• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.17 no.2
• /
• pp.125-130
• /
• 2005

This study was peformed to investigate the phase change temperature, the supercooling, the maintenance time of liquid phase and the change rate of volume of TMA 30 $wt\% clathrate compound with additives. TMA 30 $wt\% clathrate compound with additive was cooled at heat source temperature of $-6^{circ}C$. The additives are ethylene glycol and chloroform. Their concentration are 0.1$wt\% respectively. The experimental results showed that the phase change temperature was not affected by additives and this was average $5.3^{circ}C$. Also the supercooling and the maintenance time of liquid phase were decreased by additives. Especially, the average value of supercooling showed by $8.8^{circ}C$ and the maintenance time of liquid phase was by 19 minutes in the case of chloroform 0.1$wt\%. Additionally, the average change rate of volume showed by $1.26{\~}1.31\%$ according to additives and the volume was decreased by the phase change from liquid to solid.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.7 no.1
• /
• pp.120-131
• /
• 1995

Thermodynamic analysis of extraction process from the constant pressure LNG(Liquefied Natural Gas) vessel was performed in this study. LNG was assumed as a binary mixture of 90% methane and 10% ethane by mole fraction. The thermodynamic properties such as temperature, composition, specific volume and the amount of cold energy were predicted during extraction process. Pressure as a parameter ranges from 101.3kPa to 2000kPa. The result shows the peculiar phenomena for the LNG as a mixture. Both vapor and liquid extraction processes were investigated by a computer model. The property changes are negligible in the liquid extraction process. For the vapor extraction process, the temperature in the vessel increases rapidly and the extracted composition of methane decreases rapidly near the end of extracting process. Specific volume of vapor has the maximum and that of liquid has the minimum during the process. When pressure is increased, specific volume of vapor decreases and that of liquid increases. It was found that specific volume of vapor phase had a major effect on the heat absorption at constant pressure during vapor extraction process. If the pressure of the vessel increases, the total cold energy which can be utilized from LNG decreased.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.6B
• /
• pp.585-594
• /
• 2009

Efficient filtering is an important factor in RFID system performance. Because of huge volume of tag data in future ubiquitous environment, if RFID readers transmit tag data without filtering to upper-layer applications, which results in a significant system performance degradation. In this paper, we provide an efficient filtering technique which operates on RFID air protocol. RFID air protocol filtering between tags and a reader has some advantages over filtering in readers and middleware, because air protocol filtering reduces the volume of filtering work before readers and middleware start filtering. Exploiting the air protocol filtering advantage, we introduce a geometrical algorithm for generating air protocol filters and verify their performance through simulation with analytical time models. Results of dense RFID reader environment show that air protocol filtering algorithms reduce almost a half of the total filtering time when compared to the results of linear search.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2002.10a
• /
• pp.275-280
• /
• 2002

To study of high volume fly -ash concrete replace cement and fine aggregate together. Proportion consideration economy cost and performance improve replacement high volume fly-ash. Experimentation study of high-strength which cement about fly-ash replacement maximum 50%Flash concrete tested slump, air contest, setting and Hardening concrete tested day of age 1, 3, 7, 28, 91 compression strength in underwater curing. Purpose of study is consultation materials in field that variety of fly ash replacement concrete mix proportion comparison and valuation.

• 한국전산유체공학회:학술대회논문집
• /
• 2009.11a
• /
• pp.228-230
• /
• 2009

The moment-of-fluid (MOF) method is a new volume-tracking method that accurately treats evolving material interfaces. Based on the moment data (volume and centroid) for each material, the material interfaces are reconstructed with second-order spatial accuracy in a strictly conservative manner. The MOF method is coupled with a stabilized finite element incompressible Navier-Stokes solver for two fluids, namely water and air. The effectiveness of the MOF method is demonstrated with a free-surface dam-break problem.

• Korean Journal of Food Science and Technology
• /
• v.22 no.2
• /
• pp.150-154
• /
• 1990

Various sterilization temperatures $(110^{\circ}C,\;120^{\circ}C,\;130^{\circ}C)$ and air volumes (air, 31ml, half-vacuum; 13ml, vacuum; -0.7ml) within the retort pouch were tested for the development of the simple retort rice processing techniques in which the pouch were filled with rice and water, and then sterilized. Water content of retort rice was found to be 59.0-63.3% resulting from mixing the rice and water in the ratio of 1:1.1. The most uniform water content was obtained from retort rice sterilized at $130^{\circ}C$ and packaged under vacuum. The larger water content differences were observed with the increase in internal air volumes within the retort pouch. Spreading degree of retort rice was geater than that of general cooked rice, was lower in upper layer than in low layer, and became lower with the larger air volume and higher sterilization temperature. a degree of rice became higher with the Increase of sterilization temperature but that was not affected by the internal air volume of the pouch. The higher sterilization temperature and the lower the air volume, the higher the whiteness was. The highest whiteness was obtained by packaging under vacuum and sterilizing at $130^{\circ}C$. Intact degree was much higer in packaging under air than vacuum. In sensory evaluation the retort rice of vacuum pack was good in color and spreading degree but not in appearance because of blocking and deforming, but that of air pack was good in texture on the contrary. The best quality was obtained by packaging under half-vacuum and sterilizing at $130^{\circ}C$.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.42 no.4
• /
• pp.15-24
• /
• 2010

Many efforts to understand the deterioration processes of the beeswax-treated volume of "The Annals of Joseon Dynasty" have been made. However, most previous studies have focused on individual sample sheet of the beeswax-treated paper but not book volume format. In this study, humid cycling accelerated aging for duplicated beeswax-treated book volume and Hanji book volume were carried out to examine differences in the deterioration of different parts of each volume as well as between the two book volumes during the aging. As results, it is found that the deterioration rate for the beeswax-treated volume is higher than that for the Hanji book volume. Different parts in each volume show different magnitude of deterioration. In particular, outer sides in both beeswax-treated and Hanji book volumes, which are directly exposed to the air, are deteriorated more seriously than inner sides. It is also observed that inner sides are considerably deteriorated during the aging, implying that inner deterioration may have different mechanisms from outer deterioration.

• Journal of the Semiconductor & Display Technology
• /
• v.18 no.4
• /
• pp.129-133
• /
• 2019

In this paper, we developed a system to monitor the storage capacity of suction-type device such as vacuum cleaner or crop harvesters. The monitoring system consists of load cells and a differential pressure sensor which simultaneously monitor the weight and volume of the stock. Since weighing objects stored in storage containers alone cannot fully monitor the level of filling, more accurate monitoring can be achieved by monitoring volume and fusion with weight information. The volume was monitored using a phenomenon in which the flow rate of the inhaled air varies depending on the volume of the object filled in the storage container. In this paper, we developed a system to monitor the storage in three stages: low, medium and high.

• Journal of Advanced Marine Engineering and Technology
• /
• v.39 no.8
• /
• pp.833-837
• /
• 2015

Li-air batteries have a promising future for because of their high energy density, which could theoretically be equal to that of gasoline. However, substantial Li-air cell performance limitations exist, which are related to the air cathode. The cell discharge products are deposited on the surfaces of the porous carbon materials in the air electrode, which blocks oxygen from diffusing to the reaction sites. Hence, the real capacity of a Li-air battery is determined by the carbon air electrode, especially by the pore volume available for the deposition of the discharged products. In this study, a simple and fast method is reported for the large-scale synthesis of carbon nanoballs (CNBs) consisting of a highly mesoporous structure for Li-air battery cathodes. The CNBs were synthesized by the solution plasma process from benzene solution, without the need for a graphite electrode for carbon growth. The CNBs so formed were then annealed to improve their electrical conductivity. Structural characterization revealed that the CNBs exhibited both an pore structure and high conductivity.

• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 1999.04a
• /
• pp.216-217
• /
• 1999