• Journal of the Korean Home Economics Association
• /
• v.33 no.6
• /
• pp.179-186
• /
• 1995

The purpose of this paper was to identify bonding strength by weave (plain weave, twill weave, satin weave) and counts(20 s, 40s) of the face cloth cotton 100% in the course of sewing process using by cotton fabric of adhesive interlining. The results of the study was as follows. 1. With the increased laundry, it revealed that the bonding strength was decreased to some degree regardless of the kinds of face cloth. 2. the bonding strength by the counts of the face cloth appeared in order of 40 s<20 s. 4. It was observed that there are no significant differences on the adhesive strength in the cutting directions which are an inclination warp, weft, bias in this experiment.

• Composites Research
• /
• v.26 no.2
• /
• pp.85-90
• /
• 2013

This paper presents the fabrication and 3-point flexion testing of carbon fiber reinforced polymer (CFRP) composite face/aluminum honeycomb core sandwich panels. Specimen sandwich panels were fabricated with three honeycomb types (3.18 mm, 4.76 mm, and 6.35 mm cell size) and three panel radii (flat, r = 1.6 m, r = 1.3 m). The curved sandwiches were fabricated normally with the core in the W-direction. The tensile mechanical properties of the CFRP $2{\times}2$ twill fabric face laminate were evaluated (modulus, strength, Poisson's ratio). The measured values are comparable to other CFRP fabric laminates. The flat sandwich 3-point flexion test core shear strength results were 11-30% lower than the manufacturer published data; the test set-up used may be the cause. With a limited sample size, the 1.3 meter panel curvature appeared to cause a 0.8-3.8% reduction in ultimate core shear strength compared to a flat panel.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.9 no.1
• /
• pp.47-55
• /
• 1985

To determine the change of the mechanical properties of the wool/polyester blend fabrics in proportion to blend ratio, 10 mechanical properties were measured on 6 blend fabrics by KES-F system. Blend ratio on the 6 blend fabrics was increased by $20\%$, and the structure of the fabric were plain, 2/2 twill, respectively. And wearing performances in propoetion to blend ratio on the 6 blend fabrics were investigated. In this experiment. the following conclusions were obtained with the increase of blend ratio of polyester. 1) The values of WT, RT in tensile properties. tensile energy and elongation, and RC in compressional properties were decreased. 2) The values of B, 2HB in bending properties, 2HG. 2HG 5 in shearing properties were increased. 3) Putting on clothes, wearing performance was bad because crumbling of shape and wrinkle were easily made an appearance. Particularly it was remarkably bad as blend ratio of polyester was expressed $60\%$.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.31 no.7
• /
• pp.1097-1106
• /
• 2007

The purpose of this study is for development textile design and making fabric actually for dementia patients hospital clothing using symbol which has social care meaning. For achievement the aim, process and research methods were as follows. First the symbol design was developed. Second the symbol was applied as textile design for dementia patients hospital clothing. Symbol design was under processed with a letter 'Alzheimer' and meanings as like 'love', 'happiness' 'care' 'hope' and 12 design samples were developed by CAD and photoshop. Total 15 evaluation members chose 2 design samples. The 2 design sample were practically arrangement 7 textile design pattern with ground different colors. And finally 3 design pattern and 3 colorway were selected and add white ground. Totally 7 textile design was printed on 100% cotton, 20 yarn count, 1/2 twill. Therefore this new textile design for dementia patient's hospital clothing can be used in medical clinically and the symbol can be use for daily care item for the patients more comfort and high quality in their lives in hospital.

• Journal of Fashion Business
• /
• v.21 no.2
• /
• pp.78-90
• /
• 2017

In this study, brassiere prototype was developed for attaching the measuring module of ECG measurement and body movement while sleeping. For ECG measurement, textile electrodes was made of stretch fabric containing polyurethane in consideration of elasticity of brassiere band. It was used as a conductive yarn by silver coating on the warp. The textile electrodes was woven with twisted twill to increase the density of conductive yarns. The pressure of the brassiere band was enough to sensing stably the ECG, and the elastic band of the brassiere was designed to be wider than 3cm to install the textile electrodes inside, so that textile electrodes was close fitting to the skin at a constant pressure without lifting. The textile electrodes coated with silicon on rear was attached to brassiere elastic band, and the module was installed with a snap connector to textile electrodes of brassiere band. The module was suitable to monitering ECG measurement of a typical R peak, pulse rate and body movement while sleeping without interfering.

• Journal of the Korean Home Economics Association
• /
• v.12 no.1
• /
• pp.459-471
• /
• 1974

This study was carried out on the thermal transmission on account of variation of weaves and researched on the selection of the most suitable weaves for warmth. Also the interrelation among the density, thickness and thermal transmission by different weaves was studied, the author has woven three fundamental weaves, five weaves derived from the fundamental weaves and two special weaves for the purpose of experiment. In weaving of fabrics for experiments the lever type hand loom was used. Testing of texture was carried out according to KS and ASTM. The thermal transmission was also tested by as cooling method which were developed by the author. The conclusions of experiments were as follows. 1. Matt weaves, honey comb weaves and satin weaves having long floating yarns have large cover factor and were thicker. these structures of the weaves were good in warmth. 2. Thermal transmission was reciprocated to the cover factor, thickness and value of cover factor multiplied by thickness : It was found that the weaves of woven fabrics for warmth had better use of satin weaves, Matt weaves, Granite weaves and Honey comb weaves. In the time of warmth is not the first purpose, had better use of Rib weaves. Plain weaves and Twill weaves with thin thickness and high thermal transmission.

• Korean Journal of Heritage: History & Science
• /
• v.55 no.2
• /
• pp.146-165
• /
• 2022

The purpose of this study is to identify differences in the formative characteristics and system of Jobok by comparing the three relics Ui, Sang, and Daedae, which comprised Jeon-Sik's Jobok, with the data in the literature and five excavated Jobok relics, Sin Kyung-yu, Kwon-Woo, Hwasan-Gun, Milchang-Gun, and Lee Ik-jeong, from the 17th and 18th centuries. Jeon-Sik'sJobok was designated as a Gyeongbuk tangible cultural heritage, Sangju JeonSik Jobok and Crafts, in 2021. The three components of Jeon-Sik's Jobok are valuable as historical data since they are the oldest relics confirming colors. Regrettably, the edging fabric of the Ui made of red twill was mostly lost, with only traces remaining. Based on records, it was presumed that the edging fabric was black. It was confirmed that white decorative lines were yet to be used. In Jeon Sik's Sang, only the three front widths and one rear width remain, but the shape of the four rear widths can be inferred, and the creases were held only at the waist. Eighteenth-century Sang was connected at intervals at the end of the waist. Seventeenth-century Sang was connected with a slight overlapping of the rear Sang below the front Sang; therefore, it is assumed that Jeon Sik's Sang was also connected by overlapping the rear by more or less than 5cm below the front. After Hwasan-gun, the Sang was first made using black lines, then white lines were inserted, and, finally, it was pleated from the waist to the hem. The Daedae made the Yo and the Sin by folding the corners to form a 冂 shape with a single long band. The white Ju(紬) and the green yumunsa were used for the Daedae and the edges. This matches the color of the Daedae seen in the Jobok portraits of Milchang-gun, Lee Ik-jeong, and Jeong Hwi-ryang from the 18th century. In the 17th century, the Daedae made the Yo and the Sin by folding a long band like the Daedae of Jeon-Sik. After the 18th century, the Yo and the Sin were made separately and connected. To tie the Daedae to the waist, thin straps were attached at both ends. The relics of Jeon-Sik can be evaluated as reflecting the 17th-century Jobok system in terms of color and shape. Furthermore, it can be said that they are important historical data complementing the insufficient or inaccurate records of the Gukjoolyeui-seolye and Gyeongguk-daejeon.