• Geophysics and Geophysical Exploration
• /
• v.11 no.3
• /
• pp.263-270
• /
• 2008

The Gas Hydrate Research and Development Organization (KGHDO) of Korea accomplished successfully geophysical logging (LWD: Logging While Drilling, MWD: Measurement While Drilling) for five sites in 2007, in order to investigate the presence of gas hydrate in the Ulleung Basin, the East Sea of Korea. The togging parameters acquired from LWD/MWD dre electrical resistivity, acoustic velocity, neutron density and porosity, and natural gamma. In addition, pressure, temperature, and diameter of borehole were measured. LWD/MWD data showed several evidences indicating the presence of gas hydrate. Based on LWD/MWD data, three coring sites were selected for sampling of gas hydrate. Subsequently, various gas hydrate samples were collected directly from three sites. Therefore. the presence of gas hydrates was verified by coring. LWD/MWD data will be significantly used to estimate the amount of gas hydrate. Also, they will provide important information to elucidate about sedimentologic characteristics of gas-hydrate bearing formation and sedimentary environment of the Ulleung Basin.

• Geophysics and Geophysical Exploration
• /
• v.2 no.1
• /
• pp.33-42
• /
• 1999

AVO and complex trace analyses mainly used to characterize natural gas reservoir were tested in this paper for a possible application to detection of major geological discontinuities such as fracture zones. The test data used in this study were calculated by utilizing a viscoelastic numerical program which was based on the generalized Maxwell body for a horizontal fracture model. In AVO analysis of a horizontal fracture zone, p-wave reflection appears to be variant depending upon the acoustic-impedence contrast and the offset distance. The fracture zone is also effectively clarified both in gradient stack and range-limited stack in which fracture zone reflection is attenuated with the increasing offset distance. In complex attribute plots (instantaneous amplitude, frequency, and phase), the top and bottom of the fracture Tone are characterized by a zone of strong amplitudes and an event of the same phase. Low frequency characteristics appear at the fracture zone and the underneath. Amplitude attenuation and waveform dispersion are dependent on Q-contrast between the fracture zone and the surrounding media. They were properly compensated by optimum inverse Q-filtering.

• 한국해양학회지
• /
• v.22 no.1
• /
• pp.43-56
• /
• 1987

A study on sedimentation, geochemical behavior and seismic stratigrapht of the continental shelf sediments along the Korea Strait and a part of south and southeast offshore area of the Korea Peninsula was carried out. In the inner shelf floor with depth ranging up to 80m zonal distribution patterns of mud, sandy silt, and silty sand were observed. In the outer shelf, however, coarse sandy sediments are dominant, and shills and gravels were frequently observed. These observations seem to confirm the Holocene sedimentary processes on the continental shelves off the south, south to east coasts of Korea discussed by Park (1985 and 1986) and Park and Choi (1986). The suface sediments (upper most 5cm thick)from selected 9 stations were analyzed for Al,Mn, Fe,Cr,Ni,Cu,Zn and Pb in order to study geochemical behavior of the sediments in the study area. All data were normalized to Al to com,pensate the size effect of the sediments.In general,inner shelf sediments show slight enrichment compared to the outer shelf sediments.In particular,Pb and Zn show heavy enrichment in most of the sediments.to degrees comparable to those observed at the polluted Kwangyang and Masan Bay sediments.Thus,it is considered that rapid migration or movement of fine-grained sediments in the study area does exist. Three seismic stratigraphic units were analyzed based on the seismic records.The acoustic basement the lower sedimentary deposit(B)and the upper deposit(A)were observed.The strong reflectivity R,in particular, between unit A and B is considered to be an erosinal unconformity during the last Glacial time.

• Journal of Environmental Impact Assessment
• /
• v.26 no.1
• /
• pp.11-26
• /
• 2017

Approximate empirical equations obtained by measuring overall noise levels at different distances have been used to evaluate environmental influence of the railway noise though the accurate prediction of noise levels is important. In this paper, a noise prediction model considering the frequency characteristics of noise sources and propagation was suggested to improve the accuracy of noise prediction. The railway noise source was assorted into track, wheel, traction and aerodynamic components and they were characterized with the source strength and speed coefficient at each octave-band frequency. Correction terms for the acoustic roughness and the track/bridge condition were introduced. The sound attenuation from a source to a receiver was calculated taking account of the geometrical divergence, atmospheric absorption, ground effect, diffraction at obstacles and directivity of source by applying ISO 9613-2. For obtaining the source strength and speed coefficients, the results of rolling noise model, numerical analysis and measurements of pass-by noise were analyzed. We compared the predicted and measured noise levels in various vehicles and tracks, and verified the accuracy of the present model. It is found that the present model gives less error than the conventional one, so that it can be applied to make the accurate prediction of railway noise effect and establish its countermeasures efficiently.

• Clinical and Experimental Pediatrics
• /
• v.50 no.9
• /
• pp.896-900
• /
• 2007

Purpose : The aim of this study was to investigate the speech problems in benign rolandic epilepsy (BRE) according to the seizure focus in EEG and semiology. Methods : Twenty three patients [right origin (13 patients) or left side (10 patients)] who met the BRE criteria by International League Against Epilepsy (ILAE) were prospectively enrolled. We excluded the patients who had abnormal MRI or showed both side spikes in EEG. Computerized Speech Lab was used to assess the speech characteristics of the patients. Results : The error pattern of laryngeal articulation in BRE was exclusively substitution of stop consonants, these errors showed more frequent in the left group (16.0% vs 25.5%). Voice onset time (VOT) of stop consonants and Total duration (TD) of word in both groups were prolonged than normal control group, especially in left group (P<0.05). The first formant of vowel /o/ and second formant of /e/ were significantly decreased in left group (P<0.05). The right group scored wider on pitch range ($192.9{\pm}54.0Hz$) and energy range in spontaneous speech ($14.2{\pm}6.4db$) than the left group ($233.3{\pm}12.5Hz$, $19.4{\pm}9.3db$, respectively, P>0.05). Duration of counting (5 to 9) in left group slower than right group ($8.6{\pm}1.7$ vs $7.9{\pm}1.8sec$). Conclusion : Our data suggested that interictal spikes and seizures in either centrotemporal sides, especially left side group, may induce speech problems. We recommend the logopedic and phoniatric evaluations of speech in BRE patients.

• The Journal of the Acoustical Society of Korea
• /
• v.21 no.2
• /
• pp.150-159
• /
• 2002

The possibility of a broadband noise reduction of piezoelectric smart panels is experimentally studied. Piezoelectric smart panel is basically a plate structure on which piezoelectric patch with shunt circuits is mounted and sound absorbing material is bonded on the surface of the structure. Sound absorbing materials can absorb the sound transmitted at mid frequency region effectively while the use of piezoelectric shunt damping can reduce the transmission at resonance frequencies of the panel structure. To be able to tune the piezoelectric shunt circuit, the measured electrical impedance model is adopted. Resonant shunt circuit composed of register and inductor in stories is considered and the circuit parameters are determined based on maximizing the dissipated energy through the circuit. The transmitted noise reduction performance of smart panels is investigated using an acoustic tunnel. The tunnel is a square crosses sectional tunnel and a loud speaker is mounted at one side of the tunnel as a sound source. Panels are mounted in the middle of the tunnel and the transmitted sound pressure across the panels is measured. Noise reduction performance of a double smart panel possessing absorbing material and air gap shows a good result at mid frequency region except the first resonance frequency. By enabling the piezoelectric shunt damping, noise reduction is achieved at the resonance frequency as well. Piezoelectric smart panels incorporating passive method and piezoelectric shunt damping are a promising technology for noise reduction in a broadband frequency.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.8A
• /
• pp.777-784
• /
• 2010

Recently, the necessity of underwater communication and demand for transmitting and receiving various data such as voice or high resolution image data are increasing as well. The performance of underwater acoustic communication system is influenced by characteristics of the underwater communication channels. Especially, ISI(inter symbol interference) occurs because of delay spread according to multi-path and communication performance is degraded. In this paper, we study the OFDM technique to overcome the delay spread in underwater channel and by using CP, we compensate for delay spread. But PAPR which OFDM system has problem is very high. Therefore, we use DFT-spread OFDM method to avoid nonlinear distortion by high PAPR and to improve efficiency of amplifier. DFT-spread OFDM technique obtains high PAPR reduction effect because of each parallel data loads to all subcarrier by DFT spread processing before IFFT. In this paper, we show performance about delay spread through OFDM system and verify method that DFT spread OFDM is more suitable than OFDM for underwater communication. And we analyze performance according to two subcarrier mapping methods(Interleaved, Localized). Through the simulation results, performance of DFT spread OFDM is better about 5~6dB at $10^{-4}$ than OFDM. When compared to BER according to subcarrier mapping, Interleaved method is better about 3.5dB at $10^{-4}$ than Localized method.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• v.23 no.1
• /
• pp.48-58
• /
• 2001

After performing mandibular setback surgery, we found some changes in patterns and organs of speech. This investigation was undertaken to investigate the aspect and degree of speech patterns according to the amount of surgical setback in mandibular prognathic patients. Thirteen patients with skeletal Class III malocclusion were studied preoperative and postoperative over 6 months. They had undergone the mandible setback operation via bilateral sagittal split ramus osteotomy(BSSRO). We split the patients into two groups. Group 1 included patients whose degree of mandibular setback was 6mm or less, and Group 2 above 6mm. Control group was two adults wish normal speech patterns. A phonetician performed narrow phonetic transcriptions of tape-recorded words and sentences produced by each of the patients and the acoustic characteristics of the plosives, fricatives, and flaps were analyzed with a phonetic computer program (Computerized Speech Lab(CSL) Model 4300B(USA)). The results are as follows: 1. Generally, Patients showed longer closure duration of plosives, shorter VOT(voice onset time) and higher ratio of closure duration against VOT. 2. Patients showed more frequent diffuse distribution than the control group in frication noise energy of fricatives. 3. In fricatives, frequency of compact from were higher in group 1 than in group 2. 4. Generally, a short duration of closure for /ㄹ/ was not realized in the patient's flaps. Instead, it was realized as fricatives, sonorant with a vowel-like formant structure, or trill type consonant. 5. Abnormality of the patient's articulation was reduced, but adaptation of their articulation after surgery was not perfect and the degree of adaptation was different according to the degree of surgical setback.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.12 no.4 s.27
• /
• pp.301-306
• /
• 2006

In order to estimate the characteristics of water movements around artificial upwelling structure, current measurements were carried out along lines E-W and S-N on May 4th(neap tide} and May 30th(spring tide), 2006. In the study area, southeastward flow was dominant during the field observations, and the pattern of water movement in the upper layer above 30m depth was different from that in the lower layer below 30m depth Vertical flow(w-component} around the artificial structure area and western area was shown to be upward flow, but downward flow occurred in the southern, northern and eastern parts at the neap tide. At the spring tide, the ebb current along E-W line showed upwelling flow in the eastern part and western area and showed upwelling flow near the artificial structure area and downwelling flow far away that one. At the spring tide, upward flow was dominant along S-N line during the flood current Volume transport by upward flow was higher than that by downward flow. Volume transport by upward flow during ebb of neap tide was greater than during flood current of neap tide, but was reverse at the spring tide.

• Korean Journal of Optics and Photonics
• /
• v.17 no.1
• /
• pp.94-98
• /
• 2006

An optical microphone based on a dual-core fiber collimator and a membrane type micromirror serving as an optical head and a reflective diaphragm respectively was implemented. The micromirror diaphragm is suspended by a thin silicon bar linked with a frame, thus it is subject to a displacement induced by acoustic waves. The optical head incorporating two collimators integrated in a single housing gives light to and receives it from the diaphragm, rendering the optical microphone structure simple and compact. This dual-core collimator having a slowing varying beam profile facilitates the initial alignment of the optical head with the diaphragm, especially the distance between them. For the assembled microphone, the static characteristics were investigated tofind the operation point defined as the optimum distance between the head and the diaphragm, and a frequency response with a variation of about $\pm$5 dB for the range of up to 3kHz was achieved.