• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.1
• /
• pp.456-463
• /
• 2019

Micro climatic conditions within the livestock facility are affected by various factors such as ventilation, cooling, heating, insulation and latent and sensible heat generation from animals. In this study, numerical BES method was used to simulate energy flow inside the poultry house. Based on the BES method and THI concept, degree of thermal stress of poultry was evaluated according to the locations in South Korea. Comparison of THI values within the poultry house was also carried out according to the stocking densities to reflect recent animal-welfare issue. Significant decrease in thermal stress of poultry was observed when the stocking density of $30kg/m^2$ was applied in the change of the seasons(p<0.05) however, there was no statistically significant difference in summer season(p>0.05). It meant that installation of proper cooling system is urgently needed. For Iksan city of Jeollabuk-do province, total 252 hours of profit for thermal stress was found according to decrease in the stocking density.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.25 no.5
• /
• pp.617-626
• /
• 2019

This study analyzes the optimal location of gas detectors through the gas dispersion in a cargo compressor room of a 174K LNG carrier equipped with high-pressure cargo handling equipment; in addition, we propose a reasonable method for determining the safety regulations specified in the new International Code of the Construction and Equipment of Ships Carrying Liquefied Gases in Bulk (IGC). To conduct an LNG gas dispersion simulation in the cargo compressor room-equipped with an ME-GI engine-of a 174 K LNG carrier, the geometry of the room as well as the equipment and piping, are designed using the same 3D size at a 1-to-1 scale. Scenarios for a gas leak were examined under high pressure of 305 bar and low pressure of 1 bar. The pinhole sizes for high pressure are 4.5, 5.0, and 5.6mm, and for low pressure are 100 and 140 mm. The results demonstrate that the cargo compressor room will not pose a serious risk with respect to the flammable gas concentration as verified by a ventilation assessment for a 5.6 mm pinhole for a high-pressure leak under gas rupture conditions, and a low-pressure leak of 100 and 140 mm with different pinhole sizes. However, it was confirmed that the actual location of the gas detection sensors in a cargo compressor room, according to the new IGC code, should be moved to other points, and an analysis of the virtual monitor points through a computational fluid dynamics (CFD) simulation.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.22 no.2
• /
• pp.593-601
• /
• 2021

The axial fan is an element of a blower used for ventilation in various industrial fields. Many studies on aerodynamic performance have been conducted to assess axial fans using fluid dynamics. The subject was a large axial fan size, 1800 mm in diameter with 100 horsepower. The blower's axial fan consisted of blades, hubs, hub caps, and bosses are important components. The blade design has a great influence on the aerodynamic performance. 3D point data is extracted using an aerodynamic performance prediction program, and a 3D modeling shape is generated. The blades and hubs, which are important components, can be easily modified if processed by cutting owing to the environment in which blades and hubs are manufactured through die casting or gravity casting. In this study, the structural safety of components and the analysis results of weak areas at the rated operating speed of the axial fan were verified using the maximum stress and safety factor. The tip clearance reflected in the design was the rotation of the blade. To check whether there is interference with other components, the displacement result was derived to verify the structural safety of the axial fan.

• Journal of Advanced Marine Engineering and Technology
• /
• v.40 no.3
• /
• pp.157-164
• /
• 2016

In this study, researchers performed preliminary design and numerical analysis for a pilot-scale helium heating system intended to support full-scale construction for a sulfur-iodine (SI) cycle. The helium heat exchanger used a liquefied petroleum gas (LPG) combustor. Exhaust gas velocity at the heat exchanger outlet was approximately 40 m/s based on computational thermal and flow analysis. The maximum gas temperature was reached with six baffles in the design; lower gas temperatures were observed with four baffles. The amount of heat transfer was also higher with six baffles. Installation of additional baffles may reduce fuel costs because of the reduced LPG exhausted to the heat exchanger. However, additional baffles may also increase the pressure difference between the exchanger's inlet and outlet. Therefore, it is important to find the optimum number of baffles. Structural analysis, followed by thermal and flow analysis, indicated a 3.86 mm thermal expansion at the middle of the shell and tube type heat exchanger when both ends were supported. Structural analysis conditions included a helium flow rate of 3.729 mol/s and a helium outlet temperature of $910^{\circ}C$. An exhaust gas temperature of $1300^{\circ}C$ and an exhaust gas rate of 52 g/s were confirmed to achieve the helium outlet temperature of $910^{\circ}C$ with an exchanger inlet temperature of $135^{\circ}C$ in an LPG-fueled helium heating system.

• Tuberculosis and Respiratory Diseases
• /
• v.44 no.5
• /
• pp.1040-1050
• /
• 1997

Pulmonary rehabilitation has been known to improve dyspnea and exercise tolerance in patients with chronic lung disease, although it does not improve pulmonary function. The mechanism of this improvement is not clearly explained till now; however some authors suggested that the improvement in the skeletal muscle metabolism after the rehabilitation could be a possible mechanism. The metabolc changes in skeletal muscle in patients with COPD are characterized by impaired oxidative phosphorylation which causes early activation of anaerobic glycolysis and excess lactate production with exercise. In order to evaluate the change in the skeletal muscle metabolism as a possible cause of the improvement in the exercise tolerance after the rehabilitation, noninvasive $^{31}P$ magnetic resonance spectroscopy(MRS) of the forearm flexor muscle was performed before and after the exercise training in nine patients with chronic lung disease who have undertaken intensive pulmonary rehabilitation for 6 weeks. 31p MRS was studied during the sustained isometric contraction of the dominant forearm flexor muscles up to the exhaustion state and the recovery period. Maximal voluntary contraction(MVC) force of the muscle was measured before the isometric exercise, and then 30% of MVC force was constantly loaded to each patient during the isometric exercise. After the exercise training, exercise endurance of upper and lower extremities and 6 minute walking distance were significantly increased(p<0.05). There were no differences of baseline intracellular pH (pHi) and inorganic phosphate/phosphocreatine(Pi/PCr). After rehabilitation pHi at the exercise and the exhaustion state showed a significant increase($6.91{\pm}0.1$ to $6.99{\pm}0.1$ and $6.76{\pm}0.2$ to $6.84{\pm}0.2$ respectively, p<0.05). Pi/PCr at the exercise and the recovery rate of pHi and Pi/PCr did not show significant differences. These results suggest that the delayed intracellular acidosis of skeletal muscle may contribute to the improvement of exercise endurance after pulmonary rehabilitation.

• Journal of Advanced Marine Engineering and Technology
• /
• v.38 no.6
• /
• pp.704-709
• /
• 2014

Plate heat exchanger is being applied in the field of marine plants and chemical industry, such as OTEC and SWAC equipment. The study aims to interpret the heat transfer and pressure drop characteristics of plate heat exchangers to determine the geometric design parameters such as the channel space. In this study, heat transfer performance was numerically studied with respect to the variation of channel spaces. The results from numerical analysis indicated that the j factor was linearly decreased with the flowrate of seawater over every cases. As the flowrate of water increased with respect to channel spaces, the j factor decreased linearly. And the f factor decreased linearly with the increase of flowrate. When the channel space is 2.8~3.2 mm and 3.2~3.2 mm, respectively, the area goodness factor of plate heat exchanger showed the highest performance.

• Cartoon and Animation Studies
• /
• s.32
• /
• pp.1-21
• /
• 2013

Silhouette Animation has been recognized as a genre of animation since the very beginning of the animation history, and also Its segmental movement and Aesthetic expression has led a variety of semantic interpretations. Especially the French animation director, Michel Ocelot, recently integrated 3-dimensional digital to the silhouettes animation, and it extended the possibility of the silhouettes animation in many aspects. In his latest animation feature, , he showed how he made changes in 3-dimension by creating and evolving his own way and style of silhouette animation. Although mainstream digital animations preferably to show realistic images and motion, Michel Ocelot used very selective movement, subjective digital colors and extended space which couldn't be expressed in the way of creating traditional style of silhouette animation. This alternative slow movement and the unique aesthetics in 3-dimension emphasize the unconscious elements of color, composition, patterns, and it provides digitally enhanced images and pictorial impression. In addition, the acquisition of digital three-dimensional use of space made possible to provides the wider formative imagination to the audience. In this paper, we analyzed aesthetic characteristics of the digital silhouette animation, (2011), specially focusing on the aspects of Movement, Image, Space, which could not be found in the traditional silhouette animation. It is significant to obtain diversity of the future digital animation and its positive development. In addition, this provides opportunity to explore Michel Ocelot's new experiments and animation philosophy.

• Journal of Energy Engineering
• /
• v.26 no.4
• /
• pp.92-99
• /
• 2017

In Korea, the zero energy building was designated as the 7 new industries in the Ministry of Land and the 8 new industries in the Ministry of Industry. In order to maximize the insulation performance of the building envelope, improve the efficiency of building equipment, We are aiming. It is necessary to analyze the energy requirements of the buildings (cooling, heating, hot water supply, lighting, ventilation) of buildings with energy efficiency level of 1++ which is equivalent to the zero energy building certification system in Korea, It is aimed to be used as basic data for the advancement of energy building certification system. Zero Energy Building certification is estimated to be 61 buildings by 2017, and the approximate reference value and the first energy requirement for each of the five loads are calculated considering passive and active aspects. It is difficult to say that it is a clear standard because there is a small sample of data for calculating the load standard. However, it is necessary to interpret various methods in order to upgrade the Zero Energy Building certification standard in the future.

• Journal of Digital Convergence
• /
• v.13 no.5
• /
• pp.177-185
• /
• 2015

The gender difference in social roles affects digital devices' utilization differences in man and woman even in the 21st Century. Prior studies analyze the digital divide (genders, ages, etc.) from the assessment perspectives of digital equipment, such as PCs. In the area of high speed internet, most functions of PCs have been replaced with smartphones, and around 80% of the mobile phone users adopt smartphones. Subsequently the inequality of physical access to the digital devices is no longer a criterion for digital divide. The focus on digital divide should be shifted from the physical access to other factors, such as socio-technical or socio-cultural ones. This paper examines utilization of women's digital equipment, in particular, preparing for tourism activities, which is popular but sensitive to the technology. A survey was conducted with participants of [Suncheon Garden Expo] 2013. The results of this study capture the inactive use of digital devices particularly women over 50s. This phenomenon (high utilization of the digital devices for social or informative purposes, but low utilization of the digital payment) implies other aspects of Korean women (economic independence, low self-assertion, technical difficulties, etc.), which is considered from the socio-technological convergence perspective. This study also has a practical implication on the side of the digital device developers as well as marketing, where the qualitative communication is likely to be incorporated for the women over 50s.

• Archives of design research
• /
• v.17 no.1
• /
• pp.25-36
• /
• 2004

The purpose of this study is to analyse and interpret the way of differentiated expression and changing creative trend following 5-day workweek which has been recently adopted. For this aim 11 pieces of distinctive advertising text were analysed. The criteria for selection of analysing text were relativeness with 5-day workweek and cognitive inconsistency. These texts were negative phrases, exaggerated expression, and excessively humorous appeals. The study revealed the followings: First, 5-day workweek concerned advertising texts were considered as high attention getting and successful in stimulating advertising audiences' curiosity by using the elements opposing the value and belief system formed in the existing audience. Second, consumption-driving lifestyle was found in most expressions for credit cards advertising. Third, hedonic need-oriented lifestyle was typical in young consumer products category. Fourth, family centered lifestyle emphasized meaning of rest and solidarity of family.