• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.1 s.104
• /
• pp.45-51
• /
• 2006

In this paper, a new predistortion linearizer for controlling the amplitude of low frequency intermodulation distortion signals is proposed. The low frequency intermodulation distortion(IMD) components are generated by harmonic generator. A vector modulator, modulate fundamental signal with low frequency IMD signals, generates predistortion IMD signals and controls amplitude and phase of them with modulation factors. As a result, this predistorter is suppressed IMD signals of power amplifier effectively. The predistortion linearizer has been manufactured to operate in cellular base-station transmitting band($869{\sim}894\;MHz$). The experimental results show that IMD3 of power amplifier are improved more than 20 dB for CW two-tone signals. Also, it's improved the adjacent channel power ratio(ACPR) more than 10 dB for IS-95 CDMA IFA signals.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.12
• /
• pp.2609-2614
• /
• 2010

Temperature compensation circuit is implemented by using the temperature sensor, and Intermodulation (IM) Specification of Power Amplifier is satisfied in the temperature range of $-30^{\circ}C{\sim}60^{\circ}C$ with this temperature compensation circuit. The output voltage of temperature compensation circuit which vary 170mV with the temperature is applied to the gate of TR in 3W output power Amplifier. As the result, right 3rd IM component is -18.5~-26dBm, left 3rd IM component is -18.5~-35dBm, and the left and right 5th IM component is -24~-26dBm in the temperature range of $-30^{\circ}C{\sim}60^{\circ}C$. It is confirmed that IM specification of power amplifier which is under -17dBm in the whole temperature range is satisfied.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.5 s.108
• /
• pp.476-482
• /
• 2006

In this paper, a multimode feed horn antenna is suggested for a high power microwave(HPM) antenna system. The proposed HPM feed horn antenna which is connected with a mode converter is located between source and reflector antenna. A multimode feed horn antenna which has reduced -25 dB beamwidth is designed and fabricated for miniaturization of reflector antenna because -25 dB beamwidth which is determined by considering spillover of feed horn antenna decides a size of reflector in case of HPM. As a result, feed system which uses the multimode feed horn antenna has high gain about 27 dBi and return loss is less than -22 dB at 10 GHz. The measured -25 dB beamwidths of the radiation pattern at vertical, horizontal-plane equal to $20.24^{\circ},\;28.92^{\circ}$ which is less than about $10^{\circ}$ beamwidth of conventional feed system. Thus the suggested feed hem antenna is suitable to feed horn for miniaturization of HPM antenna system.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.39 no.9
• /
• pp.28-34
• /
• 2002

In this paper, a new type predistorter using a low frequency intermodulation signals terms of harmonic generator is proposed. A vector modulator, in which fundamental signal is modulated with low frequency intermodulation signals derived from harmonic generator, generates predistorted third and fifth IM components. Using predistorted signals, intermodulation distortion signals of power amplifier suppressed. The suggested predistorter has been manufactured to operate in Korean PCS base-station transmitting band (1840~1870MHz). The test results show that the third IMD signal level is reduced more than 20dB and the fifth IMD signal is reduced about 10dB for CW two-tone signals. The predistorter improves the Adjacent Channel Power Ratio (ACPR) more than 10dB for CDMA (IS-95) signals.

• International Journal of Highway Engineering
• /
• v.12 no.3
• /
• pp.113-119
• /
• 2010

This study presents experimental findings on the performance of cement concrete pavement incorporating mineral admixtures such as ground granulated blastfurnace slag and silica fume. Flexural strength, compressive strength, charge passed, diffusion coefficient of chloride ions and initial surface absorption of cement concrete pavement incorporating mineral admixtures were periodically measured and the corresponding results were compared to those of plain concrete pavement. As a result, strength behaviors of concrete pavement were dependent on the types of mineral admixtures. However, it was true that incorporation of silica fume had a beneficial effect on compressive strength development. Furthermore, the application of mineral admixtures led to a lower diffusion coefficient of chloride ions compared to plain concrete pavement. Based on the experimental results, the present study would be helpful to design high-performance cement concrete pavement.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.8
• /
• pp.943-953
• /
• 2007

In this paper, we propose a Cassegrain antenna with a scalar feed horn opt rating in Ka-band. For an effective EM simulation of the Cassegrain antenna, the near-field of the feed hone is used ai the equivalent source of the Cassegrain antenna using the surface equivalent theorem. A corrugated circular horn operating with $HE_{11}$ mode is used as the feed horn. The angle and feed center of the main and sub reflectors are optimized to achieve maximum antenna efficiency. The designed feed horn shows the gain of 19dBi, the side-lobe level of less than -25dB and the half power beam width of $20^{\circ}$ at 33 GHz. The Cassegrain antenna shows the gain of 41dBi, the efficiency of 60%, the side-lobe level of less than -20dB and the half power beam width of $1.2^{\circ}$.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1996.06a
• /
• pp.177-181
• /
• 1996

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.5
• /
• pp.389-392
• /
• 2018

Herein, a horn antenna that has the maximum back lobe reduction characteristic using a corrugated structure at 1.57 GHz for a high-power microwave system is proposed. The back-lobe characteristics of the proposed antenna was optimized using simulation as the number of corrugated structures increase, and the three-staged corrugated structure was designed. Consequently, the front-to-back ratio(FBR) of the fabricated antenna is 47.2 dB, which is improved by 23.7 dB based on that of the basic horn antenna, i.e., 23.47 dB.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2007.06a
• /
• pp.569-571
• /
• 2007

In this paper, hem antenna composed of rectangular hern, circular polarizer and straight-type mode convertor is designed and fabricated. The circular polarizer is designed as a dielectric type having broadband characteristic, and it is inserted into the rectangular hem with $45^{\circ}$ inclination. The straight-type mode convertor has a terrace-type structure in order to convert the TEM mode signal of coaxial cable to the TE mode of rectangular waveguide, and this structure minimizes conversion loss. Fabricated hem antenna operates at $30.085\sim30.885GHz$ and has VSWR < 1.5, Axial ratio < 1.0dB and antenna gain of $6.7\sim7.0dBi$ in the band.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.1
• /
• pp.91-96
• /
• 2008

In this paper, a monopulse fled for three mode $2{\times}2$ array feed horn antenna was designed. Gain of single feed was 8.25dB. Increasing property of gain and rectangular waveguide and reflection of free space is decreased because it has structure extending to electric plane at connected part from transformation to free space. When fled port1 and port2 is placed vertically and thickness of aperture hem is reduced, isolation is satisfied with property of lower -25dB. Also, at higher frequency, it is confirmed that isolation is improved. Combination of electric field occurs less influence because port1 and port3 is placed horizontally and distribution of electric field is connected to parallel. However, because of combination of electric field, it is more improved from 2dB to 6dB than isolation of port1 and port2. Direct combination occult less effect at port1 and port4 than effect of port2 and port3, it is lower -35dB.