnO:In) 박막을 In 박막$(100{\AA})$ 및 ZnO박막$(3000{\AA})$의 연속적인 증착과 열처리공정을 통하여 제조하고, 이와 같은 방법으로 Al과 In이 도핑된 ZnO (ZnO:Al, In) 박막을 In 박막과 ZnO:Al 박막의 연속적인 증착과 같은 조건에서의 열처리를 통하여 제조하였다. 기판은 $1000{\AA}$의 산화막이 열적으로 성장되어 있는 Si 기판을 사용하였다. In/ZnO 및 In/ZnO:Al 박막 이중층의 열처리온도에 따른 구조적 및 전기적 특성을 x-선회절기, 주사전자현미경, 오제전자분광법 및 4점측정시스템을 통하여 조사하였다. 이들 막에 대하여 열처리온도에 따른 암모니아가스에 대한 감도, 선택성 및 시간응답특성을 구하였다. 열처리온도 $400^{\circ}C$, 동작온도 $300^{\circ}C$에서 100 ppm의 암모니아가스를 주입한 결과 140 %의 최대감도를 나타내었으며 CO, $NO_x$ 가스에 대한 감도는 아주 낮은 것으로 나타났다.

• Korean Journal of Materials Research
• /
• v.15 no.9
• /
• pp.604-607
• /
• 2005

Dependence of the crystallinity, surface roughness, carrier concentration, carrier mobility, electrical resistivity and transmittance of Al-doped ZnO films deposited on glass substrates by RF-magnetron sputtering on effects of the ratio of the RF power for AlZnO to that for ZnO (R) have been investigated. X-ray diffraction spectra show strong preferred orientation along the c-axis. The full width at half maximum (FWHM) of the ZnO (002) peak decreases slightly as R increases in the range of R<1.0, whereas it increases substantially in the range of R>1.0. Scanning electron micrographs (SEM) show that the ZnO film surface becomes coarse as R increases. The carrier concentration and the carrier mobility in the ZnO thin film are maximal for R=1.5 and 1.0, respectively. The electrical resistivity is minimal for R=1.0 The transmittance of the ZnO:Al film tends to increase, but to decrease slightly in the range of R>0.5. It may be concluded that the optimum R value is 1.0, considering all these analysis results. The cause of the changes in the structure and physical properties of ZnO thin films with R are also discussed.

• New & Renewable Energy
• /
• v.2 no.3
• /
• pp.31-36
• /
• 2006

Superstrate pin amorphous silicon thin-film(a-Si:H) solar cells are prepared on $SnO_2:F$ and ZnO:Al transparent conducting oxides(TCO) in order to see the effect of TCO/p-layers on a-Si:H solar cell operation. The solar cells prepared on textured ZnO:Al have higher open circuit voltage VOC than cells prepared on $SnO_2:F$. Presence of thin microcrystalline p-type silicon layer(${\mu}c-Si:H$) between ZnO:Al and p a-SiC:H plays a major role by causing improvement in fill factor as well as $V_{OC}$ of a-Si:H solar cells prepared on ZnO:Al TCO. Without any treatment of pi interface, we could obtain high $V_{OC}$ of 994mV while keeping fill factor(72.7%) and short circuit current density $J_{SC}$ at the same level as for the cells on $SnO_2:F$ TCO. This high $V_{OC}$ value can be attributed to modification in the current transport in this region due to creation of a potential barrier.

• 한국신재생에너지학회:학술대회논문집
• /
• 2006.06a
• /
• pp.158-161
• /
• 2006

Superstrate pin amorphous silicon thin-film (a-Si:H) solar cells are prepared on $SnO_2:F$ and ZnO:Al transparent conducting oxides (TCO) In order to see the effect of TCO/P-layers on a-Si:H solar cell operation. The solar cells prepared on textured ZnO:Al have higher open circuit voltage $V_{oc}$ than cells prepared on $SnO_2:F$. Presence of thin microcrystalline p-type silicon layer $({\mu}c-Si:H)$ between ZnO:Al and p a-SiC:H plays a major role by causing improvement in fill factor as well as $V_{oc}$, of a-Si:H solar cells prepared on ZnO:Al TCO. Without any treatment of pi interface, we could obtain high $V_{oc}$, of 994mv while keeping fill factor (72.7%) and short circuit current density $J_{sc}$ at the same level as for the cells on $SnO_2:F$ TCO. This high $V_{oc}$ value can be attributed to modification in the current transport in this region due to creation of a potential barrier.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.20 no.4
• /
• pp.363-366
• /
• 2007

[ $Zn_2SiO_4:Mn$ ] green phosphors doped with $NH_4Cl$ and Al for PDP were synthesized by solid state reaction method. The luminescence of 532 nm in $Zn_2SiO_4:Mn$ phosphors was associated with $^4T_1{\to}^6A_1$ transition. Photoluminescence intensity of $Zn_2SiO_4:Mn$ doped with $NH_4Cl$ 15 mol% increased about two times as compared with that of $NH_4Cl$ non-doped sample. The color of the emission of Al-doped $Zn_2SiO_4:Mn$ phosphors changed to yellowish green.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.11a
• /
• pp.535-538
• /
• 2004

Zinc Oxide (ZnO) films have attracted considerable attention for transparent conducting films, because of their high conductivity, good optical transmittance from UV to near IR as well as a low-cost fabrication. To increase the conductivity of ZnO, doping of group III elements (Al, Ga, In and B) has been carried out. Transparent conducting films have been applied for optoelectric devices, the development of the transparent conducting thin films on flexible light-weight substrates are required. In this research, the transparent conducting ZnO thin films doped with Aluminum (Al) on polymer substrates were deposited by the RF magnetron suputtering method, and the structural, optical and electrical properties were investigated.

• Korean Journal of Materials Research
• /
• v.25 no.6
• /
• pp.265-268
• /
• 2015

ZnO micro/nanocrystals at large scale were synthesized through the thermal evaporation of Al-Zn mixtures under air atmosphere. The effect of synthetic temperature and time on the morphology of the micro/nanocrystals was examined. It was found that the temperature and time affected the morphology of the ZnO crystals. At temperatures below $900^{\circ}C$, no crystals were synthesized. At a temperature of $1000^{\circ}C$, ZnO crystals with a rod shape were synthesized. With an increase in temperature from $1000^{\circ}C$ to $1100^{\circ}C$, the morphology of the crystals changed from rod shape to wire and granular shapes. As the time increased from 2 h to 3 h at $1000^{\circ}C$, tetrapod-shaped ZnO crystals started to form. XRD patterns showed that the ZnO crystals had a hexagonal wurtzite structure. EDX analysis revealed that the ZnO crystals had high purity. It is believed that the ZnO nanowires were grown via a vapor-solid mechanism because no catalyst particles were observed at the tips of the micro/nanocrystals in the SEM images.

• 한국신재생에너지학회:학술대회논문집
• /
• 2009.06a
• /
• pp.159-159
• /
• 2009

RF 스퍼터링법을 이용하여 유리기판위에 ZnO:Al 박막을 증착하고 다양한 조건 하에서 후 열처리를 실시하여 이에 따른 박막의 구조적, 전기적 및 광학적 특성과 HCl 습식 식각 후의 표면형상 변화를 조사하였다. ZnO:Al 투명전도막은 우수한 전기적, 광학적 특성, 수소 플라즈마 안정성 및 저 비용 등으로 실리콘 박막 태양전지 전면 전극용으로 많은 관심을 받고 있다. 기존의 비정질 실리콘 박막 태양전지용으로 많이 사용되고 있는 상용 Asahi-U형 ($SnO_2:F$) 투명전도막의 경우는 수소 플라즈마에 대한 안정성이 낮고 입사광의 장파장 대역에서의 낮은 산란특성으로 인하여 실리콘 박막 태양전지의 고효율화를 위한 적용에 한계를 나타내고 있다. 이를 개선하기 위하여 스퍼터링법으로 우수한 전기적 특성을 갖는 ZnO:Al 박막을 제조한 후 습식 식각을 통한 표면형상 변화를 통하여 입사광의 산란특성을 향상시키는 방법이 개발되어 많은 연구가 이루어지고 있다. 본 연구에서는 2.5 wt%의 $Al_2O_3$가 함유된 ZnO 타겟을 이용하여 ZnO:Al 박막을 RF 스퍼터링으로 증착한 후 $N_2$ 분위기와 진공 분위기 하에서 다양한 시간과 온도에 따라 후열처리를 하여 열처리 전 박막과의 물질 특성을 상호 비교하고 1%로 희석된 HCl로 습식 식각하여 열처리 전 박막의 구조적 특성이 습식 식각 후의 박막 표면형상 변화에 미치는 영향을 조사하였다. 이로부터 후열처리를 통한 ZnO:Al 투명전도막의 특성을 최적화하고 Asahi-U형 투명전도막과의 특성 비교를 통하여 실리콘 박막 태양전지용 전면전극으로의 적용 가능성을 조사하였다.

• Journal of the Korean Ceramic Society
• /
• v.45 no.5
• /
• pp.256-262
• /
• 2008

$ZnAl_{1-x}\;Cr_xO_4$ solid solutions were synthesized as pink pigments with and without mineralizer. The pigments were examined to optimize color development conditions of temperature and $Cr_2O_3$ contents. The characteristics of synthesized pigments were analyzed by XRD, XPS, FT-IR and UV-vis spectrophotometer. While samples without mineralizer fired at $1300^{\circ}C$, showed $ZnAl_2O_4$ and $ZnCr_2O_4$ spinel in XRD analysis. While samples with mineralizer resulted in $ZnAl_2O_4$. As a results, the pigments show pink color and most effective pink color was obtained at X=0.15 and $1250^{\circ}C$ when mineralizer was used. The chromatic coordinates are $L^*$ 58.61 $a^*$ 24.48, and $b^*$ 9.60.

• Transactions on Electrical and Electronic Materials
• /
• v.9 no.2
• /
• pp.67-72
• /
• 2008

Al-doped p-type ZnO thin films were fabricated by RF magnetron sputtering on n-Si (100) and homo-buffer layers in pure oxygen ambient. ZnO ceramic mixed with 2 wt% $Al_2O_3$ was selected as a sputtering target. XRD spectra show that the Al-doped ZnO thin films have ZnO crystal structure. Hall Effect experiments with Van der Pauw configuration show that p-type carrier concentrations are arranged from $1.66{\times}10^{16}$ to $4.04{\times}10^{18}\;cm^{-2}$, mobilities from 0.194 to $198\;cm^2V{-1}s^{-1}$ and resistivities from 0.0963 to $18.4\;{\Omega}cm$. FESEM cross section images of different parts of a p-type ZnO:Al thin film annealed at $800^{\circ}C$ show a compact structure. Measurement for same sample shows that density is $5.40\;cm^{-3}$ which is smaller than theoretically calculated value of $5.67\;cm^{-3}$. Photoluminescence (PL) spectra at 10 K show a shoulder peak of p-type ZnO film at about 3.117 eV which is ascribed to electron transition from donor level to acceptor level (DAP).