• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.29 no.6B
• /
• pp.537-542
• /
• 2009

To improve stage-discharge curve equation considering water level's function, this study suggested the method that can efficiently compute rivers discharge based on hydraulic characteristics such as river width, area, channel bed slope and entropy concept adopting probabilistic approach. This scheme is proposed to estimate discharge from the velocity formulation based on the entropy function in the equilibrium state derived from the relation between mean and maximum flow velocity. It has been tested using field and laboratory hydraulic data collected from the Alberta university in Canada. As a result it was found that the method proposed in this study was more efficient and accurate comparing with the traditional stage-discharge curve equation.

• Journal of the Korea Concrete Institute
• /
• v.24 no.4
• /
• pp.399-406
• /
• 2012

Beam-column joints are generally recognized as the critical regions in the moment resisting reinforced concrete (RC) frames subjected to both lateral and vertical loads. As a result of severe lateral load such as seismic loading, the joint region is subjected to horizontal and vertical shear forces whose magnitudes are many times higher than in column and adjacent beam. Consequently, much larger bond and shear stresses are required to sustain these magnified forces. The critical deterioration of potential shear strength in the joint area should not occur until ductile capacity of adjacent beams reach the design demand. In this study, a method was provided to predict the deformability of reinforced concrete beam-column joints failing in shear after the plastic hinges developed at both ends of the adjacent beams. In order to verify the deformability estimated by the proposed method, an experimental study consisting of three joint specimens with varying tensile reinforcement ratios was carried out. The result between the observed and predicted behavior of the joints showed reasonably good agreement.

• Clean Technology
• /
• v.26 no.3
• /
• pp.186-195
• /
• 2020

The isothermal adsorption, dynamic, and thermodynamic parameters of Acid black (AB) and Quinoline yellow (QY) adsorption by activated carbon were investigated using the initial concentration, contact time, temperature, and pH of the dyes as adsorption parameters. The adsorption equilibrium data fits the Freundlich isothermal adsorption model, and the calculated Freundlich separation factor values found that activated carbon can effectively remove AB and QY. Comparing the kinetic data showed that the pseudo second order model was within 10% error in the adsorption process. The intraparticle diffusion equation results were divided into two straight lines. Since the slope of the intraparticle diffusion line was smaller than the slope of the boundary layer diffusion line, it was confirmed that intraparticle diffusion was the rate-controlling step. The thermodynamic experiments indicated that the activation energies of AB and QY were 19.87 kJ mol^-1 and 14.17 kJ mol^-1, which corresponded with the physical adsorption process (5 ~ 40 kJ mol^-1). The adsorption reaction was spontaneous because the free energy change in the adsorption of AB and QY by activated carbon was negative from 298 to 318 K. As the temperature increased, the free energy value decreased resulting in higher spontaneity. Adsorption of AB and QY by activated carbon showed the highest adsorption removal rate at pH 3 due to the effect of anions generated by dissociation. The adsorption mechanism was electrostatic attraction.

• Korean Journal of Remote Sensing
• /
• v.33 no.6_1
• /
• pp.947-960
• /
• 2017

Soil moisture plays an important role to affect the Earth's radiative energy balance and water cycle. In general, satellite observations are useful for estimating the soil moisture content. Passive microwave satellites have an advantage of direct sensitivity on surface soil moisture. However, their coarse spatial resolutions (10-36 km) are not suitable for regional-scale hydrological applications. Meanwhile, in-situ ground observations of point-based soil moisture content have the disadvantage of spatially discontinuous information. This paper presents an experimental soil moisture retrieval using Sentinel-1 SAR (Synthetic Aperture Radar) with 10m spatial resolution for cropland in South Korea. We developed a soil moisture retrieval algorithm based on the technique of linear regression and SVR (support vector regression) using the ground observations at five in-situ sites and Sentinel-1 SAR data from April to October in 2015-2017 period. Our results showed the polarization dependency on the different soil sensitivities at backscattered signals, but no polarization dependence on the accuracies. No particular seasonal characteristics of the soil moisture retrieval imply that soil moisture is generally more affected by hydro-meteorology and land surface characteristics than by phenological factors. At the narrower range of incidence angles, the relationship between the backscattered signal and soil moisture content was more distinct because the decreasing surface interference increased the retrieval accuracies under the condition of evenly distributed soil moisture (during the raining period or on the paddy field). We had an overall error estimate of RMSE (root mean square error) of approximately 6.5%. Our soil moisture retrieval algorithm will be improved if the effects of surface roughness, geomorphology, and soil properties would be considered in the future works.

• Korean Journal of Microbiology
• /
• v.37 no.3
• /
• pp.197-203
• /
• 2001

An ubiquitous bacterium, Pseudomonar cepacia KH410 was isolated from fresh water plant root and identified. Adsorption of heavy metals of lead, cadmium and copper by this strain was investigated. Optimal conditions foradsorption was 1.0 dry g-biomass, at pH 4.0 and temperature of $40^{\circ}C$. Adsorption equilibrium reached max-imum after 120 min in 1000 mg/l metal solutions. The adsorption capacity (K) of lead was 5.6 times higher thancadmium and 4.0 times higher than that of copper. Adsorption of lead was applicable for Langmuir modelwhereas Freundlich model for cadmium and copper, respectively. Adsorption strength (1/n) of heavy metal ionswere in the order of lead>copper>cadmium. Uptake capacity of lead, cadmium and copper by dried cell was83.2,42.0,65.2 mg/g-biomass, respectively. Effective desorption was induced 0.1 M HCI for lead and 0.1 $HNO_3$ for cadmium and copper. Pretreatment to increase ion strength was the most effective with 0.1 M KOH.Uptake by immobilized cell was 77.8,58.5,71.2 mg/g-biomass for lead, cadmium and copper, respectively. Theimmobilized cell was more effective than ion exchange resin on removal of heavy metals in solution containinglight metals.

• Korean Journal of Agricultural Science
• /
• v.29 no.2
• /
• pp.53-66
• /
• 2002

This study was performed to evaluation the consolidation behavior of agricultural reservoir in the very soft ground. The final settlement prediction methods by Terzaghi, Hyperbolic and Asaoka methods were used to compare with the degree of consolidation estimated by exess pore water pressure. The dissipated excess pore water pressure during embankment construction and peak excess pore water pressure on the completed embankment were suggested for the estimation of the degree of consolidation. It was concluded that the degree of consolidation estimated from dissipated excess pore water pressure was more reliable than that from the peak excess pore water pressure. The stability methods for agricultural reservoir was used to compare and analyze with various condition by limit equilibrium method.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.8 no.3
• /
• pp.61-71
• /
• 1988

The stage-discharge relation curve(rating curve) is the basic formula in hydrologic analysis. It plays an important role in converting to the discharge from available flood water level data including the daily mean stage. However, the river induces a cross section change at the gauging station because of the composed material of the river bed and three processes of the stream flow; i.e., erosion, transportation, and sedimentation. Rating curve has to be revised according to the temporal variation of the river bed due to the those factors. In this study, the basic rating curve is developed with respect to the current river bed to convert the existing rating curves and also to seize the hydraulic and geometric characteristics for the temporal variation of the river bed, relationships among the basic rating curve and the existing rating curves, water level, cross sectional area, and flow velocity are analyzed. Indogyo station, which is not only the key station of the Han river but also greatly changed the river bed after completion of the Han river development plan during the year 1983 to 1986, was chosen for the study. In this study, the river bed is assumed in a dynamic equilibrium condition. The basic rating curve is developed using hydrologic data of the physical year of 1987. For a given discharge, relationships for conversion of previous data, stage and velocity, the current one are formulated. To verify the usefulness of the relationships, stage-cross sectional area and stage velocity formula are also derived. Both hydrologic method using continuity equation and statistical method by the rating curve are compared and checked, then the validation of the both are positively shown.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.4 no.4
• /
• pp.335-344
• /
• 2006

In this paper a computer program was developed, which simulates the Li reduction process of PWR spent fuel, and the amount of a produced metal or chloride compound was calculated at the various amount of Li with the program. It establishes a database, which is composed of some characteristics related to a chemical reaction equation and thermodynamic data, and it calculates the transformed rate of PWR spent fuel oxide at the certain amount of Li by using the database as input data. As the results of the performance test of the program, it was validated that the transformed values of oxides, except for $Eu_2O_3$ and $Sm_2O_3$, were almost the same to within about a 6 % error with those calculated by the previous code and that the calculated amount of Li was also exactly consistent with the theoretical one, which is used for a complete reaction of each oxide in a single chemical reaction. A relationship between Li and the transformed metal of each oxide was analyzed on the basis of the quantities calculated with the verified development program. Of the results, when the amount of Li was given to be 250 mole, the 83.73 percentage of $UO_2$ was transformed into U while the remainder was still to be $UO_2$. In addition, it was appeared that the 297 mole of Li was needed to completely convert $UO_2$ into U.

• Korean Journal of Optics and Photonics
• /
• v.28 no.1
• /
• pp.9-15
• /
• 2017

We precisely measured and analyzed the dynamics of peptide-antibody interactions, using an ellipsometric biosensor based on a silicon substrate. To reduce the signal error due to the imperfect flatness of the substrate for extremely low concentrations of peptide, we fabricated the biosensor with a silicon substrate coated with Dextran SAM, instead of a glass prism coated with a thin metallic thin film. At an injection speed of $100{\mu}l/min$ of buffer liquid, we detected the dynamics of antibody-Dextran SAM or peptide-antibody fixed on biosensor, respectively. We detected the dynamics of antibody-Dextran SAM interactions down to a low concentration of 5 ng per liter, and we precisely measured the dynamics of association and dissociation of peptide and antibody down to 100 nM of peptide. We obtained the rate constants for association and dissociation from fitting the data by using deduced dynamical equation. As a result, we obtained an equilibrium constant for dissociation of 97 nM of peptide-antibody complex, which belongs to Class I.

• Korean Journal of Remote Sensing
• /
• v.20 no.2
• /
• pp.103-116
• /
• 2004

The mesoscale atmospheric models to produce surface temperature can not generally consider the effect of the sloped terrain for direct solar radiation. These have not showed the regional difference of solar radiation and as a result, have made the big error in the local surface temperature. Therefore, we wished to represent the exact locality of surface temperature by considering the geometric properties of surface as well as the vegetated properties of surface. The purpose of the study is to produce local surface ground temperature in sloped terrain diagnostically using surface Energy Balance Model (EBM) with the use of GRID model in Geographic Information Systems (GIS). In this study, surface inhomogeneity over southeastern part of Korean peninsula are considered in estimation of the absorbed surface solar radiation in terms of the illumination angle, depending on topographical aspect and slope in GRID. Also, the properties of vegetated surface which the major components for the variability of surface temperature are considered in terms of NDVI. The results of our study show the locally changes in the surface ground temperature due to local ground aspect and slope effect and local properties of vegetated surface. The more detailed distribution of local surface temperature may drive the local circulation at lower atmospheric and it may explain better the real local circulation.