• Clean Technology
• /
• v.26 no.4
• /
• pp.321-328
• /
• 2020

This experiment compared V/W/TiO2 and V/Mo/TiO2 catalysts that were used for commercial catalysts. The effects of SCR reactions on low-temperature activity were studied. NH3-TPD, DRIFT, and H2-TPR analysis, alongside O2-on/off experiments, were conducted to identify the effects of NH3 acid sites and oxygen participating in the SCR reaction, which had a significant impact on the NH3-SCR reaction. The effect on activity was analyzed at 250 ℃, a high temperature of reaction activity, and 180 ℃, which showed significant activity degradation. In NH3 involved in the SCR reaction at 250 ℃, B and L acid sites contributed to the reaction. In particular, the B acid site was found to have significantly participated in the reaction and affected the NH3-SCR activity, which was reduced at 180 ℃ to affect the activity degradation. Also, atmospheric oxygen contributed to the SCR reaction, causing the active property to facilitate reaction activity at 250 ℃. However, oxygen did not comprise the reaction at 180 ℃, indicating a drop inactivity. Therefore, the B acid site was reduced, and the activity was judged to be degraded due to failure to share in the reaction and low effects by atmospheric oxygen.

• Korean Journal of Food Science and Technology
• /
• v.33 no.1
• /
• pp.1-6
• /
• 2001

Emulsion products with water soluble protein were exposed under light at $5^{\circ}C$ for 8 days. Peroxide value (POV) was increased significantly at the bigining of storage and 2-thiobarbituric acid (TBA) value also increased until 4 days of storage with increase of the production of carbonyl compounds, suggesting that the condition was reacted different from that of the lipid autoxidation. The reaction was similar to the flavor reversion that usually produced from the bigining of soybean oil oxidation. The reason might be the meat pigment, myoglobin, oxidation and it would be due to the singlet oxygen rather than superoxide anion. When the light was excluded general pattern was similar but the production of oxidation products were smaller than that when the sample was exposed under light. The effect of the singlet oxygen was also smaller which meant that the singlet oxygen produced during emulsion process may affect on the flavor reversion at the bigining of storage. The POV of the emulsion without water soluble protein increase gradually by storage and the results indicated that the degradation rate of the peroxides were lower than the sample with water soluble protein. Especially after 4 days of storage, production of carbonyl compounds were decreased. During storage it would be possible to produce the singlet oxygen and the sensitizer from the plants that can be produced during decoloration of soybean oil may be responsible for it. When the light was excluded the production of oxidation products were reduced at the begining of storage and the effect of quencher also was not detected. Therefore the results indicated that the light can accelerate the lipid oxidation.

• Korean Chemical Engineering Research
• /
• v.60 no.3
• /
• pp.459-467
• /
• 2022

Redispersion of Pt-Sn particles in Pt, PtSn catalyst which have been sintered by high temperature hydrogen reduction was investigated using oxygen treatment with various temperatures. The aim of this study was to understand the relationship between the catalytic activity for propane dehydrogenation reaction and the change in the physicochemical properties of the catalyst. X-ray diffraction analysis (XRD), CO pulse chemisorption, and H₂ temperature programmed reduction (H₂-TPR) were performed to investigate the state of active metal and interactions between particles of redispersed catalyst. It was confirmed that the dispersion and particle size of platinum, the crystal phase of the catalyst, and the reduction behavior were changed according to the oxygen treatment. As for the catalytic activity in propane dehydrogeantion, sintered PtSn catalyst treated with oxygen at 500 ℃ showed best activity and recovery of initial activity. It was confirm that catalyst after oxygen treatment at 500 ℃ showed high dispersion of Pt and decreased particle size as the results of CO pulse chemisorption and XRD of catalyst, and thus the redispersion of PtSn particles in sintered catalyst was occurred. Catalytic activity was recovered due to redispersion using oxygen treatment, and the activity recovery of the PtSn catalyst was higher than that of Pt catalyst.

• The Korean Journal of Quaternary Research
• /
• v.18 no.2 s.23
• /
• pp.5-16
• /
• 2004

The geomorphic deformation of the alluvial fans by tectonic movement was investigated along the lineaments of the northem part of the Ulsan(Bulguksa) fault system. Based on the aerial photographs interpretation and field surveys Ulsan fault system was identified as an active reverse fault which has displaced the Quatemary fan deposits. Buguksa fault system strikes for the direction of NW-SE and N-S. These two lineaments of active fault are crossing at Jinty village in Gyeongju city and the fault plane forms here almost vertical dip. The lateral pressures from the two directions have possibly influenced on the formation of the vertical dip at jinty villagy. It should be resulted from that the two pressures responsible for the active reverse fault at which the one with the NW-SE strike thrusts the hanging wall of Tohamsan block southwestward and the other pressure with the N-S strike thrusts it westward over the foot wall of the fan deposits. The marine oxygen isotope stage 8(0.30-0.25 Ma. BP) and stage 6(0.20-0.14 Ma. BP) are presumed to be the ages of high and middle surfaces of the alluvial fan, repectively. The vertical displacements on the high surfaces along the Bulguksa fault system are about 1.05 m at Ha-Dong, 9.5-10.5 m at Jinhyun-Dong, and about 10 m high at Jinty village. And the vertical displacement on the middle surface was measured about 6 m high at Ha-Dong. The average slip rate of vertical displacements is calculated about 0.03-0.43 mm/y.

• Journal of the Korean Geographical Society
• /
• v.34 no.3
• /
• pp.231-246
• /
• 1999

The geomorphic deformation of the alluvial fans by tectonic movement was investigated along the lineaments of the northern part of the Bulguksa fault system. Based on the aerial photographs interpretation and field surveys Bulguksa fault system was identified as an active reverse fault which has displaced the Quaternary fan deposits. Bulguksa fault system strikes for the direction of NW-SE and N-S. These two lineaments of active fault are crossing at Jinty village in Kyungju city and the fault plane forms here almost vertical dip. Thelateral pressures from the two directions have possibly influenced on the formation of the vertical dip at Jinty village. It should be resulted from that the two pressures responsible for the active reverse fault at which the one with the NW-SE strike thrusts the hanging wall of Tohamsan block southwestward and the other pressure with the N-S jstrike thrusts it westwrd over the foot wall of the fan deposits. The marine oxygen isotope stage 8(0.30-0.25 Ma. BP) and stage 6(0.20-0.14 Ma. BP) are presumed to be the ages of high and middle surfaces of the alluvial fan, repectively. The vertical dispiacements on the high surface along the Bulguksa fault system are about 10.5m at Ha-dong, 9.5-10.5m at Jinhyun-dong, and about 10m at Jinty village. And the vertical displacement on the middle surface was measured about 6m high at Ha-dong. The average slip rate of vertical displacements is calculated about 0.03-0.043mm/y.

• Korean Chemical Engineering Research
• /
• v.45 no.2
• /
• pp.183-189
• /
• 2007

We have investigated the oxidation of gas phase elemental mercury using dielectric barrier discharge (DBD). In the DBD process, active species such as $O_3$, OH, O and $HO_2$ are generated by collisions between electrons and gas molecules. Search active species convert elemental mercury into mercury oxide which is deposited into the wall of DBD reactor because of its low vapor pressure. The oxidation efficiency of elemental mercury has been decreased from 60 to 30% by increasing the initial concentration of the elemental mercury from 72 to $655{\mu}g/Nm^3$. The gas retention time at the DBD reactor has showed the little effect on the oxidation efficiency. The more oxygen concentration has induced the more oxidation of elemental mercury, whereas there has been no appreciable oxidation within pure $N_2$ discharge. It has indicated that oxygen atom and ozone, generated in air condition determine the oxidation of elemental mercury.

• Journal of the East Asian Society of Dietary Life
• /
• v.16 no.2
• /
• pp.136-144
• /
• 2006

This research evaluated how the composition of Yak-sun(oriental diet therapy), taken as a nutritional supplement with daily meals, can effect the medical condition of those suffering from modern diseases like obesity and hyperlipideia. We produced Yak-sun tea, determined its nutrient composition and physical characteristics and evaluated how this tea effects affects the active oxygen concentration inside the body by clinical practices. The study results indicated that this tea significantly decrease active oxygen concentration. We think that scientific and objective evaluation was done on the components of Yak-sun tea prescription. We concluded that we could apply the components not only in the form of tea, but also in other food forms. The information we received from this conclusion will provide basic information for the application of oriental medicinal resources into other foods and will also be a steppingstone in the field of functional food research for the development of medicinal herbs which is already an important research field world-wide.

• BMB Reports
• /
• v.48 no.2
• /
• pp.91-96
• /
• 2015

Cells express several antioxidant enzymes to scavenge reactive oxygen species (ROS) responsible for oxidative damages and various human diseases. Therefore, antioxidant enzymes are considered biomedicine candidates. Among them, extracellular superoxide dismutase (SOD3) had showed prominent efficacy against asthma and inflammation. Despite its advantages as a biomedicine, the difficulty in obtaining large quantity of active recombinant human SOD3 (rhSOD3) has limited its clinical applications. We found that a significant fraction of over-expressed rhSOD3 was composed of the inactive apo-enzyme and its potency against inflammation depended on the rate of metal incorporation. Also, purified rhSOD3 was unstable and lost its activity very quickly. Here, we suggest an ideal preparative method to express, purify, and store highly active rhSOD3. The enzymatic activity of rhSOD3 was maximized by incorporating metal ions into rhSOD3 after purification. Also, albumin or polyethylene glycol prevented rapid inactivation or degradation of rhSOD3 during preparative procedures and long-term storage.

• Corrosion Science and Technology
• /
• v.6 no.6
• /
• pp.291-296
• /
• 2007

The corrosion of metals and alloys in flowing liquids can be classified into uniform corrosion and localized corrosion which may be categorized as follows. (1) Localized corrosion of the erosion-corrosion type: the protective oxide layer is assumed to be removed from the metal surface by shear stress or turbulence of the fluid flow. A macro-cell may be defined as a situation in which the bare surface is the macro-anode and the other surface covered with the oxide layer is the macro-cathode. (2) Localized corrosion of the differential flow-velocity corrosion type: at a location of lower fluid velocity, a thin and coarse oxide layer with poor protective qualities may be produced because of an insufficient supply of oxygen. A macro-cell may be defined as a situation in which this surface is the macro-anode and the other surface covered with a dense and stable oxide layer is the macro-cathode. (3) Localized corrosion of the active/passive-cell type: on a metal surface a macro-cell may be defined as a situation in which a part of it is in a passivation state and another in an active dissolution state. This situation may arise from differences in temperature as well as in the supply of the dissolved oxygen. Compared to uniform corrosion, localized corrosion tends to involve a higher wall thinning rate (corrosion rate) due to the macro-cell current as well as to the ratio of the surface area of the macro-anode to that of the macro-cathode, which may be rationalized using potential vs. current density diagrams. The three types of localized corrosion described above can be reproduced in a Jet-in-slit test by changing the flow direction of the test liquid and arranging environmental conditions in an appropriate manner.

• Applied Biological Chemistry
• /
• v.32 no.1
• /
• pp.37-43
• /
• 1989

Some phenolics were examined as an antioxidant for the autoxidation of soybean oil. Soybean oil was autoxidized under a mild condition (the flow rate of 67ml $O_{2}/min$ and $50^{\circ}C$). The antioxidant effect was estimated by active oxygen method. Phenolics show distinctive antioxidant effect, and the effect is prominent when cupper or iron was added. Phenolics showed a tendency to increase antioxidant effect with an increase of the number of hydroxyl group, and the increasing order was ferulic acid, quinalizarin, sesamol, alizarin, fisetin and purpurogallin. However, the effect was remarkably low in ferulic acid, alizarin and quinalizarin. It was found that the antioxidant effect was dependent on the functional group and geometric molecular structure of phenolics.