• Journal of Digital Convergence
• /
• v.15 no.10
• /
• pp.551-557
• /
• 2017

Hair beauty treatments that can express individuality have increased and diversified. However, their repetitive use has also brought about hair damage. To reduce such damage, the importance of hair treatments when receiving chemotherapy has magnified greatly. In this study, the hair (normal hair, NH) of 5 people in their 20s has been collected and observed with SEM before dyeing (NH), after dyeing (DH) and after dyed and treated (DTH) to measure the hair's morphological damage and mineral content. SEM observation results revealed that, in DTH, a cuticle-like arrangement appears almost uniformly, the hair settles, the lines are smooth, and the damage degree is low. Regarding mineral content, the concentration of minerals was generally balanced. However, in the observation of toxic minerals and minerals found in large amounts, the concentration of Ba, Na, Ca, and Mg was higher than the balance range in NH, DH, and DTH.

• Korean Journal of Agricultural Science
• /
• v.6 no.2
• /
• pp.192-197
• /
• 1979

Spread factors were tried to determine the diameter of airborne droplet emitted: from the sprayer by the measurements of airborne droplet diameter emitted from the uniform size droplet producer and impression diameter on Kromekote card or Eucalypt's leaf in the different dilute concentration with Geigy Red Herbicide Dye from 0.5% to 2% by weight. The results abtained were as follows; The general form of the equation in the relationship between airborne droplet and impression diameter on Kromekote card or Eucalypt's leaf was an exponential equation as follows; $$Y=aX^b$$ which gave a linear relation on log-log graph paper. The spread factor seemed to be larger in the thin dilute concentration than in the thick dilute concentration. The spread factor was remarkably smaller on Eucalypt's leaf than on Kromekote card due to the penetration of liquid into the leaf and the stomata of the epidermis. The calculated equation of the mean depth of the droplet sprayed on Eucalypt's leaf was the same form as $Y=aX^b$, which implied that the spray liquid was distributed in surplus in accordance with the diameter of the droplet larger than the optimum size droplet to control insect and disease.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.25 no.6
• /
• pp.1074-1079
• /
• 1996

Physicochemical characteristics of pigment separated from cockle shell were studied. Pigment on the cockle shell was peeled with distilled water, and soaked in 4% TCA solution for 30 minutes and filtered. Filtrate was washed 3 times with distilled water and Iyophilized. Dried pigment was dissolved with 2N NaOH solution and preparative TLC with 2N NaOH : acetone(1 : 1). UV/vis spectrum of pigment separated from cockle shell and melanin as standard was same one peak at UV area and λ$_{max}$was 226nm. Dissolved property of pigment was same as that of melanin. Pigment was not ommochrome but like melanin, because it was insoluble in formic acid, whitening in $H_2O_2, $ and pattern of UV-spectrum was same as melanin. Pigment separated from cockle shell was stable at high temperatures. In thermal treatment at $70^{\circ}C, $ $80^{\circ}C, $ $90^{\circ}C$ and $100^{\circ}C$ for 8 hours, retention ratio of pigment separated from cockle shell were 95.0%, 93.3%, 90.8% and 87.6%, respectively.

• Composites Research
• /
• v.29 no.4
• /
• pp.145-150
• /
• 2016

Polyvinylidene fluoride (PVDF) as a representative polymer with the piezoelectric property has been studied since the 1960s. Crystalline structure of poly(vinylidene fluoride) polymer is composed of five different crystal structure of the polymer as a semi-crystalline. Among the various crystal structures, ${\beta}-type$ crystal exhibits a piezoelectricity because the permanent dipoles are aligned in one direction. Generally ${\beta}-form$ crystal structure can be obtained through the transformation of the ${\alpha}-form$ crystal structure by the stretching and it can increase the amount through the after treatment as poling process after stretching. ${\beta}-form$ crystal structure the PVDF fibers produced by wet spinning is formed through a diffusion mechanism of a polar solvent in the coagulation bath. However, it has a disadvantage that the diffusion path of the solvent remains as pores in the fiber because the fiber solidification occurs simultaneously with the diffusion of the polar solvent. These pores play a role in reducing effect of poling process owing to effect of disturbances acting on the polarization by the electric field. In this work, the drying method using the microwave was introduced to remove more effectively the residual solvent and the pore within PVDF fibers produced through wet-spinning process and piezoelectric PVDF fibers was produced by transformation of the remaining ${\alpha}$ form crystal structure into ${\beta}-crystal$ structure through the stretching process.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.3 no.1
• /
• pp.45-52
• /
• 1998

The transport of suspended matter was interpreted in the coastal zone off Taean Peninsula during the summer (June) in 1996. Coastal waters were homogenous in water temperature and salinity, whereas offshore waters were characterzed by the strong thermocline. Mixing between coastal and offshore waters are negligeable, largely lessened, due to the existence of strong tidal front between the two water masses. In the offshore area, less saline coastal waters from the Kyunggi Bay are considered to be transported southward along the mid-depth layer of thermocline. Concentration of suspended matters was higher than 5 mg/l in the northern coastal area near the Kyunggi Bay, but generally less than 2 mg/l in the offshore area. Less saline waters along the mid-depth layer in the offshore area sustain maximum turbidities throughout the water column. Therefore suspended matters supplied from the coastal area of Kyunggi Bay are considered to be transported southward by the advective movement of less saline coastal waters. Mean particle size of the suspended matters shows 2~9 ${\mu}m$. Coarse grains (mean size larger than 7 ${\mu}m$) are predominant in the less saline coastal waters extending to the offshore mid-depth waters. Such size distributions of suspended matters together with the characteristics of water masses are considered to be an indicator for the southward movement of suspended matters derived from Kyunggi Bay.

• Journal of Animal Environmental Science
• /
• v.1 no.2
• /
• pp.117-124
• /
• 1995

This study was carried out to investigate the effect of depth of sawdust bedding and ground material in dairy cattle barn. Treatment included the concrete floor with a 10cm or 30cm sawdust and the earth floor with a 30cm sawdust. Eighteen cows were assigned to 3 pens with 16.5㎥/head bedding area. The results obtained were as follows : 1. The temperature of sawdust bed was highest in the earth floor with 30cm sawdust, and the moisture content of sawdust bed was highest in the concrete floor with 10cm sawdust bed. 2. Cows defecate feces 9.2, 8.7 and 9.3 times a day in 10cm sawdust on concrete floor(10S+C), 30cm sawdust on concrete floor(30S+C) and 30cm sawdust on non concrete floor(30S+ NC) respectively. In average, they excreta 9.1 times/day(85.8%) in the sawdust beds and 1.5 times/day(14.2%) in the feeding alley. 3. The ratio of daily water amount deposited vapor to total water amount deposited in sawdust beds was 74.0%, 61.5% and 47.1% in 10S+C, 30S+C and 30S+NC respectively. 4. N.P.K contents in the sawdust beds were higher for 10S+C compared with other treatments. 5. When 30cm of sawdust was applied on the earth ground NO$_3$-N contents in the sawdust bed was 37.7, 14.1 and 15.0ppm in depth of 30, 60 and 90cm under the ground, respectively, indicating some possibility of water pollution.

• The Journal of the Petrological Society of Korea
• /
• v.14 no.3 s.41
• /
• pp.141-148
• /
• 2005

Lead isotopic compositions are analyzed from the sulfide minerals of the Yeonhwa, Janggun and Uljin deposits and from host limestone, intrusives, and basement rocks to reveal the source of Pb in these deposits. In the $^{206}Pb/^{204}Pb$ vs $^{207}Pb/^{204}Pb$ plot, Galenas from the Yeonhwa mine display relatively well defined positive linear array, similar to the Precambrian basement rocks of the Korean peninsula. A galena sample from the Uljin mine, Janggun limestone and the basement rocks also follow the variation of Yeonhwa mine. However, ore minerals from the Janggun mine, having relatively low $^{206}Pb/^{204}Pb$ values, reveal offset from such trend toward lower $^{207}Pb/^{204}Pb$ values. Considering the fact that Mesozoic igneous rocks and ores within the Gyeongsang basin display considerably lower $^{207}Pb/^{204}Pb$ values than basement rocks of the Korean peninsula, the deviation of Janggun ore minerals can be interpreted as to reflect mixing between leads from old continental crustal materials and from Mesozoic igneous rocks with more mantle signature. The lead of the Yeonhwa and Uljin mine, following trend of Precambrian basement rather well, seems to have been originated mostly from such basement. However, regarding that they occupy low $^{207}Pb/^{204}Pb$ side of the variation trend of the basement, the possibility of having some leads derived from the Mesozoic igneous rocks cannot be excluded.

• Economic and Environmental Geology
• /
• v.30 no.2
• /
• pp.81-87
• /
• 1997

Chonnam and Kyongsang clay alteration areas are distributed in volcanic fields of the Yuchon Group in late Cretaceous period. The host rock of the Chonnam alteration area is generally acidic and that of the Kyongsang alteration area is acidic to dominantly intermediate volcanics. The important difference of two alteration areas is source of fluid; the Chonnam alteration area is characterized by dominantly meteoric water and the Kyongsang alteration area is characterized by dominantly magmatic water. Accordingly, the high temperature minerals such as pyrophyllite and andalusite, and boron bearing minerals such as dumortierite and tourmaline are common in the Kyongsang alteration area. In contrast to this, the lower temperature minerals such as kaolin and alunite are common in the Chonnam alteration area. The mineralogical difference of two alteration areas were depended on the difference of the formation temperature of clay deposits. The other important geochemical difference is the chemistry of hydrothermal solution such as pH. The alteration of "acid-sulfate type" with alteration mineral assemblage of alunite-kaolin-quartz is dominant in the Chonnam alteration area, which was caused by the attack of strong acid and acid solution. In contrast to this, the that of "quartz-sericite type" with the mineral assemblage of sericite-quartz is dominant in the Kyongsang alteration area, which was caused by the attack of neutral or weak acid solution. Also, the Kyongsang and Chonnam alteration areas show the difference in structural setting; the Chonnam alteration area is commonly associated with silicic domes and the Kyongsang alteration area is commonly associated with calderas.

• Korean Journal of Food Science and Technology
• /
• v.45 no.6
• /
• pp.721-726
• /
• 2013

In this study, a yogurt containing skim milk powder and whole barley flour was fermented with lactic acid bacteria, and its quality and properties were estimated. The yogurts with 1% and 3% barley flour had lower pH values, higher titratable acidity, and higher Brix values than the control. In addition, the viable cell counts were lower and viscosity was higher. The value of L was low, and the values of a and b were high. The yogurt with 3% barley flour had more lactic acid than the control and showed a substantial increase in the amount of acetic acid. ${\beta}$-Glucan content and antioxidant activity increased with the amount of barley flour added. In sensory evaluation, there was a similar preference for the yogurt with 3% barley flour and the control, and as the barley flour content increased, the preference decreased. Moreover, the preference for the yogurt was higher among old people.

• Applied Chemistry for Engineering
• /
• v.3 no.1
• /
• pp.130-137
• /
• 1992

The Graft copolymerization of acrylonitrile(AN) and styrene(ST) onto chloroprene rubber(CR) were carried out with benzoyl peroxide(BPO) as an initiator. The synthesized graft copolymer(ACS) was separated from polymeric mixture by the extraction with ethyl acetate and n-hexane, acetone and methanol, dimethylformamide(DMF) and methanol mixed solvent systems. The graft copolymer obtained, acrylonitrile-chloroprene-styrene(ACS) was identified by IR spectrophotometer. The effect of mole ratio of styrene to acrylonitrile, reaction time and temperature, initiator concentration, CR content and solvents on graft copolymerization were examined. It was observed that the grafting efficiency increased with [ST]/[AN] mole ratio and reaction time. The grafting efficiency increased with increasing initiator concentration and CR content. The maximum grafting efficiency was obtained when the mole ratio of [ST]/[AN] was 1.5 and reaction was made at 40hrs, and $70^{\circ}C$ using chloroform/toluene mixed solvent. The thermal properties, light resistance and flammability of ACS were compared with those of ABS and AES. It was found that flame retardancy of related polymers increased in the order ACS>ABS>AES. The thermal stability of ACS was greatly improved when compared with ABS or AES. Morphology of ACS was also investigated by using a transmisson electron microscope(TEM).