• Proceedings of the KWS Conference
• /
• 2005.11a
• /
• pp.3-5
• /
• 2005

Explosion Bulge Test has been carried out in order to evaluate base metal and weldment of high strength steels which used for submarine and aircraft carrier. High strength steels such as DS80/100/130 and PFS80/100 were developed by ADD and POSCO. In future, these materials will be used for the construction of larger submarine and aircraft carrier, and EBT is necessary to certificate hull materials for these. EBT methode in air and underwater was developed by ADD, and this report described the test procedure of EBT and the results of EBT for high strength steels.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.13 no.6
• /
• pp.1026-1033
• /
• 2010

The analysis of water-entry impact forces acting on the fin shaft of high speed water-entry body is described. During the entry of high speed body into water, the physical phenomenon and flow properties are analyzed. A proper analysis model is established and the method to estimate the flow force which causes impact torque at the fin shaft is described. It is assumed that the fin shaft is damaged by the force which is induced by contacting with cavity wall. The pressure distribution of fin and the maximum torque are estimated and compared with breaking force. Conclusively, it is hard to resist water-entry impact force in terms of the reinforcement of fin shaft. Additionally safe equipment is essentially required.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.12 no.1
• /
• pp.37-43
• /
• 2009

Fluctuations in the ocean are closely related with the underwater acoustic propagation. Internal waves are generated by fluctuation of isopycnal layer in the upper part of the stratified ocean, which are propagated from offshore to coastal area. Physical characteristics of the internal waves existed in the East Sea were derived from the five field experimental data and the ocean monitoring buoy nearshore the mid-east coast of Korea. The dominant periods are appeared in the near-inertial period about $17{\sim}20hours$ and the short period about a few minutes. The wavelengths of them are $10{\sim}50km$ and $300{\sim}1000m$, and the phase speeds are $20{\sim}100cm/s$ and $30{\sim}70cm/s$, respectively The maximum amplitudes are about $20{\sim}25m$. Under the environment of short depression internal wave propagation, the variations of transmission loss field were investigated using an range-dependent acoustic transmission loss model(RAM). The result shows that the large irregular variations of transmission loss caused by progressing the internal wave from offshore toward coast.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.12 no.2
• /
• pp.206-212
• /
• 2009

The pressurized spray system with nitrogen gas was designed to fabricate the spherical AN(ammonium nitrate) particles. When AN melt was sprayed from a nozzle with equivalent diameter of 0.28mm into an ambient dry air, the ligament breakup mechanism of the molten AN was found to be responsible for the droplet formation(or disintegration) of AN melt. In the experimental range of spray temperature with $170{\sim}200^{\circ}C$ and atomization pressure with $0.1{\sim}0.4MPa$, the spherical AN particles with mean diameter of $130{\sim}250{\mu}m$ were obtained.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.7 no.6
• /
• pp.1390-1395
• /
• 2006

In this paper, we propose an optical add-drop multiplexer(OADM) for dense-WDM (DWDM) which consists of the fiber Bragg grating(FBG) filter and investigate the temperature characteristics of it. To resolve the characteristics, we find and analyze numerically its temperature response, and fabricate an OADM and measure its output spectrum. From the obtained results, we khow that the center wavelength of output spectrum shifts approximately 0.01230$nm/^{\circ}C$ within a temperature range $-30^{\circ}C{\sim}90^{\circ}C$.

• Journal of Biomedical Engineering Research
• /
• v.28 no.3
• /
• pp.423-428
• /
• 2007

Programmable FIR filters are used in various signal processing tasks in medical ultrasound imaging, which are one of the major factors increasing hardware complexity. A widely used method to reduce the hardware complexity of a programmable FIR filter is to encode the filter coefficients in the canonic signed digit (CSD) format to minimize the number of nonzero digits (NZD) so that the multipliers for each filter coefficients can be replaced with fixed shifters and programmable multiplexers (PM). In this paper, a new structure for programmable FIR filters with a improved frequency response and a reduced hardware complexity compared to the conventional shift-and-add architecture using PM is proposed for implementing a very small portable ultrasound scanner. The CSD codes are optimized such that there exists at least one common nonzero digit between neighboring coefficients. Such common digits are then implemented with the same shifters. For comparison, synthesisable VHDL models for programmable FIR filters are developed based on the proposed and the conventional architectures. When these filters have the same hardware complexity, pass-band ana stop-band ripples of the proposed filter are lower than those of the conventional filter by about $0.01{\sim}0.19dB$ and by about $5{\sim}10dB$, respectively. For the same filter performance, the hardware complexity of the proposed architecture is reduced by more than 20% compare to the conventional SaA architecture.

• Korean Journal of Environmental Agriculture
• /
• v.30 no.1
• /
• pp.43-51
• /
• 2011

BACKGROUND: This study was conducted to investigate the arsenic (As) contaminations in polished rice cultivated nearby abandoned mine areas, and to estimate the potential health risk through dietary intake of As-enriched polished rice in each age-gender population. METHODS AND RESULTS: The As contents in polished rice grown fifteen abandoned mine areas were analyzed. The average daily intake (ADD) as well as probabilistic health risk were estimated by assuming probability distribution of exposure parameters. The average total As concentration in polished rice was $0.09{\pm}0.06$ mg/kg with a range of 0.02~0.35 mg/kg. For health risk assessment, the ADD values in all age-gender populations did not exceed the provisional tolerable daily intake (PTDI) of 2.1 ${\mu}g/kg$ b.w./day for inorganic As. Cancer risk probability (R) values were $2.45{\sim}3.28{\times}10^{-4}$ and $2.51{\sim}5.75{\times}10^{-4}$ for all age population and gender population, respectively. Particularly, the R value, $5.75{\times}10^{-4}$, for children less than six years old were estimated to be high. Hazard quotient (HQ) values were 0.23~0.31 and 0.11~0.33 for general population and age-gender population, respectively. CONCLUSION(s): The average R values assessed via intake of polished rice cultivated in abandoned mine areas exceeded the acceptable cancer risk of $10^{-6}{\sim}10^{-4}$ for regulatory purpose. Considering the HQ values smaller than 1.0, potential non-cancer toxic effects may not be caused by the long-time exposure through intake of As-contaminated polished rice.

• Journal of the Institute of Convergence Signal Processing
• /
• v.11 no.1
• /
• pp.41-46
• /
• 2010

In this paper, the DoA(Direction of Arrival) estimator using unitary MUSIC algorithm is studied. The complex-valued correlation matrix of MUSIC algorithm is transformed to the real-valued one using unitary transform for easy implementation. The eigenvalue and eigenvector are obtained by the combined Jacobi-CORDIC algorithm. CORDIC algorithm can be implemented by only ADD and SHIFT operations and MUSIC spectrum computed by 256 point DFT algorithm. Results of unitary MUSIC algorithm designed by System Generator for FPGA implementation is entirely consistent with Matlab results. Its performance is evaluated through hardware co-simulation and resource estimation.

• Journal of the Korean Applied Science and Technology
• /
• v.19 no.1
• /
• pp.56-62
• /
• 2002

Microemulsion is stable to aggregation, sedimentation, fusion and has $3nm{\sim}200nm$ of particle size which is transparent and semitransparent. The isoflavone as a derivatives of Flavone is colorless crystalline compounds. It has similar basic structure to steroid materials which is hormone that acts to skin physiological phenomenon. On this study, we tried to search and demonstrate system content rate of dermal translocation system for cosmetics using O/W type microemulsion containing isoflavone. We manufactured O/W microemulsions by phase inversion emulsification method. It's was found that POE(20) monostearate with HLB value 14 caused microemulsion to be formed, which had $4nm{\sim}18nm$ of average diameter and $3nm{\sim}33nm$ of particle size distribution. Apparent viscosities of the microemulsions have increased in proportion to add surfactant dose.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2013.05a
• /
• pp.476-477
• /
• 2013

Gadget-2 is a scientific simulation code has been used for many different types of simulations like, Colliding Galaxies, Cluster Formation and the popular Millennium Simulation. The code is parallelized with Message Passing Interface (MPI) and is written in C language. There is also a Java adaptation of the original code written using MPJ Express called Java Gadget. Java Gadget writes a lot of checkpoint data which may or may not use the HDF-5 file format. Since, HDF-5 is MPI-IO compliant, we can use our MPJ-IO library to perform parallel reading and writing of the checkpoint files and improve I/O performance. Additionally, to add reliability to the code execution, we propose the usage of Hadoop Distributed File System (HDFS) for writing the intermediate (checkpoint files) and final data (output files). The current code writes and reads the input, output and checkpoint files sequentially which can easily become bottleneck for large scale simulations. In this paper, we propose Sim-Hadoop, a framework to leverage HDFS and MPJ-IO for improving the I/O performance of Java Gadget code.