• Proceedings of the IEEK Conference
• /
• 2002.06b
• /
• pp.57-60
• /
• 2002

In this paper, transmission lines with low and high characteristic impedance (Z$_{0}$) are fabricated and analyzed. The transmission lines are fabricated on the benzo-cyclo-butene (BCB) films of a low dielectric constant. For the low Z$_{0}$, two types of coplanar waveguide (CPW) structures are fabricated, which include bottom-ground and double-ground type. Measurement shows that Z$_{0}$ values for each CPW type are 7.3 and 9.4$\Omega$, respectively, at a signal line width of 100 #m. Whit the ratio between the spacing of bottom-ground and the signal line with becomes greater than 2.5, the Z$_{0}$ is nearly saturated. In addition, thin film microstrip lines fabricated using the BCB insertion layers show very low Z$_{0}$ of 25.5$\Omega$, and this impedance is ~64 % of the values obtained from the BCB-based CPW structures of the same line width. Measurement result of CPW on BCB layer is 100.5 Ω.s 100.5 Ω.

• Tuberculosis and Respiratory Diseases
• /
• v.38 no.3
• /
• pp.317-323
• /
• 1991

Pulmonary mucormycosis is an uncommon opportunistic fungal infection associated with diabetis mellitus, leukemia, lymphoma & other debilitating diseases. Their clinical presentations depend on the associated underlying disorders. Generally patients with leukemia and lymphoma often have rapidly progressive clinical course, and may cause diffuse parenchymal disease refractory to medical and surgical therapies. However, some diabetics with pulmonary mucormycosis have a striking tendency to develop a localized endobronchial disease in major airway which is amenable to therapy with surgery and Amphotericin B. We have experienced a case of endobronchial mucormycosis complicating lung abscess associated with diabetic ketoacidosis, which was cured without specific antifungal therapy or surgery. A brief review of the literature was given.

• Journal of Embryo Transfer
• /
• v.8 no.1
• /
• pp.9-12
• /
• 1993

포유동물의 초기 발생단계에서 핵의 분화와 전능성을 규명하고 제2세대 핵이시 기법을 개발하고자 생쥐를 모델로 하여 공핵란은 2-세포기에 있는 수정란의 핵을 사용하였으며, 수핵란은 zygote 및 2-세포기에 있는 수정란을 탈핵하여 제2세대 핵이식을 실시하여 electrofusion system으로 핵융합을 실시하고 cloned embryo를 작출하여 이를 24-48시간동안 체외에서 배양을 시킨 다음 위임신이 유기된 수란생쥐의 난관에 체내 이식을 실시하여 개체로의 발생 여부 등을 조사하였다. 핵이식후의 융합율은 zygote 및 2-세포기의 수정란을 수핵란으로 사용하였을 때 각각 84.7 및 84.0%으로서 차이가 없었으며, 제1세대의 86.8 마ㅊ 85.4%로서 세대간에 차이가 없었다. 4-세포기 이상으로 발달한 제2세대 핵이식 수정란의 체외배양율은 수핵란을 zygote 및 2-세포기 수정란을 사용하였을때 각각 36.2 및 43.7%로서 제1세대 핵이식의 44.3 및 50.4% 보다는 다소 낮았다. 제2세대 핵이식 수정라늘 위임신이 유기된 수란생쥐의 난관에 이식을 실시하여 얻은 산자생산율은 수핵란을 zygote 및 2-세포기 수정란을 사용하였을때 각각 23.0 및 25.0%로서 모두 25마리의 산자를 생산하였다.

• Conservation Science in Museum
• /
• v.12
• /
• pp.77-88
• /
• 2011

The study investigated conservation and fiber of 66 letters of Sukmyeonghancheob (national treasure No.1629) that the National Cheongju Museum kept. Before treatment, the cover was destroyed and inner paper was stained by water and humidity and destroyed by insects. One volume of King Hyojong was kept at separate frame. The author disassembled book and removed old Baejeobji and inspected paper quality of letter and tested fiber by using C-stain: The author reassembled one volume by including one letter separated after repairing destroyed area of the edge.

• The KIPS Transactions:PartB
• /
• v.12B no.3 s.99
• /
• pp.257-264
• /
• 2005

The number of vehicles are rapidly increased as our society is developed. The vehicle recognition has been studied for a while because many people acknowledged it has critical functions to solve the problems of traffic control or vehicle-related crimes. In this paper a novel method is proposed to recognize vehicle models corresponding makers. Vehicles' models are recognized based on the texture parameters from segmented radiator region above a number plate. A three-layer neural network was built and trained with the texture features for recognition. The proposed method shows $93.7\%$ of recognition rate and $99.7\%$ of specificity for vehicles' model.

• The KIPS Transactions:PartA
• /
• v.8A no.2
• /
• pp.157-166
• /
• 2001

A simulation package has been developed as an event-driven system that can handle the hardware configuration of STC104 and algorithm proposed in the sister paper of ‘Study on High Speed Routers(II).’After various STC104 topology of meshes, torus, and hypercubes are constructed using up to 512 switches, the performance of each topology has been analyzed under different message generation rate in terms of throughputs, latency, and packet blocking time. Modified multicast algorithms for STC104 have been proposed for STC104 after U-mesh and U-torus in order to overcome the multicasting difficulty because of the point-to-point communication method found in STC104. The performance of the multicast algorithms have been analyzed over meshes and torus configuration. Throughput gets higher in the order of mesh, torus, and hypercube. Throughput difference among topology were distinctive in the zone of high message generation rate. Latency and blocking time increased in the order of hypercube, torus, and mesh. U-mesh and U-torus of software multicast showed similar throughput, however, U-mesh peformed slightly better result. These algorithms showed eight to ten times better results compared to individual message pass for 90 destination nodes. Multi-link environment also showed better performance than single-link environment because multi-link network used the extra links for communication.

• The KIPS Transactions:PartA
• /
• v.8A no.2
• /
• pp.147-156
• /
• 2001

A high performance routing switch is an essential device to either the high performance parallel processing or communication networks that handle multimedia transfer systems such as VOD. The high performance routing chip called STC104 is a typical example in the technical aspect which has 32 bidirectional links of 100Mbps transfer sped. It has exploited new technologies, such as wormhole routing, interval labeling, and adaptive routing method. The high speed router has been applied into some parallel processing system as a single chip. However, its performance over the various interconnection networks with multiple routing chips has not been studied. In this paper, the strucrtures and characteristics of the STC104 have been investigated in order to evaluate the high speed router. Various topology of the STC104, such as meshes, torus, and N-cube are defined and constructed. Algorithms of packet transmission have been proposed based on the interval labeling and the group adaptive routing method implemented in the interconnected network. Multicast algorithms, which are often requited to the processor networks and broadcasting systems, modified from U-mesh and U-torus algorithms have also been proposed overcoming the problems of point-to-point communication.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2017.05a
• /
• pp.67.1-67.1
• /
• 2017

구리는 탄성이방성이 큰 재료로 Si 박막상에 성장시키면 (111) 방향으로 우선 배향된 박막을 얻을 수 있다. 본 연구는 이러한 (111) 우선 방위를 갖는 Cu 박막의 전기도금층의 재결정 후의 매우 평탄한 표면을 갖는 박막에서 에칭에 따른 박막의 단차와 표면형상을 통해 결정방위별 에칭 특성을 비교 분석한 결과이다. 10 vol% 질산용액에서 에칭한 결과는 구리의 용해에 따라 각 결정면에 대한 고유의 facetted surface morphology를 나타내며, 대표적인 결정 방위인 (111), (110), (100)에 대해 triangular flake, ridge and rectangular pyramidal shapes을 나타내는 것을 알 수 있었다. 에칭속도의 정량적 측정을 위해 120초간 2.2M 농도의 질산용액으로 에칭을 실시하였고, nanosize의 as-plated initial region, (111), (110), (100) oriented regions의 각각에서 383, 270, 276, 317 nm/min의 에칭속도를 갖는 것을 확인하였다. Facet surface의 관찰을 통해 에칭반응이 (111) front surface를 갖는 열역학적 평형상태에서 일어나며, 이러한 결정방위별 에칭속도 차이는 각 결정S면이 갖는 Kink or ledge의 밀도의 차이에 기인할 것으로 판단된다. 즉, 에칭이 평형상태에서 step flow mechanism에 의해 열역학적 평형상태를 유지하면서 진행이 된다. 본 연구는 향후 다양한 에칭관련 용액 효과, 구리 박막의 응력 및 불순물에 의한 효과를 볼 수 있는 기본 방법을 제공해 줄 것으로 기대한다.

• Korean Journal of Animal Reproduction
• /
• v.14 no.3
• /
• pp.205-211
• /
• 1990

Single nuclei from two-, four- and eight-cell mouse embryos were transplanted into enucleated two-cell mouse embryos by micromanipulation and sendai virum mediated fusion. no significant difference in successful injectin rate and fusion rate was found between the cell stages of nuclear donor embryos. There nuclear transplant embryos receiving different cell stage nuclei were cultured in vitro for 96 hours. 75.3% of 255 embryos receiving 2-cell nuclei, 68.2% of 236 embryos reciving 4-cell nuceli and 46.9% of 228 embryos receiving 8-cell nuclei were developed to blastocyst, respectively. The number of blastomeres was significantly(P<0.05) reduced in the embryos receiving 8-cell nuclei, compared with the embryos receiving 2-cell, 4-cell nuclei or the intact embryos. Also the size of blastocysts was significantly(P<0.05) smaller in the embryos receiving 8-cell nuclei, compared with the intact or other nuclear transplant embryos. These results suggest that single nuclei introduced into the enucleated two-cell embryos are able to support the in vitro development of the reconstituted embryos to blastocysts. The prominant retardation of blastocoele formation and cell division was shown in nuclear transplant embryos receiving eight-cell nuclei when they were cultured in vitro.

• Fire Science and Engineering
• /
• v.29 no.6
• /
• pp.129-138
• /
• 2015

This study investigates the influence of transformational and transactional leadership styles of commanders in fire service organizations on organizational commitment and job satisfaction. A survey was conducted with the staffs of four fire stations in Gyeonggi Province. The results show that the charismatic characteristics of transformational leadership and the management by exception of transactional leadership positively influence both organizational commitment and job satisfaction. This indicates that the fire officers can be devoted to their organizations and be satisfied with their jobs when their supervisors give directions with charisma and vision and when they delegate authority to the fire officers except in particular situations.