• Journal of Bio-Environment Control
• /
• v.29 no.1
• /
• pp.73-79
• /
• 2020

The objective of this study is to analyze the heat transfer loss of covering materials in a single-span plastic greenhouse under the steady-state wind environment. To achieve this objective, the following were conducted: (1) design of a small-scaled wind tunnel (SCWT) to analyze heat losses of the greenhouse and its performance; (2) determination of the overall heat transfer coefficient (OHTC) for the covering materials using a small-scaled greenhouse model. The SCWT consists of the blowing, dispersion, steady flow, reduction and testing areas. Each part of the SCWT was customized and designed to maintain air flow at steady state and to minimize the variances in the SCWT test. In this study, the OHTCs of the covering materials were calculated by separating each with the roof, side wall, front and back of the small-scaled greenhouse model. The results of this study show that the OHTC of the roof increases as wind speed increases but the zones in which the increase rate of the OHTC decreased, were distinguished by wind tunnel wing speed of 2 ms^-1. For the side wall, the increase rate of the OHTC was particularly higher in the 0-1 ms^-1 zone.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.34 no.10
• /
• pp.1367-1375
• /
• 2010

In this study, optimization of the process parameters of the resistance spot welding of a sheet of aluminum-coated boron alloyed steel, 22MnB5, used in hot stamping has been performed by a Taguchi method to increase the strength of the weld joint. The process parameters selected were current, electrode force, and weld time. The heating temperature and heating time of 22MnB5 are considered to be noise factors. It was known that the variation in the thickness of the intermetallic compound layer between the aluminum-coated layer and the substrate, which influences on the formation of nugget, was generated due to the difference of diffusion reaction according to heating conditions. From the results of spot weld experiment, the optimum weld condition was determined to be when the current, electrode force, and weld time were 8kA, 4kN, and 18 cycles, respectively. The result of a test performed to verify the optimized weld condition showed that the tensile strength of the weld joint was over 32kN, which is considerably higher than the required strength, i.e., 23kN.

• Korean Journal of Organic Agriculture
• /
• v.24 no.1
• /
• pp.61-71
• /
• 2016

This study was carried out to investigate antimicrobial activities of water extracted Pleurotus ostreatus var Heuktari (PO), and their application to F. fujikuroi Nirenberg growth inhibition material. Various organic solvents (chloroform, hexane, ethyl acetate, ethanol) were tested to investigate the antimicrobial activities of Pleurotus ostreatus var Heuktari against F. fujikuroi Nirenberg. Chloroform, hexane, ethyl acetate and hot water extracts had no antimicrobial activities, but butanol extract showed 2.5% strong activities in order of F. fujikuroi Nirenberg disk diffusion test. Then we observe Antifungal activity using green house. Bed soil and mushroom extract mixed at 10%, 7.5%, 5%, 2.5%, 1% total bed soil mass. Screening of Antifungal activity was tested two periode 18day and 25day. The Antifungal activity rate of each period and extract density was 7.5% mixed bedsoil has investigated 80% Antifungal activity rate. The result indicates that the Pleurotus ostreatus var Heuktari extract using F. fujikuroi Nirenberg registance, which shows the development of organic agriculture seed disinfectant.

• Journal of fish pathology
• /
• v.5 no.1
• /
• pp.37-48
• /
• 1992

Antibiotics are chemical substances produced by various species of microorganisms that suppress the growth of other microorganisms or may destroy them. Among the more than 4000 antibiotics that has been identified, about 20s are using as the therapy of infectious fish diseases. There are several methods used to classify and group antibiotics, and the most common classification has been based on chemical structure and proposed mechanism of action. The effect of antibiotics may be determined by the kind of fish pathogens and by the external environment surrounded the infected fish. It implies that the kind of antibiotics and its application method should be decided after the determination of the reasons of fish disease. The uncontrolled usages of antibiotics may induce the selection of resistant mutants appeared spontaneously and present in any group of bacteria. The epidemic spread of such antibiotic resistant strains of fish pathogenic bacteria already has been reported in various districts of japan. Importantly, transferable drug resistant(R) plasmids were detected in strains of most of fish pathogens. Based on those reports, the antimicrobial resistance appears to be a rapidly emerging problem in the fish industry on the country. The expanding literatures on the pharmacokinetics, clinical trials, withdrawal periods and efficacy of environmental effect for the commonly using antibiotics have met the needs of data for the practical application of antibiotics. However, the most important thing for the treatment of fish diseases would be the communication and exchanging of information between the site of aquaculture and the diagnostic laboratory.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.37 no.3
• /
• pp.541-547
• /
• 2017

In Yongwon channel, its natural flow of seawater is blocked by the construction of Busan Newport including the container berth. The channel was transformed into a narrow and long one, where it is possible that ships are only allowed to pass through the north-side channel of Gyeonmado located at the point of river mouth to Songjeongcheon. So it is considered that the changes in the terrain characteristics of Yongwon channel is likely to alter the circulation of sea water, thereby changing its water quality. Contaminants are accumulated from the sediment release. In this study, before and after dredging the sediment release test was performed. As a result, after the sediment dredging is performed, the reduction rate was higher at the same point. The results show that the water quality can be improved by dredging. Each group (A~C) reduction rate of the evaluation of the reduction rate of 4.64% T-N, 18.00%, 18.59%, respectively. T-P rate of 24.75% reduction, 24.17%, 44.08%, respectively. COD reduction rate was 18.57%, 19.76%, 38.08%, respectively. These results can be used as basic data for controlling the contamination by dredging in Yongwon channel.

• Journal of Korean Society of Environmental Engineers
• /
• v.30 no.4
• /
• pp.446-452
• /
• 2008

This study was conducted to research the biosorption characteristics using algae, Spirulina platensis, for the removal of Pb and Cu ions in wastewater. Both of free algal cell and immobilized algae by Ca-alginate were used as bioadsorbent, and experiment was proceed in batch reactor for Pb and Cu ions removal, respectively. In the biosorption of Pb and Cu ions by free Spirulina platensis cell, the adsorption equilibrium reached within 20 minute. The higher adsorbed amount of Pb and Cu was shown as increasing of initial concentration of Pb and Cu, and pH of solution, respectively, and the optimum pH was 4.5$\sim$5.0. Under the conditions of initial concentration of Pb or Cu are 200 mg/L, the maximum amounts of Pb and Cu adsorbed to the unit weight of Spirulina platensis were 86.43 and 57.02 mg/g, respectively, and these values were 1.94 and 1.48 times higher than those of activated carbon under same conditions, respectively. The biosorption kinetics of Pb and Cu ions by free Spirulina platensis cell fitted very well to the Freundlich and Langmuir isotherm. The maximum amount of Pb or Cu adsorbed to the unit mass of adsorbent by the Langmuir isotherm($q_{max}$) represented as 95.24 and 62.50 mg/g, respectively. The FT-IR results of free Spirulina platensis biomass showed that biomass has different functional groups and these functional groups are able to react with metal ions in aqueous solution. In the biosorption of Pb and Cu ions by Ca-alginate immobilized algae Spirulina platensis, the adsorption equilibrium reached within 40 min. and observed a little diffusion limitation differed from the free algal cell adsorption.

• Journal of Korean Society of Environmental Engineers
• /
• v.35 no.5
• /
• pp.356-362
• /
• 2013

An attempt has been made to optimize elongated rotating arc plasma $NH_3$ scrubber. Among diverse semiconductor processes, diffusion and implantation process inevitably produce $NH_3$ as byproduct and efficient dry process for the decomposition of $NH_3$ is required. Plasma process does not produce NOx that is commonly produced in combustion process and there is no problem of deactivation, usually experienced in catalyst process. However, plasma process uses electrical energy and needs to be optimized to achieve feasibility of application. In this work, mode control of rotating arc is presented as tentative solution for the possible optimization of the process. Based on existing rotating arc, scale-up and following mode mapping was tried. Proposed reactor design was evaluated in the $NH_3$ decomposition process and revealed that optimization scheme is at hand. In the experiment of full scale scrubber including heat exchanger, the process gave more stable and efficient process of $NH_3$ decomposition.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.5 no.1
• /
• pp.53-64
• /
• 2007

The dynamic release behavior of Cs from high burn-up spent PWR fuel was experimentally performed under the conditions of a thermal treatment process such as voloxidation and sintering conditions. In voloxidation process, influence of the oxidation and reduction atmosphere on the Cs release characteristic using fragment type of spent fuel heated up to $1,500^{\circ}C$ was compared. In sintering process, temperature history effect on Cs release behavior was evaluated using green pellet under 4% $H_2/Ar$ environment. Temperature range for complete Cs release from spent fuel fragment under voloxidation condition was about $800^{\circ}C{\sim}1,200^{\circ}C$, but that of green pellet under the reduction atmosphere was $1,100^{\circ}C{\sim}1,400^{\circ}C$. Key parameters on Cs release behavior from spent fuel was powder formation as well as the diffusion rate of Cs compound to grain boundary and fuel surface.

• Journal of Energy Engineering
• /
• v.20 no.3
• /
• pp.191-199
• /
• 2011

The char burn-out and NOx emissions from sub-bituminous coal were investigated in drop tube furnace under $O_2/N_2$ and $O_2/CO_2$ environments with different $O_2$ concentrations of 12, 21 and 31%. Results show that the char burn-out rate is faster as $O_2$ concentration increases higher and char burn-out rate under $O_2/CO_2$ decreases due to the lower oxygen diffusion into coal surface through the $CO_2$ rich boundary layer. NO concentration increases with increasing $O_2$ concentration, but declines at $O_2$ concentration of 31%. Meanwhile, NO emission indexes decreases monotonically with increasing $O_2$ concentration, which indicates that more NO reduction occurs with higher $O_2$ concentration probably due to greater HCN formation. For all conditions of $O_2$ concentration, the NO concentration under $O_2/N_2$ maintains higher than those of $O_2/CO_2$ due to presence of thermal NO.

• Applied Chemistry for Engineering
• /
• v.9 no.2
• /
• pp.232-237
• /
• 1998

This study was carried out to find the optimal operating conditions for separation of residual uranium from the simulated radwaste solution containing 19 elements, and to evaluate the validity of the process. The selected process was based on the solvent extraction with TBP(tributyl phosphate). As an extractor, two miniature mixer-settlers with a total of 18 stages were used. Extraction yield of U, Np and Tc was about 99.2%. 32.1%, and 99.9%, respectively. The other elements were coextracted in the range of 1~4%. Extraction yield of U exceeded those of the previous work performed with batch system, which resulted in the low extractability of U (about 80%) according to the coexisting element such as Nd and Fe. It was due to the characteristics of multi-stage extractor. On the other hand, low extractability of Np was caused by various oxidation states in the nitric acid medium. In the case of Tc, its high extractability may be attributed to the complex formation with Zr and U, which is not well proved yet. All elements extracted with TBP were stripped into aqueous phase more than 99% by 0.01M $HNO_3$. From the results, this process has no problem with respect to in the same step was required, because Np was distributed in the raffinate and U product, respectively.