• Journal of the Korean Society of Hazard Mitigation
• /
• v.4 no.3 s.14
• /
• pp.1-8
• /
• 2004

In this study, the change of the current in the coastal zone before and after the construction of Jeju new harbor was predicted by using the numerical model, which uses Hardy-Cross method. The numerical model was carried out for the present state, before the construction, and the state after the construction, and for the wave direction the NNW direction for winter and NE direction for summer were tested so that the seasonal change may be considered. The computation result shows that a large amount of the wave induced current was occurred when there were high waves coming in from NNW direction before and after the construction. Also, before the construction a longshore current occurred moving from the west to the east at the new harbor construction site so that it formed a rip current in the Hwabuk-dong front sea. And also, after the construction, the tip current produced changed into nearshore circulating current and a small circulating current appeared at the harbor entrance. On the other hand, at Samyang 4each, which is 3.0km away from the new harbor in the NE direction, shows that there was a longshore current occurred from the west to the east, which is in the opposite direction the new harbor, and the effect on the new harbor by sediment transport at Samyang beach is thought to be very small.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.17 no.1
• /
• pp.1-7
• /
• 2005

The heat transfer characteristics of an internal heat exchanger for $CO_2$ refrigeration cycle are numerically investigated. The numerical model is verified using the published experimental results for the concentric tube type internal heat exchanger. The Hardy-Cross Method gives very good agreement between the calculation and experimental results on the heat transfer rates and exit temperatures. Also, appropriate combination of heat transfer correlations is found. The operating parameters of the heat exchanger are calculated at transcritical region of $CO_2.$ The heat transfer rate of the counter flow type heat exchanger shows the $32\%$ greater than that of the parallel flow type heat exchanger. The increase of heat exchanger length enhances the heat transfer rate. The thermodynamic characteristics and heat transfer coefficient of $CO_2$ in the internal heat exchanger are estimated.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.18 no.3
• /
• pp.291-303
• /
• 2016

Recently, various forms of diverging sections in tunnels have been designed as the demand for underground passageway in urban areas increases. Therefore, the complexity of the ventilation system in tunnels with diverging sections requires a ventilation analysis method different from the conventional method for the straight tunnels. None of the domestic and foreign tunnel ventilation design standards specifies the method for the ventilation network analysis, and the numerical analysis methods have been most widely used. This paper aims at reviewing the ventilation network analytical method applicable as the design standard. The proposed method is based on the characteristic equations rather than the numerical analysis. Thanks to the advantages of easy application, the Hardy-Cross method has been widely applied in the fields of mine ventilation and tunnel ventilation. However, limitations with the cutting errors in the Taylor series expansion and the convergence problem mainly caused by the mesh selection algorithm have been reported. Therefore, this paper examines the applicability of the ventilation analysis method for network-type tunnels with the gradient method that can analyze flow rate and pressure simultaneously without the configuration of mesh. A simple ventilation analysis method for network-type tunnels is proposed.