• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.2 no.3
• /
• pp.431-437
• /
• 1998

In this paper, we have investigated the electrical properties of ultra-thin nitrided oxide(NO) and re-oxidized nitrided oxide(ONO) films that are considered to be promising candidates for replacing conventional silicon dioxide film in ULSI level integration. Especially, we have studied a variation of I-V characteristics, gate voltage shift, and time-dependent dielectric breakdown(TDDB) of thin layer NO and ONO film depending on nitridation and reoxidation time, respectively, and measured a variation of leakage current and charge-to-breakdown(Q$\_bd$) of optimized NO and ONO film depending on ambient temperature, and then compared with the properties of conventional SIO$\_2$. From the results, we find that these NO and ONO thin films are strongly influenced by process time and the optimized ONO film shows superior dielectric characteristics, and (Q$\_bd$) performance over the NO film and SIO$\_2$, while maintaining a similar electric field dependence compared with NO layer.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.8
• /
• pp.32-36
• /
• 2018

A tensile test evaluation of a polypropylene plate was carried out using an Instron tester with a capacity of 500 kgf. To evaluate the strain rate sensitivity of the polypropylene plate with a thickness of 0.8 mm, a tensile test was performed at room temperature through strain rate variations from $5{\times}10^{-4}/sec$ to $5{\times}10^{-2}/sec$. From these, the changes in strength due to the strain rate change and temperature change were compared. As a result of the experiment, the strength increased with increasing initial strain rate. Polypropylene was found to be a material with a positive strain rate sensitivity. In addition, the high temperature tensile properties of the polypropylene plate were evaluated using high temperature tensile tests at 80, 120, and $160^{\circ}C$. The strength decreased with increasing temperature. In particular at $160^{\circ}C$, the tensile strength decreased to zero. The increase in yield strength and the tensile strength at room temperature, $80^{\circ}C$ and $120^{\circ}C$ were similar. At $160^{\circ}C$, however, there was almost no increase in strength because the stress approached zero. In the high temperature tensile test, the tensile strength increased more than the increase in yield strength with increasing strain rate.

• Korean journal of food and cookery science
• /
• v.11 no.5
• /
• pp.472-478
• /
• 1995

녹두가루와 전분의 일반성분 및 무기성분을 조사하고 녹두가루의 농도(4-8%,건량기준), 녹두전분의 농도(3-8%,건량기준)에 따른 호화 특성 및 리올로지특성을 비교하였다. 녹두가루의 일반성분은 수분 6.8%, 단백질 25.0%,지방 1.21%,회분 1.77%,비타민 B$_1$과 B$_2$는 각각 0.57과 0.11 mg/100 g이었다. 전분의 비타민 함량은 B$_1$이 0.002 mg/100 g, B$_2$가 0.02 mg/100 g이었다. 가루의 무기질함량은 칼슘이 374.9 mg/100 g으로 가장 높았고 인(353.0 mg/100 g), 칼륨(176.3 mg/100 g), 마그네슘(116.9 mg/100 g), 나트륨(107.6 mg/100 g) 순서이었다. 전분현탁액의 광투과도로 부터 예측한 전분의 호화온도는 67$^{\circ}C$이었다 녹두가루와전분의 팽윤력은 60-8$0^{\circ}C$의 가열온도에서 직선적으로 증가하였으며 그 정도는 전분이 가루보다 컸다. 용해도는 $65^{\circ}C$이후부터 증가하여 녹두 가루는 8$0^{\circ}C$까지 지속적으로 증가하였으나 전분은 7$0^{\circ}C$ 이후에는 완만하게 증가하였다 녹두가루는 농도가 증가함에 따라 아밀로그래프의 최고 점도가 증가하였으나 전분은 6-8%의 농도에서 최고점도를 나타내지 않았으며92.5$^{\circ}C$에서 15분간 유지하는 동안 점도는 지속적으로 증가하였다. 최고점도의 대수값과 농도는 직선적인 관계를 나타냈으며 동일한 최고점도를 나타내는 농도는 전분이 가루보다 2.6ft'3도 낮았다. 녹두가루(4-8%, 건량기준)와 전분(3-8%, 건량기준)현탁액을 95$^{\circ}C$에서 40분간 유지시켜 호화시킨 액을 6$0^{\circ}C$에서 측정한 결과, 항복응력과 점조 도지수는 농도가 증가함에 따라 커졌고 유동지수값은 1.0보다 작아 녹두가 루와 전분호화액은 항복응력을 가진 의가소성 유체의 성질을 나타내었다 동일한 점조도지수값을 나타내는 농도는 전분이 가루보다 약 1.3%정도 낮았다.

• Korean Journal of Food Science and Technology
• /
• v.12 no.1
• /
• pp.18-23
• /
• 1980

Rheological behaviors of red pepper paste acre investigated with rotational viscometer at $25{\sim}55^{\circ}C$ and the following results were obtained. 1. At shear rate of $0.323{\sim}1.653\;sec^{-1}$, red pepper paste was found to be a thixotropic food product which showed pseudoplastic proper ties and also exhibited a yield stress and time dependent characteristics. 2. At a shear rate of 0.978 $sec^{-1}$, flow behavior index, consistency index and yield stress were 0.597, 192.3 dyne $sec^s/cm^{2}$, and 91 dyne/$cm^{2}$ respectively. 3. Variation of consistency of red pepper paste with time was found to be decayed by a second order kinetic equation and thereafter nearly time independent. 4. Variation of consistency of red pepper paste with temperature was found to follow Andrade's equation and the activation energy as calculated on the basis of this equation was $1.03\;kcal/g{\cdot}mole$.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.27 no.10
• /
• pp.106-112
• /
• 1990

The progress of oxidation of a porous silicon layer(PSL) was studied by examining the temperature dependence of the oxidation and the infrared absorption spectra. Thick OPSL(oxidized porous silicon layer). which has the same properties as thermal $SiO_{2}$ of bulk silicon, is formed in a short time by two steps wet oxidation of PSL at $700^{\circ}C$, 1 hr and $1100^{\circ}C$, 1 hr. Etching rate, breakdown strength of the OPSL are strongly dependent on the oxidation temperature, oxidation atmosphere. And its breakdown field was ${1\MV/cm^-2}$ MV/cm The oxide film stress was determined through curvature measurement using a dial gauge. During oxidation at temperature above $1000^{\circ}C$ in dry $O_{2}$, stress on the order of ${10^9}\dyne/{cm^2}{-10^10}\dyne/{cm^2}$ are generated in the OPSL.

• Korean Journal of Food Science and Technology
• /
• v.28 no.3
• /
• pp.538-544
• /
• 1996

A highly viscous biopolymer from alkali-tolerant Bacillus sp. was purified and its rheological properties were studied. 1% (w/v) solution of purified biopolymer showed pseudoplastic fluid behavior with the yield stress similar to those of xanthan and guar gum, and its consistency index was exponentially dependent on concentration and temperature. The concentration dependency of consistency index exhibited two rectilinear plots with different slopes at 1% concentration and pseudoplastic property increased with the increase of biopolymer concentration. The biopolymer solution exhibited a low temperature dependency and the activation energy of flow was 1.16 kacl/g mol. The apparent viscosity was very dependent on the change of pH and the addition of salt. However, no organic solvent effects were observed effects of viscosity synergism with the addition of viscosifier were not observed.

• Journal of the Korean Applied Science and Technology
• /
• v.32 no.3
• /
• pp.497-504
• /
• 2015

Apart from hydrates, asphaltenes, and inorganic minerals, paraffinic waxes are also very important in flow assurance area. Evaluation of wax gel behavior has been important as off-shore oil recovery becomes more popular in oil production. Restart after either planned or emergency shutdown requires pump operation in high pressure since a waxy oil forms troublesome gel. In this paper, vane method is introduced to determine wax gel strength by determining yield stress. Prediction of gel strength are discussed in qualitative and quantitative manners.

• Journal of Korea Multimedia Society
• /
• v.3 no.5
• /
• pp.535-541
• /
• 2000

In this paper, we analyzed the characteristics of schottky junction to develop the voltage swing of ISL, and simulated the characteristics with the programs at this junctions. Simulation programs for analytic characteristics are the SUPREM V, SPICE, Medichi, Matlab. The schottky junction is rectifier contact between platinum silicide and silicon, the characteristics with programs has simulated the same conditions. The analytic parameters were the turn-on voltage, saturation current, ideality factor in forward bias, and has shown the results of breakdown voltage between actual characteristics and simulation characteristics in reverse bias. As a result, th forward turn-on voltage, reverse breakdown voltage, barrier height were decreased but saturation current and ideality factor were increased by substrates increased concentration variations.

• The Korean Journal of Rheology
• /
• v.10 no.3
• /
• pp.165-172
• /
• 1998

본논문에서는 전기장 부하에 따라 유동성질이 변화하는 ER유체의 빙햄특성을 실험 적으로 연구하였다. 특히 ER유체의 빙행특성에 영향을 주는 여러인자중 전극 간격 및 재질 에 따른 ER유체의 항복전단응력과 전류밀도의 변화를 온도에 따라 고찰하였다. 이를 위하 여 전극 간격을 가변시킬수 있는 전기 점도계를 세가지 재질로 자체 제작하였다. 전극간격 은 0.75 mm, 1.00mm 및 1.25 mm 로 설정하였으며 전극 재질은 스테인레스 스텔, 동 그리 고 기계구조용 탄소강(SMS45C)을 사용했다. 한편 실험에 사용된 ER유체는 자체 조성한 수 계 ER유체인 ERF-1과 외국의 우수하다고 알려진 비수계 ER유체인 ERF-2 두가지를 선택 하였다. 실험은 $25^{\circ}C$와 7$0^{\circ}C$ 및 10$0^{\circ}C$에서 수행하였으며 전기장은 0-4kV/mm 범위에서 온 도 및 ER유체의 종류에 따라 부하 가능한 전압까지 공급하였다. 전단변형률 50, 100, 150, 200, 400, 600, 800, 1000 및 1200 s-1에서 얻은 전단응력 실험결과로부터 최소오차선형법을 이용하여 전단변형률 영에서 동적 항복전단응력 값을 도출하였으며 그결과로부터 전극 간격 및 재질에 따른 ER효과의 변화를 고찰하였다. 또한 상온과 10$0^{\circ}C$에서 4kV/mm의 전기장을 부하하여 전기장에대한 ER유체의 응답특성을 실험을 수행했다.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.30 no.7 s.250
• /
• pp.809-815
• /
• 2006

The temperature and loading-rate dependence on the mechanical behavior of single-walled carbon nanotubes under axial compression and torsion is examined with classical molecular dynamics simulation. The critical buckling is found to depend on the temperature and loading-rate. The yielding under torsion is also found to depend on the temperature and loading-rate. But it is shown that the compression and torsional stiffness are independent of the varied temperatures and loading-rates.