• Journal of Environmental Health Sciences
• /
• v.45 no.5
• /
• pp.405-425
• /
• 2019

Objective: This study aimed to review the methodologies for evaluation of consumer spray products containing engineered nanomaterials (ENM), particularly focusing on inhalation exposure. Method: Literature on the evaluation methods for aerosolized ENM exposure from consumer spray products were collected through academic web searching. Common methodologies used in the literature, including research reports and academic articles, were also introduced. Results: The number of ENM-containing products have shown a considerable increase over recent years, from 54 in 2005 to 1,827 in 2018. Currently there is still discussion over the existing regulations with regard to product safety. Analysis of both ENM suspensions in the products and their aerosols is important for risk assessment. Comparison between the phases suggests how the size and concentration of particles change during the spray process. To analyze the ENM suspensions, dynamic light scattering, electron microscopy techniques, and inductively coupled plasma with mass spectrometry were used. In the aerosol monitoring, direct-reading instruments have been used to monitor the aerosols and conventional active sampling is used together to supplement the lack of real-time monitoring. There are also some models for estimating inhalation exposure. These models may be used to estimate mass exposure to nanomaterials contained in consumer products. Conclusion: Although there is no standardized method to evaluate ENM exposure from consumer products, many concerns about ENM have emerged. Every potential measure to reduce exposure to ENM from spray product use should be implemented through a precautionary recognition.

• Journal of Climate Change Research
• /
• v.2 no.4
• /
• pp.253-267
• /
• 2011

This study summarizes some important results from the studies on clouds and aerosols, and their effects on climate in the northeast Asia that were made mainly by Korean scientists and some other scientists from around the world. Clouds and aerosols are recognized as one of the most important factors that contributes to uncertainties in climate predictions and therefore become the subject of active research in the western developed countries in recent years. However, the researches on clouds and aerosols are very weakly done in Korea except ground based measurements of aerosol physical, chemical and optical properties. These measurements indicate that aerosol loadings in the northeast Asia are generally much higher than other parts of the world. On the other hand, researches on clouds are few in Korea. Satellite and ground remote sensing, numerical modeling and aircraft in-situ measurements of clouds are highly needed for better assessment of the role of clouds on climate in the northeast Asia.

• Journal of Environmental Science International
• /
• v.31 no.7
• /
• pp.637-652
• /
• 2022

In this study, the contributions of emissions (foreign and domestic) and atmospheric physical and chemical processes to PM_2.5 concentrations were evaluated during a high PM_2.5 episode (March 24-26, 2018) observed on the Jeju Island in the spring of 2018. These analyses were performed using the community multi-scale air quality (CMAQ) modeling system using the brute-force method and integrated process rate (IPR) analysis, respectively. The contributions of domestic emissions from South Korea (41-45%) to PM_2.5 on the Jeju Island were lower than those (81-89%) of long-range transport (LRT) from China. The substantial contribution of LRT was also confirmed in conjunction with the air mass trajectory analysis, indicating that the frequency of airflow from China (58-62% of all trajectories) was higher than from other regions (28-32%) (e.g., South Korea). These results imply that compared to domestic emissions, emissions from China have a stronger impact than domestic emissions on the high PM_2.5 concentrations in the study area. From the IPR analysis, horizontal transport contributed substantially to PM_2.5 concentrations were dominant in most of the areas of the Jeju Island during the high PM_2.5 episode, while the aerosol process and vertical transport in the southern areas largely contributed to higher PM_2.5 concentrations.

• Journal of Korean Society for Atmospheric Environment
• /
• v.19 no.6
• /
• pp.719-731
• /
• 2003

In order to maintain and manage ambient air quality, it is necessary to identify sources and to apportion its sources for ambient particulate matters. The receptor methods were one of the statistical methods to achieve reasonable air pollution strategies. Also, receptor methods, a field of chemometrics, is based on manifold applied statistics and is a statistical methodology that analyzes the physicochemical properties of gaseous and particulate pollutant on various atmospheric receptors, identifies the sources of air pollutants, and quantifies the apportionment of the sources to the receptors. The objective of this study was 1) after obtaining results from the PMF modeling, the existing sources of air at the study area were qualitatively identified and the contributions of each source were quantitatively estimated as well. 2) finally efficient air pollution management and control strategies of each source were suggested. The PMF model was intensively applied to estimate the quantitative contribution of air pollution sources based on the chemical information (128 samples and 25 chemical species). Through a case study of the PMF modeling for the PM-10 aerosols, the total of 11 factors were determined. The multiple linear regression analysis between the observed PM-10 mass concentration and the estimated G matrix had been performed following the FPEAK test. Finally the regression analysis provided quantitative source contributions (scaled G matrix) and source profiles (scaled F matrix). The results of the PMF modeling showed that the sources were apportioned by secondary aerosol related source 28.8 ％, soil related source 16.8％, waste incineration source 11.5%, field burning source 11.0%, fossil fuel combustion source 10%, industry related source 8.3％, motor vehicle source 7.9%, oil/coal combustion source 4.4％, non-ferrous metal source 0.3％. and aged sea- salt source 0.2％, respectively.

• Journal of Korean Society for Atmospheric Environment
• /
• v.19 no.6
• /
• pp.701-717
• /
• 2003

The objective of this study was to extensively estimate the air quality trends of the study area by surveying con-centration trends in months or seasons, after analyzing the mass concentration of PM-10 samples and the inorganic lements, ion, and total carbon in PM-10. Also, the study introduced to apply the PMF (Positive Matrix Factoriza-tion) model that is useful when absence of the source profile. Thus the model was thought to be suitable in Korea that often has few information about pollution sources. After obtaining results from the PMF modeling, the existing sources at the study area were qualitatively identified The PM-10 particles collected on quartz fiber filters by a PM-10 high-vol air sampler for 3 years (Mar. 1999∼Dec.2001) in Kyung Hee University. The 25 chemical species (Al, Mn, Ti, V, Cr, Fe, Ni, Cu, Zn, As, Se, Cd, Ba, Ce, Pb, Si, N $a^{#}$, N $H_4$$^{+}$, $K^{+}$, $Mg^{2+}$, $Ca^{2+}$, C $l^{[-10]}$ , N $O_3$$^{[-10]}$ , S $O_4$$^{2-}$, TC) were analyzed by ICP-AES, IC, and EA after executing proper pre - treatments of each sample filter. The PMF model was intensively applied to estimate the quantitative contribution of air pollution sources based on the chemical information (128 samples and 25 chemical species). Through a case study of the PMF modeling for the PM-10 aerosols. the total of 11 factors were determined. The multiple linear regression analysis between the observed PM-10 mass concentration and the estimated G matrix had been performed following the FPEAK test. Finally the regression analysis provided source profiles (scaled F matrix). So, 11 sources were qualitatively identified, such as secondary aerosol related source, soil related source, waste incineration source, field burning source, fossil fuel combustion source, industry related source, motor vehicle source, oil/coal combustion source, non-ferrous metal source, and aged sea- salt source, respectively.ively.y.

• Journal of Environmental Science International
• /
• v.16 no.5
• /
• pp.533-539
• /
• 2007

The research was conducted to simulate and interpret the change of $PM_{10}$ profile by Asian dust using the CALPUFF modeling system for the period April 6 through 18, 2001. The results, which are represented a daily variation of $PM_{10}$ concentration before and after Asian dust, was located between a minimum concentration of $50{\mu}g/m^3$ and a maximum concentration of $100{\mu}g/m^3$, Most concentration peaks in the $PM_{10}$ profile were shown within a level below 500 m and had a pattern that rapidly increased up the peak and decreased after the peak to 1000 m. Even though the shapes of the vertical profile during Asian dust days were similar to non-Asian dust days, no rapid change vertically was observed. In particular, the vertical profile on 1200 LST and 1800 LST was noticeably shifted to the higher concentrations, which means $PM_{10}$ in the atmosphere was changed into a vertically and horizontally heterogeneous form under the Asian dust event. Finally, it is con-firmed that the simulation result from CALPUFF might schematically sketched atmospheric $PM_{10}$ profiles and their change by Asian dust throughout the comparison with profiles of aerosol extinction coefficients, which were acquired from Lidar measurement at KGAWO.

• Journal of Korean Society for Atmospheric Environment
• /
• v.18 no.E4
• /
• pp.203-213
• /
• 2002

Receptor modeling is one of statistical methods to achieve reasonable air pollution strategies. In order to maintain and manage ambient air quality, it is necessary to identify sources and to apportion its sources for ambient particulate matters. The main purpose of the study was to survey seasonal trends of inorganic elements in the coarse and fine particles. Second, this study has attempted emission sources qualitatively by a receptor method, the PMF mo-del. After that. both PMF (positive matrix factorization) model and TTFA (target transformation factor analysis) model were applied to compare and to estimate mass contribution of coarse and fine particle sources at the receptor. A total of 138 sets of samples was collected from 1989 to 1996 by a low volume cascade impactor with 9 size fraction stages at Kyung Hee University in Korea. Sixteen chemical species (Si, Ca, Fe, K, Pb, Na, Zn, Mg, Ba, Ni, V, Mn, Cr, Br, Cu. Co) were characterized by XRF. The study result showed that the weighted arithmetic mean of coarse and fine particles were 51.3 and 54.4 $\mu\textrm{g}$/㎥, respectively. Contribution of both particle fractions were esti-mated using TTFA and PMF models. The number of estimated sources was seven according to TTFA model and 8 according to PMF model. Comparison of TTFA and PMF revealed that both methodologies exhibited similar trends in their contribution pattern. However, large differences between contributions were observed in some sour-ces. The results of this study may help to suggest control strategies in local countries where known source profiles do not exist.

• Asian Journal of Atmospheric Environment
• /
• v.2 no.1
• /
• pp.34-46
• /
• 2008

Emissions inputs for use in air quality modeling of Korea were generated with the emissions inventory data from the National Institute of Environmental Research (NIER), maintained under the Clean Air Policy Support System (CAPSS) database. Source Classification Codes (SCC) in the Korea emissions inventory were adapted to use with the U.S. EPA's Sparse Matrix Operator Kernel Emissions (SMOKE) by finding the best-matching SMOKE default SCCs for the chemical speciation and temporal allocation. A set of 19 surrogate spatial allocation factors for South Korea were developed utilizing the Multi-scale Integrated Modeling System (MIMS) Spatial Allocator and Korean GIS databases. The mobile and area source emissions data, after temporal allocation, show typical sinusoidal diurnal variations with high peaks during daytime, while point source emissions show weak diurnal variations. The model-ready emissions are speciated for the carbon bond version 4 (CB-4) chemical mechanism. Volatile organic carbon (VOC) emissions from painting related industries in area source category significantly contribute to TOL (Toluene) and XYL (Xylene) emissions. ETH (Ethylene) emissions are largely contributed from point industrial incineration facilities and various mobile sources. On the other hand, a large portion of OLE (Olefin) emissions are speciated from mobile sources in addition to those contributed by the polypropylene industry in point source. It was found that FORM (Formaldehyde) is mostly emitted from petroleum industry and heavy duty diesel vehicles. Chemical speciation of PM2.5 emissions shows that PEC (primary fine elemental carbon) and POA (primary fine organic aerosol) are the most abundant species from diesel and gasoline vehicles. To reduce uncertainties in processing the Korea emission inventory due to the mapping of Korean SCCs to those of U.S., it would be practical to develop and use domestic source profiles for the top 10 SCCs for area and point sources and top 5 SCCs for on-road mobile sources when VOC emissions from the sources are more than 90% of the total.

• Journal of Korean Society for Atmospheric Environment
• /
• v.20 no.E1
• /
• pp.1-14
• /
• 2004

Meteorological mechanisms in association with long-range transport of Asian dust in April 2001 have been investigated using weather maps, satellite images, TOMS and surface $PM_{10}$ data, backward trajectories, plus modeling output results (geopotential heights, horizontal wind vectors, potential temperatures, and streamlines). The results indicated that long -range transport of Asian dust to the west coast of North America was associated with strong westerlies between the Aleutian low and the Pacific high acting as a conveyor belt. Accelerating westerly flows due to cyclogenesis at the source regions over East Asia transported pollution from the continent to the central Pacific. When the system reached the Aleutian Islands, the intensity of troughs and the westerlies were amplified in the North Pacific. Thereafter the winds between the Aleutian Islands and the Pacific Ocean were more intensified from the air flow transport of the conveyor belt. Consequently, the strong wind in the conveyor belt enhanced the dust transport from the Pacific Ocean to the west coast of North America. This was evidenced by $PM_{10}$ concentration (maximum of about $100{\mu}g\;m^{-3}$) observed In California. Further evidence of the dust transport was found through the observation of satellite images, the distribution of TOMS aerosol index, and the analyses of streamlines and backward trajectories.

• Journal of Korean Society for Atmospheric Environment
• /
• v.11 no.3
• /
• pp.279-290
• /
• 1995

Recently in Korea, due to the significant drop of lead and bromine levels as a marker of autoemission source in the urban areas, the conventional application of receptor methods has many difficulties to properly apportion mass contribution of some sources. It is then needed to urgently develop alternative source profiles and identify new emission markers. Thus, the study has extensively examined the results obtained from using PAHs and elemental data for receptor modeling and has provided an opportunity to identify alternative source compositions and to determine a proper number of the ambient emission sources in Seoul area. The purpose of the study is to identify the sources of PM-10 and to estimate their mass contributions in Seoul area. Thus, a receptor model, target transformation factor analysis(TTFA) has been massively applied. The TTFA offers the possibility of determining the number of sources and their mass contributions. The input data used in this study are composed of two separate sets: fine (d$_{p}$ < 2.5.mu.m) and coarse (2.5.mu.m < d$_{p}$ < 10.mu.m) mode aerosol samples. Each sample was simultaneously collected by a PM-10 dichotomous sampler during the daytime(8 AM to 8 PM) and the nighttime(8 PM to 8 AM) from February to October 1993 on the Sungdong-Gu, Seoul. All the samples were analyzed to determine the levels of 10 inorganic elements by an XRF system as well as 14 PAHs by a HPLC. However, only 8 inorganic elements and 7 PAHs were used for the various statistical analysis.sis.