• Journal of Oriental Neuropsychiatry
• /
• v.7 no.1
• /
• pp.65-75
• /
• 1996

This paper is for studying stress condition of apprentice doctors who were in Oriental Medical Hospital. This study was done on 35 apprentice doctors who were in Kyungsang University Oriental Medical Hospital and Bulgy Oriental Medical Hospital. The Seven-Minute Stress Test of Thomas E. Sttats and 10 questions which were made by the present writer shows the following results.1. The Body stress scale was the highest point. In order of high percent, this shows Whole scale, Mind scale, Situation scale. 2. In comparison of the stress scale of men and women doctors, all the stress scale of women doctors were higher than men doctors. 3. In comparison of the stress scale of Interne and Resident doctors, Whole and Situation stress scale of Resident doctors were higher than Interne doctors, Body and Mind stress scale of Interne doctors were higher than Resident doctors. 4. The personal relation with other people was harmonious, the worst relation of the other colleague was the administrative staff, the next were nurses, senior apprentice doctors orderly. 5. In order of high percent of stressors, this shows personal relation, many works and troubles of care, the lack of private life, unsatisfactory administration system and equipment, the class system and overbearing atmospheres, education and continuous stress, bad conditions and fatigue, economic problems. 6. In order of high percent of systemic stress diseases, this shows musculo- skeletal disease, nervous disease, digestive disease, neurosis, urinary and genital disorder, opthalomo-otolaryngo disease, immunity disorder and vascular disease. In order of high percent of stress symptom, this show headache, fatigue, shoulder pain, back and leg pain, pantalgia and abdominal pain, diarrhea and dismenorrhea, stiffness of neck dizziness indigestion languor after a meal insomnia, neurasthenia lacking interest constipation menorrhalgia bloodshot eyes otitis media allergy thirst flushing edema. 7. In order of the seven mode of emotions in relation to stress, this shows anger, anxiety, isolation, melancholy, fright, sorrow, terror, overjoy.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.13 no.2
• /
• pp.1100-1123
• /
• 2019

A code-based cryptosystem can resist quantum-computing attacks. However, an original system based on the Goppa code has a large key size, which makes it unpractical in embedded devices with limited sources. Many special error-correcting codes have recently been developed to reduce the key size, and yet these systems are easily broken through side channel attacks, particularly differential power analysis (DPA) attacks, when they are applied to hardware devices. To address this problem, a higher-order masking scheme for a McEliece cryptosystem based on the quasi-dyadic moderate density parity check (QD-MDPC) code has been proposed. The proposed scheme has a small key size and is able to resist DPA attacks. In this paper, a novel McEliece cryptosystem based on the QD-MDPC code is demonstrated. The key size of this novel cryptosystem is reduced by 78 times, which meets the requirements of embedded devices. Further, based on the novel cryptosystem, a higher-order masking scheme was developed by constructing an extension Ishai-Sahai-Wagne (ISW) masking scheme. The authenticity and integrity analysis verify that the proposed scheme has higher security than conventional approaches. Finally, a side channel attack experiment was also conducted to verify that the novel masking system is able to defend against high-order DPA attacks on hardware devices. Based on the experimental validation, it can be concluded that the proposed higher-order masking scheme can be applied as an advanced protection solution for devices with limited resources.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.11
• /
• pp.1555-1561
• /
• 2018

Tracking and detecting targets by the millimeter wave seeker is affected by movement of platform. Stabilization equipments use an inertial sensor to compensate for disturbance of stabilizing gimbal or platform. In the direct line of sight stabilization system, an inertial sensor is mounted on inner gimbal to compensate the disturbance directly, so the performance is excellent and the implementation method is simple. However gimbal design requires somewhat larger volume. Since an inertial sensor is mounted on gimbal base in the indirect line of sight stabilization system, additional space of gimbal is not required for the gimbal design. However, this method does not directly compensate for the disturbance of the line of sight stabilization axis, which can degrade performance. In order to perform the tracking performance, two methods are analyzed for line of sight stabilization performance based on direct and indirect of a 2-axis gimbaled servo system for millimeter wave seeker in this study. The simulation and experimental results validate the performance comparison of two methods.

• Journal of Astronomy and Space Sciences
• /
• v.22 no.1
• /
• pp.47-58
• /
• 2005

This paper addresses development of the ultra-light analog sun sensors for small satellite applications. The sun sensor is suitable for attitude determination for small satellite because of its small, light, low-cost, and low power consumption characteristics. The sun sensor is designed, manufactured and characteristic-tested with the target requirements of ${\pm}60^{\circ}$ FOV (Field of View) and pointing accuracy of ${\pm}2^{\circ}$. Since the sun sensor has nonlinear characteristics between output measurement voltage and incident angle of sunlight, a higher order calibration equation is required for error correction. The error was calculated by using a polynomial calibration equation that was computed by the least square method obtained from the measured voltages vs. angles characteristics. Finally, the accuracies of 1-axis and 2-axes sun sensors, which consist of 2 detectors, are compared.

• Journal of Korean Society of Water and Wastewater
• /
• v.21 no.2
• /
• pp.195-201
• /
• 2007

A submerged flat-sheet membrane separation system integrated with PAC (powdered activated carbon) was used in this research in order to investigate the effects of PAC on the efficiencies of operation and treatment and to evaluate the performance of the system. The experiments were carried out under operating conditions of a filtration rate of 0.38 m/d, water temperature of $20-28^{\circ}C$, and PAC dose of 0 g/L (Run-A) and 20 g/L (Run-B). The influent concentrations of TOC (total organic carbon), $NH_4{^+}-N$ (ammonia nitrogen) and $UV_{254}$ (UV absorbance at 254 nm) were 2.48 mg/L, 1.4 mg/L and 2.53 1/m, respectively. TOC removal of 43.2 and 73.6%, ammonia nitrogen removal of 4.9 and 15.9%, and $UV_{254}$ removal of 20.6 and 31.6% were obtained for Run-A and Run-B, respectively. During an experimental period of 33 days, no change was found in TMP (Run-B), but the TMP in Run-A increased by 5 kPa after 29 days. This research showed that the filtrate quality and the performance efficiency were enhanced when PAC was introduced into the filtration system.

• Journal of IKEEE
• /
• v.1 no.1 s.1
• /
• pp.55-63
• /
• 1997

The purpose of this paper is to realize robust vector control of an induction motor without speed sensor. In order to do it, the speed of an induction motor is estimated using model reference adaptive system(MRAS) and two rotor flux observers which have robustness to the parameter variation are employed as the reference model and the adjustable model in MRAS speed estimator. The MRAS-based overall control scheme has been implemented on 2.2kW induction motor control system and it is verified that the proposed speed sensorless control scheme is more stable and robust than the conventional schemes.

• Journal of The Korean Astronomical Society
• /
• v.29 no.spc1
• /
• pp.395-396
• /
• 1996

We developed a telescope control system called ASTROS for the VST1 and VST2, which are specially designed radio telescopes to make a survey and have a 60-cm main dish. ASTROS is designed on the distributed intelligence concept and structurized programming. The hardware of the system is composed of several intelligent devices connected with de facto standard interfaces and main control unit is PC. The program is coded in the C language and its structure is object oriented in order to make easy to replace the component devices. ASTROS is now running on two twin telescopes, VST1 and VST2. VST1 is installed at Nobeyama in Japan and VST2 is installed at La Silla in Chile. They are making a galactic plane survey in CO (J=2-1) with 9 arcmin beam semi-automatically.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.28 no.7
• /
• pp.1029-1037
• /
• 2004

High-speed/precision servomechanisms have been widely used in the manufacturing and semiconductor industries. In order to ensure the required high-speed and high-precision specifications in servomechanisms, an integrated design methodology is required, where the interactions between mechanical and electrical subsystems will have to be considered simultaneously. For the first step of the integrated design process, it is necessary to obtain not only strict mathematical models of separate subsystems but also formulation of an integrated design problem. A two-degree-of-freedom controller described in the discrete-time domain is considered as an electrical subsystem in this paper. An accurate identification process of the mechanical subsystem is conducted to verify the obtained mathematical model. Mechanical and electrical constraints render the integrated design problem accurate. Analysis of the system performance according to design and operating parameters is conducted for better understanding of the dynamic behavior and interactions of the servomechanism. Experiments are performed to verify the validity of the integrated design problem in the x-Y positioning system.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.24 no.2
• /
• pp.83-93
• /
• 2020

Dynamic pressure transducer needs to be flush-mounted on hardware due to frequency response characteristics of pressure transmission system. However, it is sometimes necessary to be mounted in recessed configuration due to insufficient space for sensor installation and for protection of sensor from thermal damage. Dynamic response characteristics should be considered due to distortion of original dynamic pressure signal in the pressure transmission system. In this study, small perturbation model and 2nd order reduced model were compared with experiments and a guideline for selecting a frequency response model was suggested.

• Journal of Advanced Marine Engineering and Technology
• /
• v.38 no.5
• /
• pp.533-540
• /
• 2014

Recently, latent heat thermal energy storage system (LHTES) has gained attention in order to utilize middle temperature (373~573 K) waste heat from biomass gasification. This paper has investigated thermo-physical properties of erythritol [$CH_2OHCHOH$ $CHOHCH_2OH$], mannitol [$CH_2OH$ $(CHOH)_4CH_2OH$] and their compounds as phase change materials (PCMs). The differential scanning calorimetry (DSC) was applied to measure the melting point and latent heat of these PCMs. Also the melting and solidification characteristics of these PCMs were observed in a glass tube with a digital camera. In the DSC measurement, when the amount of mannitol content was more than 40 mass%, the melting point of these compounds show two melting points. The experimental results showed that the velocity of melting and solidification were different for every mixture ratio of compounds. These compounds had the super-cooling phenomenon during the solidification process.