• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.28 no.4
• /
• pp.232-239
• /
• 2016

In this study, the two-way coupled analysis method of LES-WASS-2D and DEM has been newly developed to review numerically wave attenuation due to behavior of vegetation zone could not yet applied in numerical analysis. To verify the applicability, two-way coupled analysis method is analyzed comparing to the experimental result about characteristics of wave attenuation using vegetation. Numerically analyzed behavior and characteristics of wave attenuation according to height length, distribution length, spacing of vegetation zone and incident wave conditions. It was confirmed to be effective of 3~4% wave attenuation were increased height length and distribution length, narrowed spacing of vegetation. Finally, this study is applicable to behavior and wave attenuation prediction of vegetation zone.

• Applied Microscopy
• /
• v.33 no.3
• /
• pp.179-185
• /
• 2003

The operating accelerating voltage in the electron microscopy may differ from the nominal voltage specified by the manufacture. Thus it is necessary, at least once, to determine the wavelength of electron beam for the nominal accelerating voltage. Particularly in QCBED technique, the wavelength of the incident electron beam on a specimen must be determined as accurately as possible. In this paper we present a simple method to determine accurately the wavelength of electrons from LACBED patterns of a known crystalline materials, which is analogous to a method based on Kikuchi patterns reported previously. This method is to utilize three diffraction lines not belonging to the same zone, which nearly intersect at the same point. For an application of the method, the wavelength of electrons for the 200 kv nominal acceleration voltage of JEM2010 is determined to be 0.002496(3) nm ($201.5{\pm}0.4$ kv) with an uncertainty of 0.12%.

• The Journal of the Acoustical Society of Korea
• /
• v.31 no.4
• /
• pp.205-213
• /
• 2012

Active acoustic array signal was measured in the East Sea and the South sea and spatial coherence was analyzed. The measurement of ambient noise, target reflection signal, sea surface backscattering signals took place including environmental measurements of sea wind, and vertical temperature profiles. The spatial coherence of ambient noise was lower than that of target reflection signal in the South Sea. The spatial coherence of target reflection signal was above 0.5 over all array length. The spatial coherence of sea surface backscattering signal was higher in high incident angle. The maximum non-dimensional array length was 3.0 ($26^{\circ}$) and 3.5 ($32^{\circ}$) to have spatial coherence above 0.5 in the East Sea. To find a design criteria for array configuration and array performance, more measurements of temporal and spatial coherence will be needed continuously in the future.

• Journal of Coastal Disaster Prevention
• /
• v.5 no.4
• /
• pp.183-192
• /
• 2018

In recent years, coastal areas have been suffering from coastal erosion, such as destruction of coastal roads and military facilities. In this study, the Delft3D model was used to analyze the sediment transport pattern due to seasonal characteristics of summer and winter waves in Anmok beach of the East coast. Typhoon and high waves are mainly are coming from ENE direction in the summer season and the flows occur in the northward. In winter, high waves are incident from NE and the flows occur in the southward. These seasonal patterns were simulated by using Delft3D model. As for model input, reanalysis wave data of the past 38 years were used, and the seasonal patterns were analyzed by dividing the whole year into summer and winter season. The grid point of the 38 year reanalysis data is far from the Anmok beach, so the three model grid systems (wide grid -> intermediate grid -> detailed grid) are constructed. Most of the flows in the NW direction occurred in summer, but erosion and deposition was alternated along the coastline. In winter, sediment was deposited near Gangnung Port due to the southern flow and the southern port. Strong winter waves compared to summer tend to cause deposition around Gangnung Port throughout the year.

• 한국노년학
• /
• v.41 no.3
• /
• pp.397-420
• /
• 2021

The paper tried to determine relationships between volunteering and hypertension risks, symptom betterment, activity difficulty occurrences, and medicine treatment among middle-aged and older adults, with a prospective cohort study. Multilevel mixed-effects generalized linear models were used for the analysis of longitudinal panel data collected over 10 years from 2008 to 2018, using 5,867 cohort samples. The results showed that those who volunteered at least 200 hours per year were 3.4 times more lower than not-volunteering in risks of hypertension, those who volunteered yearly 50~99 hours were a lot more improved than not-volunteering in the symptom betterment, those who volunteered yearly at least 200 hours were 7.7 times lower than not-volunteering in activity difficulty occurrences, and those who volunteered yearly 50~99 hours were 2.5 times lower than not-volunteering in the occurrences of medicine treatment. These indicate that volunteering among middle-aged and older adults may have health benefits against incident hypertension. Finally the thesis discusses the study limitations, future directions of studies, and the practices implications.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.11a
• /
• pp.435-436
• /
• 2008

Dye-sensitized Solar Cells(DSSCs) which convert incident sun light into electricity were expected to overcome global warming and depletion of fossil fuels. And it is one of study that is lately getting into the spotlight because manufacturing method is more simple and inexpensive than existing silicon solar cells. In this respect, DSSCs are in the limelight as the next generation solar cells. DSSCs are generally composed of a dye-modified $TiO_2$ photoelectrode, a Pt counter electrode, and an electrolytes containing a redox couple$(I^-/I_3^-)$. Among these elements, pt electrode were prepared by applying electric potential to FTO substrate in the $H_2PtCl_6$ solution. In this study, we report the solar cell efficiency depending on $PtCl_4$ concentration change. $PtCl_4$ concentration was 1mM, 5mM, 10mM, and 20mM, and adhered on FTO glass substrate by sintering process. When applied each $PtCl_4$ counter electrode on DSSC, the best efficiency was found at 10mM of $PtCl_4$ concentration. The catalyst promotes the movement of electron from the counter electrode to the electrolyte the higher the molarity, the better the efficiency. However, in case of 20mM, it is estimated that over-deposited $PtCl_4$ tends to restrict the movement of electron due to its bundle formation.

• Journal of Radiation Industry
• /
• v.5 no.4
• /
• pp.337-345
• /
• 2011

In order to provide an effective preparedness for a nuclear or radiological emergency happening in the domestic or neighborhood countries and to solve the vague fear of the people for the ingestion of radioactive livestock products, the establishment of national guideline level for radionuclides in feed is urgently necessary. This is because it is important to secure the safety and to manage the crisis in the agricultural, fishery and food sector by performing the effective safety control during and after nuclear incident. This study was performed to investigate the report cases of international organizations and foreign countries to set up a domestic control standard for managing radioactive substances that may be contaminated in animal feeds due to the nuclear power plant incident. In addition, an attempt was made to provide a useful reference that can help prepare a domestic control standard, using a coefficient that can consider the transfer into livestock through the intake of radioactive contaminated animal feeds. The standard radioisotopes investigated were confined to radioactive cesium ($^{137+134}Cs$) and iodine ($^{131}I$). Guideline level for the radionuclides was calculated by using the transfer coefficient factor and the maximum daily intake of animal feed provided by IAEA. For example, the maximum daily intake of animal feed was set as $25kg\;d^{-1}$ for dairy cows, $10kg\;d^{-1}$ for beef cattle, $3.0kg\;d^{-1}$ for pigs and $0.15kg\;d^{-1}$ for chickens. The result values for radioactive cesium were calculated as $8,696Bq\;kg^{-1}$, $4,545Bq\;kg^{-1}$, $1,667Bq\;kg^{-1}$ and $2,469Bq\;kg^{-1}$, respectively. The results for radioactive iodine showed the ranges between $741Bq\;kg^{-1}$ and $76,628Bq\;kg^{-1}$. These data can be utilized as a scientific reference for the preparation of a crisis management manual for the emergency control due to nuclear power plant accident in Korea and neighboring country. These results will contribute to establish the safe feed management system at national level as manual for responding the radioactive exposure of agricultural products and animal feeds, which are currently not established.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.21 no.5
• /
• pp.583-590
• /
• 2015

Submarine cable installation is essentials for grid connection between existing power grid and newly produced electricity which will be from offshore wind farm in Southwest sea area of Korea. Especially, submarine cable route and protection method is designed in order to ensure the economical efficiency, workability and stability of submarine cable installation. On this paper, we will give the basic information about the submarine cable route and protection method of offshore wind farm which will be built in Southwest sea area of Korea. For this, we have a numerical simulation at high and low tide based on the third-generation wave model SWAN(Simulating WAves Nearshore) using the long term wave data from Korea Institute of Ocean Science and Technology(KIOST). The results of the study, year mean Hs is 1.03m, Tz is 4.47s and dominant wave direction is NW and SSW When the incident wave direction is NW(Hs: 7.0 m, Tp: 11.76s), the distribution of shallow water design wave height Hs was calculated about 4.0~5.0m at high tide and 2.0~3.0m at low tide. When the incident wave direction is SSW(Hs: 5.84 m, Tp: 11.15s), the distribution of shallow water design wave height Hs was calculated about 3.5~4.5m at high tide and 1.5~2.5m at low tide. The wave direction on a dominant influence in the section of longitude UTM 249749~251349(about 1.6 km) and UTM 251549~267749(about 16.2 km) in the submarine cable route are each NW and SSW. Prominently, wave focusing phenomenon appears between Wi-do and Hawangdeung-do, in this sea area is showing a relatively high wave hight than the surrounding sea areas.

• Journal of agricultural medicine and community health
• /
• v.28 no.1
• /
• pp.15-27
• /
• 2003

Objectives: This study was conducted to compare the medical care patterns of hypertensive patients between rural and urban areas. Methods: We selected one rural county(Region A where there were 19 public health centers; one health center, 8 health sub-centers and 10 community health posts) and two urban districts(Region B and C where there was no health sub-center and community health post) in Daegu city. Region B had similar socioeconomic characteristics with rural county A while region C had different characteristics. The medical insurance records of 14,422 incident patients (2,501 in region A, 4,873 in region B and 7,048 in region C) with diagnostic code of hypertension from September 1998 to August 1999 were reviewed. Incident patient was defined as a patient who had no record of medical fee claim for hypertension to the national health insurance corporation in past 6 months and visited a medical facility for hypertension for the first time. The data for annual visit days, annual prescription days and annual total medical expenses were abstracted. The medical care pattern was categorized by the number of annual visit days and prescription days. The most proper care group was defined as the patient who visited 6-15 days with 240 prescription days or more in a year. Results: The type of medical facilities for the most visit was clinics, 373.% and it was followed by general hospitals, 28.2%; public health centers, 24.7%; and hospitals, 9.8% in region A(p<0.05). In region B, it was clinics, 63.1% and followed by general hospitals, 27.6%; health center, 5.2%; and hospitals, 4.1%(p<0.05). In region C, it was clinics, 53.8% and followed by general hospitals, 35.0%; health center, 6.3%; and hospitals, 4.9%(p<0.05). Annual mean total medical expenses per patient was highest in region C(won195,993) and followed by region A(won191,683) and region B(won178,713). The proportion of the most proper care group was 7.7% in region A, 5.2% in region B and 6.7% in region C(p<0.05). According to the type of medical facilities for the first visit, the proportion of the most proper care group was highest(14.7%) in the patients of public health centers, and it was followed by general hospitals, 8.8%; clinics, 3.6%; and hospitals, 2.0% in region A(p<0.05). In region B, it was highest in general hospitals, 9.7% and followed by hospitals, 4.0%; health center, 3.6%; and clinics, 3.4%(p<0.05). In region C, it was highest in general hospitals, 10.1% and followed by clinics, 5.2%; hospitals, 4.1%; and health center, 3.1%(p<0.05). Conclusions: The proportion of proper care for hypertension was higher in rural area and it was attributed to the care of health center, sub-centers and community health posts which appeared to follow patients better than hospitals and clinics.

• Progress in Medical Physics
• /
• v.10 no.2
• /
• pp.103-114
• /
• 1999

In this study, as a preliminary study for developing a full 3D photon dose calculation algorithm, We developed 2.5D photon dose calculation algorithm by extending 2D calculation algorithm to allow non-coplanar configurations of photon beams. For this purpose, we defined the 3d patient coordinate system and the 3d beam coordinate system, which are appropriate to 3d treatment planning and dose calculation. and then, calculate a transformation matrix between them. For dose calculation, we extended 2d "Clarkson-Cunningham" model to 3d one, which can calculate wedge fields as well as regular and irregular fields on arbitrary plane. The simple Batho's power-law method was implemented as an inhomogeneity correction. We evaluated the accuracy of our dose model following procedures of AAPM TG#23; radiation treatment planning dosimetry verifications for 4MV of Varian Clinac-4. As results, PDDs (percent depth dose) of cubic fields, the accuracy of calculation are within 1% except buildup region, and $\pm$3% for irregular fields and wedge fields. And for 45$^{\circ}$ oblique incident beam, the deviations between measurements and calculations are within $\pm$4%. In the case of inhomogeneity correction, the calculation underestimate 7% at the lung/water boundary and overestimate 3% at the bone/water boundary. At the conclusions, we found out our model can predict dose with 5% accuracy at the general condition. we expect our model can be used as a tool for educational and research purpose.. purpose..