• 한국항공운항학회:학술대회논문집
• /
• 2006.11a
• /
• pp.47-52
• /
• 2006

• Proceedings of the SAREK Conference
• /
• 2007.06a
• /
• pp.137-137
• /
• 2007

• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2010.04a
• /
• pp.547-548
• /
• 2010

• Journal of Environmental Health Sciences
• /
• v.33 no.4
• /
• pp.283-292
• /
• 2007

Atmospheric concentrations of radon had been continuously observed in Seoul, Korea since December 1999, as a tracer for long-range transport of air pollutants from China continent to Korea. In order to study radon as a tracer of long-range transport, it is important to know information about the atmospheric distribution and variation of radon concentration and its time variation. Atmospheric radon concentration are measured with electrostatic radon monitor(ERM) at Hanyang University located in Eastern area of Seoul. Air sample is taken into a vessel of ERM, and alpha particles emitted by radon daughters $Po^{218}$ are detected with ZnS(Ag) scintillation counter. Hourly mean concentrations and hourly alpha counts are recorded automatically. The major results obtained from time series observation of atmospheric radon were as follows : (1) The mean of airborne radon concentration in Seoul was found to be $7.62{\pm}4.11\;Bq/m^3$ during December $1999{\sim}January$ 2002. (2) The hourly variation of radon concentrations showed the highest in 8:00AM ($8.66{\pm}4.22\;Bq/m^3$) and the lowest in 3:00AM ($6.62{\pm}3.70\;Bq/m^3$) and 5:00AM ($6.62{\pm}3.39\;Bq/m^3$). (3) the seasonal variation of radon concentrations showed higher during winter-to-fall and lower during summer-to-spring. (4) Correlation between airborne radon concentration and the meteorological factors were -0.21 for temperature, 0.09 for humidity, -0.20 for wind speed, and 0.04 for pressure. (5) The mean difference of airborne radon concentration between Asian dust ($5.36{\pm}1.28\;Bq/m^3$) and non-Asian dust ($4.95{\pm}1.49\;Bq/m^3$) phenomenon was significant (p=0.08). We could identify time series distribution of radon concentration related meteorological factors. In addition, radon can be considered a good natural tracer of vertical dispersion and long-range transport.

• Journal of Trauma and Injury
• /
• v.28 no.3
• /
• pp.108-114
• /
• 2015

Purpose: To improve outcome of severe trauma patient, the shortening of transport time is needed. Although helicopter emergency medical services (HEMS) is still a subject of debate, it must also be considered for trauma system. The aim of this study is to assess whether transport method (HEMS versus ground EMS) is associated with outcome among inter-hospital transport. Methods: All trauma patients transported to regional emergency center by either HEMS or ground EMS from September 2011 to September 2014. We have classified patients according to two groups by transport method. Age younger than 15 years and self-discharged patients were excluded. Results: A total of 427 patients were available for analysis during this period. 60 patients were transported by HEMS and 367 patients were transported by ground EMS. HEMS group had higher mortality than ground EMS group (23.3% vs 3.5%; p<0.001), and included more patients with excess mortality ratio adjusted injury severity score (EMR-ISS) above 25 (91.7% vs 48.8%; p<0.001). In the multivariable regression analysis, HEMS was not associated with improved outcome compared with ground EMS, but only EMR-ISS was associated with a mortality of patients (odds ratio, 1.06; 95% confidence interval, 1.04-1.09). Conclusion: In this study, helicopter emergency medical services transport was not associated with a decreased of mortality among the trauma patients who inter-hospital transported to the regional emergency center.

• THE INTERNATIONAL COMMERCE & LAW REVIEW
• /
• v.40
• /
• pp.97-144
• /
• 2008

The purpose of this paper is to review the text of national legislation relating to the carrier's liability in respect of the carriage of passengers, baggage and cargo by air in major states such as United Kingdom, Germany, France, Canada, Russia and China, and to compare the air carrier's liability under the national legislations of above states with them under the Warsaw System relating to the international carriage by air. Also this paper reviews the text of the draft legislation relating to the carrier's liability in respect of the carriage by air in Korea. The Warsaw Convention for the Unification of Certain Rules Relating to International Carriage was adopted in 1929. In 1999, the ICAO adopted the Montreal Convention for the Unification of Certain Rules for International Carriage by Air vastly modernizing the unification of private air law. The Montreal Convention replaced the instruments of the “Warsaw System”, and came into force on 4 November 2003. The Montreal Convention is not only an international convention. It has also exercised a considerable influence on national legislation. A the Convention, or certain of its principles, with the object of regulating their national air transport. The main feature of the liability regime of the air carrier under the Montreal Convention is the two-tier liability system for death or injury of the passenger with strict liability up to 100,000 SDR and presumptive liability with a reversed burden of proof without any limit above that threshold. The principles of the liability of the air carrier under the Montreal Convention have been adopted into national legislations by the United Kingdom, Germany, France, Canada, Russia and China. Now the Ministry of Justice of Korea is proceeding to make a new national legislation relating to the liability of the air carrier in respect of the carriage by air. The draft legislation of the Part VI the Carriage by Air of the Commercial Code of Korea has adopted the main principles of the liability of the air carrier under the Montreal Convention. In conclusion, the national legislation relating to the liability of the air carrier in Korea will contribute to settle efficiently the dispute on the carrier's liability in respect of the carriage of passengers, baggage and cargo by air.

• Journal of Biosystems Engineering
• /
• v.33 no.6
• /
• pp.396-403
• /
• 2008

Because thermal non-uniformity of transported agricultural products is mainly affected by cooling air flow pattern in the cold transport equipment, the analysis and control of flowfield is key to optimization of cold transport equipment. The objectives of this study were to estimate the effects of geometric and operating parameters of cold container on the air flow and heat transfer, and find the optimum design parameters for the low temperature level and its uniformity in given cold container with CFD simulations. Existences of ducts, gaps between pallets and geometries of exit as geometric parameters and fan blowing velocity as operating parameter were investigated. CFD simulations were carried out with the FLUENT 6.2 code. The result showed that optimum design condition was bulk loading with no duct, wall exit and 8.0 m/s of fan blowing velocity.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.9 no.2
• /
• pp.198-209
• /
• 1997

This paper is concerned about the performance of alternative refrigerants of R-502 which has been widely used in transport and low temperature refrigeration. A breadboard heat pump was constructed with counterflow heat exchangers and tested with R-502 and transitional alternatives of R-402A and R-402B and long-term alternatives of R-404A and R-507 to compare the performance of each refrigerant. Measurements were conducted at two different condensing temperatures of $43.3^{\circ}C$ and $52.0^{\circ}C$ and the evaporating temperature was varied over a range from $-25^{\circ}C$ to $-5^{\circ}C$. The evaporator superheat and condenser subcooling were maintained constant at about $5^{\circ}C$ for all tests. Test results showed that all alternative fluids tested in this research work can be used as 'drop-in' fluids to replace R-502 without any major problem. It is also found that in the long run HFC alternatives are to be used due to their favorable environmental characteristics and better performance.

• New & Renewable Energy
• /
• v.3 no.4
• /
• pp.8-15
• /
• 2007

Liquid water in flow channel is an important factor that limits the steady and transient performance of PEM fuel cells. A computational fluid dynamics study based on the volume-of-fluid [VOF] multi-phase model was conducted to understand the two-phase flow behavior of liquid water in cathode gas channels. The liquid water transport in $180^{\circ}{\Delta}$ bends was investigated, where the effects of surface characteristics (hydrophilic and hydrophobic surfaces], channel geometries (rectangular and chamfered corners], and air velocity in channel were discussed. The two-phase flow behavior of liquid water with hydrophilic channel surface and that with hydrophobic surface was found very different; liquid water preferentially flows along the corners of flow channel in hydrophilic channels while it flows in rather spherical shape in hydrophobic channels. The results showed that liquid water transport was generally enhanced when hydrophobic channel with rounded corners was used. However, the surface characteristics and channel geometries became less important when air velocity was increased over 10m/s. This study is believed to provide a useful guideline for design optimization of flow patterns or channel configurations of PEM fuel cells.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.34 no.1
• /
• pp.1-8
• /
• 2011

Controlling industrial vehicle operated by human in warehouse was not simple since the information transfer for controlling the vehicle was not easy. However, as the technology for the WMS (Warehouse Management System) has been advanced and the PDA (Personal Digital Assistant) has come into wide use in a workplace, the control of man-operated vehicle became less difficult as do to AGVS (Automated Guided Vehicle System). This study examines the ways to improve the efficiency of warehouse operation through introducing rule of task assignment for the vehicles, particularly forklift. This study, basically, refer to AGV operation policy because a great number of studies for AGV dispatching rule have been done and the mechanism for the controlling vehicles is very similar. The workers in field prefer to simple dispatching rules such as Shortest Retrieval Time First (SRTF), Shortest Travel Time First (STTF), and Longest Waiting Time First (LWTF). However, these rules have potential disadvantage. Thus, several rules made up by combining rules mentioned above are introduced and these new rules use threshold value or evaluation formula. The effectiveness of these new rules are tested by simulation and the results are compared. This study proposes favorable dispatching rules for forklift in warehouse for the efficiency of the vehicle operation and stability of service level.