• 제목/요약/키워드: Active module

검색결과 418건 처리시간 0.023초

Design of a Low-cost Active Dry Electrode Module for Single Channel EEG Recording

  • Byeon Jong-Gil;Jin Kyung-Soo;Park Byoung-Woo
    • 대한의용생체공학회:의공학회지
    • /
    • 제26권1호
    • /
    • pp.49-54
    • /
    • 2005
  • This paper presents a design of 1-channel active dry electrode module for EEG from one's forehead. The IA(instrumentation amplifier) circuit inside the module is based on the configuration sown on the paper MettingVanRijn et al. We analyze the IA circuit to find out the related equation, and then compare its simulated characteristic with the result obtained from the real active dry electrode circuit. With the active dry electrode and the wet(Ag/AgCI) electrode connected to the separated analog processing module on one's forehead at the same time, their real time and FFT outputs of EEG are examined for comparison. The active dry electrode module has advantages over the wet electrode and its analog processing module: 1) The size of the analog processing circuit of the active dry electrode module is smaller than that of existing EEG analog processing module; 2) the total cost required to make the proposed analog processing circuit is much lower than that of the existing circuit, since the designed circuit needs smaller parts; 3) the electrical characteristic is comparable to the general EEG analog processing module even if the designed module has simpler circuit configuration.

A Compact Active Channel Module Design for Active Phased Array Antenna System

  • Jung, Young-Bae
    • 전기전자학회논문지
    • /
    • 제17권4호
    • /
    • pp.393-397
    • /
    • 2013
  • This paper introduces the T/RX combined compact active channel module which is a key unit of the active phased array antenna(APAA) system. This module is mainly compoased of two parts for TX and RX fabricated on both sides of the active module for size reduction. The TX-part is primarily composed of a 3-stage amplifier, a microstrip phase shifter, a thermal compensation and a power detection circuit. The RX-part is composed of LNAs a microstrip phase shifter and BPFs for TX power rejection. Using the proposed design structure we can realized a compact active channel module having high performance.

Nanofiltration Helical Module에서 Hollow Fiber Active Layer의 성형법에 따른 성능변화에 관한 연구 (The Effect of the Making Methods of Hollow Fiber Active Layer on Performance for Nanofiltration Helical Module)

  • 이광현
    • 멤브레인
    • /
    • 제7권2호
    • /
    • pp.95-109
    • /
    • 1997
  • Active layer의 형성법에 따른 첫번째 모듈 set와 두번째 모듈 set 사이의 성능변화가 축방향 속도와 용질 농도변화를 통하여 각 모듈 set별로 비교, 고찰되었다. 모든 실험들은 같은 transmembrane pressure와 막면적당 에너지 소모하에서 동시에 수행되었다. 첫번째 모듈 set에 대해서 Dean vortices가 존재하는 나선형 모듈과 Dean vortices가 없는 선형모듈로 수행된 모든 비교 실험에서 용질 flux와 투과계수는 vortex flow의 경우 훨씬 큰 값을 보였다. 두번째 모듈 set에 대해서 순수에 대한 두 모듈의 투과계수는 다른 값을 보이고 있으며 선형 모듈의 투과계수가 나선형 모듈에 비해 약 150% 높은 것으로 나타났다. 이는 두 모듈의 막이 완전히 달라졌음을 보여준다.

  • PDF

능동위상배열 안테나를 위한 Ka-대역 8채널 송신능동모듈 설계 (A Ka-band 8-channel TX Active Module Design for Active Phased Array Antenna)

  • 정영배
    • 전기전자학회논문지
    • /
    • 제17권2호
    • /
    • pp.135-139
    • /
    • 2013
  • 본 논문에서는 Ka-대역에서 동작하는 8채널 송신능동채널모듈을 소개한다. 본 모듈은 이동 위성통신용 능동위상배열안테나 시스템에 적용되며, 이를 위하여, 시스템의 크기와 중량의 상당부분을 차지하는 능동부 구조를 최적화하여 개별채널로 구성되는 기존의 능동모듈에 비하여 크기 및 중량을 소형화할 수 있다는 장점을 갖는다. 또한, 한 개의 모듈에 다수의 능동채널을 구비함으로써 발생될 수 있는 채널 간의 전기적 간섭을 최소화함으로써, 구성된 개별 채널이 최적의 상태에서 동작하도록 하였다. 시제품의 성능시험을 통한 채널 간의 최대 이득편차는 ${\pm}1.3dB$이며, 최소 채널출력은 21.5dBm이며, 위상천이기 제어에 따른 채널이득 변화량은 ${\pm}1.0dB$이다.

mA급 유효성분 누설전류 감지 모듈 개발 (Development of mA Level Active Leakage Current Detecting Module)

  • 한영오
    • 한국전자통신학회논문지
    • /
    • 제12권1호
    • /
    • pp.109-114
    • /
    • 2017
  • 본 연구에서는 mA급 유효성분(저항성) 누설전류를 감지할 수 있는 모듈을 개발하였다. 감지된 누설전류를 기술표준규격에서 규정하는 0.03초 이내에 차단을 할 수 있도록 16 bit 신호처리 프로세서인 MSP430 프로세서를 사용하여 모듈을 구현하였다. 개발된 모듈은 스마트그리드의 스마트분전반에서 감전예방을 위한 모듈로 적용 가능할 것으로 기대된다.

A New Controllable Active Clamp Algorithm for Switching Loss Reduction in a Module Integrated Converter System

  • Park, Chang-Seok;Jung, Tae-Uk
    • Journal of international Conference on Electrical Machines and Systems
    • /
    • 제3권4호
    • /
    • pp.465-471
    • /
    • 2014
  • This paper proposes a new switching algorithm for an active clamp snubber to improve the efficiency of a module integrated converter system. This system uses an active clamp method for the snubber circuit for the efficiency and reliability of the system. However, the active clamp snubber circuit has the disadvantage that system efficiency is decreased by switch operating time because of heat loss in resonance between the snubber capacitor and leakage inductance. To address this, this paper proposes a new switching algorithm. The proposed algorithm is a technique to reduce power consumption by reducing the resonance of the snubber switch operation time. Also, the snubber switch is operated at zero voltage switching by turning on the snubber switch before main switch turn-off. Simulation and experimental results are presented to show the validity of the proposed new active clamp control algorithm.

차량용 네트워크를 이용한 Brake-by-wire 시스템의 Active hardware redundancy 모듈 운영에 관한 연구 (A Study of Active Hardware Redundancy Module Management for Brake-by-wire using In-vehicle-network)

  • 윤종운;김기웅;김태열;김재구;이석
    • 제어로봇시스템학회:학술대회논문집
    • /
    • 제어로봇시스템학회 2000년도 제15차 학술회의논문집
    • /
    • pp.111-111
    • /
    • 2000
  • The research of network system, being used to reduce automotive wiring harness, is reaching to the development of by-wire system. It is by-wire system that apply IVN(In-Vehicle-Network) to steering, braking system, and it has the advantage of mass-decreasing, easy to diagnose fault and so on. But until now, many developed device can't satisfied with reliability that system have ever had. So redundancy of each network module, i.e., It is only way to make backup module. This paper researches development of network module and redundancy management of backup module when error occurred for implementation of brake-by-wire system.

  • PDF

능동 네트워크를 위한 Enode 운영체제 설계 및 구현 (Design and Implementation of the Enode Operating System for the Active Network)

  • 장승주;나중찬;이영석
    • 한국정보통신학회논문지
    • /
    • 제7권8호
    • /
    • pp.1831-1839
    • /
    • 2003
  • 본 논문은 능동 네트워크를 동작하게 해주는 핵심 모듈인 Enode 노드 운영체제 구조 및 세부 기능들의 내용을 정의한다. 본 논문에서 제안하는 Enode 노드 운영체제는 능동 네트워크 환경에 적합하도록 설계하였다. 또한 "실행 환경"(Execution Environment : EE)에서 편리하게 사용할 수 있도록 인터페이스를 설계하였다. 본 논문에서 제안하는 Enode 노드 운영체제는 도메인을 중심으로 핵심적인 기능 설계에 주력하였다. Enode 운영체제는 Linux 운영체제 상에서 설계되었다. 또한 본 논문에서 제안하는 Enode 노드 운영체제의 인터페이스에 대한 실험을 수행하였다.

적외선 열영상을 이용한 가시광 통신모듈의 고선량 감마선조사에 따른 열화 분석 (Analysis of Visible Light Communication Module Degraded by High Dose-Rate Gamma Irradiation using Thermal Infrared Image)

  • 조재완;홍석붕;구인수
    • 제어로봇시스템학회논문지
    • /
    • 제17권12호
    • /
    • pp.1203-1209
    • /
    • 2011
  • In this paper, the degradation evaluation method of VLC (Visible Light Communication) wireless module after high dose rate gamma-ray irradiation using the thermal infrared camera is proposed. First, the heating characteristics of the active devices embedded in the VLC wireless module during the condition of normal operation is monitored by thermal infrared camera. By the image processing technique, the trends of the intensity of the heat emitted by the active devices are calculated and stored. The feature of the blob area including the area of the active devices in the thermal infrared image is extracted and stored. The feature used in this paper is the mean value of the gray levels in the blob area. The same VLC module has been gamma irradiated at the dose rate of about 4.0 kGy/h during 72 hours up to a total dose of 288 kGy. And then, the heating characteristics of the active devices embedded in the VLC wireless module after high dose gamma ray irradiation is observed by thermal infrared camera. The high dose gamma-ray induced degradation of the active devices embedded in the VLC module was evaluated by comparing the mean value of the blob area to the one of the same blob area of the VLC module before the gamma ray irradiation.

고속 네트워크 시스템의 이중화 회로 구현 (Implementation of High Speed Router's Redundancy Architecture)

  • 강덕기;이상우;이준철;이형섭;이영천
    • 대한전자공학회:학술대회논문집
    • /
    • 대한전자공학회 2000년도 추계종합학술대회 논문집(1)
    • /
    • pp.267-270
    • /
    • 2000
  • In this paper, we consider the simple redundant structures with the function of hardware based active/standby control. The system includes two switch modules. The switch module is connected to a data bus, but only the active switch module has control of the data bus. The standby unit takes over the function of the active unit when the active unit failure or mode command are asserted. And this paper illustrate the high-speed router system and the overall redundant system architecture. The proposed redundant architecture for 80G Router system is verified and implemented with experiment.

  • PDF