• 한국연소학회:학술대회논문집
• /
• 2003.12a
• /
• pp.35-41
• /
• 2003

Propagation speeds of turbulent premixed flames have been measured in a pulsed-flame flow reactor which generates flames propagating in nearly isotropic turbulent flow field with U'/$S_L$ ranging from 1.2 to 5.3. The measurement involved a high-speed digital imaging at 1000 frames/second to capture the flame propagation motion. In addition to the flame speed measurements, flame perimeter ratio was measured for comparison. The observed flame propagation speed is high ranging from 5 to 20 times the laminar flame speed for the range of U'/$S_L$. The flames observed at extreme equivalence ratios exhibit intermittent propagation in that only a small fraction of ignited flame kernel resulted in full propagation of the flame. Also, at low equivalence ratios the flame speed decreased substantially even at high turbulence intensities.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.10 no.2
• /
• pp.73-79
• /
• 2002

The NO emissions at the exhaust manifo1d were investigated with a fast NO analyzer to investigate the cycle-by-cycle variations on NO emissions level and the dependence of NO emissions on combustion. The measurement was performed with a part load condition with respect to the mixture ratios and the changes in loads at 1800rpm. The averaged values were obtained during 200 cycles. We found that there is characteristic pattern in 70 emissions from exhaust port and it was possible to set a representative value with the data sampled during specific period. As the load increased, the characteristics of NO emissions were more dependent on combustion pressures. It was also analyzed that the correlation between combustion pressures and NO emissions for different equivalence ratios tends to increase as the mixture goes leaner, Furthermore, this correlation for the lean mixture near the lean limit seemed to be kept.

• Polymer(Korea)
• /
• v.26 no.1
• /
• pp.121-127
• /
• 2002

We investigated uranium adsorption and adsorption process characteristics in brine water, changing column bed height packed with amidoximated polypropylene-g- acrylonitrile (AOPP-g-AN) fibrous ion-exchanger. Swelling ratios of AOPP-g-AN in fibrous ion-exchanger were 8.54g/g $H_2O_2$ and 8.87 g/g for $H_2O_2$ solvent respectively. Ion exchange capacity increased with degree of graft and showed the maximum, 3.99 meq/g at 100% degree of graft. In batch process, uranium adsorption had reached an initial equilibrium in 10 min with the adsorption rate of 9.5 mg/min. Finial adsorption capacity was 3.95 meq/g, and pH effect could not be observed. In continuous process, adsorption capacity depended on various packing ratios and showed the maximum, 3.92 meq/g at L/D=1. In L/D<2, breakthrough curve was shown two step by channeling flow and ununiform adsorption. Breakthrough time and adsorption capacity were 26 min and 3.63 meq/g, respectively, in brine water adsorption. When compared with actual brine water and model solution, there was no significant difference of adsorption characteristics.

• Journal of Wetlands Research
• /
• v.3 no.1
• /
• pp.75-89
• /
• 2001

Constructed wetlands were typically cost less to build and operate, and require less energy than standard mechanical treatment technology but they have similar performance to centralized wastewater treatment plants. Therefore, they were constructed especially many in rural areas, where are small villages but not industries. Accordingly, plantless column tests were performed to investigate the possibility on using zeolite as a filter medium of constructed wetland for the wastewater treatment. $COD_{cr}$ removal efficiency was 94.63% at hydraulic load $314L/m^2{\cdot}d$ and filtering hight 100cm filled with a zeolite mixture. This zeolite mixture consisted of 1 : 1 by volume of a zeolite in the diameter range of 0.5 to 1mm to a zeolite in the diameter range of 1 to 3mm. According, hydraulic load $314L/m^2{\cdot}d$ was considered as optimal. Three zeolite mixture were used to determine the optimal mixing ratio by volume of a zeolite(A) in the diameter range of 0.5 to 1mm to a zeolite(B) in the diameter range of 1 to 3mm diameter. 1 : 3, 1 : 1 and only B in A to B by volume were tested at hydraulic load $314L/m^2{\cdot}d$ and filtering hight 100cm. $COD_{cr}$ removal efficiency was more than 89% at mixing ratios of 1 : 3 and 1 : 1 in A to B. Removal efficiency was lower at the column filled with only B. Removal efficiency was better at filter medium filled with mixing ratio 1 : 1 in A to B than with the other mixing ratios. Thus, it was found that the mixture of mixing ratio 1 : 1 in A to B was appropriate for filter medium of constructed wetland. Removal efficiency was higher in down-flow than in up-flow, and $COD_{cr}$ and BOD were removed best in 20cm filter height near feeding area.

• Asian-Australasian Journal of Animal Sciences
• /
• v.14 no.7
• /
• pp.1003-1007
• /
• 2001

This experiment was conducted to investigate the effects of dietary SAA (sulfur-containing amino acids) on growth performance, nutrient digestibility and blood urea nitrogen (BUN) content, and to determine the optimal SAA:lysine ratio for growing barrows and gilts. A total of 150 pigs (75 barrows and 75 gilts, Landrace${\times}$Yorkshire${\times}$Duroc) were assigned to 6 treatments with 5 replicates of 5 pigs per pen. All pigs were fed diets containing either 1.12 (for barrows) or 1.33% (for gilts) dietary lysine with increasing SAA levels (50, 55 and 60% of dietary lysine) in a $2{\times}3$ factorial design. Throughout the whole experimental period (15 to 54 kg body weight), there was no interaction between sexes and SAA:lysine ratios on ADG, ADFI and FCR. However, increasing the SAA:lysine ratio from 50 to 60% in a diet showed a trend to increase ADG and ADFI of barrows. None of differences in nutrient digestibilities except for calcium and phosphorus were observed and gilts showed higher digestibility of calcium and phosphorus (p<0.05). Among dietary SAA:lysine ratios, there were no differences in apparent nutrient digestibility. Mean values of the essential amino acids (EAA), non-essential amino acids (NEAA) and total amino acids (TAA) digestibilities were higher in gilts than barrows (p<0.01). However, no differences in mean value of EAA, NEAA and TAA digestibilities were observed among dietary SAA:lysine ratios. Between sexes and among SAA:lysine ratios, no significant difference in BUN concentration was observed. This study demonstrated that the optimal inclusion ratio of SAA:lysine was 55% and below 50% in barrows and gilts, respectively.

• Korean Journal of Agricultural Science
• /
• v.50 no.4
• /
• pp.829-840
• /
• 2023

Various chemical pesticides are used to control diamondback moths, Plutella xylostella, which are agricultural pests that occur in cruciferous crops worldwide and cause economic losses. However, due to pesticide misuse, resistance to P. xylostella is consistently reported domestically and internationally. Therefore, we aimed to monitor and map regional resistance to devise efficient and economical control methods for P. xylostella in Korea. This study selected eight highly used insecticides among those registered against P. xylostella. P. xylostella were collected from three cities in the Gyeonggi and Yeongnam Provinces to evaluate insecticide resistance. As a result of experiments with populations collected from Yeoju, Gyeonggi Province, resistance ratios were 114.88, 54.75, 119.00, and 64.00 times higher than the susceptible population with methoxyfenozide, indoxacarb, cyantraniliprole, and fluxametamide, respectively. The resistance ratios of the Yongin population in Gyeonggi Province were 166.33 times with cyantraniliprole and 195.25 times with fluxametamide higher than the susceptible population. The Pocheon population in Gyeonggi Province showed a resistance ratio 283.23 times higher than methoxyfenozide. As a result of experiments with populations collected from Gimhae and Sangju, Yeongnam Province, the resistance ratios of the Gimhae population were 80.97, 138.00, and 89.50 times higher than the susceptible population with methoxyfenozide, cyantraniliprole, and fluxametamide, respectively. Meanwhile, the resistance ratios of the Sangju population were 85.83, 224.67, and 303.25 times higher than the susceptible population with methoxyfenozide, cyantraniliprole, and fluxametamide, respectively. The Yeongnam Province Tongyeong population showed a resistance ratio 367.28 times higher to methoxyfenozide.

• Asian-Australasian Journal of Animal Sciences
• /
• v.27 no.10
• /
• pp.1452-1460
• /
• 2014

The objective of this work was to evaluate the nutritional parameters of young bulls supplemented with different ratios of protein: carbohydrate on tropical pastures from 4 until 18 months old. Fifty-five non-castrated beef calves ($138.3{\pm}3.4kg$, 90 to 150 d of age) were used. The calves (young bulls) were subjected to a 430-d experimental period encompassing 4 seasons. The treatments were as follows: control, only mineral mixture; HPHC, high protein and high carbohydrate supplement; HPLC, high protein and low carbohydrate supplement; LPHC, low protein and high carbohydrate supplement; and LPLC, low protein and low carbohydrate supplement. The amount of supplement was adjusted every 28 d. Dry matter (DM) intake was higher in the dry-to-rainy transition and rainy seasons for all nutritional plans. Non-supplemented animals had lower intakes of DM and total digestible nutrients (TDN) than supplemented young bulls in all seasons. Although differences in DM intake were not observed between supplemented animals, the supplements with high carbohydrate (HPHC and LPHC) had lower forage intake during suckling (rainy-to-dry transition season) and in the rainy season. However, the HPHC treatment animals had higher intake and digestibility of neutral detergent fiber. It can be concluded that supplementation with high protein levels (supplying 50% of the crude protein requirement) provide the best nutritional parameters for grazing young bulls in most seasons, increasing intake and digestibility of diet, and these effects are more intense when associated with high carbohydrate levels level (supplying 30% TDN requirement).

• Wind and Structures
• /
• v.11 no.4
• /
• pp.291-302
• /
• 2008

Three-dimensional engineering simulations of momentum-driven tornado-like vortices are conducted to investigate the flow dynamics dependency on swirl ratio and the possible relation with real tornado Fujita scales. Numerical results are benchmarked against the laboratory experimental results of Baker (1981) for a fixed swirl ratio: S = 0.28. The simulations are then extended for higher swirl ratios up to S = 2 and the variation of the velocity and pressure flow fields are observed. The flow evolves from the formation of a laminar vortex at low swirl ratio to turbulent vortex breakdown, followed by the vortex touch down at higher swirls. The high swirl ratios results are further matched with full scale data from the Spencer, South Dakota F4 tornado of May 30, 1998 (Sarkar, et al. 2005) and approximate velocity and length scales are determined.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1996.11a
• /
• pp.175-179
• /
• 1996

Ferroelectric SrBi$_2$Ta$_2$$O_{9}$ thin films were fabricated by tole Sol-Gel method using a spin-on coating with MOD(Metal Organic Dccomposition) solution on Pt/Ti/SiO$_2$/Si(100) substratcs. The films were anncalcd at 80$0^{\circ}C$ for one hour in oxygen atmosphere. The effects of Bi/Ti mole ratios on crystalline orientations, surface morphologies, and subface composition SBT thin films with a Bi/Ta mole ratios from 1.1 to 1.3 were investigated using X-ray Diffractometry (XRD). Atomic Force (AFM), X-Ray Photoelectron Spectroscopy(XPS). Ferroelectric properties of these films were also measured.d.

• Nuclear Engineering and Technology
• /
• v.36 no.2
• /
• pp.153-164
• /
• 2004

A computational fluid dynamics (CFD) analysis has been performed to investigate the turbulent flow and heat transfer in a triangular rod bundle with pitch-to-diameter ratios (P/D) of 1.06 and 1.12. Anisotropic turbulence models predicted the turbulence-driven secondary flow in a triangular subchannel and the distributions of the time mean velocity and temperature, showing a significantly improved agreement with the measurements from the linear standard $k-{\epsilon}$ model. The anisotropic turbulence models predicted the turbulence structure for a rod bundle with a large P/D fairly well, but could not predict the very high turbulent intensity of the azimuthal velocity observed in the narrow flow region (gap) for a rod bundle with a small P/D.