• Journal of Biomedical Engineering Research
• /
• v.26 no.1
• /
• pp.49-54
• /
• 2005

This paper presents a design of 1-channel active dry electrode module for EEG from one's forehead. The IA(instrumentation amplifier) circuit inside the module is based on the configuration sown on the paper MettingVanRijn et al. We analyze the IA circuit to find out the related equation, and then compare its simulated characteristic with the result obtained from the real active dry electrode circuit. With the active dry electrode and the wet(Ag/AgCI) electrode connected to the separated analog processing module on one's forehead at the same time, their real time and FFT outputs of EEG are examined for comparison. The active dry electrode module has advantages over the wet electrode and its analog processing module: 1) The size of the analog processing circuit of the active dry electrode module is smaller than that of existing EEG analog processing module; 2) the total cost required to make the proposed analog processing circuit is much lower than that of the existing circuit, since the designed circuit needs smaller parts; 3) the electrical characteristic is comparable to the general EEG analog processing module even if the designed module has simpler circuit configuration.

• Journal of IKEEE
• /
• v.17 no.4
• /
• pp.393-397
• /
• 2013

This paper introduces the T/RX combined compact active channel module which is a key unit of the active phased array antenna(APAA) system. This module is mainly compoased of two parts for TX and RX fabricated on both sides of the active module for size reduction. The TX-part is primarily composed of a 3-stage amplifier, a microstrip phase shifter, a thermal compensation and a power detection circuit. The RX-part is composed of LNAs a microstrip phase shifter and BPFs for TX power rejection. Using the proposed design structure we can realized a compact active channel module having high performance.

• Membrane Journal
• /
• v.7 no.2
• /
• pp.95-109
• /
• 1997

The effects of varing axial flow rate and solute concentration on the performance of both module sets made by different methods for active layer formation were compared and determined. All experiments were conducted simultaneously at the same transmembrane pressure and energy consumption per membrane area. In every comparative run between the presence of Dean vortices in a helical module and absence of such vortices in a linear module from the first module set, the solution fluxes and permeabilities were higher, and in some cases substantially higher for the vortex flow. With pure water, the permeabilities of both modules from the second module set were different and the flux in a linear module was 150% higher than in the helical module. This explained both module membranes were totally different.

• Journal of IKEEE
• /
• v.17 no.2
• /
• pp.135-139
• /
• 2013

This paper presents the 8-channel active module operated in Ka-band. The module is designed for the mobile satellite communication antenna systems, and the module structure has the merit to minimize the size and weight of the antenna systems by 30% compared with the conventional systems using the active module composed of single channel. This module was designed to be optimally operated by prohibiting the electrical interference among the individual channels. From the test results of the fabricated 8-channel active module, it can be confirmed that the maximum channel gain error is ${\pm}1.3dB$, the minimum channel output power is 21.5dBm, and the maximum gain variation by phase control is ${\pm}1.0dB$.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.12 no.1
• /
• pp.109-114
• /
• 2017

In this study, we have developed the active leakage current detection module based on a MSP430 processor, 16bit signal processor. This module can be operated in a desired trip threshold within 0.03 seconds as specified in KS C 4613. This developed module is expected to be applicable as a module for prevention of electric shock in smart distribution panel of smart grid.

• Journal of international Conference on Electrical Machines and Systems
• /
• v.3 no.4
• /
• pp.465-471
• /
• 2014

This paper proposes a new switching algorithm for an active clamp snubber to improve the efficiency of a module integrated converter system. This system uses an active clamp method for the snubber circuit for the efficiency and reliability of the system. However, the active clamp snubber circuit has the disadvantage that system efficiency is decreased by switch operating time because of heat loss in resonance between the snubber capacitor and leakage inductance. To address this, this paper proposes a new switching algorithm. The proposed algorithm is a technique to reduce power consumption by reducing the resonance of the snubber switch operation time. Also, the snubber switch is operated at zero voltage switching by turning on the snubber switch before main switch turn-off. Simulation and experimental results are presented to show the validity of the proposed new active clamp control algorithm.

• 제어로봇시스템학회:학술대회논문집
• /
• 2000.10a
• /
• pp.111-111
• /
• 2000

The research of network system, being used to reduce automotive wiring harness, is reaching to the development of by-wire system. It is by-wire system that apply IVN(In-Vehicle-Network) to steering, braking system, and it has the advantage of mass-decreasing, easy to diagnose fault and so on. But until now, many developed device can't satisfied with reliability that system have ever had. So redundancy of each network module, i.e., It is only way to make backup module. This paper researches development of network module and redundancy management of backup module when error occurred for implementation of brake-by-wire system.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.7 no.8
• /
• pp.1831-1839
• /
• 2003

This paper suggests Enode Operating Systems that is core part of active network. It iscomposed of five parts: domain, channel, thread, memory and file module. The domain and channel module among five parts are the main function. The remaining parts that are the thread, memory, and file are the supporting module for the domain and channel. The domain module manages active network It creates and deletes domain data structure. The channel module has an inchan, outchan, and cutchan. We also test the Enode Operating Systems to verify suggesting concept of node Operating System.

• Journal of Institute of Control, Robotics and Systems
• /
• v.17 no.12
• /
• pp.1203-1209
• /
• 2011

In this paper, the degradation evaluation method of VLC (Visible Light Communication) wireless module after high dose rate gamma-ray irradiation using the thermal infrared camera is proposed. First, the heating characteristics of the active devices embedded in the VLC wireless module during the condition of normal operation is monitored by thermal infrared camera. By the image processing technique, the trends of the intensity of the heat emitted by the active devices are calculated and stored. The feature of the blob area including the area of the active devices in the thermal infrared image is extracted and stored. The feature used in this paper is the mean value of the gray levels in the blob area. The same VLC module has been gamma irradiated at the dose rate of about 4.0 kGy/h during 72 hours up to a total dose of 288 kGy. And then, the heating characteristics of the active devices embedded in the VLC wireless module after high dose gamma ray irradiation is observed by thermal infrared camera. The high dose gamma-ray induced degradation of the active devices embedded in the VLC module was evaluated by comparing the mean value of the blob area to the one of the same blob area of the VLC module before the gamma ray irradiation.

• Proceedings of the IEEK Conference
• /
• 2000.11a
• /
• pp.267-270
• /
• 2000

In this paper, we consider the simple redundant structures with the function of hardware based active/standby control. The system includes two switch modules. The switch module is connected to a data bus, but only the active switch module has control of the data bus. The standby unit takes over the function of the active unit when the active unit failure or mode command are asserted. And this paper illustrate the high-speed router system and the overall redundant system architecture. The proposed redundant architecture for 80G Router system is verified and implemented with experiment.