• Journal of Magnetics
• /
• 제18권2호
• /
• pp.155-158
• /
• 2013

FeCoB films were being prepared on a Ru underlayer by using the oblique incidence of sputtered and back-scattered particles which have a high in-plane magnetic anisotropy field $H_k$ above 400 Oe. It is suitable to attain such deposition condition when facing targets sputtering system. The in-plane X-ray diffraction analysis clarified that there is anisotropic residual stress which is the origin of the high in-plane magnetic anisotropy. The directional crystalline alignment and inclination of crystallite growth were also observed. Such anisotropic crystalline structures may affect the anisotropic residual stress in the films. The B content of 5.6 at.% was appropriate to induce such anisotropic residual stress and $H_k$ of 410 Oe in this experiment. The film with B content of 6 at.% possessed large saturation magnetization of 22 kG and high $H_k$ of 500 Oe. The film exhibited high ferromagnetic resonance frequency of 9.2 GHz.

• Journal of Electrical Engineering and information Science
• /
• 제2권4호
• /
• pp.72-78
• /
• 1997

A free space transmission method using standard gain horn antennas in the frequency range from 9.0 to 10.5GHz is applied to determine the dielectric properties of grain such as rough rice ,brown rice and barley. The dielectric constant and loss factor, which depend on the moisture content of the wetted grain are obtained from the measured attenuation and phase shift by vector network analyzer. The moisture content of grain varied from 11 to 25% based on this wetted condition. The measured values of dielectric constants as a function of moisture density are compared with values of those obtained using he predicted model for estimating dielectric constants of grain. The effect of density fluctuation, high is an important parameter governing the dielectric properties of grain, on the dielectric constant and loss factor is presented. A new density-independent model in terms of measured attenuation an moisture density is proposed of reducing the effects of density fluctuation on the moisture content measurement.

• 대한전자공학회논문지
• /
• 제27권4호
• /
• pp.513-519
• /
• 1990

In order to realize an efficient and stable X-band harmonic generator, a 100 MHz frequency multiplier, an impulse generator using SRD(Step Recovery Diode) module, and a narrow-band bandpass waveguide filter have been designed and tested. By properly combining these devices an X-band harmonic generator has been realized. The output power of the harmonic generator was measured to be -1.5 dBm at 9 GHz which is the 90th harmonic of the 100MHz input. The power fluctuation of the harmonic generator due to temperature variation was observed to the about 0.15 dB during 24 hours of 4\ulcorner temperature variation.

• Journal of the Optical Society of Korea
• /
• 제18권2호
• /
• pp.118-123
• /
• 2014

For multi parameter optimization of Raman Fiber Amplifier (RFA), a simple genetic algorithm is presented in the scenario of a 320 channel Dense Wavelength Division Multiplexed (DWDM) system at channel spacing of 25 GHz. The large average gain (> 22 dB) is observed from optimized RFA with the optimized parameters, such as 39.6 km of Raman length with counter-propagating pumps tuned to 205.5 THz and 211.9 THz at pump powers of 234.3 mW, 677.1 mW respectively. The gain flattening filter (GFF) has also been optimized to further reduce the gain ripple across the frequency range from 190 to 197.975 THz for broadband amplification.

• 한국콘텐츠학회:학술대회논문집
• /
• 한국콘텐츠학회 2016년도 춘계 종합학술대회 논문집
• /
• pp.13-14
• /
• 2016

LTE 대역인 2.5-2.68GHz에서 동작하는 버틀러 스위치를 설계하기 위해 버틀러 매트릭스의 구성요소인 3dB 하이브리드 커플러와 크로스오버를 다단 브랜치 선로의 구조로 구성하여 광대역 특성을 갖는 평면 구조의 버틀러 스위치를 설계하였다. 설계된 버틀러 스위치는 동작대역에서 23.9dB ~ 34.18dB의 좋은 반사손실 특성과 비교적 작은 $7.124^{\circ}$의 위상오차를 보였다.

• ETRI Journal
• /
• 제33권3호
• /
• pp.462-465
• /
• 2011

A millimeter-wave (mm-wave) high-linear low-noise amplifier (LNA) is presented using a 0.18 ${\mu}m$ standard CMOS process. To improve the linearity of mm-wave LNAs, we adopted the multiple-gate transistor (MGTR) topology used in the low frequency range. By using an MGTR having a different gate-source bias at the last stage of LNAs, third-order input intercept point (IIP3) and 1-dB gain compression point ($P_{1dB}$) increase by 4.85 dBm and 4 dBm, respectively, without noise figure (NF) degradation. At 33 GHz, the proposed LNAs represent 9.5 dB gain, 7.13 dB NF, and 6.25 dBm IIP3.

• Journal of electromagnetic engineering and science
• /
• 제12권3호
• /
• pp.210-215
• /
• 2012

This paper presents a compact microstrip triple-mode filter with enhanced skirt characteristics. The presented triple-mode filter configuration supports three transmission poles and three transmission zeros within the nearby passband. Two of transmission zeros are generated by a triple-mode resonator itself, and the third one is generated by small cross-couplings between the I/O ports. Each resonance condition and the transmission zero generation conditions are analyzed using an equivalent circuit. The bandpass filter is designed for a 2.4 GHz WLAN. The filter was fabricated with a relative dielectic constant of 3.5 and a thickness of 0.76 mm. The fabricated filter has a small size ($7.9mm{\times}7.2mm$, i.e., $0.107{\lambda}_g{\times}0.098{\lambda}_g$, where ${\lambda}_g$ is guided wavelength at a center frequency) and shows high performing skirt characteristics.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2005년도 추계종합학술대회
• /
• pp.223-226
• /
• 2005

본 논문에서는 지능형 교통망 시스템 서비스에 사용하는 5.8GHz 대역에서 OFDM을 이용한 단거리 전용 통신 시스템의 성능을 분석하였다. 현재의 DSRC 시스템은 1Mbps 이상의 데이터 서비스가 어려울 것으로 예상되므로 개선도니 변복조방식이 요구된다. OFDM(orthogonal frequency division multiplexing) 방식은 보호구간의 삽입을 통하여 ISI를 방지할 수 있으므로 고속 데이터 전송에 적합하다. 따라서, 본 논문에서는 데이터 변조 방식으로는 IEEE 802.11a에 근거한 부 반송파의 수가 64개인 QPSK변조 방식을 사용하는 OFDM 시스템을 모델링 하고, 도플러 천이 효과를 고려한 Clark & Gans 페이딩 환경에서 성능을 분석하였다. 또한 페이딩 환경에서는 성능의 열화 정도가 크기 때문에 이를 극복하기 위해 채널 예측기를 사용하여 채널 응답을 근사적으로 예측${\cdot}$보상하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 제36회 하계학술대회 논문집 C
• /
• pp.2309-2311
• /
• 2005

A broadband microstrip balun is proposed and designed using a ${\lambda}/4$short-stub in order to compensate phase imbalance. For the demonstration, two baluns are proposed and designed using a ${\lambda}/4$ shorted stub. One is a modified form of the conventional Wilkinson balun, and the other is a modified ring hybrid. Baluns are implemented on TLX-9 substrate of which the dielectric constant is 2.54 and the thickness is 0.5mm. The measurements show a bandwidth of 500MHz at the center frequency of 2GHz.

• Transactions on Electrical and Electronic Materials
• /
• 제17권4호
• /
• pp.217-221
• /
• 2016

In this work, open and short stubs that were fabricated on the silicon substrate and for which the periodically arrayed grounded-strip structure (PAGS) was employed were studied along with their basic RF characteristics for an applicability regarding the RF-matching components. The PAGS-employing open and short stubs showed losses that are much lower than that of the conventional stub on the silicon substrate. Concretely, the Q values of the open and short stubs are 9 and 10.2, respectively, while the Q value of the conventional open stub is 2.5. With the use of the PAGS-employing open and short stubs, a highly miniaturized harmonic-rejection filter was also fabricated on the silicon substrate. The filter exhibited a comparatively sound harmonic-suppression characteristic at n × 13 GHz, and its size is 0.1 mm², which is only 7% of the size of the conventional filter on the silicon substrate.