• Journal of Korean Ophthalmic Optics Society
• /
• v.14 no.3
• /
• pp.43-49
• /
• 2009

Purpose: The purpose of this study was to obtain the fundamental data of dynamic visual acuity and dynamic stereoacuity. Methods: The subjects were 20 athletes (high school baseball player) and 40 nonathletes (20 male, 20 female). We assessed static visual acuity, dynamic visual acuity, static stereoacuity and dynamic stereoacuity using rotating mirror projection system and computer program. Results: Three groups had similar static visual acuity and static stereoacuity. On the other hand, the dynamic visual acuity and dynamic stereoacuity showed statistically significant differency. The mean dynamic visual acuity for athletes was 174.80${\pm}$28.70 deg/sec, 137.10${\pm}$16.54 deg/sec for male nonathletes and 111.59${\pm}$15.40 deg/sec for female nonathletes. The mean dynamic stereoacuity for athlets was 234.55${\pm}$19.64, 249.05${\pm}$8.86 for male nonathletes and 247.10${\pm}$14.89 for female nonathletes. The group of athletes had better dynamic visual acuity and dynamic stereoacuity. Conclusions: If the result of this study apply to sports, it will be very useful to improve sports performance.

• Elastomers and Composites
• /
• v.38 no.3
• /
• pp.213-226
• /
• 2003

The cure and rheological behavior of diglycidyl ether of bisphenol F/nadic methyl anhydride resin system with the kinds of imidazole were studied using a differential scanning calorimeter (DSC) and a rotational rheometer. The isothermal traces were employed to analyze cure reaction. The DGEBF/ anhydride conversion profiles showed autocatalyzed reaction characterized by maximum conversion rate at $20{\sim}40 %$ of the reaction. The rate constants ($k_1,\;k_2$) showed temperature dependance, but reaction order did not. The reaction order (m+n) was calculated to be close to 3. There are two reaction mechanisms with the kinds oi catalyst. The gel time was determined by using G'-G" crossover method, and the activation energy was obtained from this results. From measurement of rheological properties it was found that the logarithmic 1:elation time of fused silica filled DBEBF epoxy compounds linearly increased with the content of filler and decreased with temperature. The highly filled epoxy compounds showed typical pseudoplastic behavior, and the viscosity of those decreased with increasing maximum packing ratio.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.33 no.6
• /
• pp.419-426
• /
• 2020

The structural design of the steel eccentrically braced frame (EBF) was developed and analyzed in this study through multiobjective optimization (MOO). For the optimal design, NSGA-II which is one of the genetic algorithms was utilized. The amount of structure and interfloor displacement were selected as the objective functions of the MOO. The constraints include strength ratio and rotation angle of the link, which are required by structural standards and have forms of the penalty function such that the values of the objective functions increase drastically when a condition is violated. The regulations in the code provision for the EBF system are based on the concept of capacity design, that is, only the link members are allowed to yield, whereas the remaining members are intended to withstand the member forces within their elastic ranges. However, although the pareto front obtained from MOO satisfies the regulations in the code provision, the actual nonlinear behavior shows that the plastic deformation is concentrated in the link member of a certain story, resulting in the formation of a soft story, which violates the capacity design concept in the design code. To address this problem, another constraint based on the Eurocode was added to ensure that the maximum values of the shear overstrength factors of all links did not exceed 1.25 times the minimum values. When this constraint was added, it was observed that the resulting pareto front complied with both the design regulations and capacity design concept. Ratios of the link length to beam span ranged from 10% to 14%, which was within the category of shear links. The overall design is dominated by the constraint on the link's overstrength factor ratio. Design characteristics required by the design code, such as interstory drift and member strength ratios, were conservatively compared to the allowable values.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.50 no.1
• /
• pp.1-12
• /
• 2022

Wind tunnel test for a small scale electric ducted fan with a 104mm diameter was conducted to analyze the aerodynamic characteristics when it was used as a propulsion system of tilt-propeller UAV. Experimental conditions were derived from flight conditions of a sub-scaled OPPAV. Forces and moments of the ducted fan model were measured by a 6-axis balance and 3-dimensional wake vectors which could induce an aerodynamic influence in the vehicle were measured by 5-hole probes. Thrust and torque on hover and cruise conditions were measured and analyzed to drive out the operating conditions when it was applied in the sub-scaled OPPAV. On transition conditions, thrust keep its value with tilt angle variation below 40° and increase after that. But, sideforce increase constantly until 75°. The maximum axial velocity in the wake on hover and cruise conditions was around 60m/s and tangential velocity was around 12m/s. The position of the maximum axial velocity and vortex center move off the fan rotation center line as the tilt angle increases.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.35 no.3
• /
• pp.141-148
• /
• 2022

In this study, the structural behavior of reinforced concrete members under simultaneous axial and blast loads was analyzed. Nonlinear dynamic analysis verification was performed using the experimental data of panels under fundamental blast load as well as those of reinforced concrete columns subjected to axial and blast loads. Because Autodyn is a program designed only for dynamic analysis, an analysis process is devised to simulate the initial stress state of members under static loads, such as axial loads. A total of 80 nonlinear dynamic finite element analysis procedures were conducted by selecting parameters corresponding to axial load ratios and scaled distances ranging 0%~70% and 1.1~2.0 (depending on the equivalent of TNT), respectively. The structural behavior was compared and analyzed with the corresponding degree of damage and maximum lateral displacement through the changes in axial load ratio and scaled distance. The results show that the maximum lateral displacement decreases due to the increase in column stiffness under axial loads. In view of the foregoing, the formulated analysis process is anticipated to be used in developing blast-resistant design models where structural behavior can be classified into three areas considering axial load ratios of 10%~30%, 30%~50%, and more than 50%.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.50 no.2
• /
• pp.127-135
• /
• 2022

Compared to the continuous increase of domestic nano-satellite development cases, the initial communication success rate is relatively low. In a situation where communication cases of LEO satellites using commercial satellite communication networks are increasing recently. In this situation, the SNIPE project developed by the KASI(Korea Astronomy and Space Science Institute), KARI(Korea Aerospace Research Institute), and Yonsei University apply an Iridium module for communication test to the SNIPE nano-satellites. Therefore, in this paper, the visibility analysis of the iridium module on the SNIPE satellite was analyzed under considering the orbital and communication environment of the iridium satellite constellation and the attitude control mode. In the case of LEO satellites, the communication possibility was limited due to the relatively small iridium communication coverage for high altitude and the high doppler shift considered in the iridium communication network. For this reason, in this paper, it could be simulated that there was a more performance difference according to the difference in relative RAAN(Right Ascension of Ascending Node) angle with the Iridium constellation. Finally, by checking the visibility of communication module under the tumbling situation that occurred during the initial deployment of the nano-satellite, the possibility of using the iridium communication technology was analyzed.

• The Journal of the Korea Contents Association
• /
• v.22 no.10
• /
• pp.195-212
• /
• 2022

Based on the kinetic typography principle and the structure features of Chinese characters, this study took the Chinese'24 solar terms' theme dynamic poster as the research object, explored the visual expression of dynamic Chinese characters, and tried to summarize the visual expression law of Chinese characters in dynamic poster design. It can be found that, there could be 6 different types of Chinese character expressions in the 24 solar terms poster design. Among them, 'Drawing' design method has the meaning of text structure and form expression, and 'Assembling' design method has the meaning of text stroke and texture association, also, 'Forming' design method bring its meaning through stroke deformation, 'Transforming' design method conveys the content through text disintegration, 'Replacing' design method mainly bring the meaning through simulation, while 'Rotation' design method always express through visual three-dimensional and space. Finally, the findings could not only provide analytical logic and methods for the expression of Chinese characters in dynamic poster design, but also fill the lack of formative research on dynamic Chinese characters, which hopefully provide basic information for the research related to dynamic Chinese character structure, as well as the dynamic poster designers.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.26 no.2
• /
• pp.63-81
• /
• 2021

In this study, we investigated the tide-induced flow patterns near the ocean outfall of the Jeju and Bomok Wastewater Treatment Plants (WTP) in Jeju Island by using measurements of Acoustic Doppler Current Meter (ADCP) and a numerical experiment with inserting passive tracer into a regional ocean model. In late spring of 2018, the ADCP measurements showed that tidal currents dominate the flow patterns as compared to the non-tidal components in the outfall regions. According to harmonic analysis, the dominant type of tides is mixed of diurnal and semi-diurnal but predominantly semidiurnal, showing stronger oscillations in the Jeju WTP than those in the Bomok WTP. The tidal currents oscillate parallel to the isobath in both regions, but the rotating direction is different each other: an anti-clockwise direction in the Jeju WTP and a clockwise in the Bomok WTP. Of particular interest is the finding that the residual current mainly flows toward the coastline across the isobath, especially at the outfall of the Bomok WTP. Our model successfully captures the features of tidal currents observed near the outfall in both regions and indicates possibly high persistent pollutant accumulation along the coasts of Bomok.

• Journal of the Society of Disaster Information
• /
• v.19 no.3
• /
• pp.710-718
• /
• 2023

Purpose: The purpose of this study is to objectify the analysis results using the disaster safety awareness survey for high school students, which has been systematically and continuously educated since the Ferry Sewol disaster, and to promote educational effects by identifying the educational status. Method: The 12 questions of the disaster safety awareness survey were answered using the direct entry method on a Likert 5-point scale, and the SPSS 24 and varimax (orthogonal rotation) methods were used to establish and test research hypotheses. Result: As a result of the verification, it was found that the independent variables, knowledge competency and attitude competency, had a positive effect on the dependent variable, behavioral competency, and there was no multicollinearity, so it was verified that it was meaningful. Conclusion: As a result of the survey analysis, domestic disaster safety education showed a significant impact on the level of disaster safety awareness as an education that meets its goals. Various aspects of disasters show that the educational effect can be improved only when education is established as education by life cycle.

• Journal of the Korean Geotechnical Society
• /
• v.22 no.12
• /
• pp.67-76
• /
• 2006

The reasonable assessment of the shear stiffness of a dredged soft ground and soft clay is difficult due to the soil disturbance. This study addresses the development and application of a new in-situ shear wave measuring apparatus (field velocity probe: FVP), which overcomes several of the limitations of conventional methods. Design concerns of this new apparatus include the disturbance of soils, cross-talking between transducers, electromagnetic coupling between cables, self acoustic insulation, the constant travel distance of S-wave, the rotation of the transducer, directly transmitted wave through a frame from transducer to transducer, and protection of the transducer and the cable. These concerns are effectively eliminated by continuous improvements through performing field and laboratory tests. The shear wave velocity of the FVP is simply calculated, without any inversion process, by using the travel distance and the first arrival time. The developed FVP Is tested in soil up to 30m in depth. The experimental results show that the FVP can produce every detailed shear wave velocity profiles in sand and clay layers. In addition, the shear wave velocity at the tested site correlates well with the cone tip resistance. This study suggests that the FVP may be an effective technique for measuring the shear wave velocity in the field to assess dynamic soil properties in soft ground.